For the circuit below, find the current I. 20 j60 ell HE -j20 j20 ell 10 I -j20 j40 24 Va -j20 Figure 1. AC Circuit for Item # 5

Q: Given: Source = 20V (supplies 4W of power) v2 = 8V Note: Resistance is in ohms Solve for ...

A: It is given that: Psource=4W V2=8 V

Q: Determine the voltage V using Mesh Analysis. 13 4ΩV 1 A 312 0 8 V ± -27 2

A: Given circuit: R=27 Ω To find: Determine the voltage V using mesh analysis.

Q: Derive equation for E1 and E2

A: The circuit given is shown below:

Q: 9.a. What should be done with the connector ferrule once a connector is attached to a fiber optic ca...

A:

Q: Zo B= 70 r,= 60 kN a.) Determine re 24 V b.) Find the dc voltages VB, VCB, and VCE c.) Determine Zi ...

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts fo...

Q: Determine the capacitance required to establish a capacitive reactance that will match that of 20 mH...

A:

Q: Describe the combined effect of the RC circuits for higher frequency response in a BJT & FET amp...

A:

Q: A 220 V shunt motor has armature and field resistance of 0.2 2 and 220 2 respectively. The motor is ...

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Q: 2. Determine the voltage with respect to ground at each point in below. Assume the practical model. ...

A: The circuit diagram is shown below, Where,VS1=25VVS2=8VR=1kΩ

Q: v,(t) = 7.3 1+2.9[V];for 0 <tS7기s]. a) Find the value of ia at t= 2[s]. b) Find the power absorbed b...

A:

Q: primary of a certain transformer takes 1 a at a power factor of 0.4 when it is connected acrossa 200...

A: Primary current: It is a current that flows on the primary side of the transformer.

Q: Do DI -Y 10 So Y D2 1 11 12 1 13 14 1 D3 1 1 15 16 Y = S¡'.So'.Do + S¡'.So.D1 + S1.So'.D2 + S1.So.D3

A: The above circuit and the expression of Y refers to a 2*4 multiplexer.   

Q: I. TRUE OR FALSE: 1) BJTS are basically current-controlled devices. 2) In a common-emitter amplifier...

A:

Q: Describe Amplitude Modulator as one of an OTA applications       the subject : Analogue Electroni...

A: Amplitude modulator: In this modulation the amplitude of carrier wave changes in proportion to the m...

Q: in the series combination of 300 ohm resistor, 0.25H inductor and a 1 microfarad capacitor, find the...

A:

Q: 33. On opening under load, as the distance between contacts increases, the Resistance of the arc rem...

A: We are authorized to answer one question at a time, since you have not mentioned which question you ...

Q: Find the apeunit vector of P P= 10mxt 20ay +6az a. 0:256 met o.972agt 0.849 az -3 d. O.$26 art b-872...

A:

Q: Design a heart rate monitoring system using MAX30100 sensor. This sensor provides output voltage in ...

A: According to the question, we need to design ADC a) Design a three bits of binary output ADC using c...

Q: ComputationA house has the following specifications for a circuit determine the size of the circuit ...

A: Selection of right circuit breaker and wire is must while fabricating a house wiring because it ensu...

Q: A 952 range voltmeter is having an accuracy of + 0.84% of FSD. Calculate the following for the given...

A: Given: Range of voltmeter, V=952 V Accuracy, ±0.84% M1=857 VM2=912 V To find: (i) Range of acceptabl...

Q: VI R2 R. 100 2 120L 12 v R3 R4 220L 150л 100 mA Find IRa: a) By Superposition method b) By Thevenin ...

A:

Q: 1.7 The charge flowing in a wire is plotted in Fig. 1.24. Sketch the corresponding current. 9 (C) A ...

A:

Q: 3. A series circuit composed of a 0.2 henry inductor and a 74 micro farad capacitor is connected to ...

A:

Q: Example synchronous reactance of 0 + j20 2 per phase. A 500 kVA, 3-phase, 6.6 kV, star-connected sy ...

A: Given P=500 kVA V= 6.6 kV xs =20 ohm  

Q: 10) In an N-channel JFET, pinch-off occurs when the gate bias is zero. 11) When a transistor is cond...

A: As per guidelines we are supposed to answer only first 3 questions when multiple questions are given...

Q: what industry does cleaning equipment for electronic devices belong?

A: Scrubbers are used to remove stains from areas with hard floors. They're perfect for large commercia...

Q: A 10,000-kVA, 6,600-V, 16-pole, 50-Hz, 3-phase alternator has a synchronous reactance  of 15%. Calcu...

A: The synchronous impedance (ZS) is an imaginary impedance used to account for voltage effects in the ...

Q: Q1/A-What is the total cost of using the following at 4c per kilowatthour? a) 600 W air conditioner ...

A: we have given  a) 600 W air conditioner for 8 h  b) 2800 W clothes dryer for 45 min c) 850 W coffee ...

Q: Describe Schmitt Trigger as one of an OTA applications

A:

Q: 6. Find I, in the circuit. 150/20 V 32

A:

Q: 2. Find the voltage across 10A resistor and currant through 12 a resistor in the tollowing circuit. ...

A: In this question we will find current through 12 ohm and voltage across 10 ohm..

Q: The resistor R in the figure below receives 20 w of power, Determine the possible values of R. (Assu...

A: Voltage and current distribution- Voltage remains same in parallel while current remains same in ser...

Q: 1. For an electronic device operating at a temperature of 17​°​C with a bandwidth of 10 kHz, determi...

A:

Q: find the area of shell selbm & = O-> a.910 T mz b.300 Ti mt C. 2001H m²

A:

Q: Vp 10 kn 0.1 M2 k - 2.5 mA/V? Vt=0.5 V 10 MN Fig. Q3a i. Draw the small ac signal equivalent circuit...

A:

Q: all incorporators are subscribers but a subscriber need not be an incorporator

A: Incorporators- Incorporator is one who organize a new organization which may be business, organizati...

Q: 2. From the figure below, Fig. 1, if the voltage drop across the 7 0 is 24 V, find the supply voltag...

A: Here, we have given an electrical circuit, for which we have to calculate the power consumed by each...

Q: 1. A wye connected load has a 5 < 20° ohm impedance per phase and is connected across a 120 V three ...

A: In this question star connected load is given with phase impedance and line voltage....We have to fi...

Q: Consider the circuit shown below. The source voltage V1 is 45 V. Resistance R1, R2 and R3 are 4 N,11...

A: We will find out output voltage by using of krichoff's current law

Q: b) - the currents I, and I2 using node analysis 2A ( 9 9) 1A

A: We are authorized to answer one question at a time since you have not mentioned which question you a...

Q: A load of 120 MW at a power factor of 0.8 lagging can be delivered by a 3-phase transmission line. T...

A: Solution:-  Given, PL-3ϕ =120 MW PL-1ϕ = 40 MW Pf = 0.8 lagging VR-1ϕ = 45 × 1033= 25.9807 KV Single...

Q: in the event of a blackout at diablo dam a bank of batteries could be used to get system back online...

A:

Q: Silhcan 1kOhm Vout Vaut = %3D Silican 12V 1k Ohm VA = VB = Vc = Vo = D1 Silicon D2 Silicon 1 k Ohm 1...

A:

Q: Use Millman's theorem to find the common voltage across terminals A and B and the load current in th...

A:

Q: The photo has the input of a D-latch. Determine the value of Q at 1, 2, 3, and 4. Please explain why...

A: Determine the value of Q at 1, 2, 3, and 4.

Q: A three-phase, three-wire CBA system, with an effective line voltage 106.1 V, has a balanced Y-conne...

A:

Q: Determine the frequency at which a 2µF capacitor and an 80 mH inductor will have the same reactance.

A:

Q: 50 Hz, 2 pole, 3Φ star-connected turbo alternator has 54 slots with 4 conductors per slot. The pitch...

A: The solution can be achieved as follows.

Q: 1. The electric field intensity vector of a uniform plane electromagnetic wave is given a E(x,t) =10...

A: Note :  We are authorized to answer three subparts at a time, since you have not mentioned which par...

Q: PARTS A- C Read and Solve carefully please Write clearly and Box the Final answer(s) & label them Pa...

A: I am attaching a detailed solution images of this question.