For the circuit of controlled half-wave rectifier with RL Load For the circuit of controlled half-wave rectifier with RL Load, the source is 120Vrms at 60Hz, R=200, L=0.04H, and the delay angle is 45°. Determine (a) an expression for i(t), (b) therms current, (c) the power absorbed by the load.

Answered: Image /qna-images/answer/026388ff-edd0-4b9c-96cf-439df2319343.jpg

For the circuit of controlled half-wave rectifier with RL Load, the source is 120Vrms at 60 Hz, R=202, L=0.04H, and the delay angle is 45°. Determine (a) an expression for i(t), (b) the rms current, (c) the power absorbed by the load.

For the circuit of controlled half-wave rectifier with RL Load, the source is 120Vrms at 60 Hz, R=202, L=0.04H, and the delay angle is 45°. Determine (a) an expression for i(t), (b) the rms current, (c) the power absorbed by the load.

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter15: Alternating-current Circuits

Section: Chapter Questions

Problem 4CQ: For what value of the phase angle between the voltage output of an ac source and the current is the...

See similar textbooks

Related questions

Q: An electric motor, under load, has an effective resistance of 30 ohms and an inductive reactance of…

Q: Consider a power plant located 25 km outside a towndelivering 50 MW of power to the town. The…

A: Let the length of the transmission line be l, the area of cross-section of the transmission line be…

Q: a) Design a broadband parallel bandreject filter with a lower cutoff frequency of 1000 rad/s, a…

A: To determine: The circuit for the broadband parallel to the bandreject filter

Q: A balanced delta load having a 28 Q resistance in series with an 24 2 capacitive reactance in each…

A: (given) Resistance (R)= 28 Ω Capacitive reactance XC=24Ω…

Q: The instantaneous value of an 800-Hz sine wave current is 5A when t =0.5ms. What is the peak…

Q: Prove that from the relationship of the bias circuit to the voltage

A: We know that the voltage divider is a very common type of circuit in which the resistance is in the…

Q: Following the analysis applied to the half-wave rectifier with capacitor filter, show how to arrive…

A: we have to analyse half-wave ; Here we use rectifier with capacitor filter; we will show output…

Q: For the circuit used in the Additional Problem of the previous homework assignment, replace the…

A: Consider the notation points in the circuit diagram as follows. Case 1: When ω is very high i.e.…

Q: A delta modulator system is designed to operate at five times the Nyquist rate I with 3 kHz…

A: Write the given values of the problem- Band width(w)w=3 kHzSampling rate=5 NyquistStep size(∆)=250…

Q: If the Carrier frequency is 33Khz of the system build in the lab, and the receiver requires 10…

Q: A square wave e is a cyclic pattern that has a constant absolute value, but alternates between…

Q: For the RLC circult below, calculate: a) The theoretical resonant frequency (fo), of the circuit. b)…

A: *We'll answer only the first question since the question to be answered was not specified. Please…

Q: For the positional servomechanism obtain the closed-loop T.F. for the positional servomechanism…

A: Given:- Given A figure Assume that the in-put and out put of the system areinput shaft position…

Q: What is meant by rectifier? Explain the half wave rectification and also calculate its rms value of…

Q: The cutoff frequency, fo, for a low pass filter is given by the following equation: 1 2TRC The…

A: We have fc=12πRC=12π×1.5×103×0.02×10-6=5305.16 Hz

Q: Q1) For the half-wave rectifier, the source is a sinusoid of 120 V rms at a frequency of 60 Hz. The…

A: Given: V = 120 V f = 60 Hz R = 5 ohm

Q: A common emitter amplifier has a voltage gain of 50, an input impedance of 100 2 and an output…

Q: An oscillating LC circuit, with L = 1.5 mH and C = 0.01 µF, stores a maximum energy of 10 uJ. al…

Q: (II) (a) What is the reactance of a well-insulated 0.03μFcapacitor connected to a 2.0-kV (rms)…

A: The capacitive reactance is given by XC=12πfC

Q: Consider a length of Teflon-filled, copper K-band rectangular waveguide having dimensions a = 1.07…

A: In this question we have to find the attenuation due to dielectric and conductor losses. Please give…

Q: A 70-Vac source has the following waveform. Determine: a. Vpk b. Vpk-pk C. Vrms d. Period e.…

A: Given: RMS voltage = 70 V

Q: What is the RMS noise voltage associated with a 10 Q resistor at room temperature when the system…

A: Mean square noise voltage is given by- vn2¯=4kBTRhere,kB is Boltzmann'constant=4.138×10-23 J/KT =…

Q: Design a RC band stop filter such that it cutoffs frequency ranging from 10 to 10° Hz, Draw…

Q: The change in output voltage, SE, , from a 1/4 arm Wheatstone bridge circuit is 299 micro-volts.…

Q: CONNECTING A TRANSMITTER WITH AN IMPEDANCE ANTENNA (ZR=300 OHMS) BY A TRANSMISSION LİNE WITH ITS…

A: Given: Impedance of antenna τb= 300Ω…

Q: Q1) If V1 (RMS) = 110 V (60 HZ) and transformer conversion ratio is 10: 1 according to the half-wave…

A: Hi please find solution to your problem

Q: An LC circuit with a 5.00-pF capacitor oscillates in such a manner as to radiate at a wavelength of…

A: capacitance, C = 5 pF wavelength = 3.3 m

Q: .Detarmine the time constant of the circuit. b) Sketch the wave for ms For vc and ic. 30uf t. 10/-

A: We need to calculate time constant of the circuit and plot graphs of Vc and Ic.

Q: In the Maxwell bridge shown in Figure2, let the fixed-value bridge components have the following…

Q: An oscillating emf drives a series com- bination of a resistor and an air-gap ca- pacitor with…

Q: What inductance must be connected to a 20 pF capacitor in an oscillator capable of generating 590 nm…

Q: If the peak value of a 1.5-kHz audio oscillator is 25V, what is the instantaneous voltage when ϴ =…

A: ϴ = 215 degree Vmax=25 V

Q: Find the mean current and the RMS current from t-0.0s to t=4.0s if i= (1.0t+1.0Vt)A Round to the…

A: Given: I=(1.0t+1.0t) At=0.0 to t=4.0 s

Q: Calculate the magnitude of the reactance of a 3.5 mH inductor at (a) 60 Hz, (b) 600 Hz, and (c) 6000…

A: a) Given data The inductance of an inductor is given as L = 3.5 mH The frequency is given as f =…

Q: i) Bandwidth of the resonant L-C-R circuit is

Q: A lossless 75-N coaxial cable has a velocity factor of 0.67. For a shorted line at a frequency of…

A: a) Given data The resistance of the cable is R = 75 Ω. The velocity factor is given as vf = 0.67.…

Q: The input power to a 3-phase load is measured as 12KW. If the line voltage and power factor of the…

Q: a carrier signal vc(t) = 10 cos(2 pi 3000t) Volts is modulated by a sine wave vm(t) =7 cos(2 pi…

A: Modulation index = Em /Ec

Question

For the circuit of controlled half-wave rectifier with RL Load

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The voltage across a parallel-plate capacitor with area A=800cm2 and separation d = 2 mm varies sinusoidally as V = (15 mV) cos (150t), where t is in seconds. Find the displacement current between the plates.
For a sinusoidal voltage trace displayed by the CRO, the time/cm switch is on 500us/cm and the volt/cm switch is on 5V/cm. The width of one complete cycle is 4cm and peak to peak height is 5cm. Find for the waveform a) the frequency, b) the peak to peak voltage, c) the amplitude, and d) the r.m.s value
Using the physics terms and expressions show that the efficiency of half wave rectifier is given by n = 0.406/(1+rf/Rl)
What would be the depth of penetration for copper at 2 MHz frequency with σ = 5.8 x 10?
Consider a power plant located 25 km outside a towndelivering 50 MW of power to the town. The transmissionlines are made of aluminum cables with a 7 cm2crosssectional area. Find the loss of power in the transmissionlines if it is transmitted at (a) 200 kV (rms) and (b) 120 V(rms).
Consider a conducting sphere with a radius as of 1 m. What is the RCS of this sphere at an RFof 10 GHz? Give the answer in units of both square meters and dBsm. (Assume the sphere is“much larger than” the wavelength.) What must be the side length at of a trihedral so that ithas the same RCS at 10 GHz? What is the ratio of the size of the sphere compared with that ofthe trihedral, as/at ?
At s1iat frequency is the reactance of a 20F capacitor equal to that of a 10-mH inductor?
A large superconducting magnet, used for magnetic resonance imaging, has a 50.0 H inductance. If you want current through it to be adjustable with a 1.00 s characteristic time constant, what is the minimum resistance of system?
The linear attenuation coefficient for 2.0- Mev
What is meant by rectifier? Explain the half wave rectification and also calculate its rms value of current and voltage?
If the propagation losses (PEL) for a link that operates at a frequency of 4 GHz are 120dB, when using a frequency of 8 GHz the value of the new propagation losses will be: Select one: A. 126dB b. 140dB c. 130dB
For what value of the phase angle between the voltage output of an ac source and the current is the average power output of the source a maximum?