for the circuit of fig. (1) find the value ofхсхandXeyin terms of XL to satisfythe following conditions:1-Total impedance for the firstharmonic =3Total imperance for theLSixth harmonic = ∞суCXли

Answered: Image /qna-images/answer/e410f1ad-593c-4d9c-9d42-df3093b85724.jpg

for the circuit of fiz. (1) find the value of Хсх and Xey in terms of XL to satisfy the following conditions: 1-1 -Total impedance for the first harmoni (= 3 Total imperance for the sixth harmonic сх

for the circuit of fiz. (1) find the value of Хсх and Xey in terms of XL to satisfy the following conditions: 1-1 -Total impedance for the first harmoni (= 3 Total imperance for the sixth harmonic сх

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 2PP: Assume that the voltage drop across the resistor, ER, is 78 V; the voltage drop across the...

See similar textbooks

Related questions

Q: Draw the mechanical characteristics forshunt and series motor. 4

A: We will refer the concept of speed-torque characteristics.

Q: The direction of the field pattern in going and outgoing produced by a current flowing through a…

A: Single conductor Transmission line is a method of transmitting electrical power or signals using…

Q: in the shunt connected DC motor, the equation that calculate field current If is Vf/(Ra+Rf) Va/Ra…

Q: Q4) i) Find Z transform of X[n] = a^u[n]

A: Z transform of fiven signal is calculated as

Q: Q2-100 KVA, (6600/330) ,single-phase transformer, the primary connected to supply voltage 100 V and…

Q: Three distribution of charges are present in free space with: A uniform line charge of PL = 3 HC/m…

A: Electric flux density: It is the strength of the electric field E. this strength is created by the…

Q: Let voltage across a load be v(t) = 20 + 40 cos(100t) volt and current through the load by i(t) =…

A: Given voltage and current equations and asked to find the RMS value of voltage and average power…

Q: R + CC PC + W₁ +CC IR N 21 ly Z₂ 23 PC + W₂ 1B B. Supply voltage = 400V (line-to-line), phase…

A: Types of power measurement Three wattmeter method Two wattmeter method One wattmeter method

Q: find the Nyquistrate and Nyquist interval fom flowing signalsh A= m(t) = 2/ cos (900071), cos…

A: In this question we need to find a Nyquist rate and Nyquist interval of the given signal

Q: fa A 3-phase ring main ABCD fed at A at 11 kV supplies balanced loads of 50 A at 0.8 p.f. lagging at…

A: It is given that: Section AB=1+j0.6 ΩSection BC=1.2+j0.9 ΩSection CD=0.8+j0.5 ΩSection DA=3+j2 Ω

Q: - A shunt generator gave the following results in the O.C.C test at rated speed 2 3. 4 6 8 10 Field…

Q: The voltage across current source "Ic" 10 Q2 6 Ω 12 Ω Is = 10 A A 150 V B 120 V C 140 V D 420 V

A: Given circuit,

Q: Problem 2 Find V (t) for all time t. 4 V HE ΖΩ 115 HH F t = 0 t=0 7 2 H + VR www 202

A: In this question, We need to determine the voltage across the resistance R? We know, Voltage…

Q: Q5) Find the Fourier transform of: x(t)= (Cos(nt/t) for \t\<} Flo .elsewhere) Sketch X(f) versus…

A: Given that, Let, xt↔TransformFourierxF Fourier transform of xt=cosπt/τ .for t<τ20…

Q: Find the value of X for all possible values of the variables: . X = (A + B). (B+C)* . X = (A + B) +…

A: given here some boolean functions and asked to find the output.

Q: One of the following is not a law for power factor calculation. O P/S O cose O Q/P O P/VI

Q: a. Find the total impedance ZT. b. Calculate the voltage V₂ and the current IL. . Find the power…

Q: 4. Determine the unmodulated carrier power for the FM modulator given that ß =1, Vc=10 V, R = 50 Q.…

Q: A 100 V carrier peak changes from 160 V to 40 V by a modulating signal. The modulation factor is (a)…

A: Given, A 100 V carrier peak changes from 160 V to 40 V by a modulating signal.

Q: : For the Bode plots shown in Figure (1), find the values of Gm, Pm, Wp, Wg 60 01 4- 2 Fresquenes…

A: Notes Phase margin calculated at gain cross over frequency Gain margin calculated at phase cross…

Q: A/ Find the output of the system shown below: Signal Response g(t) System When the f(t) = Asinī…

A: In this question, We need to determine the output of the given system? We are solving this problem…

Q: 1. Sketch the output waveform for the following: a.) + 1kQ2 +8 V Si V₂ 4 V -8 V 16

Q: For the given closed loop system, in the Figure below, find the values of K for which the system is…

A: In this question we need to find the stability , instability range and marginal stable condition for…

Q: Find the Thevenin's and Norton's equivalent circuit -j5 Ω . 12 Ω 60/45° V j6 Ω 13 Ω 10 Ω bc 8 Ω

Q: Q5) let x(t) be a 2π periodic function such that x(t) = t² forte [-1.]. a) Find the Fourier series…

A: Given: xt=t2 t∈-π,π

Q: Find y[n] if x[n]= [ u(n+2)-u(n-2)] and h[n]= 2+ n for n=-1, 0, 1, 2 please solve step by step…

A: In the above given question we need to calculate convolution of the given sequences.

Q: 1. A wye-connected load with ZA= 12 /45, ZB= 15 / 30 and Zc= 10 /0 is connected to a four-wire, 208…

Q: )magnetic flux density (B).(2)magnetic field intensity (H),(3)current density (J).

A: Magnetic field - This line which shows the interaction between the movement of electric charges and…

Q: In the below given figure, two capacitances are in series with a 18V source. The capacitance of the…

A: The detailed solution is provided below. The formulae used is given below.

Q: Given the magnetic field vector potential: A= 2r cose ar — 3r sine a0 (A/m), find at point P…

A: Types of coordinates system Cartesian coordinate system Cylindrical coordinates system Spherical…

Q: Draw block diagram 8255 I/O mode configuration according to follow- ing: • Port A mode 1, i/p mode…

A: 8255 is a programmable peripheral device that have multiple ports. PORT A PORT B and PORT C

Q: Balanced 3 Phase Supply 3 +PC- A +CC- C Line-to-line supply voltage is 380 V with the phase sequence…

A: In this question, We need to determine the total power P, load power factor and type of the power…

Q: What is the potential difference (voltage) across capacitor C3 in the circuit below?

A: In parallel circuit the voltage across the components are same.

Q: Core depth=10 cm (uniform) I 1 = 1 mm N 82= 2 mm 8 cm-> 6 cm Consider the magnetic circuit shown…

A: Reluctance of Flux path is Directly proportional to length Inversely proportional to area of Flux…

Q: 2. For the following causal system y(n) = x(n-1) − x(n-2) + 1.6y(n-1) - 0.64y(n-2) Determine the…

A: For the given causal system, the transient and steady state response for the input x(n) = 2u(n) are…

Q: Design an asynchronous counter that divides the input clock signal by 5 then draw counter's logic…

Q: 23) Suppose that x(t) is real-valued signal, then show that: if x (t-T12) = -x(t) (half-wave…

Q: A given AM broadcast station transmits an average carrier power output of 40 KW and uses a…

A: Given a AM broadcast station transmits, Average power carrier, Pc=40 kW Uses modulation index,…

Q: Three distribution of charges are present in free space with: A uniform line charge of PL = 3 HC/m…

A: Electric displacement, denoted by D, is the charge per unit area that would be displaced across a…

Q: 10 Given the potential V = sin cos 6, (a) Find the electric flux density D at (2, 7/2, 0). (b)…

A: In this question we will find electric flux density and work done for moving a charge with the help…

Q: Prove dx(t)/dt________Laplace_ _sX(s)

A: Laplace transform is used to analyze the continous time domain signal into s domain or frequency…

Q: The modulation index of AN signal is reduced from 0.8 to 0.5. The ratio of the total power in the…

A: Given, The modulation index of AN signal is reduced from 0.8 to 0.5 μ1=0.8μ2=0.5

Q: GCS) 1000 (5+5) S (S+36) (S +70) Analytical met

Q: 16. A) In DC motor, the force on the current-carrying conductor in a magnetic field depends upon…

A: In this question we will find force on current carrying conductor in magnetic field and speed of DC…

Q: Q2:- An electrodynamometer type wattmeter has a current coil with resistance 0.202 and a pressure…

A: Given, Current coil resistance, Rc = 0.2 ohm Pressure coil resistance, Rp = 7 kohm Load current,…

Q: Q4) Draw the output waveform for the circuit in figure below. 2- Vin C1 R1 www 1kQ 0.1μF 0 2 4 -2- 1…

A: An ideal inverting op-amp has this property, that the current flowing in both the feedback and input…

Q: ANSWER THE FOLLOWING Given the block diagram, determine the following: 1) Transfer function using…

A: The block diagram is shown below,

Q: In an Amplitude Modulated (AM) wave with 100% modulation (ma), the carrier is suppressed. The…

A: Given, In an AM wave with modulation, ma=100%=1

Q: In the single-phase, three- winding, transformer, the primary current is equal to lo at the…

Q: Use the concept of source 4Ω ΜΑ 20/0° V to find Vo 14 Ω m -201₂ Ω transformation -j3 Ω ΠΩΕ ΖΩ

Concept explainers

Compensation Techniques

The compensation techniques are the methods that are employed in the electrical control systems to enhance the performance of the system. The performance are generally affected by the factors like lag in the compensating devices, slow response of the system of the components like sensors used in the control system. The basic compensation technique involves lag compensation, lead compensation or the combination of the both.

Question

for the circuit of fig. (1) find the value of
хсх
and
Xey
in terms of XL to satisfy
the following conditions:
1-Total impedance for the firstharmonic =
3
Total imperance for the
L
Sixth harmonic = ∞
су
CX
ли

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Compensation Techniques in Transmission Line

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Derive and calculate the input impedance, Zi of the circuit. Given that IDQ=3.2mA and k=1mA/V².
2. The output impedance of 600 ohms radio transmitter with signal strength reading on a meter of impedance 75ohms by 0.81 neper of unbalance non-symmetrical Pi-pad attenuator circuit. Determine the required resistor values to design this attenuator.
a) A short transmission line has a sending end voltage of VS and a receiving end voltage of VR. If the receiving end current is IR and the reactance of the line is X, derive an equation for the sending end apparent power. b) based on your answer to a) deduce equations for the active power and reactive power
Using impedances approximation, obtain the TF Eo/Ei
q13,q14
An impedance of R=100 ohms and L=20 mH is connected across another impedance of R=150 ohms and C=250 microfarad. Determine at which frequency, this circuit will resonate across a variable AC frequency source of 240 V. Determine also the Q factor of the coil used.
2.1 An ESKOM engineer made the following recommendation for 220 V, 50Hz line. 150µF capacitor and a 75 mH inductor for the TCR to correct the power factor to be at unity. What is the delay angle when the load current has a reactive component of -j9 A?
For the figure below, determine ?0 using Nodal Analysis
In the given circuit below, determine the Impedance (Z), the Current (I) supplied by the source, the True Power (PT), Reactive Power( QT), and Apparent Power (S).
Write in rectangular and polar notations, the impedance of each of the following circuits at a frequency of 50Hz. That have a, 2.1 A resistor of 2002 in series with an inductor of 0.1H.
Q34) By using Gram-Schmidt procedures, any set of M signals can be expressed as a. Summation of N orthonormal basis functions, where N ≤ M b. Product of inverse squares of N orthonormal basis functions, where N ≤ M. c. Product of logarithmic combinations of N orthonormal basis functions, where N ≤ M. d. Linear combinations of N orthonormal basis functions, where N ≤ M. This multiple choice question from DIGITAL COMMUNICATIONS course.just write for me the final answer.
Write the nonlinear function to find the ω(lowercase omega) that results in an equivalent impedance of 40 Ωfor the following AC circuit with the given parameters: