Answered: For the circuit shown below, determine…

For the circuit shown below, determine the power consumed by battery 1's internal resistance. Battery 2 V2 r2 www 00 0.5 Ohm 5 V 1.1597 W Battery 1 r1 1 Ohm www |0|0 12 V ww R3 5 Ohr

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter2: Basic Electricity

Section: Chapter Questions

Problem 34RQ: What is the Btu/hour output of an electric heater rated at 15 kilowatts? a. 51.15 Btu/hour b. 51,150...

See similar textbooks

Related questions

Q: II. In a 220 Vrms, 60 Hz. Source, determine the following values: a) Trigonometric equation b) V…

A: Given: Vrms=220 Vf=60 Hz

Q: 120 V For the circuit shown above, I(0) is equal to: 20 52 6002 t=0K 30 (2 1 µF Vc 2 mH

A: In transient analysis the inductor get short circuited at steady state and capacitor get open…

Q: The output of a 200 V, single-phase synchronous motor, taking a current of 20 A is 4 hp. effective…

Q: a. 3. We can find the frequency where the GAIN is 0 dB and the phase (phi) at that frequency. Then,…

A: We are authorized to answer only 1 question a time since you have not mentioned which question you…

Q: Compute for the current i2 in the circuit shown below. a- -555.4737 mA -555.2096 mA ○-554.6218 mA…

A: This question belongs to circuit theory . It is based on the concept of calculation of current in…

Q: An 11-kV, three-phase wye-connected generator has a synchronous impedance of 6 ohms per phase and…

Q: Q1. If vs= 50 cos(4t). Find i and vi 8 Ω ΤΩ 3Η F

Q: Calculate the resonant frequency of the circuit in Fig. 14.29. 50 mH Vm cos at (+ Figure 14.29 0.5…

A: Given L=50mH, R=20ohms,C= 0.5 mili farads, resonant frequency Wr=? To calculate resonant frequency…

Q: "If Vc is equal to 124/173 and Vab, is 214.774283, Vbc should be

Q: Determine the equivalent resistance between terminals a and b. a M 30 ohms 20 ohms 15 ohms 25 ohms…

Q: A 2002 load receives power from parallel-connected battery cells, as shown in the figure below.…

Q: Q2: A given AM (DSB - LC) transmitter develops an unmodulated power output of 1 kW. Across 500…

A: Given Pc=1 kw, RL=50ohms Am=5v, H=0.4

Q: Describe the resulting waveforms when the capacitors (initially 20uF and then replaced with 100uF

A: Given, For 20uF capacitor, the output waveform is shown below,

Q: V10. What are the key advantages of RF-ICP high-density plasma sources for application in…

A: RF-ICP stands for radio frequency inductive coupled plasma. It is used to measure elements at trace…

Q: Explain the functions of the following registers associated with the MSP430 ports: (i) Direction…

A: As per Bartleby policy we can answer only three subparts. So I am answering first three for you.…

Q: 2. Find the Norton circuit to the left of terminal A and B for the network shown below. Connect the…

Q: (1) show that the wr= resonance frequency is: 2 Lc-(^_^)² = 500 rads & 4H L IM R =1MF

A: Given here a electrical circuit and asked to find resonance frequency with proof.

Q: Describe the relationship between the current and the voltage

A: Ohm's law gives the relationship between the voltage and current. Ohm's law :- Potential difference…

Q: 7. A diode conducts 1mA at 20°C. If it is operated at 100°C, what will be the current? Given data:…

A: A diode conducts 1 mA at 20 °C. If it is operated at 100 °C. We need to find the current. Given…

Q: Problem 1. In a series circuit, a current flows from the positive terminal of a 180-V source through…

A: To solve above problem, we must know Ohm’s law and Kirchhoff’s law: Ohm's law state that in a…

Q: mework 1: Find the Laplace transforms of these functions: r(t) = tu(t), that is, the ramp function;…

Q: Q\ Compare between Variable reluctance (VR) type and permanent magnet (PM) type and Hybrid type

A: permanent magnet motor is used to magnet imbedded into a surface of the motor rotor. it is used in a…

Q: 11 Find the Laplace transform of f(t) = 10 coswtu(t). Answer: 10s/(s² + ²). هربائية

Q: Explain with the diagram the soft starting of induction motor to start from non zero speed to rated…

A: Induction Motor: A typical AC electric motor is an induction motor (sometimes known as an…

Q: B = 85. Check if approximation can be used. Show calculation proof. +Vcc=20V RB wwwww 1kn2 IB V BE…

A: Brief description: For the given BJT we need to calculate values of all the DC currents such as IB,…

Q: Compute for the voltage Vac in the circuit shown below. O 16.9464 V O 15.9436 V O 16.2963 V O…

Q: 3.- Suppose that each diode in the circuit shown in figure N°2 has a turn-on voltage of Vy=0.7…

Q: A 3-phase, 415 V, 50 Hz induction motor draws 5 times the rated current at rated voltage at…

A: It is given that: VL=415 VIsc=5IflIst=2Ifl ...... (1)

Q: An ideal shunt-shunt feedback amplifier has Rs =∞. If li= 100 microAmp, I fb = 99 microAmp and Vo =…

Q: P.1. R ww L C B 240 V At t = 0, the switch is closed. The initial energy stored in the inductor and…

A: A circuit diagram is given where the switch is closed at t=0 sec. We need to voltage across the…

Q: Initially, two resistors R1 and R2 are connected in series. The connection of the terminals of R1…

Q: A 2002 load receives power from parallel-connected battery cells, as shown in the figure below.…

Q: From the circuit below, Z₁1 is equal to: Ima 1092

Q: 3. For the circuit shown, find the Thevenin and Norton equivalent circuit to the left of terminal A…

Q: help me calculate the Rn, In or Isc, and current at Zc using NORTON’S THEOREM

A: The given circuit is as shown below,

Q: How can I be safe with electricity?

A: Always use gloves while working with electrical equipment and gloves must be insulated. While…

Q: Given the circuit below with the following data: Rs = 330 92, RB = 470 kQ, RE = 2.2 kQ, RC = 4.7 kQ,…

A: Bartleby has policy to solve only first 3 subparts of a question.so reupload the question.

Q: Problem 4: Design a sequential circuit with the finite state machine shown in Table 2, using D…

Q: The received power and noise power measured at a receiver is 0.5 mW and 150 nW, respectively.…

Q: In a balanced three-phase Y-Y system, the source is an abc sequence of voltages and Van = 139∠12°…

Q: Describe the relationship between the current and resistance

Q: 19.In a 3-phase star-connected alternator, a field current of 40 A produces a full load current of…

A: In this question we need to find the value of the synchronous reactance

Q: A long solid conductor with diameter 2 cm carries a current of 32 A uniformly over its cross…

Q: If Vab = 210 Vrms in a balanced Y-connected three-phase generator, find the magnitude of the phase-b…

A: (Q10)Solution:- Given:- (1) Vab =210 Vrms (2)Y -connected three-phase generator

Q: QUESTION 1 jΒΩ m V - Χ 2/0° A RΩ -jΑΩ For the circuit shown above, what is the magnitude of the…

A: In this question we need to find a magnitude of phasor voltage Vx

Q: a o 10 ohms bo 30 ohms 20 ohms 15 ohms 25 ohms 40 ohms

Q: Q2: Find the transmission parameters for the circuit shown below 81₁ 492 892 ww 16

Q: .A factory takes a load of 2400 kVA at 0.6 pf lagging. A synchronous motor having an input rating of…

Q: An air-filled coaxial line with e=₁ and µ-u, has a line inductance L'=(1/54)µH/m. What is the line…

A: We need to find out the capacitance of co axial cable

Q: What is the relationship of voltage,current and resistance? Explain

A: Introduction - Voltage - Voltage is defined as the charge differential between two spots. Current -…

Concept explainers

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.

Question

For the circuit shown below, determine the power consumed by battery 1's internal resistance.
Battery 2
V2
r2
나 ㅓ미다
5V
○ 1.1597 W
Battery 1
r1
1 Ohm
V1
ww
의미다
12 V
0.5 Ohm
싸
쇼
R3
5 Ohms

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 60 MW steam power station has a thermal efficiency of 30%. If the coal burnt has a calorific value of6950 kcal/kg, calculate :(i)the coal consumption per kWh,(ii)the coal consumption per day.
12. In a 100 MW steam power station working at 60% load factor the energy cost is found to be 1.5 baize Per unit. Calculate (i) the cost of energy/kWh if the power station loaf factor is improved to 70%.Due to increase energy generation the fuel cost increases the annual generation cost by 6%.
EXPRESS IN 4 DECIMAL PLACES IF NEED BE! A combination of three resistors R1, R2, and R3 in series is connected across a voltage source VT. The voltage drop across R1 and R3 are 10 V and 36 V, respectively. If the current supplied by the source voltage is 1.4 A and the total power supplied by the source is 70 W, calculate the power dissipated (in watts) by R1.
1. a) Compare traditional power systems with new generation power systems. please write it with computer .
Question 1: A wind turbine that is 80 meters tall with a blade length of 160 ft will be used to generate electricity in an off-grid farm. The average annual wind speed in the area is 50 ft/s. 1. Calculate the power in Megawatts that can be generated by the turbine with an efficiency of 95%.
months. Example 2.3. A hydroelectric power station is supplied from a reservoir of capacity 3 x 10' m' at a head of 150 m. Determine the total energy available in kWh if the overall efficiency of the plant is 70%. oper havi rain tion hem era
If X 30, Y = 14, and Z = 2.25 Calculate what the gain of the system is. "Give your answer to 2 decimal places Your Answer:
A) Assume that electricity is supplied at a price of 100Bz per unit. Calculate the electricity bill in a month of 30 days for a house having the following electrical appliances with their average daily use: 1. One vacuum cleaner of 350W working for 30 minutes a day. 2. One refrigerator of 300W working for 24 hours a day. 3. 5 tube lights each of 30W and work for 4 hours a day.
A no. 000 AWG wire is 100 meters long. For no. 000 wire, it has a wire resistance of 0.0618 ohms per 1000 ft. Determine: (a) the power loss if the current flowing through the wire is 18 amperes; and (b) how much must you pay for the loss due to the voltage drop if during the whole month, you used the wire for 300 cumulative hours? Assume a rate of 5 pesos per kWh.
1. Establish the following relations :(i) 1kWh=36×105 Joules (ii) 1kWh=860kcal(iii) 1 B.Th.U. = 1053 Joules (iv) 1 C.H.U. = 1896 Joules 2. Compare the chief sources of energy used for the generation of electrical energy.3. What do you mean by efficiency of a system ?
Two finite machines are connected together in a power station. Following are the details of the machine. Rating of machine-1, 250 MVA, Angular Momentum 2.5 PU generates electrical power 1.74 PU. Rating of machine-2, 400 MVA, Angular Momentum 9 PU. If the equivalent electrical power of two machines is 1.74, then the value of electrical power of machine-2 is _______________ PU.
A thermal station has the following data: Max. Demand = 40,000 kW, Load factor = 60%. Thermal efficiency = 75%, the cost of 1 ton of coal is 100 OMR. The quantity of coal consumed per year is 126144 kg. Calculate the consumed coal to produce 1kWh of Electrical energy.