Answered: For the coil of Figure 14-45, R = 1.7 Q…

For the coil of Figure 14-45, R = 1.7 Q and L= 150 mH. Determine coil current at t = 18.4 ms 5.6 0 3.9 0 4.7 2 十67 V Coil

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter7: Alternating Current, Power Distribution, And Voltage Systems

Section: Chapter Questions

Problem 7RQ

See similar textbooks

Related questions

Q: Quèstion 2 In ferromagnetic material p= 60. B-16y az, magnetic strength equals to 4y az /(3Ho) 2y az…

A: Here we will relationship between magnetic field strength and magnetic field density

Q: A single phase transformer has 500 primary turns connected to a 1000 V. The output voltage is 250 V.…

A: consider the given question;

Q: Si E. AC Si Click to see additionalinstouctions An AC source of 110 M 60 H2) is connected between…

A: Ac source voltage is given as ; It is known that maximum voltage is given by,

Q: Desian aproblem for wyr doltatransformations Detdrminc the eauivalent resistance betren the…

Q: Two parallel wires made of copper are placed in air. The inductance of each wire is 0.9 µH/m with…

A: Two parallel wires made of copper are placed in air. Total inductance L= 0.9uH/m What is the…

Q: 7. (30cis87.6)/24cis48

A: The question is about polar form.

Q: Quèstion 2 Magnetic field intensity at point (3, 4, 0) due to the filament current I- 3A shown in…

Q: Plane y = 10 m carries charge 15nC/m2. The electric field intensity at the origin is; О 540 п ат O…

Q: 14.6 Determine the inductive reactance (X_ in ohms) of a 2 mH coil for • DC (i.e. f = 0 Hz) 60 Hz •…

A: Given data, The value of inductance is L = 2 mH. The expression for inductive reactance is given…

Q: 14s (V Question: In load commutation when the load current is kept constant, capacitor voltage gets…

A: The solution is given below. The answer is option 2

Q: 10.A coil takes 15A from a 250V source. When a 20 Q resistor is connected across the coil, the…

A: The current flowing through any impedance is voltage divided by the impedance. The coil is made of…

Q: Is N1 (N2 = 140 turns) 42 0.66 A 84 1.285 A 112 1.645 A 140 1.917 A

A: The given table of the secondary short circuit current and the number of turns in the primary coil…

Q: 358 14.9 Determine the rms value of the current waveform shown in Figure 14-25. i(t) FIGURE 14-25:…

A: Use standard formula to calculate RMS value Writing function using plot is important

Q: Magnetic field intensity at point (3, 4, 0) due to the filament current I = 3A shown in figure will…

Q: See Figure 14.1. What is the coil current if el is 500 sin(50t +20°)? Figure 14.1 5 sin(50t+20°) 5…

A: Given, The circuit is, The supply voltage eL=500sin50t+20°.

Q: Magnetic field intensity at point (3, 4, 0) due to the filament current I= 2A shown in figure will…

Q: 3/A single phase transformer has 250 primary turns connected to a 500 V. The output voltage is 150…

A: Given, Single phase transformer has, Primary turns, N1 = 250 turns Primary Voltage, V1 = 500 V…

Q: QUESTION 16 E-06, PC-02. Three inductors 15 mH, 15 mH and 15 mH are connected in parallel. What is…

Q: 440/0° V +1 50 Ω j80 Ω www 1:2 transformer Topic: Magnetically Coupled Circuit 1:3 1₂ - دنا 40 Ω…

A: Transformation ratio of transformer is: K=V1V2 V1V2=I2I1=k

Q: A coil is made of 150 turns of copper wire wound on a cylindrical core. If the mean radius of the…

A: The resistance of a conductive material depends on three different parameters. The resistance is…

Q: A(n) _____ is a coil form that is shaped like a doughnut.

A: To determine:- The coil that is shaped like a doughnut.

Q: 1-14A 57 6. to 2 TT EL Q.Drive a from of the capacitance of infininte length coaxial cable and then…

Q: determine the slope of the curve : x^2 + y^2 - 6x - 4y - 21 = 0 at ( 0,7 )

Q: Imagine you have charges arranged to sit at the corners of 6 equilateral triangles. Three charges…

Q: 1- The primary and secondary of a transformer are coupl a) Electrically b) magnetically c)…

A: In this question we will write answers of questions related to transformers...

Q: 100 kVA, 6800-240 V, 50 Hz single phase step down transformer h RLs=0.0082 RHs=2.62 Rfe-HS=50002…

Q: Q) Ac bridges are consists of - O Arms and source. Arms, source and detector. O Arms and detector.…

A: As shown in the diagram, An AC bridge network consists of: 1) Four Arms in square shape 2) Detector…

Q: Χ () - (을-) – 2). W hat is = rect 2 х (t 1 -sin c (t) e4 IT 1 -sin c (t) e-j4t 1 – sin c (t) e¯j21 O…

Q: The primary and secondary coils of a transformer each have an inductance of 200 x 10-6 H. The mutual…

A: Given, Primary and secondary inductance of coil, LP=LS=200×10-6 H Mutual inductance between winding,…

Q: Magnetic field intensity at point (3, 4, 0) due to the filament current I= 2A shown in figure will…

Q: *? What is the value of the current passing through the circuit D1 DEAL DIOLE V1 12 V R1212 kOhm 1…

Q: ?14) = - 30 Sinyot – 40 C63 se -30 Sin voro – vo Cavero) + 2500 2 50 2500 - 30€ 7(4) = -e + 0 -032…

A: Explain given steps ?

Q: 2. Find the arc length of the curve y = 16 from x=2 to x 2x

Q: LS RKN In 32A Un 240/415V- 30mA 0.15 CE IEC61008 LS Industrial Systems Test monthly 1/3/5/N 246 N…

A: The given picture is of LS RKN, 32 A RCBO switch which is used as Residual current circuit breaker…

Q: Magnetic field intensity at point (3, 4, 0) due to the filament current I-2A shown in figure will be…

A: By using expression for magnetic field intensity for a finite length wire

Q: per form the indica ted opera tions 2) AFO14 X 10102= -9

Q: The answer of the following operation (la, x lay) x 2az

Q: The magnatie lines of torce insida a bar magnet O go trom N-poia to S-polo O are curved O cross each…

Q: Input to a step up chopper is 250 V. The output required is 450 V. If the conducting time of…

A: Given a step up chopper having, Input voltage, Vs=250 V Output voltage, Vo=450 V Conducting time of…

Q: What is Hopkinson’s la. Explain with the help of equation

A: Hopkinson’s law is said to be the Ohm’s law for magnetic circuits. As we know that in electrical…

Q: 150 X V 75V 32 Q f-60HZ %3D Figure 37 The magnitude of the current in the circuit shown in Figure 37…

A: find the explanation below

Q: a) H= 50 pd ap delermine the Given the magnelic field fotal cuooent I cioculao passing fhoough the…

A: The magnetic field is given as, Evaluate the current density by taking the curl of the field.

Q: Determine all voltages and currents in Figure 14-38 immediately after the switch is closed +VR1 +…

A: The given circuit diagram is:

Q: Find the angle between A = 5.8ay + 1.55az and B = - 6.93ay + 4az..

Q: A 46-mH inductive coil has a resistance of 10 ohms. How much current will it draw if connected…

Q: Convert these from polar to rectangular form: a) –4260° b) –0.9230° 3) a) b)

Q: Question 3 : Determine the number of poles on the RHS, LHS, and jw-axis for the following open loop…

Q: bectively if the primary winding is conne

Question

For the coil of Figure 14-45, R = 1.7 Q and L= 150 mH. Determine coil current at t = 18.4
ms
5.6 0
3.9 0
4.7 2
十67 V
Coil

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 5 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 100-turn coil is wound on a toroidal core and has an inductance of 100 mH. Suppose that a 200-turn coil is wound on a second toroidal core having dimensions (r and R as shown in Figure 14.11 on page 709) that are double those of the first core.. Both cores are made of the same material, which has very high permeability. Determine the inductance of the second coil.
Question 17 Aa A Question Vvv 14-26 What is the input Miler capacitance in Fig. 14-38 if C = 5pF and Av = 200,000?.Full explain this question and text typing work only We should answer our question within 2 hours takes more time then we will reduce Rating Dont ignore this line ..
I am trying to measure curl of del cross product A where A = -(cos(x) sin(y) + sin(x)cos(y) ⛛XA = -(cos(x)sin(y))+(sin(x)cos(y)) Thank you for your time and help!
A Volt ac voltage is applied to the primary input of a transformer. A load of B ohms at the output it depends. Since the primary spiral number of the transformer is C and the secondary spiral number is C, the primary current is, Find the secondary voltage and secondary current. A= 752 B=257 C=257 Ç= 16
A 200 V/100 V, 50 Hz transformer is to be excited at 40 Hz from 100 V side. For the exciting current to be same, the applied voltage should be ?
A parallel LC tank circuit has L = 40mH, C = 0.68nF, and a coil winding resistance of 10Ω. Calculate fr in MHz Blank 1; Q Blank 2; flc in kHzBlank 3 and fhc in kHz Blank 4
Two impedance coils A and B are connected in series to a 111-volt ac source. Coil A has a resistance of 12 ohms and an inductive resistance of 16 ohms. Coil B has a resistance of 24 ohms and an inductive reactance of 10 ohms. Calculate the voltage drop across each coil. Only in rectangular form
Number of coil windings 300; slit width 12 mm How can I get the calibration factor by using ampere's law? Plz explain in detail
What is the inductance of the primary (L_1) and secondary coil (L_2) of a step - down transformer if V_secondary = 14VAC, I_secondary = 3A. V_primary = 120VAC, Frequency = 60Hz
An impedance coil absorbs 250 W when connected across 220 V, 60 Hz mains. It is then connected across 110V 25Hz mains and also absorbs 250 W. What is the inductance of the coil? a. 0.125 H b. 0.149 H c. 0.154 H d. 0.163 H
A coil that consists of 450 windings is wound around a Bakelite ring. The mean diameter of the ring is 100 mm and the diameter of the Bakelite core is 20 mm.The current through the coil is 3A. Determine the field strength
A 200 V/100 V, 50 Hz transformer is to be excited at 40 Hz from 100 V side. For the exciting current to be constant, the applied voltage should be ?