For the signal flow graph of the given figure consider the following statements: 1. It has three forward paths. 2. It has three individual loops. 3.lt has two non touching loops. out of above the correct statements are X2 X3 X6 X1 1,3 O 2, 3 1, 2, 3 О 1,2

Q: List three gains or losses that could be modified (and how) to increase the signal-to-noise ratio in…

A: Signal-to-noise ratio is defined as the ratio of the power of a signal (meaningful input) to the…

Q: B) Select the best answer from Multiple choices: 1. In comparison of both SSB and VSB , we say: a-…

A:

Q: 4) The extent to which series mode noise corrupts measurement signals is measured by a quantity…

A: (4). The extent to which series mode noise corrupts measurement signals is measured by a quantity…

Q: Explain the relative merits of high- and low-level modulation schemes

A: The highly efficient class C amplifiers are used in high level Modulation schemes and the linear…

Q: Implement the following function with an 8 to 1 multiplexer. Remember, you are not required to…

A:

Q: Q/ Represents the PCM code [10001100101] in 1- Alternate Mark Inversion(AMI) 2-…

A: Solution- The given PCM code is, [10001100101]

Q: the result of XCE) x38(E-4),is ?

A:

Q: Q. Show how the PAL-type array in Figure below should be programmed to implement each of the…

A: AND GATE  INPUT OUTPUT A B Y 0 0 0 0 1 0 1 0 0 1 1 1 OR GATE INPUT OUTPUT A B…

Q: . A linear sign-magnitude PCM code consists of a. all magnitude bits b. a sign bit and magnitude…

A: 11) A linear sign-magnitude PCM code consists of a sign bit and magnitude bits ( option B).

Q: EX :(9):- Consider a noiseless channel with a bandwidth of 3000 Hz transmitting a signal with two…

A: a. The  maximum bit rate is the Nyquist bit rate and is given by the expression as shown below:  Bit…

Q: Match the signal state with its description. READY=1 A. The MPU has put valid data on the bus B.…

A: Here in left side specific signal is given in which * indicates the active low signal means it can…

Q: Implement the following function using 8 to 1 line Multiplexer. F(A,B,C,D) = m(0,4,5,8,10,12,14,15)

A: Implematation of funtion using 8×1 mux as- first draw k map then circle the given no on k map if…

Q: What are the similarities and differences between the information signal m (t) obtained as a result…

A: Find the distinction and similarity between demodulated signal and initial signal. Modulation :- In…

Q: 2. What would be the frequency of a signal with a period of 0.1057? 3. A signal of 5 volts is…

A:

Q: Q3: Assume that you have to spread two signals A and B, using CDMA with the DSSS. The data of…

A:

Q: The spectrum of a signal to be sampled is shown below. What is the approximate minimum sampling…

A: The spectrum of a signal is given. It has four frequencies present in it. The maximum frequency…

Q: 4) The extent to which series mode noise corrupts measurement signals is measured by a quantity…

A: 4. option d is correct answer. because The extent to which series mode noise corrupts measurement…

Q: Using Verilog continuous assignment statements or VHDL signal assignment statements, write a…

A: The verilog assignment statement for the given circuit can be obtained by converting the gates into…

Q: b) The analogue signal is defined as: v (t )= 5sin(2x 5001) + Ssin(2x 750r) is sampled as shown in…

A:

Q: Using Verilog continuous assignment statements or VHDL signal assignment statements, write a…

A: The given logic is:

Q: For a single-tone modulating signal of 5 kHz and a carrier frequency of 600 kHz, list the…

A:

Q: Prove that 1db equals 79%, and prove that 3db is equal to 50% Mathematically, the total power loss…

A: The optical fiber transmission works on the principle of TIR. Total Internal Reflection is…

Q: The analog signal x(t)=2sin 480nt + 3sin 720 nt. Calculate: i. Minimum sarnpling rate to avoid…

A: It is given that: X(t)=2sin480πt + 3sin720πt fs1=200 MHz fs2=75 Hz

Q: EX :(9):- Consider a noiseless channel with a bandwidth of 3000 Hz transmitting a signal with two…

A: Given, Bandwidth of transmitting signal is  BW = 3000 Hz Number of signal levels (L) = 2

Q: used to drive a load cap. A Chain of N muerbess wde be of 2004F. To obtam tle minimwon delay…

A: Propagation delat tp = tp0∑ j=1N1+Γsj-1     =tp01+ΓN1-ΓsN1-Γsfor this delay to be minimum,∂tp∂s=0…

Q: \ discuss a conversion of an analogue signal to digital bits Please I need to resolve the question…

A: The analog to digital converter converts the analogue signal to digital bits by the process of…

Q: This multiple choice question from DIGITAL COMMUNICATIONS course. just write for me the final…

A: If the quantization error must not exceed 2% of the peak-to-peak analog signal. Then the minimum…

Q: 4a.i.) Discuss the PAM as applied in communication system. Outcome must be supported with a signal…

A: According t question we have to discuss about,  (i) The PAM as applied in communication system.…

Q: A major advantage of PRTs is that they are very linear. A disadvantage is that they have poor…

A: PRT stands for platinum resistance thermometer. Platinum is used to determine the temperature in the…

Q: The subject is Communication Systems ( A RANDOM SIGNAL GENERATION AND ANALYSIS ) Please send the…

A: Explain SNR SIGNAL TO NOISE RATIO

Q: 5- Discuss the effect of changing the number of bits on the recovered analog waveform. 6- Discuss…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: which of the following requirement must be met for fast communicationt A.High sampling rate B.High…

A:

Q: What is counter? What is its purpose? asynchronous counter that counts from 0 to 32 ?

A: 4) Counter is a sequential digital circuit which has Number of flipflops connected in cascade. It…

Q: hich statement is true? a. In FSK, the modulating signal and the carrier signal are both analog…

A:

Q: lem he Figure below shows a screen shot of a signal recoded by an oscilloscope. a) What are the…

A: According to the bartleby's guidelines we have to solve only first three subparts of a question so…

Q: b. Explain how to decide the sampling rate for a multi-frequency input signal. c. An ADC with word…

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Q: In a Mach-Zender interferometer you measure the visibility in both output ports and find V1 = 1 and…

A: Given, V1=1V2=0.5

Q: cos t Yalt) Xa(t) Cos t X-ljm) Yo(t) w(t) cos wt -WM OM WM Yelt) Xe(t) Şekil 1 Şekil 2

A: b)This figure is of frequency division multiplexing.  In the frequency division multiplexing the…

Q: 7) Suppose we have a message signal that is a sinusoid and we quantize it using a quantizer of L…

A: We need to find out the SNR for given system.

Q: Q3: Find the required sampling frequency to get ten cycles for a signal that has frequency of 1 KHz?…

A: Sampling frequency  for ten cycles  Signal have =1kHz. Using the sampling frequency, fs =nfm

Q: 1. Design a 4 - to – 1 multiplexer for the selection lines X, = 1 and X, = 1.

A:

Q: Convert the Moore state diagram of the following figure into an equivalent ASM chart. Check only one…

A: In moore machine, the output variables are only dependent the present state only. It is a finite…

Q: 14.3.4 - What signal is sent in period 9 if a slave on the 12C bus has the same slave address as was…

A: The address of the slave with which the master communicates is sent by the master to every slave…

Q: Consider the following plots of time-domain and frequency-domain signals. Label the axes of the five…

A: Given: The Plot 'a' is given by: The Plot 'b' is given by: The Plot 'c' is given by: The Plot 'd'…

Q: ?Which signals are function of time Deterministic signal O Random & Deterministic signal O None of…

A: Deterministic signals are those whose values are defined for any particular value of time . Hence…

Q: What are the applications of FM? Define frequency deviation in FM? What are the advantages of FM…

A: The explanation is as follows.

Q: the static error coefficient of the system given in the figure is Kp = 3, what should the K value be…

A: In this question we will find K value for given Kp....

Q: a) A 4-KHz analog signal is sampled at 1.5 times the Nyquist rate, and each sample is of 128 equally…

A: