for the system given on the side, a-) Find the K interval that makes the system stable. b-) Calculate the maximum percentage exceeding of the system, dwell time (according to 2%). c-) Calculate the K value that provides the static position error coefficient Kp = 10. R(s)+ K C(s) (s + 64 )(s? + 2s + 421)

for the system given on the side, a-) Find the K interval that makes the system stable. b-) Calculate the maximum percentage exceeding of the system, dwell time (according to 2%). c-) Calculate the K value that provides the static position error coefficient Kp = 10. R(s)+ K C(s) (s + 64 )(s? + 2s + 421)

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

The closed loop pitch rate control of an airplane operating at a certain altitude and sound speed is shown in the following blog diagram as a representation. Features expected from this system ωIt is known that n>2 and ζ≥0.15. Accordingly, G Assuming c(s)=K, find the K value corresponding to the maximum ζ value that can be used by plotting the root-locus curve of this system. It should be taken into account that the system should be stable.
Explore the challenges and benefits of implementing power electronics-based grid solutions like STATCOM (Static Synchronous Compensator) for voltage control and stability.
A closed loop system with G(s) = k / [ (s+3)(s+4)(s+12) ] has its dominant poles placed so the ratio of the imaginary to real parts is -1.423. If the value of the real part is -3.3, what is the angle of the system. Draw the Root Locus showing all important points/data
Consider the system below. For this question, let C (s) = K, in this question K is a positive real number. a) Prove that if the root locus of the system is drawn, the points s1,2=−0.3214 ± 2.8951j will be on the curve. (Show it by doing mathematical calculation without drawing the curve.) b) Draw the root locus of the system. c) It is desired that the dominant (= near the imaginary axis) poles of the closed loop system be at the points s1,2= −0.3214 ± 2.8951j. What should K be for this? What can be said about the stability of the closed loop system for this K value? d) What are the unit step, ramp and parabolic reference tracking errors of the system for K in the option c?
Which of the following is not true? a.Increasing system gain increases stability b.poles farther to the left of imaginary axisimprove speed c.steady-state errors are important in the studyof unstable systems d.multiple poles on the imaginary axis improvessystem stability
G(s)=((s+1)*(s+15))/((s+0.1)*(s+2.5)*(s+120)*(s+240)) 1-draw nyquist 2- Nyquist criterion, compute the number of unstable poles of the closed loop system as a function of K 3-determine for which values of K the closed system is stable.
Given the following characteristic equation: 1+K/S(S2+2S2+8S+5)=0 (a) Using Routh method determine the range of K for which this closed loop system is stable. (b) Find the value of K for which the system has purely imaginary roots and determine the corresponding frequency of oscillations.
COURSE: Electrical EngineeringSUBJECT: Electrical ApparatusINSTRUCTIONS:• Write the GIVEN with their respective symbols and units.• Do not skip the SOLUTIONS, do it step-by-step with their respective symbols and units• Round up to 3 three decimal places the FINAL ANSWERS and BOX it. PROBLEM:A capacitor in series with a 66 Ω resistor is connected to a 120 V, 60 Hz source. If the impedance of the circuit is 116 Ω, determine the size of the capacitor.
y[(t) = {3e-2t, t0 {0, otherwise The function above defines a voltage signal y(t) monitored from a pacemaker. a.Make a sketch of the signal & state if it is non-causal/causal, aperiodic/periodic & odd/even. b. y[n] = 6cos2(πn/4) The above defines a discrete time signal y[n] from a device. Determine the four point DFT of the sequence.
Inside a system contains two small discrete time systems X and Y. X: y[n] = ax[n] + bx[n-1] + cx[n-2] , where a, b, and c are real constants Y: y[n] = med{x[n-1], x[n], x[n+1]} , where med is taking median value of three inputs. Explain and prove why different order of the two systems yields two different results.
identify the following 1. If the pole’s real value is positive and is located on the right side of the S-plane. The system exponentially ____________.2. Is a continuous connection of branches from one node to another with all arrowheads in the same direction.3. Knowing the location of the pole in the S-plane determines the ______________ of the system.
Which of the following statement(s) are true for a system with Kp = 99 A. The input to the system is ramp B. The system is not stable C. The Kp value will be finite for Type 1 system D. The steady state error = 0.1 E. The system is Type 0