For which type of flow is the momentum flux correction factor significant and must be considered in analysis? a) jet flow b) laminar flow c) transitional flow d) turbulent flow 2) Linear momentum is a vector, which is equal to the product of the mass and the velocity of the body. True or False 3) Which of the following force does NOT belong to body force?

Q: 3 Density of a brine is 1035 kg/m, mass flow rate is 776.25 kg/s, then the volume flow rate is…

A: We have to determine volume flow rate

Q: is again ‘S’ m, the densi

A: introduction: here we have find ship displacement on the arrival at second port.

Q: 1) Affinity laws apply to both pumps and turbines. True or False

A: Dear student, we are suppose to solve only one question. Please post other question as a separate…

Q: Fluid mechanics, i need solutions in 10 minutes please. MCQ/ what is the specific weight of the…

A:

Q: determine the velocity of a rocket and magnitude/direction of the rockets momentum at peak height…

A: Given: The peak height, H = 13501.45 m The horizontal length, x = 64,248.42 s Time to reach peak…

Q: At a particular hydroelectric power station water flows at a maximum rate of 155 cubic meters per…

A: According to the problem, 1 cubic metre of water has a mass of 1000 kilograms, therefore, the…

Q: A football is kicked off 40° above the ground with initial velocity of 32 m/s. If the ball landed on…

A: Using kinematic relations in curvilinear projectile motion.

Q: A vertical jet thru a nozzle supports a 150.90N weight. The velocity and diameter of the jet are…

A:

Q: centrifugal pump discharged 20 L/s against a head of 17 m when the speed is 1500 rpm. The diameter…

A:

Q: Create 10 Descriptive Research Topics for each. 1. Energy System 2. Automation Systems 3.…

A: The 10 descriptive research topics on an energy system, automation systems, agricultural…

Q: 1. volume flow rate of Benzene. 2. Mass flow rate of Benzene. 3. Weight flow rate of Benzene

A:

Q: water 0.125m glycerine P2 1.0 m 0.5 m mercury

A: Find the pressure difference .

Q: A 30 cm diameter pipe, conveying water, branches into two pipes of diameters 20 cm and 15 cm…

A:

Q: Given two potential windfarm sites with the following conditions, find the expected wind power…

A: To find: Determine the wind power density for two locations.

Q: conservation. 1 1 P1 +;pv? + pgyi = +P2 +5pv3 + pgyz List any four assumptions that must be made for…

A: Assumption are given below:

Q: The following table shows the kinetic energy and potential energy according to the speed of an…

A:

Q: The gas mileage of a certain German automobile is 22 km/L. Convert this quantity to miles per…

A: Given, Mileage = 22 km/L

Q: Oil flows through a 16 tube single cooler with a velocity of 2 m/s. The internal diameter of the…

A:

Q: Water flows steadily and smoothly along a horizontal pipe through a contraction and out into the…

A:

Q: The hydraulic grade line HGL is always [ Select ] than the energy grade line EGL and the difference…

A: Hydraulic grade line: It is the sum of pressure head and potential head. Energy grade line: It is…

Q: 4. According to the principle of conservation of energy, under the action of ... . force, the sum of…

A: Ans.4 - b) conservative forces Ans.5 - a) true

Q: A pump is tested in the laboratory and the following data were obtained: Torque Rotational speed…

A: Torque = T = 5 ft lbf Rotational speed = 1200 rpm Inlet pressure = P1 10 psia Outlet pressure P2 =…

Q: 1.27 A fluid moves in a steady flow manner between two sections in a flow line. At section 1: A, = 1…

A: (a) The mass flow rate is 15,000 lb/hr. (b) The velocity at section 2 is 10.42 ft/sec.

Q: Oil flows through a pipe AB of 30 cm diameter with velocity of 3 m/s and then passes through pipe BC…

A:

Q: Find the distance of load from the nozzle in meter

A: Given: A water jet F=150.9 N v0=17.9 m/s d=3.9 cm To determine:  The distance of load from the…

Q: What form of energy from the list below is an extensive system property (choose all what apply)…

A: Extensive propeties: An extensive property is a property that depends on the amount of matter in a…

Q: 4 A 35.0 kg lead mass rests on the bottom of a pool. ( a. What is the volume of the lead? (density…

A:

Q: find  Step 1: Known, Unknown Step 2: Schematic Step 3: Formula Step 4: Calculations Step 5:…

A:

Q: Ex 8: Farm of clay loam soil irrigated by basins. Slope in direction of irrigation 0.2% , net…

A: Given Dataslope=2%Q=100Lpsd=10cm***As per our company policy we are supposed to do onle 1 question…

Q: Question 1. A tall water tank (p = 998 Kg/m³) discharges through a well-rounded orifice to hit a…

A:

Q: Question 13) A boundary layer is a thin region (usually along a wall)in which viscous forces are…

A: Write the dimensions of the variables.

Q: A 30 cm pipe carrying water, branches into two pipes of 20 cm and 15 cm diameter. If mean velocity…

A:

Q: If you measured h=851.1 mm Hg usin specific gravity is 13.55) Select one: a. 104.62 Ob. 96.11 Oc.…

A: Option e is correct.

Q: Starting from the fundamentals wind speed and the power relations, derive an expression for power in…

A: It is given that the wind is flow in the upstream direction. Assume that the air is incompressible…

Q: Question 7 Convert the gravitational acceleration g = 9.8 m/s² to (ft/s²). g = ft/s?

A:

Q: In a certain incompressible fluid, the pressure difference from the surface to a particular depth is…

A:

Q: Four cars, with a mass of 1500 kg each, are loaded on a 6 m wide, 12 m long small car ferry. How…

A: Data given-  n = 4  m = 1500 kg  So M = 1500 × 4 = 6000 kg  w = 6 m  L = 12 m

Q: The Steady Flow Energy Equation (SFEE), as shown below, embodies three forms of energy. Name the…

A:

Q: The mean velocity of fluid flow changes with respect to time at any point is  Non-uniform flow…

A: Non - uniform flow: It is the flow in which there is a change in velocity of the flow at different…

Q: Determine the velocity of the water (in m/s) as it exits the nozzle.

A: Given that: Temperature of water is 20 oC. Volume flow rate is 0.005 m3/s. Diameter at the inlet of…

Q: A wind turbine is designed to produce the power of 5 kW. What is the percentage of mechanical and…

A:

Q: In general term, ______________ is the tendency of one fluid to spread on to a solid surface in the…

A: Given data In general term, ______________ is the tendency of one fluid to spread on to a solid…

Q: Select the most suitable complement among listed options fo T) Real fluids (a) are viscous (b)…

A: Q 1: option d is correct Possess all the above properties Real fluid: in real fluids viscosity and…

Q: Calculate energy available in 17 Kg wind, if the power available at the rotor of a wind turbine is…

A:

Q: how standpipes and automatic sprinkler differ from each other as systems for fire protection?

A: The installation and deployment of structural and operational devices to reduce the impact of fire…