Four resistors and a power supply are placed in a circuit as shown below. (a)What is the equivalent resistance (Req) ofthis circuit? (b)What is the total current ofthis circuit? (c)How much energy is consumed by this circuit in 12hours?

Q: Vhat is the resistance of a wire made of a ma esistivity of 3.2 × 10-8 ength is 22.2 m and its

A: Given values:- The resistivity of wire,(ρ)=3.2 x 10-8 Ω-m ------(1) Length of the wire,(L)=22.2 m…

Q: 1 Supposing the voltmeter used has a resistance of 20,000 ohms and it reads 5 volts while the…

A:

Q: What shunt resistance is required to make mA, zu galvanometer into an ammeter with a range 0.0 mA?

A: Shunt resistance is defined as the slope of the dark current versus applied voltage to the detector.

Q: How much current, in A, can a 16 ohm speaker handle if it is rated for 40 W?

A: The electric power is given by, P=I2R Here, I is the current and R is the resistance. Rearranging…

Q: If the load on a 50-ohm line is a 100-ohm resistor, what is the VSWR?

A: Answer: Given that: In a Transmission Line,

Q: /hat is the resistance of one of the wires, how much current will it carry if a voltage of 9 V is…

A:

Q: A circuit is connected to a potential difference, V = 26.4 volts, at a power P = 2.2 watts. What is…

A: Given, Potential difference, V = 26.4 W Power,  P =2.2 W

Q: The equivalent capacitance of the circuit shown below is 2C

A: Given that all three capacitors are in series

Q: If 18 A flows through a 48 V battery in a certain circuit, how much would it could cost to operate…

A: It is given that, I=18 AV=48 VE.C.=0.11 $/kW.hr

Q: Two resistances are joined in paralle hose resutant i 6/8ohm. One of the resistance wire is broken…

A: The equivalent resistance in parallel connection, Req=68 ΩR1R2R1+R2=68 Ω       ..... 1   In this…

Q: What is the sensitivity of the galvanometer (that is, what current gives a full-scale deflection)…

A: It is given that, V=100 VR=25 kΩ=25×103 Ω

Q: What is the total resistance if these 3 resistors are each 200 ohms? What is current coming from the…

A: Given data:  Three resistors are connected in series combination R1 = R2 = R3 = 200 Ω Battery…

Q: Your electronics friend needs a 10-Ω resistor, but only has 40 ones. How can he combine them to…

A:

Q: The proportionality constant is called resistance and depends on the material used. Typical In the…

A: Conductors: a material which has the lower resistivity is known as conductors.   Note: for best…

Q: Consider the circuit shown in the figure. A short time after dlosing the has a time constant of 19.7…

A:

Q: Suppose an electrical wire is replaced with one having every linear dimensiondoubled (i.e., the…

A: We know that the resistance of a wire is given by, R=ρLAwhere,ρ=resistivity of the wire  L= length…

Q: For a heater rated at 4 kW and 220 V, calculate: (i) the current;

A: Given information Power rating or Power consumed by Heater P = 4 kW Maximum potential across the…

Q: A traditional filament light bulb has an efficacy of 15 lumen per Watt of electrical power applied.…

A: The luminous efficacy is the ratio of luminous flux to the power. It is given by efficacy=luminous…

Q: In the circuit shown, the battery voltage, V = 15V and the load resistance, R = 15N. +, V ww R V A…

A: REcall Ohm's law  V=IR

Q: ce of the combination of the r

A: GivenRA=25 ΩRB=30 ΩRC=15 ΩRD=10 Ω

Q: A battery provides 12 volts on open circuit and it provides 11.6volts when delivering 2ampere .what…

A: e = 12 V V = 11.6 V I = 2 A

Q: What is the power consumed in the circuit when the switch S is open as shown in the figure?

A:

Q: What’s the voltage across a 3.0-ohm resistor with a current of 1.0 A going through it?

A:

Q: On what factors does the resistance of a conductor depend?

A: The property of a conductor by which it opposes the flow of the electric current through it is…

Q: RL e cir cuit shown in the figure, R = 20ohm resistance, ɛ = 20V battery 2ohm is the internal…

A: The value of resistor RL for maximum power consumption= value of the circuit without RL  present in…

Q: In the circuit shown, the battery voltage, V = 15V and the load resistance, R = 202. V ww R A +,…

A: Given data: Battery voltage (V) = 15 V Load resistance (R) = 20 Ω Required: Current (I) and voltage…

Q: An electric heater is constructed by applying a potential difference of 107.3V across a wire with a…

A: Given- Potential difference V=107.3 V Resistance R=5 Ω

Q: The power rating of the heater a Nichrome wire that has a total resistance of (8 Q) and carried a…

A:

Q: If we had 24A of current running through a series system when an additional resistance is added,…

A:

Q: The equivalent capacitance of the circuit shown below is

A:

Q: Get the egaivaknt resistance of the figure shoum.

A:

Q: Problom E= 10V For the circuit shown in figure, tind: Total current CIt)

A:

Q: Let's say you have a 30W lightbulb that operates on a 120V alternating current. When the light is on…

A:

Q: zing below shows an electric circuit, wheie resistois aie connected to a battery If the IN resistor…

A: According to Ohm law V = RI In parallel combination potential differencefor both…

Q: For some an application, it is important that the value of a resistance not change with temperature.…

A: SOlution: to make a 4.7 kOhm resistor from Carbon and Nichrome at 0 c temperature

Q: How much would you have to raise the temperature of a copper wire (originally at 20°C) to increase…

A: temperature coefficient of copper wire at 20 °C, α = 0.00386

Q: Using Ohm's Law,The electromotive force of a cell is 1.5V. When connected to an external load of 3.O…

A: Given: The emf of the battery is 1.5 V. The voltage drop is 1.35 V when the external resistor is…

Q: What is the sensitivity of the galvanometer (that is, what current gives a full-scale deflection)…

A: Given  The value of resistance is R = 1 MΩ. The voltage shown in the voltmeter is V = 30 V.   The…

Q: In an experiment on muscle a voltage of 6.64 V is applied, resulting in a current of 57.1 mA.  What…

A:

Q: The conductance G of an object is defined as the reciprocal of the resistance R; that is, G = 1/R.…

A: Given data: Magnitude of current drawn is, I=440 mA=440×10-3 A. Voltage supply is, V'=3.0 V.

Q: What is the sensitivity of the galvanometer (that is, what current gives a full-scale deflection)…

A: