In an experiment on muscle a voltage of 6.64 V is applied, resulting in a current of 57.1 mA. What is the resistance of this muscle, in Ω? What voltage is needed to supply 593 mW of power to a 2.64 kΩ resistor?

In an experiment on muscle a voltage of 6.64 V is applied, resulting in a current of 57.1 mA. What is the resistance of this muscle, in Ω? What voltage is needed to supply 593 mW of power to a 2.64 kΩ resistor?

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter29: Direct Current (dc) Circuits

Section: Chapter Questions

Problem 19PQ

See similar textbooks

Related questions

Q: A storage battery has an emf of 25 V and an internal resistance of 0.200 ohm. Compute its terminal…

Q: If the battery in the circuit below is 9.77V, resistor R1=83.862, and resistor R2=59.65N, what is…

Q: In an RC circuit, what is the value of the ratio V. /E when the current in the circuit reaches…

A: The current in the RC circuit is given by I=I0e-tτ0.1395=e-tτ

Q: 1. For each of the circuits shown, find the equivalent resistance seen by the source and the power…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: The circuit contains three resistors, A, B, and C, which have equal resistances. epsilon = 110V.…

A: Say value of each resistor is R Resistor A and B are in series therefore there equivalent will be 2R…

Q: A PHY-102 connected a RC circuit using a 3 MQ resistor, 1 µF capacitor, and 4 V battery. The rate at…

Q: For the circuit shown below and V = 12.14 V, what is the voltage, in Volts, across the lead resistor…

Q: You connect a battery, resistor, and capacitor as in (Figure 1), where E = 46.0 V, C = 5.00 μF, and…

A: Given: Battery voltage E = 46.0 V Capacitance C = 5.0 µF Resistance R = 130 Ω

Q: The nerve cell membrane has both resistance and capacitance therefore it can be modeled as an RC…

A: Given data: Resistance (R) = 3.2×107 Ohm Capacitance (C) =…

Q: 25.0 N w-(A |15.0 N V 45.0 N 15.0 N 10.0 N |+ 35.0 N E = ?

A: The Ohm's law is given by V = I R where, I is the current, V is the voltage and R is the…

Q: An emf of 10 V is connected to a series RC circuit consisting of a resistor of 1.80 ✕ 106 Ω and an…

Q: The RC circuit shown in the figure has resistance of R=4kQ and the capacitance of c=9µF. The…

Q: If 480 C pass through a 4.0-12 resistor in 10 min, what is the potential difference across the…

A: Given The amount of charge passes is Q = 480 C. The time in which charge passes is t =10 min = 600…

Q: Calculate the Thevenin equivalent resistance for the network across R₁. Given that R₁ = 3, R₂ = 6,…

Q: Table 2. Resistance of conductor for different cross-sectional areas D (cm) | A(cm?) Length (cm) | I…

A: The resistance of any wire is the ratio of the voltage across the wire to the current passing…

Q: A circuit consisting of 5 resistors is shown in the graph. Their resistances are R1 = 16 Ω, R2 = 35…

Q: In the figure R1 = 140 Q, R2 = R3 = 57.0 0, R4 = 96.7 Q, and the ideal battery has emf ɛ = 6.00 V.…

Q: What differential equation corresponds to an RC circuit with a resistor of R = 100 and a %3D…

A: Please see the solution below.

Q: 4 p 5. Find the equivalent resistance Rab (in ohms) of the circuit shown by using a Wye-to-Delta…

Q: R1 = 5 Q R, = 3 2 A ww- R3 = 6 0 ww

A: Given : 3 Resistors are connected in parallel.

Q: In the circuit below, the capacitor starts out uncharged. The resistance is R = 118 Ω, capacitance…

Q: What voltage will produce 0.2 AA of current through a 4800-ΩΩ resistor? Express your answer to two…

Q: 12 13 R1 E2 R3 R2 E1 For the circuit shown above, the emf of the batteries and the resistances are…

Q: An emf of 10 V is connected to a series RC circuit consisting of a resistor of 2.0 × 106 Ω and an…

Q: The figure below shows a simple RC circuit with a 3.30-µF capacitor, a 2.80-MΩ resistor, a 9.00-V…

Q: When a R = 92.3 Q resistor is connected across a 12.3 V battery, a current of 123.2 mA flows. What…

A: Given : E = 12.3 V R =92.3 Ω i = 123.2 mA INTERNAL RESISTANCE : i=ER+r Plug given values we get…

Q: A 12-volt battery of internal resistance r of 0.05 ohm is to be recharged by a 50-volt dc source at…

A: Let the voltage of the battery be denoted by V1, the voltage of the source be denoted by V2, and the…

Q: An RC circuit have 9 V source and lies at 54 seconds of time constant. Then, find the voltage across…

A: Given data: The source voltage is V=9 V. The time constant is τ=54 s. The time taken is t=153.5 s.…

Q: 1.30 The numerical values of the voltages and currents in the interconnection seen in Fig. P1.30 are…

Q: What is Voltage associated with 0.07 amps passing through a 87 resistor?

Q: In the figure R1 = 110 Ω, R2 = R3 = 64.0 Ω, R4 = 110 Ω, and the ideal battery has emf ε = 6.00 V.…

A: GIven data The magnitude of resistance 1 is given as R1 = 110 Ω. The magnitude of resistance 2 and 3…

Q: The figure below shows a simple RC circuit with a 2.70-µF capacitor, a 3.20-MΩ resistor, a 9.00-V…

Q: Use Kirchhoff's junction rule and voltage/loop rule to find the current through each resistor in the…

Q: 1. The cell has an emf of 2V and the internal resistance of this cell is 0.10, it is connectedto the…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: (a) In the given circuit, determine (a) the equivalent resistance and (b) the voltage across each…

Q: An RC circuit without a battery contains a 239.0 k2 resistor and a fully charged capacitor that…

Q: In the figure R₁ = 1300, R₂ = R3 = 48.0 2, R4 = 84.90, and the ideal battery has emf ε = 6.00 V. (a)…

Q: In figure, R1 = 100 ohms , R2 = R3 = 50.0 ohms , R4 = 75.0 ohms , and the ideal battery has emf V =…

Q: You connect a battery, resistor, and capacitor as in (Figure 1), where E = 36.0 V, C = 5.00 μF, and…

A: In the given question, Voltage (ε) =36V Capacitance (C) = 5μF = 5×10-6F Resistance (R) =140Ω The…

Q: Find the total resistance of the following: R1 1k0 R2 10kQ R6 3.3kQ R3 1.5kQ RA R5 2.2kQ 4.7k0

Q: The RC charging circuit in a camera flash unit has a voltage source of 285 V and a capacitance of…

Q: A resistor with resistance R is connected to a battery that has emf 13.0 Vand internal resistance r=…

A: Write the expression of the power consumed by the resistor, The current across the resistor which…

Q: Using the delta-wye or wye-delta transformation for the circuit below, Find the total resistance(R,…

Q: Your toaster has a power cord with a resistance of 0.020 Ω connected in series with a 9.6@Ω nichrome…

A: Resistance of power cord, r = 0.020 Ω Resistance of heating element, R = 9.6 Ω Voltage, V = 120 V

Q: The internal resistance of a high voltage power supply is 24 MΩ and the output is set so that the…

A: Given: Internal resistance of high voltage power supply = 24 MΩ Potential difference across output…

Q: An RC circuit has a 11 F capacitor and a 0.5 ogm resistor. If the initial charge stored on the…

A: R = 0.5 Ω C = 11 F q0 = 20 C q = 2.5 C

Q: What is the maximum voltage that can be applied to a 186 k ohm resistor rated at 16 watts? Give your…

Q: A total resistance of 3.05 is to be produced by connecting an unknown resistance to a 12.01 Q…

A: Given: The total resistance is 3.05 Ω. The known resistance is 12.01 Ω.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Power P0 = I0 V0 is delivered to a resistor of resistance R0. If the resistance is doubled (Rnew = 2R0) while the voltage is adjusted such that the current is constant, what are the ratios (a) Pnew/P0 and (b) Vnew/V0? If, instead, the resistance is held constant while Pnew = 2P0, what are the ratios (c) Vnew/V0, and (d) Inew/I0?
A circuit loop containing an external resistor of value R = 25.0 (ohms) is connected to a real battery with an internal emf = 20.0 V that has an internal resistance of R = 1.50 (ohms). How much power is generated by the power supply in Watts?
The circuit contains three resistors, A, B, and C, which have equal resistances. epsilon = 110V. Which resistor generates the most thermal energy after the switch is closed? a.B b.A c.All three generate the same amount of thermal energy. d.C e.A and B
In (Figure 1), the battery has negligible internal resistance and EMF = 44.0 V. R1 = R2 = 3.40 Ω and R4 = 3.70 Ω. What must the resistance R3 be for the resistor network to dissipate electrical energy at a rate of 275 WW?
A 1234. pF capacitor and a 5.6 × 106 ohm resistor are connected in series to 78. volts EMF. Approximately how long does it take the capacitor to become almost fully charged? A) 0.1 ms B) 1. ps C) 1. μs D) 1. s E) 0.01 s
In the circuit shown, the battery has EMF of c=32 V. At what rate is thermal energy being generated in the 60 resistor? (Ignore the internal resistance of the battery)
You have a circuit and you measure the current and find it is 9.51 micro A. You measure the potential and find it is 5.42 mV. What is the resistance of the resistor?
In the circuit below, the capacitor starts out uncharged. The resistance is R = 118 Ω, capacitance is C = 0.0647 F, and the battery emf is 16.7 V. What is the charge (Q) on the capacitor at a time of t = 3.72 seconds after the switch is closed?
A storage battery has an emf of 6.7 V and internal resistance of 0.50. Compute for the terminal voltage of the battery when it is being charged with 2.0 A.
A circuit consisting of 5 resistors is shown in the graph. Their resistances are R1 = 16 Ω, R2 = 55 Ω, R3 = 97 Ω, R4 = 63 Ω, and R5 = 23 Ω, and the emf of the battery is ε = 5.5 V. Suppose the internal resistance of the battery is zero. Express the current I through R1 in terms of the emf ε and the equivalent resistance R.
An RC has a resistor with a resistance of 12 ohms and a capacitor with a capacitance of 1.4 F. The capacitor is discharging. If the capacitor initially has a charge of Q = 11C then after how many seconds will it have a charge of 0.6875C?
A wire of resistance 5.0 ohm is connected to a battery whose emf is 2.0 V and whose internal resistance is 1.0. In 2.0 min, how much energy is (a) transferred from chemical form in the battery, (b) dissipated as thermal energy in the wire, and (c) dissipated as thermal energy in the battery?