Fresh air enters a converging nozzle with velocity 110 m/s at steady condition, one-dimensional and isentropic. The nozzle throat area 40 cm? and the back pressure 0.5 MPa. The ambient air condition at 1 MPa and 620°C. Assume that the Cp =1.005 kJ/kg.K and k=1.4. Calculate the air mass flow rate Converging Nozzle Fresh air

Fresh air enters a converging nozzle with velocity 110 m/s at steady condition, one-dimensional and isentropic. The nozzle throat area 40 cm? and the back pressure 0.5 MPa. The ambient air condition at 1 MPa and 620°C. Assume that the Cp =1.005 kJ/kg.K and k=1.4. Calculate the air mass flow rate Converging Nozzle Fresh air

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter5: Analysis Of Convection Heat Transfer

Section: Chapter Questions

Problem 5.30P: Air at 1000C flows at an inlet velocity of 2 m/s between two parallel flat plates spaced 1 cm apart....

See similar textbooks

Similar questions

Air at 1000C flows at an inlet velocity of 2 m/s between two parallel flat plates spaced 1 cm apart. Estimate the distance from the entrance to the point where the boundary layers meet.
Air at 20C flows at 1 m/s between two parallel flat plates spaced 5 cm apart. Estimate the distance from the entrance to the point at which the hydrodynamic boundary layers meet.
he reservoir pressure and temperature for a Laval nozzle are 5 atm [abs] and 520 K,respectively. The flow is isentropically expanded to supersonic speed at the nozzle exitwith area Ae = 4in2. If the exit-to-throat area ratio is 2.295, calculate the followingexit properties: g) ̇mass flow rate gamma = 1.4, R = 287 J/kgK Please show all work
10 Consider a diamond-shaped airfoil. The maximum thickness is 0.04 and occurs at mid-chord. The freestream Mach number is 2.0, and the airfoil is operating at a 5 degree angle of attack. a)Find the expressions for the lift coefficient, drag coefficient, and lift to drag ratio using shock-expansion theory Cl= 0.2286, Cd= 0.0302, and L/D= 7.57 Please show work
Air at 7.20 MPa (abs.) and a temperature 1100K flows isentropically through a converging-diverging nozzle, the throat area is 0.01 m^2. Determine:1- The downstream velocity, in the section where the Mach number is 4.0;2- The mass flow rate through the nozzle
he reservoir pressure and temperature for a Laval nozzle are 5 atm [abs] and 520 K,respectively. The flow is isentropically expanded to supersonic speed at the nozzle exitwith area Ae = 4in2. If the exit-to-throat area ratio is 2.295, calculate the followingexit properties: d) ρe; e) p0,e; f) T0,e; gamma = 1.4, R = 287 Please show all work!!
Air enters a pipe of 1-cm diameter and 1.2-m length at p1 = 220 kPa and T1 = 300 K. If f = 0.025 and the exit pressure is p2 = 140 kPa, estimate the mass flow for (a) isothermal flow and (b) adiabatic flow.
An explosion occurs which creates a plane normal shock wave propagating into a region of air that is at rest (stagnation pressure po=1.0135×105Pa) and (stagnation temperature of To=290K). The speed of the shock is 1700 m/s. The air is modelled as an inviscid fluid, specific heat ratio γ=1.4 and gas constant R=287~J/kg⋅K. Calculate the air speed in m/s, relative to a stationary observer in the region behind the shock?
One type of supersonic wind tunnel is a blow-down tunnel, where air is stored in a high-pressure reservoir, and then, upon the opening of a valve, exhausted through the tunnel into a vacuum tank or simply into the open atmosphere at the downstream end of the tunnel. For this example, weconsider just the high-pressure reservoir as a storage tank that is being charged with air by a high-pressure pump. As air is being pumped into the constant-volume reservoir, the air pressure inside the reservoir increases. The pump continues to charge the reservoir until the desired pressure is achieved.Consider a reservoir with an internal volume of 30 m3. As air is pumped into the reservoir, the air pressure inside the reservoir continually increases with time. Consider the instant during the charging process when the reservoir pressure is 10 atm. Assume the air temperature inside the reservoir is held constant at 300 K by means of a heat exchanger.Air is pumped into the reservoir at the rate of 1…
On March 16, 1990, an Air Force SR-71 set a new continental speedrecord, averaging a velocity of 2112 mi/h at an altitude of 80,000 ft.Calculate the temperature (in degrees Fahrenheit) at a stagnation point onthe vehicle.
A large tank, at 500 K and 200 kPa, supplies isentropicairfl ow to a nozzle. At section 1, the pressure is only 120kPa. What is the Mach number at this section?(a) 0.63, (b) 0.78, (c) 0.89, (d ) 1.00, (e) 1.83 assume one-dimensional fl ow of ideal air, R 5287 J/(kg ? K) and k 5 1.4.
1. A flat plate airfoil with a chord length of 1 m and a width of 6 m is required to generate a lift of 40, 000 N when flying in air at a Mach number of 2.0, a temperature of −20°C and a pressure of 105 P a. What is the required angle of attack? What is the wave drag at this angle of attack? 2. A symmetrical diamond-shaped airfoil is placed at an angle of attack of 2° in a flow at Mach 2 and static pressure of 2×103 P a. The half-angle at the leading and trailing edges is 3° . If its total surface area (top and bottom) is 4 m2 , find the forces due to lift and wave drag acting on the airfoil.