Solve correctly From the initial production of a new light bulb, a sample of 10 bulbs was formed andthe lifetime of each bulb was measured. The results from the measurements areshown in the table below. The specification was for a lifetime with a nominal value of40,000 hours and a tolerance of 2,040 hours. For the specific process, what is theProcess Capability Ratio Cp equal to?Table 1: Measurements (in hours)416024177242633404164235741489423064049242081429650.503O 0.603O 0.7030.8030.903

Solution: Given information: The specification limits 40000±2040 Upper specification limit = USL =…

Answered: From the initial production of a new…

Algebra: Structure And Method, Book 1

(REV)00th Edition

ISBN:9780395977224

Author:Richard G. Brown, Mary P. Dolciani, Robert H. Sorgenfrey, William L. Cole

Publisher:Richard G. Brown, Mary P. Dolciani, Robert H. Sorgenfrey, William L. Cole

Chapter12: Quadratic Functions

Section12.6: Solving Problems Involving Quadratic Equations

Problem 1.3E

See similar textbooks

Similar questions

If the following specimen is subjected to a tensile test, determine the followings: c- The ultimate tensile strength (ultimate stress), if the maximum load is 120 kN. d- d- The percentage of elongation, if the final length at the fracture point is 55 mm.
A sample is counted for 10 minutes and results in 530 gross counts. A 30-minute background count results in 1,500 counts. The detector efficiency is 0.10 cpm/dpm. What is the critical level (net count rate) that corresponds to a risk of making a Type I error, where α is 0.05? a. 3.0 cpm b. 4.2 cpm c. 50 cpm d. 53 cpm
The diameter of a metal shaft used in a disk-drive unit is normally distributed with mean 0.2508 in. and std. dev. 0.0005 in. The specification on the shaft have been established as (0.25-0.0015 in, 0.25+0.0015in) If the process mean has been adjusted to 0.25 in, what fraction of the shafts produced does NOT conform to specifications? a). 0.0027 b). 0.0013 c).0.08 d). 0.16
For the situation described below, state the null and alternative hypotheses to be tested. (Enter != for ≠ as needed.) A seed wash is expected to change the proportion p of seeds that germinate when planted in poorly-draining soil. Suppose that the current germination rate is about 70%.
A 6-V lead-acid battery has an A-hr rating of 180 A-hr. The battery is to be load-tested. What should be the test current, and what are the maximum permissible amount and duration of the voltage drop?
The mean ±1 sd of ln [calcium intake (mg)] among 25females, 12 to 14 years of age, below the poverty level is6.56 ± 0.64. Similarly, the mean ± 1 sd of ln [calcium intake(mg)] among 40 females, 12 to 14 years of age, above thepoverty level is 6.80 ± 0.76 Implement the procedure in Problem 8.3 using thecritical-value method.
The diameter of a metal shaft used in a disk-drive unit is normally distributed with mean 0.25 in. and std. dev. 0.0005 in. The specification on the shaft have been established as (0.25-0.002 in, 0.25+0.002in) What fraction of the shafts produced conform to specifications? a). 0 b). 0.5 c). 0.9 d). almost 1
In an oil refinery, a storage tank contains 2000 gal of gasoline that initially has 100 lb of an additive dissolved in it. In preparation for winter weather, gasoline containing 2 lb of additive per gallon is pumped into the tank at a rate of 40 gal/min. The well-mixed solution is pumped out at a rate of 45 gal/min. How much of the additive is in the tank 20 min after the pumping process begins (Attached Figure 16.7)?
An editorial in the New York Times on Sunday June 4, 2011 dicussed the redesigned fuel economy stickers to be required on new cars starting in 2013. Consider a new idsize fuord fusion s model. At $4-a-gallon gas, annual fuel costs would be about $2,200 for 15,000 miles driven... And thats for a car with a rated mileage of 34.9m.p.g. actual highway mileage, as with all vehicles, is lower, in this case about 27m.p.g. Industry clearly needs to do better. Did the times use the rated or the actual mileage in its computation?
If two gases have molar masses M1 and M2, Graham's law states that the ratio R of their rates of effusion through a small opening is given by R = √M1/M2 . The effusion rate of an unknown gas through a small opening is measured to be 1.66 ± 0.03 times greater than theeffusion rate of carbon dioxide. The molar mass of carbon dioxide may be taken to be 44 g/mol with negligible uncertainty.a) Estimate the molar mass of the unknown gas, and find the uncertainty in the estimate.b) Find the relative uncertainty in the estimated molar mass.
The standard enthalphy of formation for one mole of methanol (CH3OH) is -239 kJ what is the value in calorie?
Flexural strength is a measure of a material's ability to resist failure in bending. The accompanying data are on flexural strength of concrete (in MegaPascal, MPa, where 1 Pa (Pascal) = 1.45 ⨯ 10−4 psi): 5.6 7.2 7.3 6.3 8.1 6.8 7.0 7.6 6.8 6.5 7.0 6.3 7.9 9.0 8.2 8.7 7.8 9.7 7.4 7.7 9.7 7.8 7.7 11.6 11.2 11.8 10.5 (a) Construct a stem-and-leaf display of the data. (Enter numbers from smallest to largest separated by spaces. Enter NONE for stems with no values.) Answer: Stems Leaves 5 6 7 8 9 10 11 What appears to be a representative strength value?Answer:____________ MPaDo the observations appear to be highly concentrated about the representative value or rather spread out? Answer: ______highly concentrated around the representative value ______spread out with a large range (b) Does the display appear to be reasonably symmetric about a representative value, or would you describe its shape in some other way? Answer: _____reasonably…

SEE MORE QUESTIONS

Recommended textbooks for you

Algebra: Structure And Method, Book 1

Algebra

ISBN:

9780395977224

Author:

Richard G. Brown, Mary P. Dolciani, Robert H. Sorgenfrey, William L. Cole

Publisher:

McDougal Littell

Mathematics For Machine Technology

Advanced Math

ISBN:

9781337798310

Author:

Peterson, John.

Publisher:

Cengage Learning,

Algebra: Structure And Method, Book 1

Algebra

ISBN:

9780395977224

Author:

Richard G. Brown, Mary P. Dolciani, Robert H. Sorgenfrey, William L. Cole

Publisher:

McDougal Littell

Mathematics For Machine Technology

Advanced Math

ISBN:

9781337798310

Author:

Peterson, John.

Publisher:

Cengage Learning,

SEE MORE TEXTBOOKS