Fuel oil in a day tank for use of an industrial boiler is tested with a hydrometer. The hydrometer reading indicates an SG = 0.919 when the temperature of the oil in the tank is 40°C. Calculate the higher heating value of the fuel using ASME formula.

Fuel oil in a day tank for use of an industrial boiler is tested with a hydrometer. The hydrometer reading indicates an SG = 0.919 when the temperature of the oil in the tank is 40°C. Calculate the higher heating value of the fuel using ASME formula.

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter16: Temperature And The Kinetic Theory Of Gases

Section: Chapter Questions

Problem 4P

See similar textbooks

Related questions

Q: 5.00 μF, 10.0 μF, and 50.0 μF capacitors are connected in series across a 12.0-V battery. What is…

A: Given: The capacitors are 5.00 μF, 10.0 μF, and 50.0 μF. The connection in series. The potential…

Q: Find the displacement value Work done=120 J Force=23 N

A: Given, Work done (W) = 120 J Force (F) = 23 N displacement (d) =?

Q: An insect subtends an angle of only 4.0 x 10-3 rad at the unaided eye when placed at the near point…

A: angle subtended by the insect at the unaided eye = 4×10-3 radposition of insect = near point for…

Q: How much energy is required to remove a proton from 157? ? (Units: MeV) The following table…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Calculate how many litters of gasoline are used in the USA in one day? Assume that there are two…

Q: An alpha particle and proton have same velocity when enter uniform magnetic field. The period of…

A: Answer:- (C) one half times that of alpha particle Because Time period of revolution in a…

Q: Question 2 The molar volume of a certain solid is 142.0 cm³ mol-¹ at 1.00 atm and 427.15 K, its…

Q: As shown, a layer of water covers a slab of material X in a beaker. A ray of light traveling upward…

Q: Assume acceleration due to gravity is -32 ft/s². A ball is thrown vertically upwards from a platform…

Q: A golf ball was hit and projected at an angle of 60° with the horizontal. If the velocity was 50.0…

Q: Given a converging lens with a focal length equivalent to 10.0 cm. Answer in Engineering Notation.…

Q: If an 8 cm doll is standing away from a diverging lens and the focal length is 6 m, find the image…

Q: 1 A BLOCK OF GLASS IS PUSHED INTO THE PATH OF THE LIGHT, AS SHOWN BELOW. THE POINT WHERE THE LIGHT…

Q: 2 particles are 10 cm away from each other A forse between them quadruples. What is the distance…

Q: Arnie's new Bug Habitat toy comes with a built-in magnifier, allowing Arnie to get a close-up view…

Q: 5. A billiard ball moving with a speed 5m/fee collides Lead-on with a second ball of equal mass at…

Q: Explore the relationship of Lenz Law to Newton’s 3rd Law of Motion, Energy Conservation, and the 2nd…

A: Lenz's law is used in electromagnetic induction to find out the direction of induced current.

Q: Mountaineers often use a rope to lower themselves down the face of a cliff (this is called…

Q: 2. A horizontal force of 1.2 N is applied to the top of a stack of pancakes 13 cm in diameter and…

Q: ya=2m 52 4x=030 P (05(50) Wsin 30 k "fx-MKN wen 30° + P sin(50) - Normal force N = W (930' + P 3in…

Q: ACTIVITY: Problem solving. Show your solutions. 1. Say that the rocket is moving at 0.95 times the…

A: There are 3 different problems asked here. As per the Bartleby policy, we will answer the first one.…

Q: A Step-Down Transformer. A transformer connected to a 120-V (rms) ac line is to supply 12.0 V (rms)…

Q: . A coin is tossed straight up. Find the (a) initial velocity when it is released if it reaches a…

Q: pushes her 25 kg grocery cart by a force of 225 N inclined at an angle of 60° with the horizontal…

A: Given:- The force on the cart is F = 225 N inclined at an angle of 60° with the horizontal. The…

Q: Patty is 5 feet and 5 inches tall while Dante is 1.6 meters. How much is the difference between the…

A: Given data: The height of Patty is h=5 ft and 5 in. The height of Dante is H=1.6 m.

Q: Use graphical method to answer the given problems. A rural mail carrier leaves the post office and…

Q: The heat of vaporization of hexane is 30.8 kJ. mol-1. The boiling point of hexane at a pressure of…

Q: Question: A particle moves in the x-y plane with an x-component of velocity in meter per second…

A: The x component of the velocity is given by…

Q: An alpha particle and proton have same velocity when enter uniform magnetic field. The period of…

A: We know thatT=2πmqBHereT=timeperiod of particleq=charge of particlem=mass of particleq=charge of…

Q: If the 10.0 μF capacitor of a heart defibrillator is charged to 9.00×10³ V, what is the energy…

A: Given Data Capacitance C = 10.0 μF Voltage V = 9×103 V Energy Stored in Capacitor W to be known?

Q: An older-model car accelerates from 0 to speed vin 15 s. A newer, more powerful sports car of the…

Q: magnetic field is B.

A: Given; A disc of mass m has a charge Q It is distributed on its surface. Rotating about XX' with an…

Q: 2.A. Assuming idealized ammeter reading of 2Amp in the schematic circuit diagram below, what are the…

Q: The current I in the loop,

A: Given; A uniform magnetic field B is applied parallel to x-axis. The current I in the loop,so that…

Q: Q9/ Steam initially at 10 bar and 0.25 dryness fraction (i.e. quality = 85%). Expands down to p2 =…

Q: The continuity equation is an expressiom of a.Conservation of mass b.Conservation of energy…

A: The continuity equation is derived after equating the masses going in and out in a given time.

Q: Suppose that F410 N (1) Figure Correct < 1 of 1 Part C Determine the magnitude of the resultant…

Q: 26.29. In the circuit shown in Fig. E26.29 the batteries have neg- ligible internal resistance and…

Q: 750 mV with series 4 A series RC circuit is connected to a voltage source. V resistance. R = 500 and…

A: We have a series RC circuit with resistance R=50 ohm, Capacitance C=20 uF=20*10-6F which is…

Q: 26.31 In the circuit shown in Fig. E26.31 all meters are idealized and the batteries have no…

Q: vectors A and B are shown in the figure. Vector C is given by C = B - A. The magnitude of vector A…

Q: A force of 3.0 pounds is needed to stretch the spring to 1.0 ft. from its natural length of 10…

Q: Find the displacement value Work done=120 J Force=23 N

A: Given: The work done is 120 J. The force is 23 N.

Q: Class Management | Help Homework 5 Extension Begin Date: 2/14/2022 12:01:00 AM -- Due Date:…

Q: Gama decay: 39 yields K 19

Q: two boys searching for buried treasure are standing underneath the same tree. One boy walks 18 m…

A: Given: The displacement of the first boy is 18 m west and 18 m north. The displacement of the second…

Q: A nuclear power plant operates at 66 % of its maximum theoretical (Carnot) efficiency between…

Q: A force F acts on the box as shown. The box is about to slide down. Determine the value of F if θ =…

Q: Differentiate alpha decay, beta decay, and gamma decay.

Q: 4. Answer the below questions using this graph. V(V) 4 6 40 30 20 10 0 0 2 a. What is Ex at 1m?…

Question

Fuel oil in a day tank for use of an industrial boiler is tested with a hydrometer. The
hydrometer reading indicates an SG = 0.919 when the temperature of the oil in the
tank is 40°C. Calculate the higher heating value of the fuel using ASME formula.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Using a numerical integration method such as Simpson's rule, find the fraction of molecules in a sample of oxygen gas at a temperature of 250 K that have speeds between 100 m/s and 150 m/s. The molar mass of oxygen (O2) is 32.0 g/mol. A precision to two significant digits is enough.
When 120 mg of naphthalene, C10H8(s), was burned in a bomb calorimeter the temperature rose by 3.05 K. The standard enthalpy of combustion of naphthalene is -5157kJ/mol Calculate the calorimeter constant?
The boiling temperature of liquid oxygen (O2) is -297.3°F. Convert this temperature to Kelvin and Celsius degrees. Given the barometric pressure of 14.7 psia (29.92 in. Hg abs), make these conversions: (a) 10 psia to psi vacuum and to Pa, (b) 15 in. Hg gauge to psia, to torrs, and to pa.
Suppose a walrus transfers energy by conduction through its blubber at the rate of 125 W when immersed in -1.25°C water. The walrus’s internal core temperature is 37.0°C, and it has a surface area of 1.85 m2. Chart attached. What is the average thickness of its blubber, in centimeters, which has the conductivity of fatty tissue?
In a standard gas grill propane tank, there is approximately 4,579 mL of propane (C3H8). At atemperature of 55˚C, the tank has a pressure of 1,798 kPa. The tank is cooled to 25˚C and the pressurereduced to 1,025 kPa. What will the new volume be?
On a walk a person burn 345 cal/h. at this rate how many hours of brisk walking would it take to lose 1 lb of body fat?
A steel tape measure is used to measure a 10 m distance at a temperature of 10oC. If it was calibrated at 22oC, by what amount in m is the measurement incorrect?
Can volumetric or electrogravimetric methods be used to measure the amount of lead in water?
Convert 2800K to the Fahrenheit scale?
A balloon is filled to a volume of 1.50 L with 3.00 moles of gas at 25 °C. With pressure and temperature held constant, what will be the volume (in L) of the balloon if 0.50 moles of gas are released? with the correct amount of sig figs
If the initial temperature of the sample is 63.5°F, what is its temperature in degrees Fahrenheit when the desired temperature increase has been achieved (3 sig fig)
In a student experiment, a constant-volume gas thermometer is calibrated in dry ice (-78.5°C) and in boiling ethyl alcohol (78.0°C). The separate pressures are 0.900 atm and 1.635 atm. (a) What value of absolute zero in degrees Celsius does the calibration yield? What pressures would be found at (b) the freezing and (c) boiling points of water? Hint : Use the linear relationship P = A + BT, where A and B are constants.