Given: 10 = 6 amperes, V1 - 7 volts, and V2 = 93 volts. Find the value of Vy (in volts). 5V, 1Ω Ig V₁ 4 Ω (+1 Μ 3 Ω Alg Io 5Ω V₂ (1+ 2Ω V

Q: what are the factors affecting breakdown voltage in gases ??

A: Factors affecting breakdown voltage in gases : There are lot of factors which affect the break…

Q: 4. Compute the pole for the transfer function H(z) z+1

A:

Q: Reduce the block diagram below to simplest form, and determine the transfer function Y(s)/R(s). Show…

A: In this question,  We need to determine the transfer function of the given control system.  We know…

Q: The armature of a d.c. The machine has a resistance of 0.25 ohm and is connected to a 300V supply.…

A: Resistance (R) = 0.25 Ω Voltage (V) = 300 V Ia = 100 (When it runs as a generator) Ia = 100 (When it…

Q: Determine which of the following sinusoids are periodic and compute their fundamental period:

A: Two discrete time signals are given, and we need to find the time period of the signal. These two…

Q: For the two gears, A and B, in Figure 3-23, compute the relative deflection in shaft 2 due to the…

A:

Q: The pulse train shown below represent average Va Hage appearing a resistance load at (R=16²) Sind.…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: Question 3 Determine the inductance at terminals A-B in the network in the figure below. Express…

A: Given, The circuit diagram is,

Q: 2. Find the Inverse Fourier Transform of: 7jw + 29 (5 + jw) (3 + jw) Hint: Treat jo as a single…

A:

Q: 1. Find Vo using superposition theorem. 30V (+ 20022 +20V 5002³ 40052 + Vo

A:

Q: 1. What is the S/N at the output of an amplifier whose NF = 10 dB and the input S/N = 25 dB? 2. A…

A: We need to find out the signal to noise at output for given noise figure .we need to find out loss…

Q: when is it desirable to connect cells in series

A: cells are connected in series when  there is requirement of increased voltage capacity. there is…

Q: Determine the current across R1 if Vi=5V.

A: The required parameter can be calculated by replacing the diode with a short circuit and then we…

Q: Calculate the electric resistance in ohms for a copper wire has a length of (8 m) and a radius of…

A: Given, The length of the wire, L=8 m The radius of the wire, r=2×10-3 m2 The resistivity of the wire…

Q: 1. In the circuit shown, determine (a) load current; (b) the load voltage and power; (c) current…

A: In this question,  We need to determine the load current, load voltage, power delivered by sources…

Q: Find R₂ (in kohms) and power (W) in the network in the figure below in order to achieve maximum…

A:

Q: Minimize the following boolean function- F(A, B, C, D) = Σm(1, 3, 4, 6, 8, 9, 11, 13, 15) + Σd(0, 2,…

A: In this question we need to  minimize the given Boolean function by using k map

Q: what are the advantages of high voltage DC transmission compared to high voltage AC ??

A: Advantages of High voltage DC transmission over high voltage ac transmission

Q: Question 4 Find the voltage V shown in the figure below. 120/0 v 10 www -j¹n + V Enter (a) the…

A:

Q: 16. Find the mesh currents is, iz, and is. 1 ΚΩ 1 ΚΩ 12 V 10 V 51 1 ΚΩ 1 ΚΩ 12 V

A: The given circuit diagram is shown below,

Q: When does large scale propagation occur? (Topic) RADIO PROPAGATION & LARGE SCALE PATH- LOSS?

A: Large scale propagation occurs due to general terrain and the density and height of buildings and…

Q: In the circuit given below, R = 20 Ω. Find vo using mesh analysis. 6Ω 11 www 60 V +201 www vo 4Ω 12…

A: Given circuit,

Q: 7-Represent in block diagram, the control system used in automatic control of speed of a wind…

A: A wind turbine is a revolving device that uses wind energy to create mechanical energy. This…

Q: Prove that if a continuous-time white noise random process with ACF rū(t) = (№₁/2)8(t) is input to…

A:

Q: Find the steady-state error for input of 2u(t) to the system below. The function u(t) is the unit…

A: Steady state error = s→0 LTSRs1+GsHs. Where R(s) is the input and G(s) is the transfer function .

Q: 2. Find the value of ix. 20V (1+) 492 wwww 492 www 1292 wwww 4A

A: Given We need to find current ix.

Q: where is the Fourier transform of the real part of the given function

A: Given, g(t) = 5t3e-4tu(t)  We need to find i)the Fourier transform of real part of g(t) and ii) The…

Q: A 600 meters copper wire is to be used for a three loads that dissipates 1600W, 795W, 1560W power…

A: Dissipation of power is the process through which heat is produced by electric or electronic…

Q: Hello. We designed and built 4-bit adder using a GAL 22V10 device. We programmed the GAL22V10 chip…

A: Ripple Carry Adder adds 2 n-bit number plus carry input  and gives n-bit sum and a carry output. The…

Q: Provide 3 example calculations involving DC Circuit under transient current conditions on series R-L…

A:

Q: Can you help me to answer this! 1. Draw and explain the atomic structure of Gallium Arsenide (GaAs)?…

A: The GaAs is a compound semiconductor made up of Gallium and arsenic. The covalent bonding If formed…

Q: A signal g(t) is produced by switching on a continuous-time signal v(t) for a limited time -0.5T ≤ t…

A: Fourier transform:

Q: Question 5: Electromagnetism A charge of -2 C and a charge of 4 C are placed 1 m apart. Where should…

A: We need to find out position of charge partical to get net force zero on it .

Q: 3. Determine the Thevenin's and Norton's equivalent circuit of the given network. IOV (+1 52 M M…

A:

Q: 14 Find the Fo. To of the following Signals using 2 2 2 +t Ans differentiation prop. F(w) = 4(…

A: The answer provided by you is not correct. Here, I am providing original solution i e using…

Q: 3. Given the discrete input signal x(n) = {-2, 5, 1, -3, 6, 4, 9, -7, 2} on the filter block diagram…

A:

Q: find the complex Fourier expansion of the periodic function shown below TT <x<2 f(x) = cosx TT 2…

A:

Q: Find the magnitude of F = 2xyz a x – 5 (x + y + z) a z in cylindrical coordinates at P ( p= 2, Ø =…

A: It is given that: F=2xyzax-5x+y+zazP=r=2,ϕ=60°,z=3

Q: Problem 3: For what emf & does the 2002 resistor in Fig.3 dis- sipate no power? Should the emf be…

A: The given question can be analysed by using the kirchhoff's law and mesh analysis. The power…

Q: Given the characteristic equation of a unitary feedback system by: S(S+40)(S+50)(S² + 205 +200) +…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: A battery, resistor, capacitor and switch are connected in series to form an RC circuit as shown…

A:

Q: (+2 0 1 V1 60V 60Hz 0° ㅔ 30uF 3 L1 60pF

A:

Q: A) Compute and plot the convolution y(t) = x(t) * h(t), where: 0 ≤t≤1 x(t) = = 2-t, 1<t≤2 = (0,…

A:

Q: The input to a half-wave rectifier is 60 Hz AC voltage. If the voltage drop across diodes is 0 V,…

A: The half-wave rectifier is used to convert the alternating current into a direct current. The…

Q: The input of a full-wave rectifier is 60 Hz AC voltage. If the voltage drop across diodes is 0 V,…

A: The rectifier is a circuit that converts alternating current into direct current. The average…

Q: Determine the forward differences y₁ [n] and y2[n], respectively, of the signals and and x₁[n]: =…

A:

Q: Complete the truth table for the given statement by filling in the required columns. -qv-p Pq TT TF…

A:

Q: Determine vo using superposition theorem. зл M +1 Vo = 22 ↑) 4A 50 W + lov

A: The given circuit is:

Q: Compute and plot the convolution y[n] = x[n] * h[n], where: -n (²) u[ − n − 1] x[n] = h[n] = u[n −…

A:

Q: In the circuit given below, R= 20 2. Calculate the mesh currents i and 12. R W 10 92 ww 40 V + Vo i₁…

A: Here we have to find the mesh currents i1 and i2.

Nodal Analysis

In the analysis of any electric circuit, nodal analysis is the method of determining the potential difference or voltage between different nodes in an electric circuit. A node is a point where two or more branches connect each other. In the nodal analysis, the voltages are determined in the terms of branch currents. The nodal analysis is also known as the node voltage method or branch current method. The nodal analysis method is one of the several applications of Kirchhoff's Current Law (KCL).