Given below are Za=Zb=Zc=(25+j5) Ω :Calculate the total average, reactive and complex powers? 200/25" Vmis-+200-95 V rms 2200/145 Vrms3-+ILAbZaZbZcON

In this question we need to find a total average, reactive and complex powers.

Answered: Given below are Za=Zb=Zc=(25+j5) Ω :…

Engineering

Electrical Engineering

Given below are Za=Zb=Zc=(25+j5) Ω : Calculate the total average, reactive and complex powers?

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter23: Resistive-inductive-capacitive Series Circuits

Section: Chapter Questions

Problem 9RQ: What is the power factor of the circuit in Question 6?

See similar textbooks

Related questions

Q: Determine the value of the current (I) and the drop voltage across the resistance (V1) Rs www 1502…

Q: 9. Find the magnetic field intensity when the flux density is 8 x 10-6 T in the medium of air. a. 1…

Q: Q3) Find which of following systems are Memory and Memoryless systems? Answer Two only a) y(t) = 3x…

Q: Briefly explain the behavior of the circuit below.

A: Given: Consider the following circuit: To find: Briefly explain the behavior of the given circuit.

Q: 720 PRACTICE PROBLEM 16.1 1 H O F 2u(1) V 492 ww + v (1) PART 3 Advanced Determine vo(t) in the…

Q: 2 Q1// Calculate the output voltage (Vout) for the amplifier RF ww 1MQ R1 www 10kQ V1 1mV- R2 20kQ…

A: In this question we will find output voltage of given operational amplifier.....

Q: A 200μF capacitor is connected in series to a 250V, 60Hz source. Assuming its resistance is 2002,…

A: For the given values of resistance, capacitance and frequency we need to compute equivalent…

Q: Q.2) A Full-wave bridge rectifier with a (400 Sin(100)t) sinusoidal input has a load resistor of…

A: For the above given question we need to calculate all the parameters of the full wave bridge…

Q: The correct BCD code of the given Decimal number 273.98 is--------------- a. 0010 1110 0011 .1001…

A: In this question we will convert given decimal number to BCD number...

Q: 50. For the system in Fig. 14.87, find the sinusoidal expression for the unknown voltage vif 60…

Q: if the wind turbine power = 9.9 watt and the speed of turbine = 184.052 rpm swap area = 0.6m what…

A: Wind turbine:- Wind turbine is used to convert wind energy into electricity. Vertical axis wind…

Q: A. For the following circuit, Determine the value of the current source (1) and the drop voltage…

Q: Provide the zero and pole, that is available for the circuit. Calculate the frequency fo

A: For the given series RLC circuit we need to calculate the value of resonance frequency, poles and…

Q: Suppose that you are sampling the following continuous-time signal:…

A: Given a continuous-time signal, Xct=A1cos5.4t+A2cos5.5t+A3cos9.9t

Q: Base on the following digital circuit design A- DD B F write the Boolean expression for F (exactly…

A: Given is a Logic gates diagram that solves a Boolean expression:- Given Circuit:-

Q: Question 8: Given a continuous-time signal xa(t) with X₁ (F) = 0 for |F| > B, determine the minimum…

A: For the above given continuous time domain signal we need to calculate sampling rates under the…

Q: 9- In AM DSB/SC, the carrier is suppressed in order to: a) simplify the receiver design b) reduce…

A: Given Multiple choice questions based on modulation techniques. Please find the below attachment…

Q: 16. This is the ability of the material to impede a flow in magnetic flux a. Resistance b.…

A: The flow of current in a straight conductor produces magnetic filed lines perpendicular to the…

Q: Explain how a full-wave rectifier using center-tapped transformer works. Please include the…

A: For the above given question we need to explain full rectifier with having center tapping…

Q: A single phase 220/6 Volt, 50 Hz transfc has a rated primary current = 0.5 A. its maximum efficiency…

Q: 19. The value of absolute permeability is: a. 1.2566 x 10-6 H cm b. 1.2566 x 10-4- cm C. 1.2566 x…

A: 19) The absolute permeability of the free space is given by u.

Q: Design 4-bit combinational circuit for a 2’s complementer, (The output generates the 2’s complement…

A: 1. Truth table Inputs: A, B, C, and D Outputs: W, X, Y, and Z

Q: For the circuit shown: 1. Find the value of "R" that makes the circuit in resonance. 2. Determine…

A: Given figure,

Q: The magnetic Frame shown is built up of iron of square cross-section, 3cm side. Each air gap is 2mm…

A: In magnetic circuit is the molecular poles and aligned and flux does not flow but in magnetic…

Q: 1. Use Mesh analysis to solve the current through j4 Ω. j4 Ω 20/30° A 1 -j2 Ω Μ W+5 j2 Ω 2 ~j5 Ω

A: Note: For the above given question it is not possible to apply mesh analysis. Because in mesh…

Q: Referring to this figure, calculate Av if yos= 20 µS. Vp in the figure is Vgs(off)

A: The required parameters can be calculated by using the DC analysis and AC analysis of FET amplifier.

Q: For the circuit shown in Fig.(4) find the value of E, such that the current in the 5+j4 2 impedance…

Q: ) The given signal below is y(t), Sketch: a) y(t+2),b) Even and c) y(t/3). 1x0 2 0 2

Q: A 400/230V, 50Hz, single phase transformer has 200 turns on high voltage side. Find turns ratio,…

A: A transformer is an electrical machine which is used in AC circuit to either step up or step down…

Q: 38. The line integral of the magnetic field intensity is given by: a. Flux density b. MMF c. Current…

A: Dear student we can solve one question at a time please post question number 39 again

Q: 1. To safeguard the MOSFETS, an electronic device called Zener diode is 2. The channel of MESFET…

A: In this question we will answers question related to MOSFET.... Note :- as per our guideline , I am…

Q: If the surface leakage current is 2nA for a reverse voltage of 25V, what is the surface leakage…

Q: Arm resistances of Wheatstone bridge are,R₁ = 200 £2 R₂ = 400 2 R₁ = 500 S R₁ = 600 Input is, E5V.…

A: A wheat stone bridge with the given resistances is shown below: The bridge output voltage is given…

Q: Provide the zero and pole, that is available for the circuit. Calculate the frequency fo

A: The given circuit can be drawn as shown below, Vin=VPsin2πft,⇒Vin=2sin2000πt.

Q: A SERIES RC CIRCUIT TAKES A CURRENT WHOSE EQUATION Is 2 sin (754t+40) AMPERE. WHEN CONNECTED TO A…

Q: [20] For the system given below, find the sinusoidal expression for the unknown current i, if 4-20 x…

A: In this question, We need to determine the sinusoidal expression for the unknown current i1 . We…

Q: 34. The inductance of a material refers to: a. Ability of the material to store magnetic field. b.…

A: In this question, We need to choose the choose the correct options As per our guidelines we are…

Q: tie-set matrix of the network

A: For tree representation of a given circuit- We will represent voltage source, resistors, capacitor,…

Q: VDD +15 V R₁ LAMP 3Ω 1 ΜΩ T MTV10N100E R₂ 2 ΜΩ Figure 12-55 14- The lamp of Fig. 12-55 is replaced…

A: Given A circuit parameters,we need to find the lamp power when it's dark. Please find the below…

Q: ra FET, graph is drawn by taking voltage VGs in X axis and drain current in Y s, if the value of X…

Q: What are the characteristics of an ideal operational amplifier?

Q: 43. Poisson's equation is equals to: a. V.VV = Pv b. V.VV=_Pv C. V.VV = 0 d. V.VV=- £ Pu 44. Which…

A: Q.43) ans:(b) Poisson's Equation states that the Laplacian of the electric potential is equal to…

Q: 26. A parallel plate capacitor is made from 25 plates, each 70 mm by 120 mm interleaved with mica of…

A: For the above given question we need to calculate thickness of the mica sheet.

Q: 41. Let J = 10y²z ax − 2x²y αy + 2x²z α₁ and find the total current crossing the surface x = 3, αz;…

A: Current: It is the time rate of the change of the charges. It is also known as the flow of the…

Q: 5. When an open circuit load is attached to one end of a transmission line, the voltage will be the…

Q: Question 2: Determine whether or not each of the following signals is periodic. In case a signal is…

Q: Compute the (9)9 09 (2) a 32 F и UF steady-state 2023 E. ĮE Eo 12v and e(t)= A 4 sin(3t+ Jolt) 30…

Q: When two identical parallel wires are 3 m apart, the inductance per unit length is 2.5 μH/m.…

A: We need to find out diameter of wire for given inductance

Q: Find vo(t) in the circuit shown in Fig. 16.9. Note that, since the voltage input is multiplied by…

A: The s-domain circuit is shown below: v(t)=e-2tu(t)Lv(t)=Le-2tu(t)V(s)=1s+2 Applying K.V.L at the…

Q: What is the resonant peak magnitude of a unity feedback closed-loop system with the following open-…

A: Given: G(s)=4s(s+2)Hs=1

Question

Given below are Za=Zb=Zc=(25+j5) Ω :

Calculate the total average, reactive and complex powers?

200/25" Vmis
-+
200-95 V rms 2
200/145 Vrms
3
-+
ILA
b
Za
Zb
Zc
ON

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The circuit is connected to a 400-Hz line with an applied voltage of 35.678 V. The resistor has a true power of 14.4 W. and there are 12.96 inductive VARs and 28.8 capacitive VARs. ET35.678VITZVAPFERIRRP14.4WELILXLVARsL12.96LECICXCVARsC28.8C
VEE =-12V, VCC = 12V, R1=9800 ohm, R2 = 3300 ohm, RC = 1800 ohm, RE = 970 ohm, B = 100 Calculate, a)IB b)Vc c)VB d)VCE e)VE
Perform the following steps for the given circuit in below.a) Find the IC, IB currents and re value.b) Find the hfe and hie values.c) Calculate the Zi, Zo, Av and Ai.d) Calculate the effect of hoe on the Av and Ai, (hoe = 25μS)
12.a. For performing dielectric-strength tests on insulating materials, two transformers are connected in aA. parallel combination.B. series combination.C. polyphase arrangement.D. cascade arrangement.12.b. A demountable stud bushing on high-voltage leads eliminates the need forA. a gasket.B. an oil stop.C. a terminal lug.D. a porcelain bushing.
For the circuit of Figure 4.8, determine the source current and the current through each of the three components. Also, draw a phasor diagram of E, vL and vR. Source voltage is 7 volts RMS NOTE: All measurements are in standard units (volts, ohms, farads) unless otherwise stated.
8. Three generators are rated as follows: Gl: 100MVA, 33kv,Xg1 = 0.1pu. G2: 150MVA,32kv.xg1 0.08pu.G3:110MVA,30kv.xg1 = 0.12pu.Determine the reactance of the generator corresponding to base values of 200MVA and 35kv.
note: please use the attached format to solve homework question, previous solution has been marked wrong which you have solved last time. Homework-1: A device has been tested under different load conditions and load currents have been recorded. Using appropriate techniques, combine the following recorded currents into one single wave i. I1= 0.866SinƟ+0.5CosƟii. I2= 0.574SinƟ-0.819CosƟiii. I3= 0.866CosƟ-0.5SinƟ
VEE =12V, VCC = 15V, RC = 1200 ohm, RE = 2700 ohm B = 50 Calculate, a)IB b)Vc c)VB d)VCE e)VE
Determine the percentage of maximum power delivered to the load resistance, when RL =3Rth
please solve it with the load being 150 MW and - 50 MVar.
Can you solve those questions please Requirements: Frequency = 7.1656×10^-5 sec Duty Cycle = 59.48% Thank you :)
B=80 V0=? Please fast...