Given: Gen 1 1500 KVA, 3Phase , 2.3 KV, 4 Poles No load speed= 1830 rpm Speed @ 1500 Kw = 1788 rpm Gen 2 5000KVA, 3 phase, 13.2 KV ,2 Poles No load Speed = 3684 rpm Speed @ 5000 Kw = 3552 rpm If the Total Load connected is 6000 Kw, A. The Power supplied by Generator 1 is... 1590.068 Kw 1690.068 Kw 1631.068 Kw 1531.068 Kw B. The power supplied by Generator 2 is.... 5390.982 Kw 4390.982 Kw 5368.982 Kw 4368.982 Kw C. The common Frequency of Generator 1 and generator 2 is .... 59.477 Hz 60.00 Hz 58.477 Hz 58.70 Hz D.The Speed of generator 1 is ...... 1720.35 RPM 1784.35 RPM 1700.35 RPM 1710.35 RPM E. The Speed of generator 2 is.. 3510.68 RPM 3520.68 RPM 3568.68 RPM 3500.68 RPM

Q: A unity negative feedback cortrol system has the following forward-path transfer function: K(s+2)…

A:

Q: 3. The instantaneous value of an ac circuit at any time t seconds is given by The instantaneous…

A:

Q: Answer the following about measuring electricity:

A: We are authorized to answer one question at a time since you have not mentioned which question you…

Q: 5. A 15-HP motor operates at full-load from a 600 V, 3-phase, 60 Hz, delta connected source. The…

A: Power: It is the rate per unit time and at this rate electrical energy is transferred by the…

Q: A resistor of 50 ohms, a 200mH inductor, and a 1.5 x 10-4 F capacitor are connected in parallel to a…

A:

Q: A No.10 AWG aluminum conductor carrying a load of 16A on a 220 V, single-phase circuit. Approximate…

A: Conductor: It is a material in which the current can flow easily without adding any doping. It has…

Q: 2. Compute the Band width of FM for each steps

A: The solution is given below

Q: A receiver has a dynamic range of 85 dB. It has 1.5 nW sensitivity (threshold). Determine the…

A: The solution is given below

Q: If 750 µA is flowing through 11 k ohms of resistance, what is the voltage drop across the resistor?

A:

Q: What kVA rating is required for a transformer that must handle a maximum load current of 8 A with a…

A: Maximum load current, I = 8 A Secondary voltage, V = 2 kV

Q: 3. Assuming that (AX-10H), (BX=100H), (DX=1000H) What happens if XLAT instruction is executed?

A: 3.Given-AX=10H=0010HBX=100H=0100HDX=1000H=1000HXLAT moves a byte from address DX*10+BX+AL to the…

Q: The following information is given in connection with a load circuit consisting of two parallel…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: 7.) Apply Kirchhoff's current law and voltage law to the circuit shown below to identify the branch…

A:

Q: A Carier wave :8 cus (2|T |S ±) to be Used for a shift Keying, eraw Bpaiosed describe the process at…

A: Fourier Transform: The Fourier transform is a mathematical function that determines the total cycle…

Q: Choose the correct answer for ten questions

A:

Q: a) Explain the two different ways for port mapping (i.e. connecting signals in module instances). b)…

A: Given   Three questions on verilog module and module instantiations.

Q: Ex. Q 3. Calculate the output voltage Vo in the circuit shown below. 100 k2 V, =0.1 V 20 k2 400 k)…

A:

Q: Home work what s meant by Nyquist rate what s meant by Pulse Moduletina need PM ?

A: Given,  We have two questions. First one is nyquist rate, and second one is pulse modulation. Please…

Q: What is the importance of compensator in control systems?   NOTE: EXPLAIN ONLY STRAIGHT TO THE POINT

A:

Q: . Which electrical quantity is measured in terms of the amount of electrons that continuously flows…

A: Current is the electrical quantity is measured in terms of amount of electrons that continuously…

Q: t=0 R1 R3 В ww 1= 0 INT 1 INT 2 V1 R2 V 30 V

A:

Q: 3. A unity feedback system with forward transfer function G(s) = 1/[s?(s+1)] is subjected to an…

A: In this question,  We need to determine the steady state error  If input is given and feedback is…

Q: Find the electric field along z-axis due to the square loop with line charge pi and four points…

A: 1) Electric field due to point chargesE1=Q4πεoaρ→aρ→3+bρ→bρ→3+cρ→cρ→3+dρ→dρ→3aρ→=bρ→=cρ→=dρ→…

Q: 10. A circuit has a real power of 230 W and a reactive power of -250 VARS. Find the Apparent power…

A: Given, P = 230 W Q = -250 VAR

Q: A 30 IL has the following data: 2L/WI 30 Q; shunt capacitive susceptance at the middle of the line,…

A:

Q: 1) If speed of a synchronous generator decresed from 1800 RPM to 900 RPM the emf of one phase become…

A: Since you have posted the MCQ question, so we will solve 3 questions for you.

Q: The following problems refer to grounding requirements. Give the source of your responses.  1. What…

A: Consider there are three sets of the parallel 350 kcmil conductors per phase. Then, by the NEC…

Q: A copper conductor wire with a total length of 100ft is used in a 15 amp common household circuit…

A:

Q: SOLVE THE FOLLOWING. SHOW COMPLETE EQUATIONS AND COMPLETE SOLUTION USING SYSTEMS OF LINEAR…

A: In this question we need to find a mesh current for the given circuit.

Q: -j2 j5 ll ーj2 Figure 1 www www

A:

Q: A set of copper conductors on a branch circuit serve a water pump motor rated at 20A. The pump is…

A: In this question,  Choose the correct options What is copper loess in the line if current flow in…

Q: Question 4 For the State Machine shown below, if two JK flip-flops are used. The input signal is A,…

A:

Q: 2. Find the inverse Fourier Transform of X (w) with the magnitude and phase spectrum below. |X(w)|…

A:

Q: Given a variable resistor R of unknown resistance connected in parallel with an inductive reactance…

A: Given, We have certain conditions. According to that we have to find the unknown resistance value.…

Q: Find the transfer function of the system using block diagram reduction express your transfer…

A: The block diagram can be reduced by considering the parallel connected and cascade connected blocks…

Q: (a) For the common base circuit shown in Fig. Q2(a), determine Ic and VCB. Assume the transistor to…

A:

Q: 10. By first resolving ¥(z)/z into partial fractions, find 2-l(z)] when ¥(z) is given by (2z + 1)(z…

A:

Q: A system has a complex conjugate root pair of multiplicity two or more in its characteristic…

A:

Q: Design an ayrton shunt ameter with ranges 1,5,10 Amp. Using a galvanometer has a 1mA full scale…

A:

Q: -  Compute voltage peak of the input. Is it equal to what you are expecting base from the set values…

A: The diodes are made of semiconductor materials. Silicon and germanium are common semiconductors for…

Q: The network shown in Figure 2 contains two voltage sources, V, = 3020° and V, = 2020°. Using mesh…

A:

Q: Derive the truth table, simplified Boolean function (equation), and draw the logical diagram:…

A:

Q: A)- Why need Modulation:-

A: In this question we discuss why we need modulation

Q: Determine the rotational speed of a 50 Hz, 6-pole three-phase induction motor operating at 50kV with…

A:

Q: Determine developed torque and shaft torque of 220-V, 4-pole series motor with 900 conductors lap-…

A:

Q: 5. In a schematic diagram, which of the following is used to illustrate how components are…

A:

Q: 2. Given that i(t) = 13.33 et-8.33 e 0.5t A for t>0 in the circuit below, find the following: a.…

A: The solution is given below

Q: 2. A 120 V, 60 Hz voltage is supplied to a circuit with an apparent power of 750 VÀ and a Power…

A: In this question we will find reactive power supplied to improve power factor....

Q: Design a combinational circuit that will function as a Binary Divider. It will accept 2 inputs, x,…

A:

Q: Consider the circuit shown in the figure. (Assume that C, = 3 µF, C, = 5 UF. C, = 6 UF, and C = 4…

A:

Synchronous Generator

In comparison to an asynchronous generator, it is a machine where the rotor speed is equal to the rotating magnetic field produced by the stator, i.e., mechanical speed is equal to the electrical speed, thus called synchronous, and not asynchronous.

Salient Pole Rotor

Salient pole rotor includes a large number of exposed poles mounted on a magnetic wheel. The construction of a bright pole is as shown in the image on the left. The proposed poles are made of metal laminations. The rotor winding is provided on these poles and is supported by pole shoes.