Given that the delivered power to a resistor is equal to P when the currer flowing in the resistor is lo. If the current increased to 5 lo, the delivere power to the resistor will be: Select one: A. 50.0 P B. 5.0 P C. 10.0 P D02 P

Given that the delivered power to a resistor is equal to P when the currer flowing in the resistor is lo. If the current increased to 5 lo, the delivere power to the resistor will be: Select one: A. 50.0 P B. 5.0 P C. 10.0 P D02 P

University Physics Volume 3

17th Edition

ISBN:9781938168185

Author:William Moebs, Jeff Sanny

Publisher:William Moebs, Jeff Sanny

Chapter9: Condensed Matter Physics

Section: Chapter Questions

Problem 78P: The base current of a transistor is 4.4 A, and its current gain 1126. What is the collector current?

See similar textbooks

Related questions

Q: For the Resistor Network Circuit a) Calculate the Current: (I) b) Calculate the Voltages: (Vab) 6 VE…

Q: Resistors A, B, and C have the same resistance R. Resistor C is connected to the rest of the cirauit…

Q: In the cirouit shown in the figure (Figure 1), the 8.0 2 resistor is consuming energy at a rate of…

Q: The power rating of a light bulb is the power it dissipates when connected across a 120 volt…

Q: A resistor R1 is conneded across the teminals of a batery. In Ammeter following cases, explain how…

A: Given: (a) Voltage is V, resistance is R, current is I. (b) number of electron, n = 5.4 x 108…

Q: A heart defibrillator is used to enable the heart to start beating if it has stopped. This is done…

A: (a) Write the formula for the power in terms of current. Substitute the known values and solve as:

Q: A battery with emf 24.0 volts and internal resistance 1=2.0 ohms is pictured in the thick-lined box…

A: EMF of battery, V=24V Internal resistance, r=2Ω External resistance, R=15Ω Let potential difference…

Q: In the jollowing citanit, what i9 the maquetuda magaituade the current in the 20-e resisto r…

Q: H.W.1 Find the voltage across the resistor 50KN as shown in figure below if using a. Voltmeter with…

Q: In the circuit shown in the figure attached, the 6.0 Ω resistor is consuming energy at a rate of 30…

A: SOlution: given that he 6.0 Ω resistor is consuming energy at a rate of 30 J/s to fond the cirrent…

Q: In the circuit shown in the figure (Figure 1), the 6.0 Ω resistor is consuming energy at a rate of…

A: The effective resistance of the two parallel 20 ohm resistance is,

Q: An A.c has a peak voltage of 42.5V fed to a 100 ohm resistor. What is the average power dissipated…

Q: An unloaded capacitor and a resistor are connected in series as in the figure. At t=0, the switch is…

A: A resistor and capacitor are connected in series with a battery. The question is about charging a…

Q: 10 Q 30 N

Q: The potential difference across a resting neuron in the human body is about 89.0 mV and carries a…

A: Given data: Potential difference (V) = 89.0 mV = 89.0×10-3 V Current (I) = 0.270 mA = 0.270×10-3 A…

Q: Given that V is the voltage across the resistor and / is the current through the resistor, the…

Q: O N resistor has 2.0 V of potential difference across it. What is the power dissipated by the stor?…

A: Given Resistance R = 10 ohm Potential difference V = 2 V

Q: 21. a. What fraction of current I goes through the 32 resistor? b. If the 92 resistor is replaced…

A: A. The current enters in the left of the junction and it will split according to the ration…

Q: Two resistors R1 = 5.0 Ω and R2 = 20.0 Ω are connected parallel and the combined resistors is…

A: Given: The resistors are R1 = 5.0 Ω and R2 = 20.0 Ω. The connection of the resistors is parallel.…

Q: Why should you NOT set up your DMM to measure current directly across a voltage source as shown…

A: Consider the DMM being set up directly across a voltage source as shown in the circuit below:

Q: Your cellphone typically consumes 400mW of power while used t text. If the phone is operated using a…

A: Ohm's law defines a linear relationship between voltage and the current of the circuit. The…

Q: 7. A 2nF capacitor with an initial charge of 5µ Cis discharged through a 2kM resistor. What is the…

Q: What does a GFCI outlet detect? A. d. Water О В. с. High resistance O C. b. Potential difference O…

A: The ground-fault circuit interrupter (GFCI): It is a instant circuit breaker designed to close the…

Q: By measuring the currents and times and then draw the current vs time graph using the measurement at…

A: ε = 8V R = 1 M Ω = 106 Ω C = 1 μF = 10-6 F I0 = 8 μA = 8 x 10-6 A To find = Current at t= 2.5 s

Q: A digital clock has a 1.2x10 4 2 resistor and is connected to a 115 V source. How much power does…

A: Given Resistance (R) = 1.2 × 104 Ω Source voltage ( V0 ) = 115 V Power is given by :- Power (P) =…

Q: r resistors A1. 2. and A3 respectively. Iinput E for the emf e. Use context clues to fgure out if…

A: Let R1=1 kilo-ohm, R2=2 kilo-ohm, R3=3 kilo-ohm & the emf of the ideal source is ε=5 Volts.…

Q: A resistor has four color bands: brown, orange, yellow, and Gold. What is its resistance? b. A 60…

A: Here, Brown → 1Orange →3Yellow → 105Gold → ±5% Therefore, the resistance is 130,000±5% ohm

Q: he power (in Watt) delivered to resistor Z

Q: How do you measure the power output of the solar cell? O a. By looking at the brightness of the LED…

Q: In a string of holiday lights, 50 lights—with a resistance of 13.5 Ω each—are connected in series.…

A: (a) 50 lights each of 13.5 Ω, V = 120 V Total resistance, R = 50 x 13.5 = 675 Ω Let the current is…

Q: (I) An electric car uses a 45-kW (160-hp) motor. If the battery pack is designed for 340 V, what…

A: The electrical power is given by, P=VI Here, V is voltage and I is current. Given : Voltage V=340…

Q: D Two 402 resis to os and a 202 resistor are all Connected in parallel with g 1av power supply Their…

Q: If a 1500-W hair dryer is connected to a 120-V line. What is the maximum current drawn? I = What is…

A: Electric power is given by P = I×V And by Ohm's law, V = IR

Q: Rz =3,002 Ri =4.00r ; R- 3.002 = R, = 4,0ar Ei=10,0V %3D Ez=26,0V The ciruit shown in the fiqure…

Q: 4. An RC circuit has an emf of 10 sin t volts, a resistance of 120 ohms, a capacitance of 0.5 farad,…

Q: a 5-Ω, a 10-Ω, and a 15-Ω resistor are connected in parallel to a power source. a. which resistor…

Q: (II) A hair dryer draws 13.5 A when plugged into a 120-Vline. (a) What is its resistance? (b) How…

A: Given: The hair dryer draws current is I=13.5 A. The voltage of line is V=120 V. The time of current…

Q: In the circuit below, the total power dissipated by the circuit is 48 W. What is the value of the…

A: The expression for the power in terms of resistor is, Rearrange the above expression in terms of…

Q: The human body can exhibit a wide range of resistancesto current depending on the path of the…

A: Given:Resistance = 1 X 106 ohmCurrent = 500 mA

Q: Problem 1: Consider a resistor like the one shown in the figure, with the current moving in the…

Q: 3.3 a) Find the value of R that will cause 4 A of current to flow through the 80 N resistor ir the…

A: 40 ohm and 80 ohm resistors are in series , their equivalent resistance = 40 + 80 = 120 ohm Total…

Q: A flashlight with a resistance RF requires 4 V to operate normally, but only a 12 V source is…

Q: The hot resistance of a flashlight bulb is 1.93, and it is run by a 1.58-V alkaline cell having a…

A: Given data: Resistance of flashlight (R) = 1.93 Ω Emf (ε) = 1.58 V Internal resistance (r) = 0.100…

Q: Does the current in this circuit flow clockwise or counterclockwise? What is the voltage difference…

A: Here current is positive. That is current is clockwise direction.

Q: Qu 5 In a series circuit, a capacitor C is being charged through a resistor R using a cell of emf E…

Question

Given that the delivered power to a
resistor is equal to P when the current
flowing in the resistor is lo. If the
current increased to 5 lo, the delivered
power to the resistor will be:
Select one:
A. 50.0 P
B. 5.0 P
C. 10.0 P
D. 0.2 P
O E. 25.0 P

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

What semiconductor is frequently used for its high reliability at high speed? Explain why.
Q.1: A transistor has a collector current of 10 mA and a base current of 40 micro-A. What is the current gain of the transistor? A transistor has a current gain of 175. If the base current is 0.1 mA, what is the collector current? A transistor has a collector current of 100 mA and the current gain is 65, What is the emitter current? Q.2: Suppose you measure a VBE of 1v. What is the collector-emitter voltage? What is the collector-emitter voltage in the three preceding examples if the base supply voltage is 5v?
The base current of a transistor is 4.4 A, and its current gain 1126. What is the collector current?
A particular electronic-code lock provides over 500 billion combinations. Moreover, it can sustain an electric shock of 168286 V. Suppose this potential difference is applied across a series connection of the following resistors: 14.2 kΩ, 33.9 kΩ, and 239.3 kΩ. What current would pass through the resistors?
Based on the energy band gap working principle, (i) Plot the output of a semiconductor temperature sensor. (ii) Explain the underlying physics which contribute to the output behavior of the semiconductor temperature sensor (plotted in Q1 (c)(i)). (iii) Explain one drawback of using this semiconductor temperature sensor.
For the given resistor combination circuit, determine (a) the equivalent resistance(show simplification of circuits), (b) the current demanded from the 15V voltagesource (neglecting internal resistance), (c) the potential drop across eachresistor, and (d) the current across each resistor.
Photon energy of the light with a given wavelength could be calculated by the following equation (attached in this QnA post):*hint: wavelength of light is not in SI unit, unit conversion is needed. What is the band gap of the semiconductor, if it can only be excited by the light with wavelength equal to or smaller than 500 nm?*hint: the photon energy needs to be greater or equal to the band gap, in order to excite the semiconductor
A silicon crystal having a cross-sectional area of 0.001cm? and a length of 10°cm is connected at it s ends with 10v battery at temperature 300°K, when the current is 100mA. Find the resistivity and the conductivity?
How does the resistance of: i) a semiconductor ii) an alloy vary with temperature?
The Type K thermocouple has a sensitivity of about 41 micro-Volts/℃, i.e. for each degree difference in the junction temperature, the output changes by 41 micro-Volts. If you have a 32-bit ADC, what is the smallest temperature change you can detect if the ADC range is 10 V? Try leaving the answer as a decimal with significant digits: e.g., 0.00004100.
Determine VL, IL, IZ and IR considering that the following values for R = 2.7 k ohms, RL = 450 ohms, with a power supply Vi = 50 V. Using a zener diode with a Vz = 10 V and an IZM = 32 mA. Check to see if the zener conducts with that arrangement. In the case of not driving, what arrangement do you have to make to achieve the diode conducts and stays within the safety margins indicated.
Do you think the resistor you measured are generally within tolerance? What evidence support your answer ?