Given that the material is a silver where = 61.7 x 106 S/m. Assume that same current crosses both the inner and outer curved surfaces. Determine the resistance between the inner and outer curved surfaces in nano-ohms. h = 0.5 m P =50 Po= 4.0 m Pa= 0.5 m

Given that the material is a silver where = 61.7 x 106 S/m. Assume that same current crosses both the inner and outer curved surfaces. Determine the resistance between the inner and outer curved surfaces in nano-ohms. h = 0.5 m P =50 Po= 4.0 m Pa= 0.5 m

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter17: Current And Resistance

Section: Chapter Questions

Problem 58AP

See similar textbooks

Related questions

Q: A battery with an emf of 15 V delivers 374.1 mA to a 35 Ω load. a. What is the internal resistance…

A: Given, EMF of the battery = 15 V = E Current delivered by the battery = 374.1 mA =I Load resistance…

Q: 10.0 m + 8.0 m A 2.4 kg flower pot is on a shelf 10.0 meters above the floor. How much work was done…

Q: Find the gravitational potential energy of a light that a mass of 3 kg and is 5 m above the ground.

Q: You rode a roller coaster with a total path length of 250 meters. After 3 rides, how much is your…

A: Displacement = it is the shortest distance between initial and final points.

Q: 20 A golf ball lands on green grasses, the collision is inelastic because of the change in energy…

A: In golf ball experiment, when the ball is falling towards the ground from a maximum point it's…

Q: A football was kicked at an angle of 30 degrees, with a given initial velocity of 50 m/s. What is…

A: Please note : As per answering guidelines I can answer the first question only. Since, this is not a…

Q: If the resistors were replaced with light bulbs, which light bulb will glow the dimmest? You may use…

Q: A disk rotates about its central axis starting from rest and accelerates with constant angular…

Q: can you answer d please? (d) Draw the velocity vectors,  and the resultant velocity vector at this…

Q: Is there a difference in viewing angle to the Sun from opposite sides of the Earth?

Q: 18 A ball of modeling clay is dropped on the floor. Is the collision of the ball likely elastic or…

A: Since the kinetic energy of clay will not be conserved during the collision. Hence the collision…

Q: Let three equations of the model take these forms: 1 -3U + 1 dn 3 (р — п) dt dU 1 (т - р) -- dt a.…

Q: Please draw the magnetic field lines in the picture.

A: The magnetic field lines always begin from the N-pole of a magnet and end on the S-pole of the…

Q: A nichrome wire has a resistance of 12 Ω at 0 oC. Calculate its resistance when placed in a hot…

A: Formula

Q: Which of the following can be different for observers in two different inertial frames? (Select all…

A: To identify : The quantities which can be different for observers in two different inertial frames…

Q: For the given figure, the weight of the 9-ft bar is 5 lb. The moment of the tension in the cord…

A: Given: The weight of the bar is 5 lb. The length of the bar is 9 ft.

Q: A mass of 3 kg is attached with a spring constant of 12. I released the mass from a point of 0.1 m…

A: From the given data we can construct the differential equation.

Q: Whale and Kanmuro are two islands located at the Chimera archipelago. These two are separated by a…

A: In the given question, Distance of wire link (L) = 23 miles = 23×1.5 km = 34.5 km = 34500m Power…

Q: There is a light source provide 2000 lumens, which illuminates a surface given with a length of 9 m…

A: Given Light intensity L = 2000 lumens Length l = 9m Width w =8m To find Illuminance Solution…

Q: How many coulombs of charge pass through a cell if 2.20 amperes of current are passed through the…

A: Given: Current(I) = 2.20 Amperes Time (t) = 20 minutes = 20x60 = 1200 secs To find:…

Q: Which of the statement describes about "Ultraviolet Catastrophe"? A. Rayleigh-Jeans wavelength B.…

A: Answer is option A. Rayleigh-Jeans wavelength

Q: When light passes from air into water, the frequency of the light remains the same. What happens to…

Q: How much time does it take to lift 350 kg

A: Given; Determine the time does it take to lift 350 kgto a height,h=40 m Where it develops power of…

Q: ASAP PLS HUHU. A 100-N block on a rough 30o-incline is acted upon by a force P as shown causing it…

A: We need to draw the FBD of the block and also calculate the force P applied on the block in order to…

Q: DOES AN OJECT AT REST HAVE MOMENTUM? WHY OR WHY NOT? * efe WHAT ASSUMPTIONS WILL YOU MAKE REGARDING…

A: What is implied by a negative value of acceleration

Q: A charge if 20 C was passed through wire in 16 minutes. Calculate the average electric current…

A: Given value--- Charge = 20 C . time = 16 min . We have to find--- current through wire ?

Q: A typical flashlight battery will produce a 0.5 A current for about 3 hours before losing its…

Q: Find the value of kinetic energy stored in car having mass of 2.48 kg moving with velocity 0.45 m/s

A: Given data : Velocity=V Mass=m Required : Kinetic energy

Q: Calculate the value of work done Force applied on crate3D20 N Distance moved by crate=2.02 m

A: Given data : Force applied on crate=F Distance moved by crate=d Required : Work done

Q: Find the value of R so that the power of 10k2 load resistor is 10mW, by assuming the source voltage…

A: This is an op-amp and the given circuit is a noninverting amplifier. Given(s): The input voltage,…

Q: particle with a charge of -1.24 x 10-8 C moves with instantaneous velocity v (4.19 x 104 m/s)î +…

Q: Determine the direction of the force of the proton. I'll upvote if complete and typewritten. Do not…

A: Given : Velocity (v) is towards left Magnetic field (B) is out of the page

Q: coup B Questions Present a brief explanation of how changes in gas pressure relates to your ability…

A: Present a brief explanantion of how change in gas pressure relate to breathe .

Q: Part A At a particular instant, charge qı = 4.50x10-6 C is at the point (0, 0.250 m, 0) and has…

Q: Find the value of final speed of car Initial velocity=2.05 m/s

A: Given data : Initial velocity=U Acceleration=a Time=t Required : Final velocity

Q: Determine the momentum of a car having mass 200 kg moving with a velocity 34 m/s

A: Given data : Mass = m Velocity = v To find…

Q: The dielectric materials used for region A, B, and C are air (e = 1), mylar (e =3.2), and teflon (e…

Q: A major difference between light and sound is that light is a(n). wave and does not require a A…

A: Explanation-: This is a question fill in the blank. We have a property of light, light is an…

Q: a. In the ancient times, people thought that the Sun is revolving around the Earth because of how we…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub parts for…

Q: Find the distance between two slits that produces the first minimum for 430-nm violet light at an…

Q: Find the gravitational potential energy of a light that a mass of 3 kg and is 5 m above the ground.

A: Given, Mass=3kg Height=5m Acceleration due to gravity=9.8m/s²

Q: Protons in an accelerator at the Fermi National Laboratory near Chicago are accelerated to a total…

Q: The thermodynamic process represented by the diagram is Work Pressure Q = AU + W Heat Q Volume…

A: Here change in internal energy is zero so their is no change in temperature of system so this…

Q: What is the current flowing into the 1-ohm resistor? 3.00 Ω 18.0 V 4.00 N -2.00 N 1.00 N

A: The total current drawn from the battery by the circuit is i=VReq, where Req is the equivalent…

Q: If the wavelength l of the Xrays is too large relative to the spacing of planes in the crystal, no…

A: Given, The sin θ = 1 set of planes separated by d = 4.20 Å n = 1 From Bragg's law, we know, 2d sin…

Q: Find the value of force applied if work done is 280 J and displacement is 20 m

A: Force applied o the object is identified by the Force=WorkdoneDisplacement

Q: For the given figure, the weight of the 12-ft bar is 5 lb. The moment of the tension in the cord…

A: Given: The length of the bar is 12 ft. The weight of the bar is 5 lb.

Q: The kinetic energy of the

A: Given; A block of mass,m=2 kg with a speed=5 m/s AT t=0 F=(3+2t)N Determine the KE of the block…

Q: would a 100% efficient engine violate the first law of thermodynamics? What about a workless…

A: would a 100% efficient engine violate the first law of thermodynamics? What about a workless…

Q: d) What is the the velocity of the truck when it's at ¾ the length of the ramp?

Concept explainers

Resistivity

Resistivity is a characteristic property of the conductor’s material that measures the extent to which the material opposes the flow of current. It is denoted by the Greek letter “rho”. Electrical resistivity, also known as specific resistance, depends on the nature of the material of the conductor and is unaffected by its dimensions.

Question

Given that the material is a silver where = 61.7 x 106 S/m. Assume that same current crosses both the inner and outer curved surfaces. Determine the resistance between the inner and outer curved surfaces in nano-ohms.
h = 0.5 m
Pb= 4.0 m
P =50
Pa= 0.5 m

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A 0.900-V potential difference is maintained across a 1.50-m length of tungsten wire that has a cross-sectional area of 0.600 mm2. What is the current in the wire?
Resistors are commonly rated at 18W,14W,12W ,1 W and 2 W for use in electrical circuits. If a current of1 = 2.00 A is accidentally passed through a R=1.00 resistor rated at 1 W, what would be the most probable outcome? Is there anything that can be done to prevent such an accident?
If the current carried by a conductor is doubled, what happens to (a) the charge carrier density, (b) the current density, (c) the electron drift velocity, and (d) the average time interval between collisions?
Consider a wire of a circular cross-section with a radius of R = 3.00mm. The magnitude of the currentdensity is modeled as J=cr2=5.00106Am4r2 . Whatis the current through the inner section of the wire from the center to r = 0.5R?
Explain why R=R0(1 + a?T) for the temperature variation of the resistance R of an object is not as accurate as P=P0(1 + a?T) which gives the temperature variation of resistivity P.
The potential difference across the filament of a light-bulb is maintained at a constant value while equilibrium temperature is being reached. The steady-state current in the bulb is only one-tenth of the current drawn by the bulb when it is first turned on. If the temperature coefficient of resistivity for the bulb at 20.0C is 0.004 50 (C)-1 and the resistance increases linearly with increasing temperature, what is the final operating temperature of the filament?
An aluminum wire 1.628 mm in diameter (14-gauge) carries a current of 3.00 amps, (a) What is the absolute value of the charge density in the wire? (b) What is the drift velocity of the electrons? (c) What would be the drift velocity if the same gauge copper were used instead of aluminum? The density of copper is 8.96 g/cm3 and thedensity of aluminum is 2.70 g/cm3. The molar mass ofaluminum is 26.98 g/mol and the molar mass of copper is 63.5 g/mol. Assume each atom of metal contributes one free electron.
Consider a resistor made from a hollow cylinder of carbon as shown below. The inner radius of the cylinder is Ri= 0.20 mm and the outer radius is R0 = 0.30 mm. The length of the resistor is L = 0.90 mm. The resistivity of the carbon is =3.5105 m. (a) Prove that theresistance perpendicular from the axis is R=2L1n(R0Ri) . (b) What is the resistance?
Consider a power plant is located 60 km away from a residential area uses Q-gauge (A=42.40mm2) wire ofcopper to transmit power at a current of I = 100.00 A.How much more power is dissipated in the copper wires than it would be in superconducting wires?
What current flows through a 2.74 cm diameter rod of pure silicon that is 25.0 cm long, when 1000 V is applied to it? (Such a rod may be used to make nuclear particle detectors, for example.) The resistivity of pure silicon is 2.30 103 Ω · m. _____A
A current of I = 7.3 A is passing through a conductor with cross sectional area A = 6.5 × 10-4 m2. The charge carriers in the conductor, electrons, have a number density n = 2.1 x 1027 m-3. Calculate the numerical value of the drift velocity, v, in m/s. vd =