Given the following circuit of a heater R3 The Voltage of the battery is 120 Volts. The three heaters are identical R1=R2=R3=R. Find the value of R that will ensure that the total power of the heater is 3600 Watts.

Given the following circuit of a heater R3 The Voltage of the battery is 120 Volts. The three heaters are identical R1=R2=R3=R. Find the value of R that will ensure that the total power of the heater is 3600 Watts.

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 3CQ: The ignition circuit of an automobile is powered by a 12-V battery. How are we able generate large...

See similar textbooks

Related questions

Q: Consider the following electric circuit. If the emf in the electric circuit is 12V and the…

A: In series connection , resistors are connects in following pattern - REqu=R1+R2+R3+....Rn .....(1)…

Q: Consider the circuit shown in the figure. A short time after closing the switch, the charge on the…

A: To solve this problem, we will use the concept of discharging RC circuit .

Q: Suppose the voltage output of the battery in Figure 2 is 10.0 V, and the resistances are R1 = 2.00…

Q: A voltage of Vø is applied from the battery to the RC circuit as shown in the figure. The potential…

Q: What is the total power in the circuit? R 20 Rg R. 6V

A: The equivalent resistance of the series combination is R=R1+R2 Here R1 and R2 is resistance. The…

Q: The capacitor in an RC circuit 1R = 120 Ω, C = 45 mF2 is initiallyuncharged. Find (a) the charge on…

Q: 3. Two Resistances R1 = 3 N and R2 = 6 N are connected in series with an ideal battery supplying a…

A: R1 = 3 ohm R2 = 6 ohm ∆V = 9 volts

Q: In the circuit in Figure 2, Iş = 100(mA) and Rg = 10kN. It is required that the current through Rị…

A: IS = 100 mA RS = 10 kΩ Current through R1 , I1 = 25 mA Current through R2, I2 = 50 mA Let the…

Q: Two circuits made up of identical ideal emf devices (Ɛ = 1.71 V) and resistors (R = 36.2 N) are…

Q: to the nature of this problem, do not use rounded intermediate values in your calculations- nitted…

A: Given:- A circuit with the resistance and voltage is given as The resistance are given as R1 = 6…

Q: In the circuit given below. I1= 3.00A. What is the current of I5?

A: Given data: The electrical circuit I1 = 3.00 A Required: The current I5

Q: Consider the circuit shown in the figure. Let the equivalent resistance of the circuit when the…

A: Refer the circuit. When switch is open/closed The equivalent resistance is calculated below. Also…

Q: A charged capacitor is connected to a resistor and a switch as in the figure below. The circuit has…

Q: Find the time constant of the circuit shown in the figure. Given: R1 = 6 x 106 ohm, R2 = 7 x10° ohm,…

Q: Consider an electric circuit containing a capacitor, resistor, and battery; see the figure. The…

A: It is a simple RC circuit where the charge Q satisfies the equation RdQdt+QC=V where R is the…

Q: Consider a series RC circuit as in the figure below for which R = 9.00 MQ, C = 1.00 µF, and ɛ = 28.0…

A: a) Time constant = RC = 9000000 * 0.000001 = 9 seconds

Q: What value of resistor R gives the circuit in (Figure 1) a time constant of 18 μs?

A: Time constant in LR circuit ζ = L / R =18 μs L =7.5 m H R 1 = 200Ω R2 = R Req = 200+R…

Q: Shown in the figure below is an RC circuit. At t=0, the capacitor already contains a charge and as a…

Q: What is the current read by the ammeter in the circuit below? Let: R1 = 1 kiloohm. R2 = 2 kiloohm.…

A: Given Data: The resistors are, R1=1 kΩ, R2=2 kΩ, R3=3 kΩ. The emf is, V = 5 V. The current can be…

Q: Consider a circuit that consists of a real battery with an emf ε and an internal resistance of r…

A: Internal resistance of the battery = r The emf of the battery = The battery is connected to a…

Q: Consider a series RC circuit as in the figure below for which R = 9.00 MΩ, C = 4.00 µF, and = 29.0…

Q: If the emf is 7.01 V, the capacitance 14.6 µF, and the resistance 282 2, find the time constant of…

Q: For the circuit below (with Rot=8002), determine: a) Direction and magnitude of current. b) Voltage…

A: To solve the given question we will use Ohm's law i.e. if the current through a resistance 'R' is…

Q: In a combination circuit of 3 resistors R1 , R2 and R3 , R2 and R3 are in parallel on right and…

A: Consider the following circuit diagram which represents the given situation. 1. The equivalent…

Q: 4. Consider the RC circuit indicated at right!. (a) Calculate the time constant for the circuit T=…

Q: Ohm's law gives the relationship between voltage, resistance, and current in a simple circuit: V =…

A: Note: ''To get remaining sub-part solved please repost the complete question and mention the subpart…

Q: Consider the circuit shown in the figure. A) Let the equivalent resistance of the circuit when the…

Q: . A resistance of R2 is connected in series with a parallel circuit comprising two resistances of…

Q: Given the following series circuit R, R, R, 100 2 300 2 50 Ω 9 V Calculate the current I of the…

Q: Consider the circuit shown in the figure. Suppose that R = 7.0 kΩ What is the time constant for the…

Q: estimate the equivalence capacitance of the following circuit.

Q: What is the diameter of a (1.07x10^0) m length of tungsten wire whoseesistance is (2.300x10^-1) ohm?…

Q: Constants In (Figure 1), the total resistance is 11.0 kN, and the battery's emf is 24.0 V. The time…

Q: For the circuit shown in the figure, C = 12 uF and R = 8.5 MQ. Initially the switch S is open with…

A: Given: Capacitance C = 12 μF Resistance R = 8.5 MΩ Vo=80 V.

Q: Please provide help for the following question.

A: (a) Consider the circuit diagram with the directions of the currents flowing in the circuit.

Q: tor In the three circuits in the drawing has the same resistance R, and the batteries have the same…

A: Resistance,(R)=9 Ω -----(1) [Given] [It's same through each resisitor] Voltage,(V)=6 V -----(2)…

Q: 122 ww d 152 a ww 10 Ω I 50 V

Q: In the circuit shown, Find the value of the resistor R, for | = 30 mA. 510 Ω R 100 mA Select one: a.…

A: Given An electrical circuit The current source provides 100ma I=30 ma Let current on other branch…

Q: Consider the circuit shown below where the battery has an emf of & = 93 V, the resistors have the…

A: Just after closing the switch in the circuit, the capacitor will initially behave as a plain wire…

Q: What is the current read by the ammeter in the circuit below? Let R1 = 1 kiloohm, R2 = 2 kiloohm, R3…

A: general formula for current, I =VRcurrent across the resistor R1I1=VR1=51mA=5 mAcurrent across the…

Q: Consider the circuit shown in Figure 4. The emf source has negligible inte resistance. The resistors…

A: When the resistance and capacitance are in parallel then the potential difference across them is the…

Q: Consider the circuit shown. Assume that the battery connected is ideal. Let V = 16V, C = 2µF, R1 =…

A: Given: Source voltage, V1=16 V C1=2 μF=2×10-6 F R1=1 kΩ =103 ΩR2=R3=R4=13 kΩ =13×103 Ω

Q: Consider the circuit shown in the figure. A short time after closing the switch, the charge on the…

A: Given: The time constant is 17.7 s. The final charge on the capacitor is 90% of the itnial charge.

Q: In the figure shown the total resistance is 30 kQ, and battery's emf is 18 V. If the time constant…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Question

Given the following circuit of a heater
R3
The Voltage of the battery is 120 Volts. The three heaters are identical R1=R2=R3=R. Find the value of R
that will ensure that the total power of the heater is 3600 Watts.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The ignition circuit of an automobile is powered by a 12-V battery. How are we able generate large voltages with this power source?
Why do transmission lines operate at very hig1 voltages while household circuits operate at fairly small voltages?
Check Your Understanding In considering the following schematic and the power supplied and consumed by a circuit, will a voltage source always provide power to the circuit, or can a voltage source consume power?
An ideal battery has an emf of 150V on the left side and a second emf on the right side of 50V. If R1 is 3Ω and R2 is 2Ω what is the current in the circuit and which direction does it go?
When the switch S is open, the voltmeter V of the battery reads 3.05 V. When the switch is closed, the voltmeter reading drops to 2.88 V, and the ammeter A reads 1.57 A. Find the (a) emf, (b) internal resistance r of the battery, and (c) circuit resistance R. Assume that the two meters are ideal, so they don’t affect the circuit.
In the circuit below, the capacitor starts out uncharged. The resistance is R = 118 Ω, capacitance is C = 0.0647 F, and the battery emf is 16.7 V. What is the charge (Q) on the capacitor at a time of t = 3.72 seconds after the switch is closed?
An emf of 10 V is connected to a series RC circuit consisting ofa resistor of 2.0 x 106 Ω and an initially uncharged capacitorof 3.0 µF. Find the time required for the charge on the capacitorto reach 90% of its final value.
In the circuit below each capacitor initially has a charge of magnitude 3.50 nC on its plates. After the switch S is closed, what will be the current in the circuit at the instant that the capacitors have lost 80.0% of their initial stored energy?
Given the circuit, where the rate at which R1 is dissipating electrical energy is20.0W. When the total current flowing in the circuit is 3.50A, find:a.) R1 and R2 (4pts)b.) Emf of the battery (2pts)c.) Current through both R2 and the 10.0-ohm resistance (4pts)d.) What is the total electrical consumption
In the circuit shown, the battery has EMF of c=32 V. At what rate is thermal energy being generated in the 60 resistor? (Ignore the internal resistance of the battery)
A loop circuit has a resistance of R1 and a current of 1.9 A. The current is reduced to1.6 A when an additional 4.8 Ω resistor isadded in series with R1.What is the value of R1? Assume the internal resistance of the source of emf is zero.Answer in units of Ω.
Consider a series RC circuit for which R = 1.00 MΩ, C = 5.00 μF, and ε = 30.0 V. Find (a) the time constant of the circuit and (b) the maximum charge on the capacitor after the switch is closed. (c) Find the current in the resistor 10.0 s after the switch is closed.