Given the information appearing in the multiple-feedback BPF, calculate fo

Q: 3. The insulation used in high voltage circuit breakers of large power rating is (a) air (b) vacuum…

A: In this question,   We need to determine the insulation used in high voltage circuit breaker of…

Q: What is the total number of systems?

A:

Q: The FIR filter which its transfer function H(z)= can be realized as shown in figure below +) -1 1/5…

A:

Q: If the equation of the phase C line voltage is -250 sin (wt + 30°) volts. What is the equation of…

A:

Q: ОP-AMPS Derive the value of Vout in terms of V1, V2, R1, R2, Rf in the circuit below. V1 R1 1k2 1V…

A: In this question,   We need to derive the value of Vout  in terms of V1, V2, R1 and R2 and Rf  .

Q: Design a sequential circuit with two D flip-flops and two input x and y. When x=0, the state remains…

A: The state table is a tabular representation of the behavior of the system for different inputs and…

Q: Problem 10: The current through a 0.1 H coil is given. What is the sinusoidal expression for the…

A:

Q: An iron-ring of mean length 30 cm is made of three pieces of cast iron, each has the same length but…

A: Part1 : Air gap is given by 0.5mm,  Flux density B=0.5 Wb/m2 Magnetic field intensity…

Q: 18 V (B] Given the measurement VS = 1.7 V for the network of the following figure determine: 2 kn a.…

A: MOSFET: It is a semiconductor device that has a very high switching frequency in their group…

Q: What power density (W/m^2) is required to produce electric field strength of 100 volts per meter in…

A:

Q: 2. Assume your supervisor has asked you to determine the power developed by the 50 V source in the…

A: Given: Consider the given circuit: To find: Assume your supervisor has asked you to determine the…

Q: 1 X(2or the sequence x(n) = 2"-3 u(n - 3)is z-3 (1-2z-3)

A: The solution is given below

Q: What is/are the advantage/s of using lamps with a high value of CRI than that of low valued CRI?

A: CRI stands for color rendering index.  It is the ability to distinguish between the colours.

Q: What is a transistor and what it’s used  for ?

A:

Q: An industrial load consumes 94 kW at a power factor (pf) of 0.83 lagging from 490 Vrms line. The…

A: The solution is given below

Q: O Discuss the significance of the back emf in the operation of a DC Motor. (i) A shunt DC motor…

A:

Q: it. Find the current induced in the loop. radius cm and resistance10 k, is placed inside the…

A:

Q: What are oscilloscope used for?

A: We need to state the use of an oscilloscope.

Q: Given the discrete time signal x[n] = cos((πn)/3)   what are two different contiuous time signals…

A:

Q: 2. By nodal analysis, determine the voltage V, in the circuit shown. 2n jsn v. -jos 20n

A: In this question we will find nodal voltage V2....

Q: 50. Find the rms value of the periodic waveform in Fig. 101 over one full cycle. I ycle 6 7 $ 9 D 11…

A: We need to find out RMS value for waveform .p

Q: Problem 54: Express the following phasor currents and voltages as sine waves for f = 60 Hz. Notice…

A:

Q: CPU is the heart of the PLC. Define CPU and explain its function

A: CPU stands for central processing unit. It process the instructions that are written in the line of…

Q: The two conducting planes illustrated in Figure 6.14 are defined by 0.001 <p< 0.120 m, 0 < z < 0.1…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: 9- Why the gain of the amplifier in the low frequency side decrease when the frequency decrease for…

A: As per the guidelines of bartleyby I need to answer first three questions only so Kindle repost…

Q: In the following circuit, If

A:

Q: Draw block diagram /circuit diagram of the ff. FM circuits and discuss the operation.  D. PHASE…

A: Phase locked loop works on the same principle as synchronous detector.

Q: 4,1 ka 4.1 ka 20 k2 20 k2 20 ka 0.05 uF 10 k2 c0.02 µF

A:

Q: 42. Find the average value of the periodic waveform of Fig. 95 over one full cycle. i (mA) +30 3 4…

A: In this question,   We need to determine the average value of the periodic waveform?

Q: 3z2-7z X(z) for the sequence x(n) =2 u(n) + 3" u(n) is (z-1)(z-3)

A:

Q: 51. What are the average and ms values of the square wave in Fig. 102? -I eycle- 10 1as) FIG. 102

A: In this question,   We need to determine the average value and rms value?

Q: A 480 Volts, 60HZ, 50Hp, three-phase induction motor is drawing 50 Amperes at 0.85 power factor…

A:

Q: The figure represents the equivalent circuit of a single-phase transformer, if after doing the…

A:

Q: . Find the transfer function V.(s) R1 R2

A: The solution is given below

Q: Problem 5: The current through a 6.8 kN resistor is as indicated. Find the sinusoidal expression for…

A:

Q: R1 = R'2 = 0.08 Q X1 = X'2 = 0.2 Q Re = 1000 Q; Xm = 400 Q It is supplied to the load Z' at 240 V, 6…

A:

Q: Discuss the importance of the capability curve of a synchronous machine. Explain how a capability…

A:

Q: 6. The instantaneous value of current is i = 2 sin (377t + 60 ), determine at what time i= 1.8…

A:

Q: The ROC is null for the sequence x(n) = 2" u(n)-)" u(-n – 1)

A:

Q: igure 6 (a) shows the circuit diagram for a differential amplifier. You may assulne hat M, and Ma…

A: Solution- a) It is a different amplier (single stage) . Its role in three stage opamp to provide…

Q: find i, v, w in all devices. 1 H 0.25 F + v,(t) | sin(2t) A +. 4 Ω. V.

A:

Q: 3. If w = 240 rad/sec, what are the period (time) and frequency? How many cycles %3D occur in 27…

A:

Q: A sampling process uses a sampling rate of x. Determine which of the following input signal…

A: According to the question, a sampling process uses a sampling rate of x. Determine which of the…

Q: (WA m roblem #1: Five capacitors of 150 µF, 10 µF, 8 µF, 12 µF and 20 µF are given a) Find the total…

A: The solution is given below

Q: Problem 48: Perform the following operations, and express your answer in rectangular form:…

A:

Q: i, = 3 sin(377t + 60°) R1.2 N XL 1.20 Ω Χ. 20 Xc

A:

Q: W. Find the current I in the following network: V = 10/20° V ZR = 20 Z = j2N { ZR = 40 %3D

A:

Q: Electrical Circuit Analysis Lab. 3. Calculate the value of the load for maximum power transter and…

A:

Q: Q3: Explain with aid of figures and equations the type of quantization and the quantization error.…

A: The quantization is a process of converting an analog signal into an equivalent digital signal. This…

Q: 3.16 An electric flux density is given by D = Do a,, where Do is a given constant. (a) What charge…

A: flux density is a vector quantity it measure the strength and direction of magnetic filed line near…

Power Amplifier

The power amplifier is an electronic amplifier designed to maximize the signal strength of a given input. The input signal strength is enhanced to a high enough level to drive output devices such as speakers, headphones, RF (Radio frequency) transmitters, etc. Unlike voltage / current amplifiers, the power amplifier is designed to drive core loads directly and is used as a storage block in the amplifier series.

Maximum Efficiency Criterion

In every field of engineering, there is a tremendous use of the machine and all those machines are equipped for their popular work efficiency so it very much important for operation engineers to monitor the efficiency of the machine, planning engineers to check out the efficiency of the machine before installing the machine and design engineers to design machine for higher efficiency than and then the utility will procure their products that will ultimately lead to profit and loss of the company. It indicates the importance of efficiency right from the initial stage as manufacturing units, intermediate stage as planning coordinators, and end-users stage as a utility.