Given the piece of c code below. for(i=0: i<10000; i++X signal[i]=0: for(j=0: j<12: j++)X signal[]+=rand(0%32767.0; signal[i)--6: signal[*=1.1%3B signal[)+=3: Sketch a histogram of this signal. Include specific numbers on x-axes. Scan/photo the sketch and drag it to the box below. The image must be legible and correctly oriented.

Q: consider the signal shown in the figure below, the signal is sampled 10,000 time per second and each…

A: Answer is given below .

Q: A sequential circuit has an input (X) and two outputs (S and V). X represents a 4-bit binary number…

A: Solution:The following code is described about the behavioral Verilog description for given state…

Q: 3. Given the following q-values, which among the means would be in a separate c XA - Xg = 15-14 = 1…

A: 3 Given the following q values,which among the means would be in a separate cluster? a.Means of A…

Q: 1 signal element 2 signal elements a. One data element per one signal element (r = 1) b. One data…

A: Qno 1

Q: Implement 4-bit block cipher using 4 XOR gates, plain text input [3:0] p, key input [3:0] k and…

A: Verilоg  is  а  Hаrdwаre  Desсriрtiоn  Lаnguаge;  а  textuаl  fоrmаt  fоr  desсribing  eleсtrоniс…

Q: Consider an analog signal x„(t) = sin(20 7t), O < t s 1. It is sampled at T, = 0.01, 0.03, 0.05,…

A: x(t) = sin(20* pi * t) 1) For Stopping time = 0.01 Fs = 8000;  dt = 1/Fs;  StopTime = 0.01;  t =…

Q: 2. (b) A periodic composite signal is composed of 2 sine waves(S1,S2). The frequency (f) and maximum…

A: A periodic composite signal is composed of 2 sine waves(S1,S2).The frequency(f) and maximum…

Q: Compute F.T of signal in Program theoretically. syms t x=heaviside (t+2)-heaviside (t-2); f=fourier…

A: Answer: I have given answered in the handwritten format in brief explanation.

Q: 20. When propagation speed is multiplied by propagation time, we get the ________. a. throughput b.…

A: answer  d. distance a signal or bit has traveled    when propagation speed is multiplied by…

Q: B. For k-4, n-7. If the received word is R= [1 1 110 1 0], check if there's an error occurred in R,…

A: It is defined as error-correcting codes (ECC) are a sequence of numbers generated by specific…

Q: A2. Implement the circuit diagram of F= xy'z+XXz + Wy+wXy and fill in the following truth table by…

A:

Q: 2. (b) Suppose, a synchronous TDM multiplexer combines 5 sources and sends only TWO characters from…

A: Answer: I have given answered in the handwritten format in brief explanation.

Q: Osing Mathemahca: • Make a numerical simulation of a super heterudyne EM radio receiver operating in…

A:

Q: 7. In the proof of the claim that for any n-bit messages, any resulting code C with parity bits…

A: Answer : e is the correct as minimum distance is 3 so we take only three cases.

Q: The figure below shows the path of an optical ray passing through a stack of three layers with…

A: The figure is: Option a) δ = 0.57 mm This is the wrong answer. Option b) δ = 1.37 mm This is also…

Q: For a 5-bit (VWXYZ) even parity generator, what is the value of parity bit (P) if V=W=X=Y=Z="1", and…

A: This question is from the PARITY GENERATORS/CHECKERS chapter. Here we have given 5 inputs all are 1.…

Q: 4. Consider the cyclic redundancy check for computing error detection code FCS. For a bit block of…

A: Here ,We try to check redundancy for computing error detection code FCS.For a bit block of 16 bits…

Q: HW6 Consider the analog signalx, (t) given by x,(t) = 3 cos 2000t +5 sin 6000 tt+ cos12000tt What is…

A: Answer:)

Q: A signal x n has the Z-transform Xz e3/z. The values of x 1 and x2 of the signal x n are: O a) æ[1]…

A: According to the information given:- We have to find out which option is satisfy the value X[1]and…

Q: 6. What are the corresponding type of the following MIPS code: () add $ts, $t5, -1 j label Sw $te,…

A: MIPS stands for Microprocessor without Interlocked Pipeline Phases. This is a reduced instruction…

Q: A real-valued signal x(n) is called symmetric * (even) if x(-n) = -x(n) O x(-n) = x(n) O x(-n) =…

A: Answer : I attached an image please have a look oncce.

Q: We use the DFT to compute the amplitude spectrum of a sampled data sequence with a sampling rate fs…

A:

Q: We use the DFT to compute the amplitude spectrum of a sampled data sequence with a sampling rate fs…

A: Actually, given information: We use the DFT to compute the amplitude spectrum of a sampled data…

Q: A Gray code is a sequence of binary numbers with the property that no more than 1 bit changes in…

A: Gray Code is a sequence of binary number systems .IN this the first N/2 are reverse of the last N/2…

Q: Write a program in C to interpolate the noisy sensor data by a factor of 2 using linear…

A: leaves much to be desired in image quality that is especially noticeable at the edges in images. It…

Q: Problem3: Consider a time division multiplexing scheme with 14 users. Assuming each fh user has a…

A: Answer is given below .

Q: Suppose x, and x2 are binary valued (0 or 1). What boolean function does the network shown below…

A: Lets see the solution in the next steps

Q: A cyclic redundancy check (CRC) error detection scheme is constructed to generate a 4-bit frame…

A: I have provided solution for both parts. In first question, we will divide the codeword ( M(x) + 4…

Q: Write a Verilog program for a 3-to8 decoder based on the Truth Table 1. You are not allowed to use…

A: Here is Code for a 3 to 8 decoder based on the table.

Q: 2. CHANNEL CAPACITY For a case of a telephone line with a bandwith of 3,30oHz, plot the channel…

A: Matlab code:   %Bandwidth of the telephone line %SNR range is 0 to 60 db B = 3300; SNRdb = 0:1:60;…

Q: write a Matlab program to simulate the following signal by selecting a proper sampling frequency…

A: please check the step 2 for solution

Q: Q1: For the cascaded channels shown: Find P(Z\X) and mutual information between x2 and 22 if p(x2) =…

A: Note: Answering the first question as per the guidelines. Task : Given the channel diagram  The…

Q: Consider an LZW encoder and decoder system works with a table of size 1024 entry. The table is…

A:

Q: QI: Consider a line starts at (8,6) and end with (3,1), use the DDA to rasterize the line then…

A: DDA : DDA stands for Digital Differential Analyzer. It is an incremental method of scan conversion…

Q: 3.2.9 Consider the signal z(t) = |0.5 + cos(4rt)|I The signal is filtered with an ideal bandpass…

A: As per company guidelines if the question is multipart, then only first question answer can be…

Q: Compute F.T of signal in Program theoretically. syms t x=heaviside (t+2)-heaviside (t-2);…

A: Answer: I have given answered in the handwritten format in brief.

Q: Given b, set the low-order b bits of x to 1; the others to 0. For example, if b is 3, x should be 7.…

A: Bitwise operators help us to to perform this task effectively. Consider a 32 bit signed inter for…

Q: A repetition code is an [n, 1] Code in which the n - 1 parity bits are repetitions of the…

A: repetition code: The are code that repeat bits two or more times These are block code in which…

Q: Plot the following discrete-time signals using Matlab: ; where -5 s n < 15 (a) x[n] = discrete-time…

A: (a) Unit step function: u(t)={ 1 if t&gt;0 and 0 if t&lt;0} MATLAB CODE:   close…

Q: (25M) Consider the analog signal x,(t) =3cos(100 a t) + sin(150 t). a) Determine the minimum Fs to…

A:

Q: A real-valued signal x(n) is called symmetric * (even) if x(-n) = -x(n) O O ()x = (u-)x x(-n) = -x(-…

A: We know that any signal be it continuous or discrete is said to be symmetric(even) when that signal…

Q: 3. Find the time delay for the delay subroutine shown as follow, if the system has an S051 with…

A: The CPU takes a particular number of clock cycles to perform an instruction. These clock cycles are…

Q: matlab programming for n+2 not for n Learning signal processing in modulation changed step size…

A: Required :- Approach :- Since from equation we can understand that from  adding 2 to x[n] means it…

Q: matlab programming for n+2 not for n Learning signal processing in modulation changed step size…

A: Required :- Approach :-   Steps :- Point to Note :-  you can see that this is left shifting of…

Q: Given the mapping a = 1, b = 2, ... %3D z = 26, and an encoded message, count the number of ways it…

A: c++ language code is given in step 2.

Q: The joint probability of channel is defined as: P(x1, y1)=0.25, P(x1, y2)=0, P(x2, y1)=0.3, P(x2,…

A: Joint and Conditional Entropies: Joint (system) entropy is the average amount of information…

Q: Suppose, BanglaLink has 4 voice channels, each of 60Mbps. They use synchronous TDM to multiplex…

A: According to the given information the MUX can be drawn as: -

Q: 13: Consider a binary sequence with a long sequence of Is followed by a single "0" and then a long…

A: Pulse code modulation, Delta Modulation Adaptive delta modulation are used to convert analog signal…

Q: Consider the use of hamming codes to send 11-bit messages. Specifically, consider 10011011011.…

A:

Q: Consider the value of x-60 and value of y3D2. X=Y Y=X Z = 2*pow(X,Y+2)/10 + 5 %3D

A: answer is 8.2