Given the tabulated data for a closed traverse in which the bearings of BC and the length of EF have not been measured in the field. Determine these unknown lengths. Line Length (m) Bearing АВ 620.06 S 92°30' E ВС 302.24 Unknown S 42°45' E S 60°40' W CD 691.56 DE 688.48 EF Unknown N 75°27' W FA 412.35 N 07°02' E

Given the tabulated data for a closed traverse in which the bearings of BC and the length of EF have not been measured in the field. Determine these unknown lengths. Line Length (m) Bearing АВ 620.06 S 92°30' E ВС 302.24 Unknown S 42°45' E S 60°40' W CD 691.56 DE 688.48 EF Unknown N 75°27' W FA 412.35 N 07°02' E

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Given the following data for a closed traverse in which the length of sides BC and CD are unknown. For Length and Bearing of AB (795.62 m, S 03 deg 05’ W), BC (Unknown, S 52 deg 50’ W), CD (Unknown, N 12 deg 42’ W), DE (650.25 m, N 40 deg 15’ E), EA (541.55 m, S 85 deg 58’ E). If BD is chosen as the closing line, its length is • 977.23 m • 902.13 m • 853.71 m • 24.11 m • 903.48 m
Compute for the given closed traverse the following:a. Bearing of each lineb. Latitude and Departure of each line,c. Linear error of closured. Precision e. Adjust the traverse using the transit rule. If the coordinates of point B are Northing =3000.00 m. and EASTING = 1500.00 m., determine the coordinates of all other points. LINE INTERIOR ANGLE LENGTH (m.) BEARING A-B A = 125 deg 54 min 162.60 N 28o 17’ E B-C B = 135 deg 00 min 253.98 C-D C = 114 deg 27 min 256.32 D-E D = 121 deg 52 min 305.94 E-F E = 88 deg 59 min 335.40 F-A F =133 deg 48 min 182.04
A closed traverse has the following bearings. OBSERVED BEARINGS LINE FORWARD BACK AB N 55°30’ E S 55°45’ W BC S 58°40’ E N 58°30’ W CD S 14°30’ E N 14°00’ W DE S 77°10’ W N 77°10’ E 0EA N 40°20’ W S 40°15’ E Adjust the following bearings in order to close the traverse. Also draw the corrected traverse.
A line has a magnetic bearing of S41°30’E when the declination was 1°30’E. What is thetrue bearing of the line if a local attraction of 3°30’ to the east of the vicinity?
Surveying In order to locate the position (P) of a sounding boat, the angles APB & BPC subtended at P by three points A, B and C on the shore were measured with a sextant and found to be 28º 42’ 40” and 30º 28’ 20” respectively, the point B & P being on opposite of AC. The length of AB & BC scaled from a map were 662 m and 4662 m respectively, and the angle ABC was 60º 50’ 40”. Carry out all the necessary calculations to compute the distances PA, PB and PC.
Given the following data of a closed traverse. Compute the bearing of line DE a. N 56°55’ W b. N 56°55’ E c. N 46°55’ W d. N 52°55’ E
▪ A line has a magnetic bearing of S41°30’E when the declination was 1°30’E. What is thetrue bearing of the line if a local attraction is 3°30’ to the east of the vicinity?
Compute and tabulate the bearings and azimuths of a regular hexagon. Given the first starting direction of side AB: N 34 deg 09 min E, station C is easterly of B.
1. A triangular piece of land ABC (clockwise) has the following directions in azimuth fom South. AB = 225o23’, BC = 325o20’, CA = 100o10’ Compute the interior angles. 2. An open traverse ABCDE has following azimuth from South: AB = 250o30’ BC = 280o20’ CD= 210o45’ DE = 150o50’ Required: Deflection angles at points B,C, and D. Draw the figure properly.
0:£) B s, Mt B Traverse.. X o I onder 1o determine a tunnel between staton A and B where the vision was obstrucied between them, a traverse was slected o link between these stations, The field measurements of the raverseas in the table blow: - Line Length(m) | Azimuth DA 500 2000 be 00 oo ) 0o [oor AB ? ? Tength and the bearing of the tunnel (AB) and the angle BAD for stting it out
Three lines have the following north azimuths: AB 114o36’, CD 254o45’, and EF 302o14’. What are the bearings?
complete the distance between two points A&B by using level instrument if the upper reading of stadia was 1.532 and lower reading was 0.921