Helping tags: Electrical Engineering . . . WILL UPVOTE, just pls help me answer the question and show complete solutions. Thanks. . . . Find Rb, Ibq, Icq, Vre, Vrc , Vc , Vrb, Vb, Zb, Zin and Zo for the CE amplifier shown in fig.1 Remember Icmax = Vcc/Rc+Re Graph the DC loadline showing the Q point of the circuit

Q: Q4 a) Calculate the N=3 point DFT of x[n] = {x[0] = 0, 1, 2} b) What is the relation between DTFT…

A:

Q: A series RLC resonant circuit has an inductance equal to 5 mH, and capacitance equal to 4.7 micoF.…

A:

Q: 1. Match the load to the line using a shunt stub: a) Short-circuited Open-circuited a) ZL = 500 ohms…

A: We need to match the load to the line using a shunt stub: a) Short-circuited. b) Open-circuited.…

Q: 315. What is the bandwidth of an AM signal modulated by a 15-kHz intelligence signal? a. 7.5 kHz b.…

A: Types of Modulation Frequency Modulation Amplitude Modulation  Pulse Modulation  Phase Modulation

Q: 20.a. What's the primary disadvantage of using copper conductors? A. Durability B. Cost C.…

A: 20. (a) Although one of the most electrically conductive materials known, copper is easily corroded…

Q: A 100 Ω resistor in parallel with a 5 pF capacitor terminates a 100 Ω transmission line. Calculate…

A: Solution is attached with this notes. Thank you .

Q: 1.6. The resistance of a coil is 140 and its inductance 0.85 H. Determine the current, the p.f. and…

A:

Q: a. 18.6 cos (wt b. 48.81 cos (wt c. 72.79 cos (wt 54°) V; + 126.68°) mA; + 97.08°) V.

A:

Q: 1. How to solve differential equation using transform method

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: If two capacitors having capacitance of 5 µF and 10 µF respectively are connected in series across a…

A: Given, Two capacitors of 5 μF and 10 μF are connected in series across supply voltage 200 V. C1=5…

Q: 2 @ A LII system has H(W) = 4+jw find the D.E. 6 +5jw-w² -relating the input XII) and the output…

A: 9) Given an LTI system H(w)  To find the impulse response h(t) relating input x(t) and output y(t)

Q: Find the F. T. of the following Signals using differentiation pro ĴA

A:

Q: IB3 +10 5 кл 10 кл in Alo - 10V de |c Find. B=50 (6=2 13 => 1c=> vc=> V<= ?

A:

Q: 5. Find the F.T. of the following periodic signal 3 -2 2

A:

Q: A 25 V battery, delivers 250 mA of current when connected to a 90 Ω resistor. Make a sketch of the…

A:

Q: JA ITI system

A:

Q: Calculate the current required in the coil of the figure to produce a flux density in the air gap…

A: Note : Unit of H A.V/m is confusing. we assume it as AT/m   B=1.6 H75+H cross sectional area of core…

Q: In a system of 132 kV, the circuit phase to ground capacitance is 0.2 uF and the circuit inductance…

A:

Q: Consider the system shown below. M(f) (the Fourier transform of m(t)) is also shown. M (f) y(t) ∞…

A:

Q: Find the convolution between X(t) and hitt AX(U 4 h(t) st -1 1 y(t) = x (t) htt), the find Yew),…

A:

Q: a) Explain the cooling process of an oil-immersed transformer.

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Discuss the suitability of dielectric heating for a particular application.

A: Dielectric Heating:- Dielectric Heating is an electric heating process that raises the temperature…

Q: 8. In 8-bit microprocessor, how many opcodes are present? a) 246 b) 278 c) 250 d) 256

A: Given  In a 8 but microprocessor....

Q: Three bulbs of resistances 5 Ω, 25 Ω, and 30 Ω are connected in parallel with a 12-V DC source.…

A:

Q: Find the F.T. of the fall wing Signals (functions): F(t)=1+cos(6nt+) w Ans: F(W)=2π8 (W) + ле¯в [8(w…

A: Given data : The given function is,  ft=1+cos6πt+π8

Q: Find the convolution between X(t) and hitt AX(U 4 h(t) st -1 1 y(t) = x (t) htt), the find Yew),…

A:

Q: What is the load, in amps, for a three-phase, 208V feeder supplying a load calculated at 96.75kVA

A: Given data, Load KVA S=96.75 KVA Supply voltage VL=208 V

Q: transistor uses

A: A unipolar transistor uses the orientation to the one pole.

Q: A 4-pole, 50 Hz induction motor operates at 5% slip. The frequency of e.m.f. induced in the rotor…

A: Given, An induction motor has Number of poles, P=4 Supply frequency, f=50 Hz Slip, s=5%=0.05

Q: For the circuit shown, find the values of R₂ and C to yield 6% overshoot with a settling time of 2.5…

A:

Q: -3t How Find y(t) if x(t) = S(t) and X(t) = e

A:

Q: 2. How to solve electric circuit analysis using transform method (series circuit analysis & parallel…

A:

Q: 2 Find the F.T. of the following Signals (functions) C. f(t) = 35gn (3t) 1 jt d. f(t) = 1 + cos (6H+…

A: For the given time domain signals we need to calculate their fourier transforms by using the…

Q: A silicon diode is fabricated by starting with an n-type substrate (Nd = 1016 cm-3), into which…

A: Here,Nd=n= 1016 cm-3Na=p=1018 cm-3Now,np=ni2ni=np=1017 cm-3p=ni eEi-EF/kTEi-EF=kT lnpnikT=26 meV at…

Q: deduce the equivalent circuit of the coil

A: If the supply is applied to coil with iron core, then the power is observed for meet the core…

Q: (a) A 240 Vrms, 50Hz is supplied to a circuit shown in Figure 3. It is estimated that the diode will…

A:

Q: Discuss in detail different types of induction heating with the help of neat diagram.

A:

Q: Given: Vb = 100 volts R = 10000 ohms C = 200 μF Assuming that after a long period of time, the…

A:

Q: 2. 1. Find the equivalent impedance. 11-31-2 m 1522 mo J252 ZIR

A: Given circuit,   there

Q: (III) Two 9.4-k2 resistors are placed in series and connected to a battery. A voltmeter of…

A: It is given that: R=9.4kΩS=1000ΩVV=3 VVR=1.9 V

Q: 5. Find the F.T. of the following periodic signal 3 -2 2

A:

Q: 10 Ω 2002 is 20 lb va 12 3 Va E ≤502 13 10 V

A:

Q: Find the F.T. of the fall wing Signals (functions) e(t) = 3 Sgh(3+) - ans: F(w) - SW- 6 = +jt гпе

A: Given data : The given function is, ft=3sgn3t-11+jt

Q: A 6 pole generator with wave wound armature has 50 slots each having 20 conductors. The flux per…

A: Given data, A generator has P=6A=2Slots=50Conductors per slot, 20ϕ=0.01 WbE=220 V

Q: A series RLC circuit is connected to a 400-hZ line with an applied voltage of 35.678 V. The resistor…

A: An RLC circuit consists of a resistor R, an inductor L, and a capacitor C connected either in series…

Q: seatwork/assignment VL(6) V( GOLVE

A: Given:

Q: Find the E.T. of the following periodic signal. -2 -1 1 2

A: Fourier series is used to analyze the frequency response,Harmonics content and Total Harmonics…

Q: 2. Find, graphically, the convolution between xit and hit) X(t) = sint tho ~, h(t) = S(t) - S(t-1)…

A: Basic input function in signal and system  Impulse function  Step function  Ramp function…

Q: semiconductors in electronic circuits

A:

Q: 2 Find the F.T. of the following Signals (functions) C. f(t) = 35gn (3t) 14 jt d. f(t) = 1 + cos…

A:

Multistage Amplifier

The multistage amplifier is generally a voltage or power amplifier. The multistage amplifier has a number of single stage amplifier that are cascaded together. Since a single stage amplifier output is not useful, they are being replaced with multistage amplifiers or multistage transistor amplifiers. The multistage amplifier are used where the gain required is high or the input signal is very small such that only a single stage amplifier cannot amplify it.