Answered: How can you convert the wavelength to…

Science

Physics

How can you convert the wavelength to wave number and absorbance to transmittance?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter15: Alternating-current Circuits

Section: Chapter Questions

Problem 72CP: The two circuits shown below act as crude low-pass filters. The input voltage to the circuits is...

See similar textbooks

Related questions

Q: what is the maximum frequency, if the circuit minimum frequency is 7000 Hz and the banwidth is 21…

A: what is the maximum frequency, if the circuit minimum frequency is 7000 Hz and the banwidth is 21…

Q: Consider a power plant located 25 km outside a towndelivering 50 MW of power to the town. The…

A: Let the length of the transmission line be l, the area of cross-section of the transmission line be…

Q: a) Design a broadband parallel bandreject filter with a lower cutoff frequency of 1000 rad/s, a…

A: To determine: The circuit for the broadband parallel to the bandreject filter

Q: can someone please explain to me how a dynamic microphone involves magnetic flux and faradays law in…

A: Dynamic microphone

Q: Prove that from the relationship of the bias circuit to the voltage

A: We know that the voltage divider is a very common type of circuit in which the resistance is in the…

Q: Following the analysis applied to the half-wave rectifier with capacitor filter, show how to arrive…

A: we have to analyse half-wave ; Here we use rectifier with capacitor filter; we will show output…

Q: A transmission line whose characteristic impedance is 500, find that the speed of the wave…

A: Given data, Characteristic impedance = 500 We know that Speed of wave = Speed of light = 3×10^(8)…

Q: When phase difference (0) is 90° the power dissipation (P) will be maximum Select one: True False

A: We need to tell whether the power dissipation is maximum or not when the phase difference between…

Q: A delta modulator system is designed to operate at five times the Nyquist rate I with 3 kHz…

A: Write the given values of the problem- Band width(w)w=3 kHzSampling rate=5 NyquistStep size(∆)=250…

Q: The reactance of a capacitor is 65 Ω at a frequency of 87 Hz.What is its capacitance?

Q: For what value of the phase angle ϕ between the voltage output of an ac source and the current is…

A: The average power output of the source is given as,

Q: A square wave e is a cyclic pattern that has a constant absolute value, but alternates between…

Q: For what value of the phase angle between the voltage output of an ac source and the current is the…

A: Here in this question, we are asked to find the phase angle between the Voltage output of an A.C…

Q: What is meant by rectifier? Explain the half wave rectification and also calculate its rms value of…

Q: What is the capacitive reactance of a 0.100 mF capacitor at a 100 Hz audio frequency and at a 100…

A: Given, Capacitive reactance, C=0.100 mF Audio frequency, f1=100 Hz FM-radio frequency, f2=100…

Q: 1. Find the output of each of these combinatorial circuits. a) P b) P

Q: Consider a length of Teflon-filled, copper K-band rectangular waveguide having dimensions a = 1.07…

A: In this question we have to find the attenuation due to dielectric and conductor losses. Please give…

Q: What do you mean by rms voltage and rms current?

A: The rms means root mean square value, which is as the name implies, the "square root of the mean…

Q: •• The capacitors referred to in this problem have only empty space between the plates. (a) Show…

A: Capacitance of a parallel plate capacitor=€A/d

Q: electromaznetic An Wave in free when has 'A'. space the wave.length same wave enters dielectric de'…

Q: What is meant by term ‘modulation’? Draw a block diagram of a simple modulator for obtaining an AM…

Q: I mean that the equivalent impedance in an alternating current circuit is given by the following…

A: In the ac circuit there are capacitors and inductors along with the resistor so the net impedance is…

Q: In the Maxwell bridge shown in Figure2, let the fixed-value bridge components have the following…

Q: In common emitter amplifier, the output voltage closely follows the input voltage both in phase and…

Q: For what absolute value of the phase angle does a source deliver 74 % of the maximum possible power…

A: The expression for the phase angle is,

Q: A sinusoidal signal has a 580.59 V peak to peak amplitude. What is its RMS value, to 3 significant…

A: Given,

Q: i) Bandwidth of the resonant L-C-R circuit is

Q: The waves transmitted from the source in the open circuit lines suffer complete regression, so the…

Q: Balanced modulator is a circuit for the data signal with carrier wave to generate a digital…

A: We are asked about the function of balanced modulator.

Q: Using Maxwell's Mesh Current Analysis, determine all the loop current 11, 12 (with 4- ohm resistor),…

A: By Maxwell Mesh loop equation, we have to find out the values for I1 , I2 and I3

Question

100%

How can you convert the wavelength to wave number and absorbance to transmittance? Please shortly write at your own words. Answer should be to the point.(5-6 lines maximum).

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

What is meant by rectifier? Explain the half wave rectification and also calculate its rms value of current and voltage?
Following the analysis applied to the half-wave rectifier with capacitor filter, showhow to arrive at the output waveform for a center-tapped full-wave with filtercapacitor
For a Symmetrical Slab AlGaAs Waveguide, calculate the number of Modes that will propagate if the Wavelength is 870 nm and the Thickness is 8.5 um.
Consider a power plant located 25 km outside a towndelivering 50 MW of power to the town. The transmissionlines are made of aluminum cables with a 7 cm2crosssectional area. Find the loss of power in the transmissionlines if it is transmitted at (a) 200 kV (rms) and (b) 120 V(rms).
The tungsten elements of incandescent light bulbs operate at 3200 K. At what frequency does the filament radiate maximum energy?
The two circuits shown below act as crude low-pass filters. The input voltage to the circuits is vin, and the output voltage is vout. (a) Show that for the capacitor circuit, voutvin=11+2R2C2 and for the inductor circuit, voutvin=RR2+2L2 (b) Slow that for low frequencies, voutvin , but for high frequencies, vout0 .
Calculate the resonant angular freqency of an RLC series circuit for which R=20 , L=75mH, and C=4.0F , (b) If R is changed to 300, what happens to the resonant angular frequency?
Distinguish between fast and slow frequency hopping spread spectrum with a suitableexample in detail.
design an ordinary end fire uniform linear array with only one maximum so that its directivity is 20 dB (above isotropic). The spacing between the elements is lambda/4 and its lenth is much greather than the spacing. Determine the (a) the number of elements (b) overall length of the array (in wavelengths) (c) approximate half-power beamwidth(in degrees) (d)amplitude level (compared to the maximum of the major lobe) of the first minor lobe (in dB) (e) progressive phase shift between the elements (in degrees)
Consider a conducting sphere with a radius as of 1 m. What is the RCS of this sphere at an RFof 10 GHz? Give the answer in units of both square meters and dBsm. (Assume the sphere is“much larger than” the wavelength.) What must be the side length at of a trihedral so that ithas the same RCS at 10 GHz? What is the ratio of the size of the sphere compared with that ofthe trihedral, as/at ?