How many digits is the Octal System capable of having?

Q: Q. A single phase transformer has 350 primary and 1,050 secondary turns. The net cross-sectional…

A: Given- Single phase transformer- Primary turns N1=350, Secondary turns N2=1050, Area a=55 cm2=0.0055…

Q: A 4-pole wave wound armature has 720 conductors and is rotated at 1000 rpm. If the useful flux is 20…

A: Given, Total number of poles, P = 4 Total number of conductors, Z = 720 Speed, N = 1000 rpm For wave…

Q: Perform the BCD addition of the following numbers:  234 + 146 67 + 39

A: Given two numbers 234 + 146   67 + 39 Perform the BCD addition.

Q: Consider the following statements: Adjustment is required in an induction type energy meter in the…

A:

Q: a) Calculate 1₁ b) Determine l2 c) Find 13 d) Calculate VAB e) Determine VBC f) Determine VCD g)…

A: We need to find current and voltage for given circuit

Q: A transformer has a turn ratio of 1: 10. A resistance of 2000 ohms is connected across the secondary…

A: Given, Transformer turns ratio, a=110=0.1. Secondary terminal resistance, R2=2000 Ω.

Q: A stranded cable consists of eight copper conductors each having a diameter of 1.0mm. Twisting the…

A: Given: d=1.0 mm, ρ=1.72×10-8 W-m, length 1 km Percentage extension of cable 3% Find : Resistance

Q: A generator supplies power to a factory through cables of total resistance 20 ohms. The potential…

A:

Q: Neglecting saturation, if the current taken by a series motor is increased from 10 A to 12 A, the…

A: Given, The current taken by series motor increased from 10 A to 12 A. I1=10 A.I2=12 A.

Q: Q2) Infinite line charge of pu-5nc/m at X-1, Y-1 and a sheet of charge of ps-3 nc/m² at y=-2, the…

A:

Q: The meter constant of a single phase 230 Volt induction watt hour meter is 400 revolution per kWh,…

A: Given a induction watt hour meter with, Voltage, V=230 V. Meter constant, K=400 revkWh. Current,…

Q: 3. Determine Vo. 30V +1 зл 8n 20 APÚA DO NOT DIBUT + Vo jnauthorized distribution to fo@mapua. j

A: We need to find out voltage for given circuit

Q: Given vectors: Ā= αāx + āy +4āz B = - 3āx + ßāy − 6āz C = 5āx - 2y + yāz *** Determine a, p, and y…

A: We need to find out value of unknown for given vector for given conditions

Q: Vs The source Vs=10 sin (ot); R=100 ohms; w=2лf; f=1000 Hz; C = 1 mF. R w +1₁

A:

Q: (5) If Sxx (@) is a psd of the WSS random process X(t), then XX 1 2π [Sxx (@do = A{E[X² (1)]} = R₁x…

A:

Q: (2) Find the final value of the function f(t), where: 2(s+1) F(s) = - s(s+3)(s+5)²

A: Given: Transfer function, Fs=2s+1ss+3s+52.

Q: The meter constant of a single-phase energy meter is 500 rev/kWh. It is found that with a load of 5…

A: Given a single phase energy meter with, True value of meter constant, Kt=500 revkWh. Load power…

Q: VI 5 ΚΩ B A 10 ΚΩ с mim mm 2 ΚΩ · 1 ΚΩ 8 ΚΩ V₂ a) Find the closed loop voltage gain, ACL b) Given v₁…

A:

Q: What is engineering ethics and why is important to have establishedguidelines, standards, and rules?

A: Engineering ethics are an important part of the engineering curriculum. The knowledge gained during…

Q: A 120 V, 40 W bulb is connected in series with a 120 V, 60 W bulb and the combination is connect…

A:

Q: 23. A fault has occurred in the circuit of Fig. 18. One resistor is burnt out and has become open.…

A:

Q: The LED is normally operated in O reverse breakdown. O reverse bias. O forward bias. O depends on…

A: In this question,  We need to choose the correct option LED stand for light emitting diode

Q: QI. B. In the single-phase half-wave rectifier shown below, assume that the load current iola is…

A:

Q: 27. Two resistors of 100 2 and 200 2 are connected in series across a 4-V cell of negligible…

A:

Q: Can you use a single oscilloscope probe to measure a differential voltage on a system in which…

A: The oscilloscope is used for electrical measurement and testing. The device comes embedded with an…

Q: 3 V 1+ 1 V +- ix 10 Ω www + Vx

A:

Q: Simplify the expression: Z = (A+B)(A'+B)B'

A: In this question,  Boolean expression is given.  We need to simplify the given expression.  We know…

Q: Three single phase 11000/220 V transformers are connected to form 3-phase transformer bank. High…

A: Given: The single phase transformer voltage ratio of input and output is: 11000/220 V The connection…

Q: A composite parallel plate capacitor is made up of two different dielectric materials with different…

A: Given- Thickness- t1=0.5 mm,t2=1 mm, V=100 V. To Find- The voltage of conducting foil.

Q: Assume that the diode D1 is ideal and D2 has cut-in voltage of 0.3 V as given in the circuit below.…

A: Given circuit, Diode D1 is ideal and D2 has a cut-in voltage of 0.3 V.

Q: The current i(t) through a 10 2 resistor in series with an inductance is given by: i(t) = 3+4 sin…

A: Given, Current, it=3+4 sin100t+45°+4 sin300t+60° A. Resistance, R=10 Ω.

Q: A battery can deliver 15 joules of energy to move 9.4 coulombs of charge. What is the potential…

A: Given: Energy delivered by battery, E=15 J. Charge, Q=9.4 C.

Q: Nacs) FL Mics) Vath = 0 -1/3C₂ NUEST R₂ www Weess J (664) Ry R₁C₂s -Nois) e

A: Operational amplifier is direct coupled gain amplifier. It is used to amplify dc and ac signal. It…

Q: the minimum value of RL to ensure that the Zener diode is in the "ON" state 20 V IR 220 Ω Rs Vz = 10…

A:

Q: A 3-phase, 60 Hz induction motor has 2 poles. If the slip is 2% at a certain load, determine the…

A: Given parameters Frequency = 60 Hz Number of poles = 2 Slip = 2%

Q: Given that the total resistance is 15 Ohms and the Voltage Source is 30 V: (1) Determine the…

A:

Q: with Izk=15mA Zz = 20ohm and Vz = 14 V at 45 mA. VIN ā 14.8v 0.57v 21.8v O 13.43v O 14.3v R 560 Ω

A:

Q: Q5. Give the reason for(4) of the following? (assist your answer with necessary drawings) a) Series…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: 2.5 For the parallel plate line shown in the accompanying figure, derive the R, L, G, and C…

A: Given  Let  R Resistance parameter Let be the inductance parameter   Let Cbe the inductance…

Q: An alternating current is having an equation I = 161.4 sin 314 t. Find: (1) Frequency (2) R.M.S.…

A:

Q: Determine the resultant of forces system shown in Figure below and locate it Q.3 with respect to…

A:

Q: A 50 Hz, 22 kV generator is corrected to a power system. The system inductance (L) and capacitance…

A:

Q: Which mode of propagation is used by short wave broadcast services having frequency range from a few…

A: A wave of propagation: A wave of propagation is defined as the wave to reach from one medium to…

Q: An ideal DC/DC step-down converter is supplied by a direct voltage of 40V and operates in continuous…

A: Given data, Direct voltage applied Vs=40 V. Switching frequency, fs=20 kHz On state time, Ton=20 μs

Q: Find the equivalent resistance of the circuit below. 260 m b m 36 12 3 1802 www 60 100

A: Given- Resistances values = 36 ohm, 6 ohm, 10 ohm, 18 ohm, 26 ohm To find- Equivalent resistance =?

Q: If A = ax + 3az and B = 5ax + 2ay - 6az, find the angle between A & B

A: please comment if you need any clarification. If you find my answer useful please put thumbs up.…

Q: Q In the arithmetic operations in ALU the meaning of arithmetic shift left instruction for a binary…

A:

Q: An electric radiator is required to dissipate 1 kW when connected to a 230 V supply. If the coils of…

A:

Q: Q In memory hierarchy which of the memory types is the expensive one O Cache memory O Disk memory O…

A:

Q: Determine resistor values using the color code and find all missing electrical values.

A: The resistor values can be calculated by using the resistor colour coding method and the remaining…

Analog to Digital Converters

The analog-to-digital converter (ADC) allows circuits controlled by microprocessors, Arduinos, Raspberry Pi, and various reasonable digital circuits to be connected to the real world. In the real world, analog signals have a continuous stream of information from a variety of sources and sensors capable of measuring sound, light, temperature, or movement, in addition to the many digital systems that interact with their environment by measuring analog signals from those transducers.