How much current flows through a 250-millihenry inductor when a signal of 12 volts and 60 hertz is applied across it?

Q: 95.6 cm and a radius of 1.90 cm. It consists of 1230 turns and carries a current of 3.58 A. how…

A: Given,         l = 95.6 cm         r = 1.90 cm         N = 1230 T         i  = 3.58 A

Q: What is servo motor? And what is the operating principle of servo motor?

A: What is servo motor and what is the operating principle of servo motor?

Q: find the power factor Find the power factor 492 ww -j2Ω j552 -j2n Ans pf 0.555 (leading)

A: The equivalent impedance is calculated from the terminals of circuit.  The calculation is done in…

Q: 6. In this circuit, the current I is 5245° Arms. Find SLoad. A) 50.01 2134.43° VA B) 5000 Z0° VA C)…

A: Voltage source connected to a load through impedance Z is given and value of both voltage source and…

Q: A m 2K B. 2K www 1K 4K 2K 1K 2K 4K 4K

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: Q2.Three phase half-wave diode rectifier is operated fr 460 V,50 Hz supply at secondary side and the…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: Parts A and B

A: Given: A random process, X(t)=Acos(ω0t+θ), where A and ω0 are constants, and θ is a random variable…

Q: The output expression for the circuit given in Figure below is V1 10 k V2 WW 10 ΚΩ 10 k w 10 ΚΩ O…

A: Given opamp circuit is as follows.

Q: Hy R(s) MOD专四作 G1 G2 C(s)

A:

Q: 11) Sampling and quantization If the analog signal to be quantized (unipolar quan- tization with 4…

A: 11) Given, Number of bits of encoder, n = 4. The range of input signal is => 0V to 10V We need to…

Q: I-Assume that a 12 V voltage drop occurs across an element from terminal 1 to terminal 2 and that a…

A:

Q: 13) Explain the nomenclature of additive white Gaussian noise (AWGN). What the PSD and…

A: Additive: It is a noise signals that gets added to the original signal in the channel. y(t)=  x(t)+…

Q: 24 V + www 80 www 30 20 ww 12.02 wwww 30

A: It is asked to find equivalent resistance of given circuit

Q: Find the wavelength of a carrier wave with a frequency of 100 MHz.

A:

Q: Problem 03.035 - Mesh analysis: Independent voltage sources In the circuit given below, R = 5 k.…

A: The given problem is from mesh analysis. The detailed solution is given in the next step

Q: Determine the magnetic field at (0, 0, 5m) due to 15 A current flowing in a circular loop of radius…

A:

Q: II: Consider the four waveforms shown in the following figure. 1. Determine a set of basis…

A:

Q: A piezoelectric force transducer has a charge sensitivity of 20 pC/N. It is connected to a charge…

A:

Q: € Problem 1 . For the circuit shown below A) Calculate the equivalent resistance of the circuit. B)…

A:

Q: The radiation intensity of an antenna is given by: U = 2π (sin 0 +cos 0) for 0 ≤ 0 ≤ π/2 Find: a)…

A: The radiation intensity of the Antenna is given as U=2πsinθ+cosθ for 0≤θ≤π2. Here we need to…

Q: The type of filter that has a very flat passband which is desirable in most applications is Bessel…

A: The question is about filters.

Q: In AC voltage controls, do the two thyristors work at the same time? What happens if they work at…

A: In AC voltage controls, do the two thyristors work at the same time? What happens if they work at…

Q: Consider the following RL circuit with Vs-200V, R1-100 ohm, R2- 100 ohm, R3- 50 ohm, L-20 H. The…

A: The general expression of inductor current in series RL Circuit Charging…

Q: Req 2 ΚΩ 5 ΚΩ A 4 ΚΩ Β 3 ΚΩ 6 ΚΩ

A:

Q: (b) Figure Q4 (b) shows a clamper circuit, and input waveform (i) Sketch Vo from 0 until t4…

A:

Q: 3) The choosing of a PCM waveform for a particular applications is limited by some parameters. What…

A: To explain: Parameters that effect the selection of a PCM waveform for a particular application.…

Q: Series connection of switches would normally create O NOR logic gate O NAND logic gate O AND LOGIC…

A:

Q: A balanced twelve-phase mesh connected load has a line current of magnitude 10.3 A.  What is the…

A: Given Line current IL = 10.3 Amp, To find Phase current

Q: 10-bit unipolar ADC has a Vref = 5V. What digital output will be generated if Vi = 1.32V? 0000000010…

A:

Q: Question # 1: A unity feedback system with the forward transfer function G(S) = Do the following: K…

A: Given data OLTF, Gs=Kss+7 Feedback, Hs=1 Peak overshoot, %Mp=15% We need to determine the settling…

Q: A very short (1≤ 2/50) vertical electric dipole is mounted on a pole a height h above the ground…

A: Electric dipole An electric dipole is made up of two point charges that are equal and in opposition…

Q: QUESTION 8. Find the piecewise-linear equivalent circuit for the diode of Fig. 1.15. Use a…

A: Diode A diode is a two-terminal electronic component that primarily conducts current in one…

Q: Determine the gain vo / vs of the given transistor amplifier circuit where I= 25/ 1 Us 2 ΚΩ www 4 ΚΩ…

A:

Q: 2. Label the mesh currents and write the equations for the mesh currents and solve for them. ww 10 5…

A:

Q: 3. Phasors and complex exponential function a) Consider 2 voltage functions: v₁ (t) = 5 sin(10t+60°)…

A: The question is about phasors and ac sinusoidal analysis. Note : due to multiple subparts i had…

Q: 7. For this circuit, find the value of load impedance that will maximize power transfer to the load.…

A:

Q: Statement 1: Shunt resistance of an ammeter is low. Statement 2: The shunt maybe connected in series…

A:

Q: A redundant part or component increases reliability because it is connected in parallel, not in…

A: Q 40. System reliability: Components and otherwise elements are organised parallely in parallel…

Q: R(s) 2. For the block diagram shown in the figure determine the overall transfer function. + + G1 H1…

A:

Q: An audio amplifier with resistance 7 supplies power to a speaker. In order that maximum power is…

A: Given, The audio amplifier is supplies power to speaker. The resistance of audio amplifier is…

Q: 6. A three-phase power transformer used in power system can be a) step down current b) extra step-up…

A:

Q: n ammeter model consists of an ideal ammeter in series with a 20-22 resistor. It is connected with a…

A: We need to find out the unknown resistor for given circuit.

Q: A motor load of a workshop and a wood shaper establish a 22 kVA power demand at 50 percent lagging…

A: The given problem is from power factor improvement in motor.  The detailed solution is given in the…

Q: Problem 04.033 - Thevenin equivalence with independent source Determine the Thevenin equivalent…

A: We need to find out the current for given circuit by using of thevenin equivalent circuit .

Q: 1. Find the voltages at the essential nodes in the circuit below. m 12 2 + IOV 20 10€ #)2 12 4NX 2A…

A: "Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: QUESTION 3. In the reverse-bias region the saturation current of a silicon diode is about 0.1 μA (T=…

A: Given, Reverse saturation current (Isat(1)) = 0.1uA at temperature, T1 = 20°C We need to find…

Q: If the current density in a co b. с 0.138 V/m Not enough informat ed. 7.25 V/m 4.64 x 10¹4 V/m

A: Given data, Conductivity is given as, σ=5.8×107 S/m. Current density is given J=8×106 A/m2.

Q: V₁ +1 R₁ www R2 ww + Xt = 0 UL - elle L iL

A:

Q: Consider the circuit shown below. Assuming that the switch is closed at t= 0, calculate v(t) for t >…

A: given circuit problem. we have to calculate voltage

Q: Question Overall transfer function of a system is given as G(s) = (2s+1) (s²+2s+5) The system is…

A:

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.