Geotechnical Problem 2 :How much does the capillary water rise above the water table in a very fine sand (d = 0.1 mm) if the surface tension force is Ts = 0.064 N/mwith an a = 3°?Dicntinn metare eCapillary fringeCapillary ateratiens Saturatin neParti Ser ()4Tshe =dyw(negative to indicate suction)Pement Pig

Given Data, d = Diameter of the capillary = 0.1 mm = 0.1x10-3 m ζS = Surface tension of water =…

Answered: How much does the capillary water rise…

How much does the capillary water rise above the water table in a very fine sand (d = 0.1 mm) if the surface tension force is Ts-0.064 N/m with an a - 3?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: find the specific gravity of the given unknown fluid, the hydrometry weight is 0.015 N. A=0.1 cm 63…

A: Weight of the hydrometry = 0.015 N = Buoyant force Calculating the specific weight of the unknown…

Q: What would be the rotation rate (in rad/sec) if during rotation the water in the right leg (with a…

Q: -18 ft radius Water 30 30

Q: A water gate is sbown to the right It is denigned to open (rotate clockwise) when the water level…

Q: Q1/ The tank of water in Fig. 1 is (12 cm) wide into the paper. If the tank is accelerated to the…

Q: Determine how far the bottom of the ship is below sea level.

A: Given: L=250 m w=80 m h=80 m density of sea water=1024 kg/m3 m=10.2*108 kg To determine: The bottom…

Q: To what depth in meters will a 2-m diameter log, 4 m long and specific gravity of 0.425 sink in…

Q: Q2/ In Fig. 2 both the tank and the tube are open to the atmosphere. If L=2.13 m, what is the angle…

A: Given data as per the question Length =2.13 m The specific gravity of oil =0.8

Q: If the pressure at A was 78 kPa, what is the pressure at B?- Note all dimensions are in cm. Water…

A: Given data: The pressure at point A is PA=78 kPa The density of the mercury is ρm=13.6×103 kg/m3…

Q: Q3) A thin wire ring, 3 cm in diameter, is lifted from a water surface at 20 C°.a=1° (the angle…

A: Given data: The diameter of the ring, d = 3 cm. The temperature of the water, T=20°C. Refer to the…

Q: 3. A spaceship lands on a planet where the atmosphere is completely made of water (p = 1000 -g). The…

Q: Determine the depth of a liquid needed to create a pressure difference of 225 kPa if the liquid is…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: What will be the diameter (in mm) of a water droplet, the pressure inside which is 0.00181 N/cm2…

A: Excess pressure in water droplet, P=4σ/D...

Q: What is the minimum Block mass (kg) that is required to open the gate A-B? The density of water is…

Q: Any pressure reading can be expressed as a length or head,h = p / ρ g . What is standard sea-level…

A: Given data The temperature of all given fluid is, T = 20°C. The pressure at sea level, P = 101325…

Q: Fill a glass approximately 80 percent with water, and add alarge ice cube. Mark the water level. The…

A: It is stated that the glass is filled 80% with water, and a large ice cube added in the glass due to…

Q: A graduated cylinder filled with water. A cube is dropped into the cylinder and the water rises. See…

A: Given data, a= side of the cube =3.7 cm γwater= Specific weight of water=9.81x103 N/m3 From the…

Q: Newfound lake, a fresh water lake near Bris has a maximum depth of 60 m, and the mea pressure is 91…

A: given:depth of lake h=60matmospheric pressure p=91kpa

Q: 13. Find the difference in pressures between points A and B in Fig. 2.47. Neglect weight of air.…

Q: If a = 2 in, and the density of the fluid is 60 lbm/ft^3, what is the pressure at point B in psia?

Q: For the vertical wall shown on the left, the oil thickness is assumed to be 0.2 m and its SG is 0.8.…

Q: (c) Determine the height of the water at 60 "F will rise due to capillary action in a clean…

A: given data,water temperature=60°Fdiameter of tube=0.25 inchsurface tension=5.03×10-3 lb/ft2specific…

Q: Consider the sealed containers (same fluid and on the same ground level) below with heights given in…

A: Pressure = Weight Density of fluid X Height of fluid

Q: Parts A-C and Label them Question : Water flows downward in a pipe at 45°, as shown in figure below.…

A: Given Data:-

Q: Q4. IF 1 Pa = 1 N/m, how many pascals when atmospheric pressure at sea level is 101 kN/m²? [0.5…

A: Given Data : 1 Pa=1 Nm2 Atmospheric pressure at sea level(P)=101.325KNm2

Q: A rectangular plate of width 2 m and height 5 m is suspended in the water so that the top of the…

A: If a plate is suspended in water, then force on a plate will cause due to buoyancy effect. It is…

Q: Situation 6 The gate shown in the Figure 5 will open automatically when the water level reaches a…

A: For solution refer below images.

Q: hat will be the diameter (in mm) of a water droplet, the pressure inside which is 00181 N/cm2…

Q: A closed vessel 1 m in diameter is completely filled with water. If the vessel is rotated at 1200…

Q: 1. If the pressure at a point in the ocean is 75 kPa, what is the pressure 27 meters below this…

Q: What is the pressure at the bottom of 0.5m height fluid if the container moves 5m/s2 upward? Fluid…

Q: Question (3):- Find the pressure difference (PA-PB) in the figure shown. Oil (s=0.8) 200 mm 100 mm…

A: The manometer with line MN is given below,

Q: A manometer containing mercury with density, ρ = 13,600 kg/m3 is attached to a tank filled with air.…

A: Let ρ =density of mercury=13600kg/m3 ρa = density of air h=Level difference of mercury between two…

Q: A continuous gravity decanter is used to separate two immiscible liquids, oil (SG = 0.76) and water.…

A: Given information A continuous gravity decanter is used to separate two immiscible liquids. oil (SG…

Q: Determine the hydrostatic force on the bottom of a tank 3 x 3,6 x 3 m if filled vith vater to a…

Q: A 4.27-m diameter cylindrical tank, open to atmosphere, is filled to a depth of 4.88 m with…

Q: 2.154 A very deep 18-cm-diameter can has 12 cm of water, overlaid with 10 cm of SAE 30 oil. It is…

Q: A tank contains 400 kg of a fluid. If the volume of the tank is 2.5 m?, then what is the density of…

A: Given:Mass of fluid, m=400 kgVolume of tank, V=2.5 m3Find: Density and specific gravity of the…

Q: b) A tiny steel cube is suspended in water by a string. If the lengths of the sides of the cube are…

A: Pressure: Pressure is an expression of force exerted on a surface per unit area. P = ρgh where as ρ…

Q: Q-4 A 3-m-wide, 8-m-high rectangular gate is located at the end of a rectangular passage that is…

A: Given data Rectangular gate dimension Wide = 3m Height = 8m Horizontal force FH = 3500kN…

Q: An open, clean glass tube is inserted vertically into a pan of water. What tube diameter is needed…

Q: Q5: A U-shaped tube contains water, if it rotates around one of its arms at a speed of 100 pm, what…

A: GIVEN DATA- SPEED N=100 rpm L=05m WE HAVE TO FIND DIFFERENCE IN FLUID LEVEL

Q: Ultra-Heavy crude oil has a density of approximately 925 kg/m3, specific gravity? And what is its…

A: Density of crude oil = 925 kg/m3 Specific density = density of substance / density of water

Q: An open cylindrical tank has a base diameter of 1.2 meter and contains 3.86 meter deep water. the…

Q: For a liquid with the contact angle of 53.6 degrees and surface tension of 0.075 N/m, capillary rise…

Q: If a ball has a volume of .52 cubic feet, what is the bouyant force on it if it is pushed under…

A: Write the expression of buoyant force.

Question

Geotechnical

Problem 2 :
How much does the capillary water rise above the water table in a very fine sand (d = 0.1 mm) if the surface tension force is Ts = 0.064 N/m
with an a = 3°?
Dicntinn metare e
Capillary fringe
Capillary ateratien
s Saturatin ne
Parti Ser ()
4Ts
he =
dyw
(negative to indicate suction)
Pement Pig

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

End D of a 2.5 long uniformly plain wooden rod( s.g=0.7) is held 0.3m below the surface of still water. (a.) How much of the rod remains above the water surface? (b.) if the rod diameter is 25mm what force of D is required to hold it in place ?
Discuss the variations of hydrostatic force with depth of immersion.
ASAP pls dont round off initial values, round off final ans only ty. Calculate the absolute pressure in kPa at a depth of 8 m below the oil's free surface, with a barometric reading of 752 mm Hg.
1-The point of action of the result force is below the centroid, why? 2-If we change the water to some other fluid,such as oil, does the magnitude of the result force and its location change? why? 3-What is the applications of this experiment? 4-Explane why the tank take the shape of quadrant? 5-Discuss the sources of error? 6-Plot ,find the slope, and discuss the results for both cases
A closed cylindrical vessel, 3 m in diameter and 4 m high is filled with water to a depth of 3m and rotated about its own vertical axis at a constant angular speed, ω. The air inside the vessel is under a pressure of 130 kPa. If ω = 13 rad/sec, what is the pressure at the center and circumference at the bottom of the tank?
15- What will be the diameter (in mm) of a water droplet, the pressure inside which is 0.00221 N/cm2 greater than the outside pressure? (Take surface tension as 0.075 N/m)
A 1.7 ft3 rigid vessel contains 2 lbs of water at 400F. What is the pressure in the vessel?
What is the smallest diameter glass tube that will keep the capillary height-change of water at 20 deg.C. less than 0.9 mm?
Fill a glass approximately 80 percent with water, and add alarge ice cube. Mark the water level. The ice cube, havingSG ≈ 0.9, sticks up out of the water. Let the ice cube meltwith negligible evaporation from the water surface. Will thewater level be higher than, lower than, or the same as before?
Three types of fluids stack in an open tank as shown in the picture. If the specific gravidties are sg1=1, sg2=1, sg3=1, and h1=0 m, h2=0 m, h3=0 m, calculate the gage pressure at location 4, P4(gage)=_________(kPa)
Clear and complete solution please thank you. No shortcuts When the U-tube is not rotated, the water stands in the tube as shown ( See attached figure). If the tube is rotated about the eccentric axis at a rate of 8 rad/s, what are the new levels of water in the tube?
A 2m x 2m tank with vertical slides contains oil ofdensity 900 kg/m3 to a depth of 0.8m floating on a 1.2-m depth ofwater. Calculate the total thrust and its location on one side of thetank.