Quickly answered The outlet at the bottom of a tank is so formed that the velocity of water at a point A as shownin the figure below is 2.0 times the mean velocity within the outlet pipe (atmospheric pressure= 95.48 kPa(absolute) and vapour pressure = 4.00 kPa (abolute) and neglect all other losses).The greatest length of pipe L which may by used without cavitation ism.Atmosphere1150 cmL= ?Atmosphere

Answered: Image /qna-images/answer/077f1f20-b76e-4ae7-bc98-d9a40100027f.jpg

i the figure below is 2.0 mes the mean vélőčity within the outlet pipe (atmospheric pr 95.48 kPa(absolute) and vapour pressure 4.00 kPa (abolute) and neglect all other 1 he greatest length of pipe L which may by used without cavitation is m. Aimosphere 150 cm L= ?

i the figure below is 2.0 mes the mean vélőčity within the outlet pipe (atmospheric pr 95.48 kPa(absolute) and vapour pressure 4.00 kPa (abolute) and neglect all other 1 he greatest length of pipe L which may by used without cavitation is m. Aimosphere 150 cm L= ?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Water flows steadily into the Venturi tube in the following figure. In the section considered, negligible friction losses and uniform properties in the sections are assumed. The entrance area (A1) is 20 cm2, while the throat area is A2 = 10 cm2. A pressure gauge whose manometric fluid is mercury (Yhg = 136,000 N / m3) is connected between the inlet sections and the throat, as seen in the figure. The flow of water that flows through the Venturi tube is requested (γH2O = 10,000 N / m3. Answer .: ϕ = 5.8 L / s.
A pipe with unequal ends is used to transport a fluid. The pipe diameter at the larger end is 0.67 cm and the other end is 0.29 cm. The larger and smaller ends are located 9 m and 3 m, respectively, from the datum line. If the flow at the 9 m datum line is 1.48 m/s and the pressure is 5156 kN/m2, compute for the pressure, in kPa, at the smaller end. Express your answer in 3 decimal places.
kindly help me with this problems INSTRUCTIONS: Solve the problems neatly and systematically. SUse free-floating decimals in all your calculations and in expressing your answers. Box your final answers. 2. Water in a partially filled large tank is to be supplied to the rooftop, which is 8 m above the water level inthe tank, through a 2.5 cm internal diameter pipe by maintaining a constant air pressure of 300 kPa (gauge) inthe tank. If the head loss in the piping system is 2 m of water, determine the discharge rate of the supply ofwater to the rooftop in L/s
Water at 20°C is withdrawn from a reservoir by means of a siphon, as shown in the figure. For d=10cm and D= 16cm, Determine: a) the minimum flow rate that can be achieved without cavitation occurring in the piping system, and b) the maximum elevation of the highest point in the piping system to prevent cavitation. c) Also, comment on the ways to increase the maximum elevation of the highest point in the piping system to prevent cavitation. (The saturation pressure of water at 20°C is 2.33 kPa)
Using a flexible drinking straw and a ruler, explain how you would measure the water flow velocity in a river.
Question : SAE 30 oil at 20°C flows in the 3.5-cm-diameter pipe, which slopes at 37°. For the pressure measurements shown, determine Part (a) whether the flow is up or down and Part (b) the flow rate in m3/h. Neglect minor losses. Directions - Solve carefully, Write Clear, Label as Part (A) and (B) Circle Final answer(s) Hint : flows in the 3.5-cm-diameter pipe, *** USE IMAGE BELOW Pb = 190kPa, Pa = 550kPa, 25m, etc
A certain amount of water (H2O) flows permanently into the pipe venturi(image2) in the figure next to it. In the stretch considered between (1) and (2), it is assumed the losses by friction that were despicable and the uniform properties in the sections are assumed. The entrance area is A1 while that of throat is A2 (A1 > A2). A pressure gauge whose manometric fluid is Mercury Hg (YHg> YH2O) is connected between the input sections and the throat. Show, without omitting any calculation steps that the flow rate at the input (1) is given by(image1):
A 50 mm diameter siphon discharges oil (SG=0.88) from a reservoir (elev. 20m) into open air (elev. 15m). The head loss from the reservoir (point 1) to the summit (point 2, elev. 22m) is 2.5 times the velocity head in the siphon and head loss from the summit to the discharge end is 4 times the velocity head in the siphon. What is the absolutepressure at the summit (point 2) assuming the atmospheric pressure to be 101.3 kPa? Do not write the unit. You will only input the numerical answer in the space provided. Unit of the Correct Answer: kPa (indicate the sign if negative) Decimal Places required in the final answer: 3
The discharge of a fluid is 0.80 L/s in a 100 mm diameter pipe. Determine the type of flow if the fluid is:a. Mercury (? = 1.15 x 10-7 m2/s)b. Gasoline (? = 4.06 x 10-7 m2/s)c. Hydrogen (? = 1.08 x 10-4 m2/s)
A pipe discharges 142 lps of water into a reservoir at a point 1.85 mbelow the water surface. At point A the diameter is 25.4 cm and the center of thepipe is 1.25 m above the water surface. At the discharge end the pipe is 30.5 cm.If the head loss from A to the reservoir is 0.7 m, determine the pressure in A.
Determine the available suction head of the pump that is taking a gasoline at 204°C at a closed tank with a pressure 585 kPa gauge. the specific gravity of gasoline is 0.78 and it’s vapor pressure is 620 kPa absolute. the loss in suction pipe is 0.60 m and the pump center line is located 3.60 m above the gasoline level A. 8.66m B. 3.67m C. 7.66m D. 4.47m
If the inner diameter of the penstock that deliver water form the dam to the hydroelectricpower plantis 90 cm and the water flows inside itat a rate of 10 L/s. (?=0.0131?????)a.Define the type of flowinside the penstockusing Reynolds numberequation.b.Explain the significance of the information we get from Reynolds number equation.