i. Draw the block diagram of a solar Photo-Voltaic system with the stand by diesel generator and explain about each component in it? ii. Discuss how you can you avoid the overcharging of the battery?

Q: Question 6 What is an ohm? O A measure of charge O A measure of EMF O A measure of electron flow O A…

A: In this question we need to choose a correct option

Q: Which type of power supply is required to power up a LVDT? does not matter AC no power supply…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: What is the voltage across the terminals of DS1 if a multi-tester set at 600V AC range is connected…

A: The electrical instruments are used for measurement purposes of various parameters. The various…

Q: List the three steps of nuclear fuel fabrication processes. Also sketch a schematic diagram and…

A: Steps are mentioned below :

Q: Introduction about fuel supply system

A: Different energy sources are required in day to day life. These energy sources can be renewable or…

Q: (b) If the temperature of the cold body is -2°C for the refrigerator, and 5°C for the heat pump,…

A:

Q: A cable wire maybe coaxial or twisted. Coaxial costs 25 centavos per meter while twisted wire costs…

A: Given, cost of coaxial wire = 25 centavos/metercost of twisted wire = 18 centavos/metersoldering…

Q: B// Explain the important functions of the condenser in a thermal power station.

A: Important of condenser    1. The condenser creates the vacuum required for steam to exit the turbine…

Q: . Mention any three factors that determine the output of wind energy conversion tem. Length of the…

A: In wind energy system, kinetic energy stored in blade convert into wind energy.

Q: Every device in a DC, whether a light or electric motor, can be replaced by an electric ________?

A: In DC, light or electric motor can be represented by resistors.In DC, inductor acts as short circuit…

Q: With an elegant drawing, explain the characteristics of the dynamic operation of the device used in…

A: To explain the characteristics of the dynamic operation of the device

Q: Calculate the gauge of TW type copper wires required for a two-conductor power supply in an FMC tube…

A: Given information, Type of material is copper. Type of insulation is TW insulation. Number of…

Q: What are the main limiting factors to battery improvements? Why is the infrastructure for battery…

A: Introduction: The main limiting factors to battery improvements. the infrastructure for battery…

Q: onsider the adjacent circuit diagram of three different rectifier topologies connected to an  346…

A: To charge a battery from AC supply or convert AC into DC rectifier (converter) circuits are used.…

Q: what is the importance of identifying the uses of electricity in farm operations and safety…

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: A) Explain with a neat sketch the process of solar cooling?

A: Solar Cooling- The solar cooling system is used for refrigeration and air conditioning with the help…

Q: What must be known in order to calculate the energy used by an electrical appliance?    a. power and…

A: Generally, Energy is equal to integration of power with respect to time. Unit of energy is watt-s.

Q: 12.a. An electrical device would also fall into the classification of an electric(al) A. motor. B.…

A: Answer 12.a. An electrical device would also fall into the classification of an electrical motor. An…

Q: 1.List the three steps of nuclear fuel fabrication processes. Also sketch a schematic diagram and…

A: Different energy sources are required in day to day life. These energy sources can be renewable or…

Q: Modify the schematic of gas turbine for power generation? Explain briefly.

A: gas turbines have been used for electricity generation in the periods of peak electricity demand.…

Q: Q1: Answer only one of the following: A- What are the advantages of a Nuclear power station?

A: The solution for part A is as follows.

Q: how can you ensure the safety of workers and

A:

Q: Discuss briefly the classification of electrical heating method

A: The classification of electrical heating method:

Q: Design and describe a system to generate electricity from a fuel cell.

A: Fuel cells perform chemical reactions on reactive gases (Fuel) and produce electricity. It generates…

Q: Advantages and Disadvantages of using fossil fuel energy.

A:

Q: Assuming a maintenance factor of 0.85 and coefficient of utilization of 0.65 of a room 10 m by 5 m…

A: The Following data is given in the question Maintenance Factor = 0.85 Utilization Factor = 0.65 Area…

Q: )Explain any four basic components of hydro electric power plant.

A: Hydroelectric power plant has various components in it . I have explqined the 4 basic components as…

Q: A- What are the advantages of a Nuclear power station? B- Several points should be taken into…

A: Advantages of nuclear power station :- * It is a cost effective system in terms of generating the…

Q: Electrical Engineering Calculate the gauge of TW type copper wires required for a two-conductor…

A:

Q: Draw a diagram of a variable speed wind energy system and explain its properties

A: A variable speed wind turbine is specifically designed to operates a wide range of rotor speed.…

Q: What do you think are the most important electrical properties of agricultural products and why?

A: Agriculture materials : agriculture materials  is used to do agriculture work like harvesting ,…

Q: State two (2) Advantages of wind turbine

A: advantages of wind turbine: 1)Even though wind turbines are very tall, they need small space to…

Q: 6. A 60 watt incandescent lamp is operated from a 120 volt ac power line. Calculate the following:…

A: Given P=60W; V=120V

Q: remedies

A:

Q: A cylindrical 00 AWG copper wire is coated with NEMA class B insulation. The normal operating…

A:

Q: What do you think is the main problem that might inhibit the widespread deployment of solar cells?…

A: A solar cell is an electrical device that is used to convert the sunlight energy into electrical…

Q: How is the type of boiler selected in a certain thermal power plant? Discuss the effects depend upon…

A: As we know that the boiler is a device used to generate the steam by applying heat energy to water.…

Q: Explain briefly the methods available to improve thermal efficiency of gas turbine plant.

A: The methods which can be used to improve the thermal efficiency of gas turbine plant are as follows:…

Q: Essay (Minimum 300Words ) How Wireless Wearable Tech aid in the progress of Electrical Engineering?

A: Wearable technology: It is also known as "wearables", is a category of electronic devices that can…

Q: write 4 points on working of nuclear power station

A:

Q: 7/Which among these is not classified as a Petroleum Product used for Power Generation? a. DIESEL b.…

A: Kerosene is not used for power generation.

Q: explain the operating principle of the hydroelectric power plant

A: The hydroelectric power plant is used for the conversion of the mechanical energy of the blades in…

Q: Explain any four basic components of hydro electric power plant.

A: A) major components of hydroelectric powerplant is - 1) forebay 2) intake structure 3)penstock…

Q: Q3. 1. What are the benefits of flue gases in thermal station?

A: As per Bartleby guidelines we are allowed to solve only one question,please ask the rest again.

Q: A cylindrical 00 AWG copper wire is coated with NEMA class B insulation. The normal operating…

A:

Q: block diagram of the electromechanical energy conversion of a power tool

A:

Q: HYDROELECTRIC, GEOTHERMAL, BIOMASS, Explain the operations and stages used by the power plants in…

A: Electric power generator-   In an electric power generator, one type of energy is converted into…

Q: As an electrical engineer how can you help preven the destruction of habitat of animals?

A: There are many ways in which we can prevent the destruction of habitat animal but in taking the view…

Q: Explain the important functions of the condenser in a thermal power station.

A: Condenser is a part of regenerative feed heating system. It is also called as condensate recovery…

Electrical Power Generation

In an electric power generator, one type of energy is converted into electrical energy. Power-generating systems are simply a combination of potential or stored energy that is converted to provide kinetic energy, which, in turn, generates electrical energy for use in engines, lighting, heating, and other benefits of modern life.