wavelorm deminethe averagempeak vollage TngeConsider the circuit shown. The switch is closed at t-0, determine the expression for thevoltage across the capacitor. Sketch the voltage across the capacitor, the inductor, the diode,and the inductor current. Sketch the current flowing through the inductor. Icd=2A0.002H0.01uF

Answered: Image /qna-images/answer/166cecc0-e999-48a6-9008-bbbfb8fc111b.jpg

Answered: Icd=2A 0.002H F0.01UF

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Compute for the theoretical voltages across the resistor and inductor for 10kHz and 60kHz. Show the step-by-step computation. Express the voltages in polar form.
a) Examine the charging and discharging phases of the circuits and then answer the following: What is the time constant () of both circuits in each case? Describe the voltage across and the current through the capacitor combination in both charging and discharging phases.
a) We assume that the switch is on. Calculate the reactance values and find the charging current in the circuit below. Is the circuit capacitive or inductive? Show that the voltage across the capacitance can be slightly larger than the source voltage U. (This is called the Ferranti effect and means that we can get a voltage rise beyond overhead lines with small loads. This is mostly relevant at the highest voltage levels. The frequency f is 50Hz, and assume voltage U= √2⋅24kV
The dynamic current and voltage curves of the transient state of inductor. Explain the equations which describe the current an voltage in function of time
For the circuit, now keep switch J2 closed, close switch J1. Determine the expressions for the voltage across the capacitor and the current delivered by the source.
What voltage is boosted at the output of a multiplier.Choices: average, rms, peak, or instantaneous Which assumption is not used in the analysis of multipliers?Choices: a capacitor will not discharge, start with the cycle of the source that will forward bias the nearest diode, the output will always be multiplied, or a single diode is forward biased at a time A voltage multiplierChoices: multiplies the output voltage, has very high voltage and low current ,can employ inductors, or may not have equal numbers of diodes and capacitors A voltage regulator maintains constant voltage at the load regardless of variations atChoices: the input and output, the load, source, or in the environment Between a lower percent regulation and a higher one, which is better?Choices: lower or higher
Consider more realistic situation, silicons intrinsic Fermi level isn't at the midgap. Please find the energy differences between real Fermi level and midgap Please give some explanations.
The specific capacitance in F/g can be estimated by using both cyclic voltammetry curves atdifferent voltage scan rate and Galvanostatic charge-discharge curves. The following graphshows the charge-discharge curves of a typical MnO2 pseudocapacitive electrode. There is acharge drop in the voltage at the onset of the discharge curve (one such drop is denoted bydeltaV2). What is the reason behind it?
For the circuit, now keep switch J2 closed, close switch J1. Determine the expressions for the voltage across the capacitor and the current delivered by the source. Find the time it takes for the capacitor to reach its final voltage and what value it is.
Suppose we have a 10-Hz sinusoidal voltage source, vin(t). Draw the diagram of a circuit that clamps the positive peaks to -4 V. The circuit should be composed of ideal diodes, dc voltage sources, and other components as needed. List any constraints that should be observed in selecting component values. Be sure to label the terminals across which the clamped output waveform vo(t) appears.
The dynamic current and voltage curves of the transient state during capacitor charging. Explain the equations which describe the current an voltage in function of time. Please explain in details the equations
a) Find the mathematical expression for the voltage VR (t).b) Calculate the reactive power on the capacitor.

SEE MORE QUESTIONS

Recommended textbooks for you

Introductory Circuit Analysis (13th Edition)

Electrical Engineering

ISBN:

9780133923605

Author:

Robert L. Boylestad

Publisher:

PEARSON

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Programmable Logic Controllers

Electrical Engineering

ISBN:

9780073373843

Author:

Frank D. Petruzella

Publisher:

McGraw-Hill Education

Introductory Circuit Analysis (13th Edition)

Electrical Engineering

ISBN:

9780133923605

Author:

Robert L. Boylestad

Publisher:

PEARSON

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Programmable Logic Controllers

Electrical Engineering

ISBN:

9780073373843

Author:

Frank D. Petruzella

Publisher:

McGraw-Hill Education

Fundamentals of Electric Circuits

Electrical Engineering

ISBN:

9780078028229

Author:

Charles K Alexander, Matthew Sadiku

Publisher:

McGraw-Hill Education

Electric Circuits. (11th Edition)

Electrical Engineering

ISBN:

9780134746968

Author:

James W. Nilsson, Susan Riedel

Publisher:

PEARSON

Engineering Electromagnetics

Electrical Engineering

ISBN:

9780078028151

Author:

Hayt, William H. (william Hart), Jr, BUCK, John A.

Publisher:

Mcgraw-hill Education,

SEE MORE TEXTBOOKS