ide caldiodeeffechive valueFrequency equal to 60 He.the voltage ripple at the terminals of R is equealthe source is sinu soidal, withequal to120Vandato 6.06 % ofthe arerage value of he voltageof R.at the terminalsvalue of Hhe vollagethe cueraye value of the volkageR is ĕ guual to:acrossO lo5 Vl10 v(3165 V160 V

This is half wave Rectifier with RC filter. If the ripple = 6.06% The average output Voltage?

ide al diode ffechive vulue frequency equeal to 6o He. the source is sinu soidal, with an e equal to120r the voltage ripple at the terminels of R is equal lo 6.06 % of the areraye value o the voltoge at the and terminals of R. the cueraye value of Hhe vollage R is equal te: across O lo5 V (3 165 V O 160 V

ide al diode ffechive vulue frequency equeal to 6o He. the source is sinu soidal, with an e equal to120r the voltage ripple at the terminels of R is equal lo 6.06 % of the areraye value o the voltoge at the and terminals of R. the cueraye value of Hhe vollage R is equal te: across O lo5 V (3 165 V O 160 V

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

In the circuit given in the figure | VBE | = 0.7V, R1 = 34.65Kohm, R2 = 118.04Kohm, RC = 1.32Kohm, RE = 3.97Kohm, VCC = -12.00V, Beta = 287.00, calculate IC current with full analysis.
In the circuit given above VS = 17,3V, R1 = 11202, R2 = 11k1,If RL = 17.4kN and Vzener-5.6, how many mW will P(zener) be?
The R, L and C circuit has resistance, R=10Ω, inductance, L= 107 milli-Henry and Capacitance, C=80 micro-farad. The supply voltage is 120 Volts-RMS with a frequency of 60 HZ. What is the power dissipated, across the resistor of the circuit in units of Watts?
Identify the equation that proves Kirchhoff's Voltage Law for the circuit below given the following:ES1 = 8 V, ES2 = 14 V, R1 = 12 Ω, R2= 10 Ω, R3 = 22 Ω, and IT = 0.5 A
1 Ia = ?? A 2.ib= ?? A 3 Vx = ?? 4 power at Rx = ?? 5 power at Rb = ??
In the voltage regulator in figure 2 below, Vi=15V, Vz=10V, Ri=200 ohms, and Pz(max)=400mW. Determine Il, Iz, Ii, if Rl=350 ohms
The values of the circuit elements are given below.Accordingly |I| What is its value (the maximum value of its current)? V=110 phase 40 VR1=10 ohmsR2=12 ohmsR3=14 ohmsL1=j15 ohmsL2=j8 ohmsM=j15 ohmsC1=-j5 ohmsC2=-j12 ohms
Estimate voltage E2 when E1=90sin2400t V, R1=R2=20 ohms, L1= L2=3mH and M=0.15mH
determine the following by DC Analysis. a. IDQ b. VGse c. VDS RD=4 KOhms VGG=2volt
Calculate the value of VCC. at VE=4V, RE=339 ohm, IB=19uA, RC=2803ohm and VCE=11V
Current | I | What is the value (maximum value of the current)?Values of circuit elements:V= 120 phase 50 VR1= 5 OhmsR2= 12 OhmsR3= 12 OhmsL1= j10 OhmsL2= j10 OhmsM= j13 OhmsC1= -j17 OhmsC2= -j17 Ohms
Three generators are rated as follows: G1: 100MVA, 33kV, xg1 = 0.1pu G2: 150MVA, 32kV, xg2 = 0.08pu G3: 110MVA, 30kV, xg3 = 0.12pu. Determine the reactance of the generator corresponding to base values of 200MVA and 35kV