Answered: If a system does not change its volume…

Science

Chemistry

If a system does not change its volume during the course of a process, does it dopressure–volume work?

Living By Chemistry: First Edition Textbook

1st Edition

ISBN:9781559539418

Author:Angelica Stacy

Publisher:Angelica Stacy

ChapterU3: Weather: Phase Changes And Behaviour Of Gases

SectionU3.6: Sorry, Charlie: Charles's Law

Problem 5E

See similar textbooks

Related questions

Q: According to the opposite figure, the ideal gas volume is reached from 1 to 2 volumes during three…

A: The ideal gas law is the equation of state of a hypothetical ideal gas (in which there is no…

Q: If the heat is supplied to the gas and piston move by distance L due to that then what is the work…

A: Let the piston of area of cross section ‘A’ move through a distance l, so that the gas expands by a…

Q: exothermic processes?

Q: 2. Sulfur dioxide gas is reacted with oxygen gas to produce sulfur trioxide gas: SO2(g) + O₂ → SO If…

Q: The table provides data for two CH3OH(l) samples. Based on this information, which of the following…

A: The two given samples are- Sample 1- 125.0 mL of CH3OH at 36°C Sample 2- 250.0 mL of CH3OH at 18°C…

Q: The diagram below shows how a chemical reaction in a cylinder with a piston that affects the volume…

A: a)Here after the reaction the volume is decreasing. That is Vfinal < V initial.Since the work is…

Q: Distinguish between work and heat at the macroscopic level

A: Step 1: At the macroscopic level, there is no difference between work and heat, and they are both…

Q: calculate change in internal energy for each of thr following a) a gas absorbs 63 KJ of heat while…

A: The first law of thermodynamics is based on law of energy conservation. This states change in…

Q: An adiabatic process is one that involves no heat transfer. What is the relationship between work…

A: Energy in the form of heat can be gained or lost by the system but in the Adiabatic process are…

Q: Describe what happens when a heat engine runs backwards.

A: Explained as follows

Q: What is Pressure-Volume Work?

A: The work which is done by some change in the volume of system against any applied external pressure…

Q: The internal energy of a gas changes from 12 calories to 15 calories when 8 calories of heat is…

A: Welcome to bartleby !

Q: Joules can be converted into units of energy known as calories: 1 Joule = .24 Calories To convert…

A: Given: Total work = 1299 J

Q: What difference is necessary for heat to flow between two systems? Can you think of an exception to…

A: Applying second law of thermodynamics The heat flow always take place hot body to cold body unless…

Q: A mixture of krypton and oxygen gas is expanded from a volume of 23.0L to a volume of 81.0L, while…

A: The work done on the gas mixture is calculated using equation,

Q: A typical hot-air balloon has a volume of 22.0 m3 when inflated. How much work (in J) must be done…

A: Given: Atmospheric pressure = 762 torr. And final volume of balloon = 22.0 m3 = 22000 L…

Q: Differentiate between Work and Heat at the macroscopic level.

A: Both heat and work at macroscopic level are similar and are mode of transportation of energy.

Q: An adiabatic process is one that involves no heat transfer.What is the relationship between work and…

A: Introduction: From the First law of thermodynamics, Internal energy is a property of the system…

Q: Calculate the specific heat capacity of iron according to

Q: Measurements show that the enthalpy of a mixture of gaseous reactants decreases by 123. kJ during a…

A: Given: The enthalpy of the mixture i.e. system is decreasing by 123 KJ. And the work done on the…

Q: When heat is added to a gas during a constant volume (isochoric) process, * The work done by the gas…

A: ANSWER IS

Q: Energy can be used to perform work on a system or by a system. O True O False

A: ANS: TRUE IF WORK PERFORMED BY A SYSTEM ENEGY TRANSFERE FROM SYSTEM TO SURROUNDINGS(WORK BY SYSTEM)…

Q: Does thermal energy can increase even if the average kinetic energy is constant?

A: Thermal energy depends on the temperature and kinetic energy as follows.

Q: How much energy does it take to raise the temperature of 48g of liquid water by 43oC? Please round…

A: Given: Mass = 48 g Change in temperature = 43°C

Q: For each of the following events, the system is in italics.State whether heat, work, or both is…

A: When air is pumped inside an automobile tire, the volume of the tire increases gradually and the gas…

Q: How much work is done when a 105 g tomato is lifted 19.8 m?

A: In the Question, it is mentioned that 105 g Tomato is lifted to 19.8 m, this indicates Gravity comes…

Q: A sample of gas occupies a volume of 68.1 mL. As it expands, it does 142.5 J of work on its…

A: The work done by a gas is given by expression (1), in which, w represents the work done, P…

Q: Define the term pressure-volume work?

A: The term pressure-volume work has to be defined below,

Q: When energy is exchanged between the system and the surroundings, it is exchanged as either .... or…

A: The study of exchange of energy between system and surroundings is called Thermochemistry. On the…

Q: How can the thermometer in the flask on the previous page be used to demonstrate the relationship…

A: To explain the relationship between heat transfer and Kinetic energy , at first we have to know "…

Q: A sample of gas occupies a volume of 74.8 mL74.8 mL. As it expands, it does 117.4 J117.4 J of work…

Q: What is the work done by the system in step 1?

Q: A sample of gas under a pressure of 622 mm Hg has a temperature of of 233 K. The pressure is…

Q: 1. In the laboratory of an educational institution there is a calorimeter like the one shown in the…

A: Answer 1: The flow of heat always takes place from a body at higher temperature to a body at lower…

Q: A sample of gas occupies a volume of 71.2 mL. As it expands, it does 123.2 J of work on its…

A: Given, pressure = 783 Torr Initial volume = 71.2 mL Work = 123.2 J

Q: Distinguish between work and energy at the macroscopic level

A: Both heat and work at macroscopic level are similar and are mode of transportation of energy.

Q: An electrical heater is used to supply 105.0 J of energy to a 15.0 g sample of aluminum (specific…

A: The heat supplied to a sample of aluminium is 105 J. The final temperature is calculated as,

Q: 1. Will dumping heat into a system necessarily raise the temperature of the system? Explain.

A: Heat is a form of energy that is transferred in three ways viz. conduction, convection and…

Q: Thermodynamics is a branch of physical chemistry that deals with thermal changes.

A: Given: Thermodynamics. To find : statement is True or false. Solution : As we know that, There are…

Q: 7,845 cal is equal to how many Joules

A: Given that a question of 7845 calories is change of joule. 1 calories is equal to 4.184 joules

Q: The exchange of energy between a system and its surroundings can occur in two ways: _____________…

A: In thermodynamics, a closed system can exchange energy (as heat or work) but not matter, with its…

Q: How many grams of C6H6 must decompose according to the following chemical equation to transfer 430KJ…

A: Given, a chemical reaction as follows,C6H6(l)→3C2H2(g) ∆H =630 kJwe are asked to calculate the…

Q: A 5 L of gas expanses (ΔV) against a pressure of 742 mmHg. Calculate the quantity of work associated…

A: A numerical problem based on work done, which is to be accomplished.

Q: A gas expands at a constant pressure of 1 bar from 4 liter to 5 liters, how much work is done by the…

Q: Calculate the pressure-volume work done when a system containing a gas expands from 56 liters to 114…

A: Initial Volume of gas = 56 L Final volume of gas = 114 L Constant external pressure = 3.017 atm

Question

If a system does not change its volume during the course of a process, does it do
pressure–volume work?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

hat difference is necessary for heat to flow between two systems? Can you think of an exception to your answer?
Suppose heat flows into a vessel containing a gas. As the heat flows into the gas, what happens to the gas molecules? What happens to the internal energy of the gas?
Draw a cylinder with a movable piston containing six molecules of a liquid. A pressure of 1 atm is exerted on the piston. Next draw the same cylinder after the liquid has been vaporized. A pressure of one atmosphere is still exerted on the piston. Is work done on the system or by the system?
Redraw the cylinder in Question 77 after work has been done on the system.
Consider a mixture of air and gasoline vapor in a cylinder with a piston. The original volume is 40. cm3. If the combustion of this mixture releases 950. J of energy, to what volume will the gases expand against a constant pressure of 650. torr if all the energy of combustion is converted into work to push back the piston?
In which of the following systems is(are) work done by the surroundings on the system? Assume pressure and temperature are constant. a. 2SO2(g)+O2(g)2SO3(g) b.CO2(s)CO2(g) c. 4NH3(g)+7O2(g)4NO2(g)+6H2O(g) d.N2O4(g)2NO2(g) e.CaCO3(s)CaCO(s)+CO2(g)
If pumping up an automobile tire is assumed to be adiabatic and reversible, what is the new temperature of the air if a tire is pumped from 14.7 psi to 46.7 psi using air whose initial temperature is 22 C? Use = 7/5.
Determine whether the statements given below are true or false. Consider enthalpy (H). (a) It is a state property. (b) qreaction(atconstantP)=H=HproductsHreactants (c) The magnitude of H is independent of the amount of reactant. (d) In an exothermic process, the enthalpy of the system remains unchanged.
9.11 Analyze the units of the quantity (pressurevolume) and show that they are energy units, consistent with the idea of PV-work.