Answered: If all the sequence voltages at the…

If all the sequence voltages at the fault point in a power system are equal, then the fault is a line to ground fault double line to ground fault line to line fault three-phase fault

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter9: Unsymmetrical Faults

Section: Chapter Questions

Problem 9.2P

See similar textbooks

Related questions

Q: The least common fault in 3-phase power systems is O Three-phase short circuit O Single line to…

A: Choose the correct option The least common fault in 3 phase power system? as per our guidelines…

Q: 5.26 An unloaded generator with a pre-fault voltage 1 pu has the following sequence impedance: Z, =…

A: Given, An unloaded generator with pre-fault voltage, E = 1 pu Zero sequence impedance, Zo=j0.15 pu…

Q: QUESTION 7 The % age reactance of the system up to the fault point is 17% and the base MVA is 59.…

A: Given: % reactance of the system upto the fault, Xeq=17%=0.17 Base MVA is 59.

Q: 5.The most frequently occurring fault in electrical power systems is Immersive reader. A)…

A: There are two types of fault namely, Symmetrical faults Assymetical faults

Q: 30kV, 50MVA generator having a solidly grounded neutral and Z1 = 0.25pu, Z2=0.15pu and Z0=0.05pu.…

A: Let Zn represents the limiting reactance. Let us also assume that the fault current is equal to 1…

Q: Due to the fault at bus number -4 the Circuit breaker connected to the phase "B" starts functioning…

A: In this question we need to find a type of fault and fault current through circuit breaker.

Q: A 50 MVA, 11 kV three-phase alternator was subjected to different types of faults. The fault…

A: We have been given an 3-phase 50 MVA alternator which was subjected to different types of fault.…

Q: If all the sequence voltages at the fault point in a power system are equal, then the fault is a…

A: When all the sequence voltages at the fault point in a power system are equal, then the fault is a…

Q: Draw the schematic diagram of a double line to ground fault and basic equipment of a substation.

A: A double line to ground fault is also known as a phase to phase to ground fault, in this type of…

Q: 5.26 An unloaded generator with a pre-fault voltage 1 pu has the following sequence impedance: Z =…

Q: 25) What is the type of electrical fault shown in the diagram : XA) Phase to phase to ground. (B)…

A: In this question we will find type of fault....

Q: The chances of faults in underground system are . . as compared to overhead system less more O above…

A: The difference between underground system and overhead system is given below: Overhead system…

Q: For the diagram shown below find fault current If in terms of their fault impedance with their…

A: The given circuit is shown below, The above circuit is a three phase generator with a fault current…

Q: GFCI Circuit Breaker means O a. Great Fault Circuit Interrupter circuit breaker O b. Ground Fault…

A: An automatically operated electrical switch for protecting electrical circuits from damage that may…

Q: In its simplest form, ____ completes a path through which fault current can flow. Select one: A.…

A: Reason - Because this path has the least resistance. The earth is a good conductor due to its…

Q: In case of permanent fault, for the coordination of protective devices the following data is…

A: all of the above .

Q: 1-The following sequence currents were recorded in a power system under a fault condition…

A: In this question we will find fault type....

Q: A 12 MVA, 132/6.6 kV, transformer having a reactance of 0.15 pu is fed from an infinite bus. The…

A: The components given in the circuit will be replaced by per unit reactance respectively. The…

Q: component of current equal to zero. The nature of fault is a.Three phase fault b.Double line to…

Q: 3-phase fault is the severe fault among all other faults True False

A: Choose the correct option Is it true or false The given Statment "3 phase fault is severe fault…

Q: What are different types of fault in electrical power system

A: The fault in the power system is expressed as the any unwanted or abnormal condition of the system…

Q: 1) Prepare data for fault analysis of the system (see figure below). Recommended base MVA is 10 MVA

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: ence components of the fault current are as Ipositive 12 p.u., Inegative and Izero The type of fault…

A: SOLVE ABOVE QUES

Q: 7.In a line-to-ground fault we can expect that A) There are no currents to ground. B) The…

A: Single line to ground fault is asymetrical fault that makes the system unbalance. Sequence networks…

Q: 5. The Metallic Shield provides a path for Fault and Leakage Currents. Select one: True False

A: Given The Metallic Shield provides a path for Fault and Leakage Currents.

Q: A report on Fault analysis in presence of renewable energy sources.

A: Fault in electrical equipment or apparatus refers to an imperfection in the electrical circuit due…

Q: 1- Complete the table below No Type of Fault Operation of Relay 1 Phase to Ground fault (Earth…

A: For phase to ground fault : A current-based ground-fault relay may look for ground-fault current in…

Q: The using of relay is * Break the fault current O Sense the fault Sense the fault and direct to trip…

A: Current transformer is used to step down high current and then the output is feed to relay.

Q: When a line to ground fault occurs, the current in a faulted phase is 100 A.What will be the zero…

A: In this answer we will find the zero sequence component of the current as shown below.

Q: Single line to ground fault is one type of the symmetrical fault. Select one: True False

A: Need to find true false

Q: The least common fault in 3-phase power systems is O Line to line fault O Three-phase short circuit…

Q: A fault exists in a three-phase system is depend on the insulation level of the rated cable. Analyse…

A: Given A fault exists in a three-phase system is depend on the insulation level of the rated cable.…

Q: .The most severe fault in the power system is three phase fault . Select one?: O True O False

A: Given The most severe fault in the power system is three phase fault . Select one O True O False

Q: Location of fault is difficult in overhead line: Select one: O True O False

A: Need to find true false

Q: 26) What is the type of electrical fault shown in the diagram : (A) Three Phase. (B) Phase to phase…

Q: Question 6 Which of the following has the highest percentage of occurrence in a power networl L-L…

A: In this question , we will find which fault has highest percentage of occurrence...

Q: The chances of faults in underground system are as compared to overhead system less more above none

A: Given: The chances of faults in underground system are ________ as compared to overhead system?

Q: In a power system the short circuit KVA due to symmetrical fault occurred away from generating…

A: Short circuit MVA =base MVA/equivalent impedance seen from fauld point. From above short circuit MVA…

Q: Which of the following is the purpose of conducting fault studies? To determine fault voltages All…

A: In power system the fault analysis is done in order to determine the information about the selection…

Q: 4.In a double line-to-ground fault we can expect thatImmersive reader A) There are currents in the…

A: Faults are a part and parcel of power system. There are various types of faults in power systems…

Q: Different type of fault in power system

A: List out the Different types of fault in power system

Q: STRF = 6 MVA XTRF = % 3 UB / Uc = 36 kV/6 kV Generator A B C D KA XHCD = j 0,5 Ohm Kci Kc KB XHAB =…

A: Consider the Base MVA =4 MVA Base KV=36 KV

Q: Q: A three phase alternator 100 MVA, 13.5 KV, exposure to types of faults are fallowing: i) Balanced…

A: 3 phase fault current = 0.437 pu I3ϕ =EX10.437 =1X1X1 =10.437 =2.28 pu Line to Line fault current =…

Q: 3. The most famous fault in a power system is a) Symmetrical three phase fault b) Single line to…

Q: Due to the failure of circuit breaker the two phases of bus bar connected to generator are short…

A: If two phases of bus bar connected to generator are short circuited through fault impedance of j0.l…

Q: b) The general function of the circuit breaker (CB) is to close and open the circuit to be able to…

A: “Since you have asked multiple questions, we will solve the first question for you. If youwant any…

Q: Single line to ground fault is one type of the unsymmetrical fault. Select one: O True O False

A: During line to ground falut positive, negative and zero sequence currents are available.becaue of un…

Q: State some applications of series and parallel circuits

A: As per our company guidelines we are supposed to answer only first one question. Kindly repost other…

Q: When a line to ground fault occurs, the current in a faulted phase is 100 A.What will be the zero…

A: In this answer let us try to understand what is the value of the zero sequence component current…

Concept explainers

Current Division Method

The generalized current divider formula is given by the following relation below,

Question

q10

If all the sequence voltages at the fault point in a power system are equal, then the fault is a
line to ground fault
double line to ground fault
line to line fault
three-phase fault

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

5.The most frequently occurring fault in electrical power systems is Immersive reader. A) Symmetrical three-phase fault B) Line to ground fault C) Line to Line Fault D) Double Line to Ground Fault E) N. A.
he phase sequence of positive sequence current will be a. Unit matrix b. a-c-b c. b-a-c d. a-b-c 75 percentage of the fault that happens in a power system are ____________ . a. THREE PHASE Fault b. GROUND FAULT c. SINGLE LINE TO GROUND FAULT d. Two phase fault
The series fault is equal to : -open conductor fault -Line-to-Line fault -Double Line-to-Ground fault -Line-to-ground fault
7.In a line-to-ground fault we can expect that A) There are no currents to ground. B) The voltages at the fault point with respect to ground are zero in all three phases. C) The current in the faulted phase flows to ground. D) There are short circuit currents in all three phases. E) N. A.
IN A POWER SYSTEM WITH NEGLEBLE RESISTANCE , THE THREE PHASE FAULT CURRENT AT A POINT IS 8 PU . THE SERIES REACTANCE TO BE INSERTED AT THE FAULT POINT TO LIMIT THE SHORT CIRCUIT CURRENT TO 5 PU IS
4.In a double line-to-ground fault we can expect thatImmersive reader A) There are currents in the ground connections. B) The current values in the ground connections are zero. C) Short-circuit currents exist in all three phases. D) The currents in the faulted phases are equal. E) N. A.
1. component of current equal to zero. The nature of fault is a.Three phase fault b.Double line to ground fault c.Single line to ground fault d.Line to line fault 2.if all the three sequence currents at the fault point in a power system are equal, then the type of the fault is a.Line to line fault b.Three phase fault c.Double line to ground fault d.Single line to ground fault 3- Voltage at Slack bus a. Remains same in all the iterations b. Varies in each iteration c. Changes in each iteration d. Will not remain constant 4-The information cannot be obtained from power flow study is a.Fault voltage at slack bus b.fault current at generator buses c.Phase angles of load bus voltages d.Stability of generator i uploded the houndots (book )here :https://seomidea.com/hct/nu.pdf
What type of fault is Single phase to ground fault in power system.(Symmetrical or Unsymmetrical). Discuss the chance of occurrence of the above-mentioned type of fault.
a) Classify the four categories of 3 phase power system faults we experience in our electrical power industry. b) Explain the emergence of such power systems fault as required in (question 1a)? c) Point out each type of fault specified under (a). d) Produce the (1D) design of the three-phase star connected faults stated under(b)
8.In a line-by-line failure we can expect Immersive reader A) Currents exist in the ground connections. B) The current values at the ground connections are zero. C) Short-circuit currents exist in all three phases. D) The voltages at the fault point with respect to ground are zero in the faulted phases. E) N. A.
When a line to ground fault occurs, the current in a faulted phase is 100 A.What will be the zero sequence current in this case?
Different type of fault in power system