Answered: If each resistor is rated at 0.50 W…

If each resistor is rated at 0.50 W (maximum without overheating), what is the maximum voltage that can be applied across the whole network?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter9: Current And Resistance

Section: Chapter Questions

Problem 89CP: Consider a resistor made from a hollow cylinder of carbon as shown below. The inner radius of the...

See similar textbooks

Related questions

Q: Three identical resistors are connected in series. When a certain potential difference is applied…

Q: The voltage drop through resistors #1 and #2 is the same, but resistor #1 has two times greater…

A: The power dissipated by resistor is equal to, P = V2/R Where, P = power V = voltage R = resistance…

Q: 15.0 (2 10.0 Q 20.0 Q 40.0 V イ介介分 16.0 Q

A: Given Data : The voltage of the battery is given as V = 40V The above-shown circuit has 2 resistors…

Q: If the current through a resistor is increased by a factor of 2, how does this affect the power…

A: Given , current through a resistor is increased by a factor of 2 Power dissipated = ?

Q: If the current through a resistor is decreased by a factor of 2, how does this affect the power…

A: Given, Current through a resistor decreased by a factor of 2 Let current I A and resistance= R ohm…

Q: The power absorbed by the resistor in the following circuit is: 10 kN 5 V Select one: O a. -0.25 W O…

A: R = 10 k ohm R = 10000 ohm V = 5 volts

Q: 10.00 A`is flowing through a 5.0-ohm resistor. How much power is being dissipated? W 50.0 2.5KW W…

A: Given data : Current (I) = 10.00 A Resistance (R) = 5.0 Ω Required: Power (P)

Q: If the current through a resistor is decreased by a factor of 4, how does this affect the power…

Q: A battery of 9V is connected in series with resistors of 0.2Ω, 0.3Ω, 0.4Ω ,0.5Ω and 12 Ω,…

Q: You need a 45 W resistor, but the stockroom has only 20 W and 50 W How can the desired resistance be…

Q: Find the voltage drop across 1802 resistor if the source of the circuit is 24.5volts. Submit…

Q: A resistor draws 60 W power then connected across a potential difference of 120V. What power does…

Q: A circuit contains four resistors. Resistor R has a resistance of 49.0 2, resistor R, has a…

A: Power dissipation P = I2 R

Q: What is the total power (W) dissipated in the two resistors in the circuit shown if R1=10ohms,…

A: Given Data : The resistance of resistor R1 is given as R1=10 Ω The resistance of resistor R2 is…

Q: R3 R2 ww

A: Since all the resistors are in parallel connection, the voltage drop across each resistor will be…

Q: A circuit in a student’s room has a 15 A circuit breaker. One evening, she plugs in a computer (240…

A: In the household wiring, the electrical instruments are connected in parallel. Thus, in the room,…

Q: Given the following combination of resistors below: If the total resistance of the combination…

Q: If there is 60 v across a 680 ohm resistor, what is the power?

A: Given data: Voltage (V) = 60 V Resistance (R) = 680 Ω Required: Power (P)

Q: A 120-Ohm resistor is in series with unknown resistor. The voltage drop across the unknown resistor…

Q: Three 100-Q resistors are connected as shown in 100 Q Figure. The maximum power that can safely be…

Q: How many 0.5W resistors, each of the same resistance, must be used to produce an equivaler 3.0 kN ,…

A: Given:- The power of the single resistor = 0.5 W The total equivalent resistor is 3 KΩ= 3000 Ω…

Q: Ritche The potential difference across a 100 ohm resistor is 4.0 volts . What is the power…

A: All three resistance connect in parallel

Q: A meter having 0-1000HA range and 10000 resistance is required to be changed to 0-100 mA meter. The…

Q: What is the minimum number of 8 Ω resistors arranged in series that would be necessary to keep the…

Q: The constant potential difference across a 2 ohm resistor is 20 volts. How many watts of power are…

Q: Which resistor in the following figure consumes the largest power? 30 100 10 V O 30 O 50 O All…

A: We know the expression for power is P=V2RP∝ V2P∝1R From the above expression we can seen that power…

Q: The value of a resistor that carries 2 A when connected to 10 V is

Q: As more resistors are added in series to a constant voltage source, the power supplied by the source…

A: Given data: Resistors are added in series Voltage is constant Required: The changes in the power…

Q: In the circuit shown in the next Figure, PMCC has a full scale of 1mA meter movement with an…

Q: In the circuit shown, how much power is consumed by the resistor? V=6V 400 0.9 W O 0.3 W O 0.7 W 0.5…

A: Given data The potential difference across the circuit is V = 6 V The magnitude of the resistance is…

Q: The power supply voltage is 15 V. Resistor 1 has a resistance of 1.5 ohms. Resistor 2 has a…

A: The power supply voltage The voltage across each branch of the parallel combination is

Q: If the current through a resistor is increased by a factor of 2, how does this affect the power…

A: The power in terms of current and resistor is P=I2R

Q: Find the voltage drop across 180 resistor if the source of the circuit is 12.5volts. Submit solution…

A: in this question we determine voltage across 18 ohm resistance.

Q: Two resistors are connected in parallel to a 220 V line. R1=50 ohms and R2=100 ohms. How much power…

A: Given value--- R1 = 50 ohms. R2 = 100 ohms . voltage = 220 V. We have to find--- How much power…

Q: A 5.0 A current is set up in a circuit for 6.0 min by a rechargeable battery with a 6.0 V emf. By…

Q: Three resistors, rated at 100.02, 200.0 2, and 300.0 2, are connected in parallel to a 12.0 V…

A: Given data: Three resistors are connected in parallel R1 = 100.0 Ω R2 = 200.0 Ω And R3 = 300.0 Ω…

Q: 50 50 80 C.)1. the equivalent/total resistance 2. the current from the power supply 3. the current…

Q: Find the voltage drop across 1802 resistor if the source of the circuit is 12.5volts. Submit…

Q: A 120 resistor is connected in parallel with a series combination of resistor of 8.02 and 16.00. If…

A: solution as

Q: How much power is dissipated by the 2Ω resistor? Suppose that ΔV1 = 3V and ΔV2 = 6V

A: Given: ∆V1=3 V∆V2=6 V

Q: If the current through a resistor is decreased by a factor of 4, how does this affect the power…

A: Given: Current I'=I4

Q: What must be the value of R in the network of resistors for the lotal resistance to be 10 12 ww ww…

Q: The temperature coefficient of resistance of a wire is 0.00125 per degree celcius. At 300K its…

A: Given Temperature coefficient, TRC = 0.00125 /°C At ,T1 = 300 K , Resistance, R1= 1 ohm for…

Q: How many kWh of energy does a 550 W toaster use in the morning if it is in operation for a total of…

A: Given: power of toaster P =550 W operation time each day t=6 min = 6/60 hr =0.1 hr cost per KWh =…

Q: If you were to place a 3kΩ resistor across a 9 volt battery, what is the power dissipated from this…

A: Given data: Resistance (R) = 3 kΩ = 3000 Ω Battery (V) = 9 V Required: Power (P)

Q: The voltage V across a resistor was measured to be 898 mV and the current / through the resistor was…

A: Given Data:- The voltage across the resistor is V = 898 mV. The current across the resistor is I =…

Q: What power is dissipated by a 40 Ω resistor when a voltage of 6 V is connected across it?

A: Given : R = 40 Ω V = 6 V

Question

Question is attached.

Constants
A 3.0-kN and a 2.7-kN resistor are connected in
parallel; this combination is connected in series
with a 1.3-kN resistor.
Part A
If each resistor is rated at 0.50 W (maximum without overheating), what is the maximum voltage that can be applied
across the whole network?
Express your answer to two significant figures and include the appropriate units.
?
Vmax =
Value
Units
Submit
Request Answer

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A 160F capacitor charged to 450 V is dischargedthrough a 31.2k resistor, (a) Find the time constant.(b)Calculate the temperature increase of the resistor, given that its mass is 2.50 g and its specific heat is 1.67kJ/kg °C,noting that most of the thermal energy is retained in the short time of the discharge, (c) Calculate the new resistance, assuming it is pure carbon. (d) Does this change in resistance seem significant?
Consider a circuit that consists of a real battery with an emf and an internal resistance of r connected to a variable resistor R. (a) In order for the terminal voltage of the battery to be equal to the emf of the battery, what should the resistance of the variable resistor be adjusted to? (b) In older to get the maximum current from the battery, what should the resistance variable resistor be adjusted to? (c) In order for the maximum power output of the battery to be reached, what should the resistance of the variable resistor be set to?
Ralph has three resistors, R1, R2, and R3, connected in series. When connected to an ideal emf source E1, current I1 flows through the resistors. a. If the resistors are instead connected to a second source with E2=2E1, what is the new current through the resistors in terms of the first current? b. Show that, if each resistance is doubled and the resistors are connected in series to the second emf source, the current through the resistors is equal to I1.
A student makes a homemade resistor from a graphite pencil 5.00 cm long, where the graphite is 0.05 mm indiameter. The resistivity of the graphite is =1.38102/m . The homemade resistor is place inseries with a switch, a 10.00-mF capacitor and a 0.50-V power source, (a) What is the BC time constant of the circuit? (b) What is the potential drop across the pencil 1.00 s after the switch is closed?
A 1,00-?O voltmeter is placed in parallel with a 75.0kresistor in a circuit, (a) Draw a circuit diagram of the connection, (b) What is the resistance of the combination? If the voltage across the combination is kept the same as it was across the 75.0-kresistor alone, what is the percent increase in current? (d) If the current through the combination is kept the same as it was through the 75.0-kresistor alone, what is the percentage decrease in voltage? (e) Are the changes found in parts (c) and (d) significant? Discuss.
Consider a resistor made from a hollow cylinder of carbon as shown below. The inner radius of the cylinder is Ri= 0.20 mm and the outer radius is R0 = 0.30 mm. The length of the resistor is L = 0.90 mm. The resistivity of the carbon is =3.5105 m. (a) Prove that theresistance perpendicular from the axis is R=2L1n(R0Ri) . (b) What is the resistance?
Check Your Understanding A strain gauge is an electrical device to measure strain, as shown below. It consists of a flexible, insulating backing that supports a conduction foil pattern. The resistance of the foil changes as the backing is stretched. How does the strain gauge resistance change? Is the strain gauge affected by temperature changes?
A child's electronic toy is supplied by three 1.58-V alkaline cells having internal resistances of 0.0200 inseries with a 1.53-V carbon-zinc dry cell having a 0.100- internal resistance. The load resistance is 10.0 . (a) Draw a circuit diagram of the toy and itsbatteries, (b) What current flows? (c) How much power is supplied to the load? (d) What is the internal resistance of the dry cell if it goes bad, resulting in only 0.500 W being supplied to the load?
A battery has an emf of 15.0 V. The terminal voltage of the battery is 11.6 V when it is delivering 20.0 W of power to an external load resistor R. (a) What is the value of R? (b) What is the internal resistance of the battery?
(a) When the switch S in the circuit of Figure P28.14 is closed, will the equivalent resistance between points a and b increase or decrease? State your reasoning. (b) Assume the equivalent resistance drops by 50.0% when the switch is closed. Determine the value of R.
A 12-guage gold wire has a length of 1 meter. (a) What would be the length of a silver 12-gauge wire with the same resistance? (b) What are their respective resistances at the temperature of boiling water?
A flashing lamp in a Christmas earring is based on an RC discharge of a capacitor through its resistance. The effective duration of the flash is 0.250 s, during which it produces an average 0.500 W from an average 3.00 V. (a) What energy does it dissipate? (b) How much charge moves through the lamp? (c) Find the capacitance, (d) What is the resistance of the lamp? (Since average values are given for some quantities, the shape of the pulse profile is not needed.)