University Physics Volume 2
18th Edition
ISBN: 9781938168161
Author: OpenStax
Publisher: OpenStax
expand_more
expand_more
format_list_bulleted
Textbook Question
Chapter 9, Problem 9.6CYU
Check Your Understanding A strain gauge is an electrical device to measure strain, as shown below. It consists of a flexible, insulating backing that supports a
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
A high tension (HT) supply of, say, 6 kV must have a very large internal resistance. Why?
The interior of thehuman body has an electrical resistivity of 0.15 Ω # m. (a) Estimatethe resistance for current flowing the length of your index finger.(For this calculation, ignore the much higher resistivity of yourskin.) (b) Your muscles will contract when they carry a currentgreater than 15 mA. What voltage is required to produce this current through your finger?
A 0.20-ΩF capacitor is to be charged through a resistor so that it becomes 63 percent charged in0.10 s. What should the resistance of the capacitor be?
Chapter 9 Solutions
University Physics Volume 2
Ch. 9 - Check Your Understanding Handheld calculators...Ch. 9 - Check Your Understanding Circuit breakers in a...Ch. 9 - Check Your Understanding In Example 9.4, the drift...Ch. 9 - Check Your Understanding The current density is...Ch. 9 - Check Your Understanding Copper wires use...Ch. 9 - Check Your Understanding A strain gauge is an...Ch. 9 - Check Your Understanding The resistance between...Ch. 9 - Check Your Understanding The voltage supplied to...Ch. 9 - Check Your Understanding Electric motors have a...Ch. 9 - Check Your Understanding Is the efficiency of the...
Ch. 9 - Can a wire cany a current and still be...Ch. 9 - Car batteries are rated in ampere-hours (Ah). To...Ch. 9 - When working with high-power electric circuits, it...Ch. 9 - Incandescent light bulbs are being replaced with...Ch. 9 - It was stated that the motion of an electron...Ch. 9 - Electric circuits are sometimes explained using a...Ch. 9 - An incandescent light bulb is partially evacuated....Ch. 9 - The [R drop across a resistor means that there is...Ch. 9 - Do impurities in semiconducting materials listed...Ch. 9 - Does the resistance of an object depend on the...Ch. 9 - If aluminum and copper wires of the same length...Ch. 9 - In Determining Field from Potential, resistance...Ch. 9 - Shown below are the results of an experiment where...Ch. 9 - The current I is measured through a sample of an...Ch. 9 - Common household appliances are rated at 110 V,...Ch. 9 - Your electric bill gives your consumption in units...Ch. 9 - Resistors are commonly rated at 18W,14W,12W ,1 W...Ch. 9 - Ail immersion heater is a small appliance used to...Ch. 9 - What requirement for superconductivity7 makes...Ch. 9 - Name two applications for superconductivity listed...Ch. 9 - A Van de Graaff generator is one of the original...Ch. 9 - A cathode ray tube (CRT) is a device that produces...Ch. 9 - How many electrons flow through a point in a wire...Ch. 9 - A conductor carries a current that is decreasing...Ch. 9 - The quantity of charge through a conductor is...Ch. 9 - The current through a conductor is modeled as...Ch. 9 - The charge on a capacitor in a circuit is modeled...Ch. 9 - An aluminum wire 1.628 mm in diameter (14-gauge)...Ch. 9 - The current of an election beam has a...Ch. 9 - A high-energy proton accelerator produces a proton...Ch. 9 - Consider a wire of a circular cross-section with a...Ch. 9 - The current of an electron beam has a measured...Ch. 9 - The current supplied to an ail conditioner unit is...Ch. 9 - What current flows through the bulb of a 3.00-V...Ch. 9 - Calculate the effective resistance of a pocket...Ch. 9 - How many volts are supplied to operate an...Ch. 9 - What is the resistance of a 20.0-m-long piece of...Ch. 9 - The diameter of 0-gauge copper wire is 8.252 mm....Ch. 9 - If the 0. 10.0-mm-diameter tungsten filament in a...Ch. 9 - A lead rod has a length of 30.00 cm and a...Ch. 9 - Find the ratio of the diameter of aluminum to...Ch. 9 - What current flows through a 2.54-cm-diameter rod...Ch. 9 - (a) To what temperature must you raise a copper...Ch. 9 - A resistor made of nichrome wire is used in an...Ch. 9 - Of what material is a resistor made if its...Ch. 9 - An electronic device designed to operate at any...Ch. 9 - (a) Of what material is a wire made, if it is 25.0...Ch. 9 - Assuming a constant temperature coefficient of...Ch. 9 - A copper wire has a resistance of 0.500 at 20.0°C...Ch. 9 - A 2.2-k resistor is connected across a D cell...Ch. 9 - A resistor rated at 250 k is connected across two...Ch. 9 - A resistor is connected in series with a power...Ch. 9 - A resistor is placed in a circuit with an...Ch. 9 - The following table show the measurements of a...Ch. 9 - A 20.00-V battery is used to supply current to a...Ch. 9 - What is the maximum voltage that can be applied to...Ch. 9 - A heater is being designed that uses a coil of...Ch. 9 - An alternative to CFL bulbs and incandescent bulbs...Ch. 9 - The power dissipated by a resistor with a...Ch. 9 - Running late to catch a plane, a driver...Ch. 9 - SI. A physics student has a single-occupancy dorm...Ch. 9 - A 0.50-W, 220- resistor carries the...Ch. 9 - Consider a power plant is located 60 km away from...Ch. 9 - A wire is drawn through a die, stretching it to...Ch. 9 - Digital medical thermometers determine temperature...Ch. 9 - Electrical power generators are sometimes "load...Ch. 9 - A 12-guage gold wire has a length of 1 meter. (a)...Ch. 9 - What is the change in temperature required to...Ch. 9 - A coaxial cable consists of an inner conductor...Ch. 9 - A 10.00-meter long wire cable that is made of...Ch. 9 - A nichrome rod that is 3.00 mm long with a cross...Ch. 9 - The temperature in Philadelphia, PA can vary...Ch. 9 - When 100.0 V is applied across a 5-gauge (diameter...Ch. 9 - A wire with a resistance of 5.0 is drawn out...Ch. 9 - What is the resistivity of a wire of 5-gauge wire...Ch. 9 - Coils are often used in electrical and electronic...Ch. 9 - Currents of approximately 0.06 A can be...Ch. 9 - A 20.00-ohm; 5.00-watt resistor is placed in...Ch. 9 - A battery with an emf of 24.00 V delivers a...Ch. 9 - A 12.00-V battery has an internal resistance of a...Ch. 9 - A 10-gauge copper wire has a cross-sectional area...Ch. 9 - The current through a 12-gauge wire is given as...Ch. 9 - A particle accelerator produces a beam with a...Ch. 9 - In this chapter, most examples and problems...Ch. 9 - A current of I= 25A is drawn from a 100-V...Ch. 9 - Consider a square rod of material with sides of...Ch. 9 - A resistor of an unknown resistance is placed in...Ch. 9 - The charge that flows through a point in a wire as...Ch. 9 - Consider a resistor made from a hollow cylinder of...Ch. 9 - What is the current through a cylindrical wire of...Ch. 9 - A student uses a 100.00-W, 115.00-V radiant heater...Ch. 9 - A 12-V car battery is used to power a 20.00-W,...Ch. 9 - A physics student uses a 115.00-V immersion heater...
Additional Science Textbook Solutions
Find more solutions based on key concepts
9.64 The motor of a table saw is rotating at 3450 rev/min. A pulley attached to the motor shaft drives a second...
University Physics (14th Edition)
Particles of light have no mass. Does the Sun’s mass change as a result of all the light it emits? Explain.
Modern Physics
Which of the listed objects would experience the largest change in orbital speed and which would experience the...
Lecture- Tutorials for Introductory Astronomy
(II) A thin film of oil (nO = 1.50) with varying thickness floats on water (nw = 1.33). When it is illuminated ...
Physics for Scientists and Engineers with Modern Physics
Choose the best answer to each of the following. Explain your reasoning. Which moon shows evidence of rainfall ...
Cosmic Perspective Fundamentals
Explain all answers clearly, with complete sentences and proper essay structure if needed. An asterisk (*) desi...
The Cosmic Perspective Fundamentals (2nd Edition)
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- Using your understanding of the nature of internal energy and temperature, explain why we might expect the resistance of a solid to increase if its temperature increases.arrow_forwardA 20.00-V battery is used to supply current to a 10-k resistor. Assume the voltage drop across any wires used for connections is negligible, (a) What is the current through the resistor? (b) What is the power dissipated by the resistor? (c) What is the power input from the battery; assuming all the electrical power is dissipated by the resistor? (d) What happens to the energy dissipated by the resistor?arrow_forwardA long uniform rod of electrically resistive material has a resistance of Roriginal =1Ω. The rod is cut into N equal short pieces which are bundled side-by-side so that the short pieces are parallel to each other. The resistance of the bundled short rods is Rnew = 0.04Ω. What is the value of N? (i.e., how many pieces was the original rod cut into?)arrow_forward
- Equation P = I2R Seems to suggest that rate of increase of internal energy in a resistor is reduced, if the resistance is made less. Equation P = V2/R seams to suggest just the opposite. How do you reconcile this apparent paradox?arrow_forwardan aluminium rod with a square cross section is 1.3 m long and 2.6mm on edge.What is the resistance between its ends? What must be the diameter of a copper rod of length 1.3m of it's resistance is same as that of aluminium rod?arrow_forwardWhat special relationship can be observed if you a have a number of resistors with same ohmic value?arrow_forward
- An ohmic appliance is rated at 100. W when it is connected to a 120. V source. a) If the power company cuts the voltage by 5.0% to conserve energy, what is the current in the appliance? b) W hat is the power consumed by the appliance after the voltage drop?arrow_forwardCan u elaborate the explanation? Does't brightness of lamp depend on power why did they mention only current? How does moving contact to Q increase resistance which then decreases voltage?arrow_forwardHow much would you have to raisethe temperature of a copper wire(originally at20◦C) to increase its resistance by 15 % ? (i.e. ∆T= ?)arrow_forward
- For the circuit shown in FigureP18.20, calculate (a) the currentin the 2.00 - Ω resistor and (b) thepotential difference betweenpoints a and b, ΔV = Vb - Va.arrow_forwardDigital medical thermometers determine temperature by measuring the resistance of a semiconductor device called a thermistor, which has a temperature coefficient of resistivity of α = −0.0600 (°C)-1, after it has reached thermodynamic equilibrium with the patient. What is a patient’s temperature, in degrees Celsius, if the thermistor’s resistance at that temperature is 82.5 % of its value at 37.0°C (which is normal body temperature)?arrow_forwardUnreasonable ResultsTwo resistors, one having a resistance of 145 Ω , are connected in parallel to produce a total resistance of 150 Ω. What is the value of the second resistance?arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
How To Solve Any Resistors In Series and Parallel Combination Circuit Problems in Physics; Author: The Organic Chemistry Tutor;https://www.youtube.com/watch?v=eFlJy0cPbsY;License: Standard YouTube License, CC-BY