If rope BC will fail when the tension becomes 45 kN, determine the greatest vertical load Fthat can be applied to the beam at B. What is the magnitude of the reaction at A for this loading? Neglect the thickness of the beam. 26 kN C 13 |B 2 m 4 m

If rope BC will fail when the tension becomes 45 kN, determine the greatest vertical load Fthat can be applied to the beam at B. What is the magnitude of the reaction at A for this loading? Neglect the thickness of the beam. 26 kN C 13 |B 2 m 4 m

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter11: Fluid Statics

Section: Chapter Questions

Problem 77PE: During heavy lifting, a disk between spinal vertebrae is subjected to a 5000-N compressional force....

See similar textbooks

Related questions

Q: 11. A ball weighing 20 N is dropped from rest from a height of 8 meters above the ground. Assuming…

A: Total mechanical energy is the sum of kinetic energy and potential energy.

Q: 5.44 Both pistons are moving to the left, but piston A has a speed twice as great as that of piston…

A: The data given in the question is: 1. Diameter of the left pipe with piston A, dA=3 m, Therefore,…

Q: 5. Two long parallel conductors separated by 10.0 cm carry currents in the same direction. The 5.00…

A: Magnetic field due to a wire (infinite) carrying current I at distance r is given as B= u°I/(2πr)…

Q: Two loud speakers are placed at opposite ends of a field at the same height. Each speaker is…

Q: What is the Kinetic Energy of a 100 kg object that is moving with a speed of 12.5 m/s? O78125 J O…

A: Given: The mass of the object is 100 kg. The speed of the object is 12.5 m/s.

Q: 6. In a parallel plate capacitor of capacitance C the magnitude of electric field is E. If a…

Q: What is the electric susceptibility of paper with dielectric constant of 2?

A: Electric susceptibility (Xe) is a dimensionless quantity and it is related to Dielectric constant…

Q: Silver has a resistivity of 1.59x10-8 at 20 oC. What is its temperature coefficient of resistance at…

Q: A skateboarder wishes to build a jump ramp that is inclined at a 19 angle and that has a maximum…

Q: Find the amount of time used by a 2,500 kg vehicle that was pushed with 200 N from a stop to a speed…

Q: A ball kicked from ground level at an initial velocity of 68 m/s and an angle 0 with ground reaches…

Q: 1.) Determine the image distance and image height for a 5.00-cm tall object placed 30.0 cm from a…

A: Since we only answer up to 1 question, we’ll answer the 1st question only. Please resubmit the…

Q: Find the constant force F required to give the 20 kg blockB an upward acceleration of D.6m/s² what…

A: If T is the tension then Net force = Pull force - Tension - Frictional force, Acceleration in total…

Q: This would be all of g. how do you get just the z component of the gravitational field

Q: magnitude of resulting acceleration,

A: Given; A 7 kg object is subjected to two forces in newton , F1¯=20i^+30 F2¯=8i-5jMagnitude of…

Q: R = 60 R3 = 42 Rg = 102 A OW R4 = 82 Rg = 62 ReQ R2 = 82 R10 = 22 Re = 62 Rs = 42 R7 = 82 (Says,…

A: This question is based on combination of resistances.

Q: ature of Physics as experimental science... enumerate the order on how physics laws are created...…

A: By nature, laws of Physics are stated facts which have been deduced and derived based on empirical…

Q: particle executes simple harmonic motion, such that at a given time, it is at x=-(1/9)A moving…

A: GivenMass of particle, m=134 g=0.134 kgx=-19AAnd t=0.24 sv=+17vmax

Q: A warehouse worker uses a forklift to raise a crate of pickles on a platform to a height 3.75 m…

A: Given: Mass of system, (combined mass of platform and the crate), M = 300 kg Height upto which it is…

Q: particle is traveling through the Earth’s atmosphere at a speed of 0.750c. To an Earth-bound…

Q: A particle moves along a curve whose parametric equations are x = 3e-4, y = 4 sin 3t, z = 5 cos 3t…

Q: Determine The total elongation of a composite body camying a tensile locid of 5.5kN. d= 350mm E-…

A: Given: Tensile load, F = 5.5 kN = 5500 N L=6 m, d=350 mm, ε=10 MPaL'=5 m, d'=175 mm,…

Q: A student of mass 63.4 kg, starting at rest, slides down a slide 22.2 m long, tilted at an angle of…

Q: A golfer hits a 50g golf ball with a golf club that weighs 200g. At the point of impact, the golf…

Q: truck is traveling south at a speed of 70 km/h toward an intersection. A car is traveling east…

A: Given: Velocity of truck, u→ = 70 -j^ km/hr (taking south as negative y-axis) Velocity of car, v→…

Q: A block of mass 0.1 kg is held against a wall by applying a horizontal force of 5 N on the block. If…

Q: 2. Electromotive force of a battery can be defined with the formula A. E = IR B. E = IR + I C. E =…

A: Please note : As per answering guidelines I can answer the first question only. Since, this is not a…

Q: how is the difference of sensitivity between PET, Gamma Camera, and SPECT?

A: We have to find the difference of sensitivity between PET and SPECT first then PET and Gamma camera.

Q: Calculate the frequency and energy given the following wavelengths, energy and indicate the…

Q: A 5.4 kgkg cat and a 2.5 kgkg bowl of tuna fish are at opposite ends of the 4.0-mm-long seesaw. How…

A: Given: m1= 5.4 kg m3 = 2.5 kg L = 4m m2 = 3.8 kg

Q: A car does a work 15060 J in just 3.00 seconds. What is the power output of the car in horsepower

Q: Photons of wavelength 325nm shine on a metal surface and electrons are ejected. A stopping potential…

Q: How tong 11) A trench in a sea is 10972.8 m deep. If the sea water has an average density of 1.04…

Q: A 500-g ball is dropped from the surface of a tank of water at a speed of 2 m/s. The water exerts on…

A: Mass of the ball=500gram Speed=2m/s Resistance force proportional to instantaneous speed Minimum…

Q: Which of these instruments would vibrate the fastest?

A: ANS: OA bass drum

Q: 30. The components of velocity vectors Ả and B are given below. What is the magnitude of vector sum…

Q: A rabbit is moving in the negative x-direction at 2.70 m/s when it spots a predator and accelerates…

A: Acceleration Acceleration is the change in the velocity of an object in motion for some time. It is…

Q: Resistor in circuit is made of a length of 14awg iron wire. When 10 V is applied across the resistor…

Q: A vertical spring with constant k = 5 N/m and damping constant β = 6 kg/s has one end fixed to a…

A: Spring is hanging from a fixed wall ; if the support is set in motion, that motion would be…

Q: The number of significant figures of the number 6.92 E-3 mm, is: A)2 B)4 C)1 D)3

Q: A skateboarder wishes to build a jump ramp that is inclined at a 19 angle and that has a maximum…

Q: Figura 101 C A B 40

A: let the mass of the suspended body = m Let the tension in the string connected to the suspended body…

Q: A uniform disk of radius 0.491 m and unknown mass is constrained to rotate about a perpendicular…

A: we have, radius r =0.491 m tangential force, ftangential =0.229 N angular acceleration, α=0.115…

Q: Sauss's law tells us that the net electric flux is NOT zero because

A: ANS: b) There is a non-zero amount of net charge within the Gaussian surface.

Q: A light, with wavelength of 1 = 550 nm, passes through a slit and shine = 4.0x10- that is at a…

A: Givenλ=550 nm=550×10-9 mL=0.3 mD=4×10-6 m

Q: List down 5 famous people who has a major contributions to Electromagnetism.

A: Following are the five famous people with great contribution in electromagnetism :- 1. André-Marie…

Q: 1. A 50.0-Qresistor is connected to a 30.0µF capacitor and to a 60.0-Hz, 100-V (rms) source. (a)…

Q: A car rounds a 12 m radius curve at 8 m/s. The magnitude of it's acceleration in m/s²

A: Given: The radius of the path is 12 m. The speed of the car is 8 m/s.

Q: Car A rounds a curve of 150-m radius at a constant speed of 54 km/h. At the instant represented, car…

A: We have to use the concept of relativity velocity to solve the problem

Q: [PROBLEM SOLVING] Show your complete detailed solution. The acceleration of an object as a function…

Concept explainers

Debye Theory of Solids

In solid-state physics, debye theory is used to estimate the phonons contributing to the specific heat capacity in a solid. It explains that the specific heat is a consequence of the vibrations of the atomic lattice of the solid, which is in contrast to the Einstein model. In the Einstein model, solids are treated as independent, non-interacting quantum harmonic oscillators. This model clearly explains the low-temperature dependence of the heat capacity, which is proportional to T3. This is known as Debye T3 law.

Question

If rope BC will fail when the tension becomes 45 kN, determine the greatest vertical load Fthat can be
applied to the beam at B. What is the magnitude of the reaction at A for this loading? Neglect the
thickness of the beam.
26 kN
F
C
13
12
B
2 m
4 m

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Why is force exerted by static fluids always perpendicular to a surface?
Gasoline is piped underground from refineries to major users. The flow rate is 3.00102m3/s (about 500 gal/min), viscosity of gasoline is 3.00102m3/s , and its density is 680 kg/m3. (a) What minimum diameter must be pipe have if the Reynolds number is to be less 2000? (b) What pressure difference must be along each kilometer of be pipe to maintain flow rate?
Do fluids exert buoyant forces in a “weightless" environment, such as in the space shuttle? Explain your answer.
During heavy lifting, a disk between spinal vertebrae is subjected to a 5000-N compressional force. (a) What pressure is created, assuming that the disk has a uniform circular cross section 2.00 cm in radius? (b) What deformation is produced if the disk is 0.800 cm thick and has a Young's modulus of 1.5109N/m2 ?
Check Your understanding Repeat ExampIe12.4 assuming that the forearm is object of uniform density that weighs 8.896 N.
Gauge pressure in the fluid surrounding an infant's brain may rise as high as 85.0 mm Hg (5 to 12 mm Hg is normal), creating an outward force large enough to make the skull grow abnormally large. (a) Calculate this outward force in newtons on each side of an infant's skull if the effective area of each side is 70.0 cm2. (b) What is the net force acting on the skull?
What is density of a woman floats in fresh water with 4.00% of her volume above the surface? (This could be measured by placing her in a Wii marks on the side to measure how much water she displaces when floating and when held under water.) (b) What percent of her volume is above surface when she floats in seawater?
An oil gusher shoots crude 25.0 m the through a pipe with a 0.100-m diameter. Neglecting resistance but not resistance of the pipe, and assuming laminar flow, calculate pressure at be entrance of be 50.0-m-Iong vertical pipe. Take of the oil to be 900 kg/m3 and its viscosity to be 100(N/m2) s (or 1.00 Pa s). Note that you must take into account the pressure due to 50.0-m column of oil in pipe.
Do fluids exert buoyant forces in a "weightless" environment, such as in the space shuttle? Explain your answer.
During heavy lifting, a disk between spinal vertebrae issubjected to a 5000-N compressional force. (a) Whatpressure is created, assuming that the disk has a uniformcircular cross section 2.00 cm in radius? (b) Whatdeformation is produced if the disk is 0.800 cm thick and hasa Young’s modulus of 1.5×109 N/m2 ?
During heavy lifting, a disk between spinal vertebrae is subjected to a 5250-N compression force. a. What pressure is created on the disk, in pascals, assuming that the disk has a uniform circular cross section 2.2 cm in radius? b. What deformation is produced, in centimeters, if the disk is 0.65 cm thick and has a Young’s modulus of 1.65 × 109 N/m2?
Determine the internal force system acting on section 1 by analyzing the FBD of (a) segment AD and (b) segment DB.