If the maximum tension either rope can sustain without breaking is 4700 N, determine the maximum value of the hanging weight that these ropes can safely support. You can ignore the weight of the ropes and the steel cable.

Q: Find the minimum force F to cause movement of the 400/1000 lb. system shown. The 5º wedge is…

A:

Q: The bars AB and AC are joined by a pin at A and a horizontal cable. The vertical cable carrying the…

A: Apply the conditions of equilibirum  RBy+Rcy=200(9.81)=1962N Calculate the length of the rod AB…

Q: If the maximum length of the spring is 40 cm, what average friction force opposes the motion of the…

A:

Q: Weight of the body 30 kg Find the value of the force P that keeps the body in equilibrium on a…

A:

Q: With what force magnitude T must the person pull on the cable in order to cause the scale A to read…

A: Given Data SA=2200 N ω=3000 N To find  the force

Q: The uniform crate shown in the figure weighs 200 lb. It is pulled up the incline by a counterweight…

A: The given problem will be solved in following steps: 1.The relation ship between the acceleration of…

Q: Q1) Find the force F on the bottom of the tank if : K=1.5 m , H= 6 m, D=5 m.

A:

Q: If the spring DB has an unstretched length of 2.7 m, determine the forces in the cable and the…

A:

Q: A flexible cable with supports at the same elevation has a span of 900ft. The cable weighs 0.75 lb /…

A: To determine the maximum tension in the cable T

Q: With what force magnitude T must the person pull on the cable in order to cause the scale A to read…

A:

Q: [P1] Draw the free body digrams for the bodies shown below. In each case, neglect the mass of the…

A:

Q: A wheelbarrow and its contents has a combined weight of 300N, which acts through its centre of mass:…

A:

Q: If the weight of cylinder A is 300N, determine the weight of cylinder C in order to hold the…

A:

Q: A wooden crate is being slid up an incline by two guys. Determine the tension T that the higher man…

A:

Q: A 292-lb box is held at rest on a smooth surface (9 = 15°) inclined by a force, 'P' making an angle…

A:

Q: Determine the minimum horizontal force P, in Newtons, required to hold the crate from sliding down…

A:

Q: A body of mass 10 kg is suspendend through a fan with the help of a rope. Determine the tension in…

A: Data given-   m = 10 kg

Q: The horizontal reaction at support O will be at the 100 lb 1 ft 50 lb 3 ft 3 -3 ft 150 lb O non of…

A:

Q: 2.0m 100 kg 2.0 m 0. 1.5m 1.5m The pulley at E is frictionless. Point B is a pinned connection;…

A:

Q: Determine the tension in the cables AB, AC, and the displacement of the cable AB supporting a lamp…

A: Given         KAB=300 NmL=2 m

Q: b. Consider the following system, where you are applying a load P: cg cg Mathematically, show which…

A: Solution: (a) Given Data: b = 5 h = 7 d = 2

Q: (b) A crane is used to lift a metal cube with a volume of 1 m³ out of seawater. The cable being used…

A:

Q: 2. The sign below hangs outside the physics classroom, advertising the most important truth to be…

A: It is basic mechanics problem, in this we can make free body diagram of joint where mass and cable…

Q: The horizontal reaction at support O will be at the 100 lb 1 ft 50 lb 3 ft 3 ft 3. 4 150 lb O non of…

A: Option 4th is correct. (In the positive direction)

Q: The forces acting on the bob of the pendulum are its weight (W = 2 N) and the tension T in the cord.…

A:

Q: Refer to the system of cylinders arranged as depicted in Fig. 1000 N each and the weight of cylinder…

A: Data given-  WA =WB = 1000 N  WC = 2000 N   rA = rB =  0.6 /2 = 0.3 m  rC = 1.2 /2 = 0.6 m

Q: A hot air balloon is tethered as shown below. Assuming that the balloon is pulling upward with a…

A:

Q: DETERMINE ALL THE FORCES ACTING ON THE SYSTEM GIVEN THAT THE SPRING CONSTANT IS EQUAL TO 20 LB/IN…

A:

Q: g) is sitting on the seat of a swing at the playground. The seat is supported by two cables, one on…

A: Given: m=75 Kg L=5m d=1 mm

Q: A 12.0 kg weight hangs from a 7.50 m pole as illustrated in the diagram.  The pole has a mass of 8.0…

A: Write the given value using suitable variables. Here W signifies given weight, L signifies pole…

Q: NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to…

A:

Q: A cylinder having a mass of 100 kg is to be supported by the cord which wraps over the pipe.…

A: Given Data → Mass (m) = 100 Kg β= 540° μs=0.2 Let us draw the free body diagram of the system

Q: the man is holding up the 35-kg ladder ABC by pushing perpendicular to ladder. The total length of…

A: given data; mass of ladder (m)=35kglenth of ladder (AC)=6mmaximum force (F)=400NAB=2mangle(θ)=?

Q: The uniform crate shown in the figure weighs 200 lb. It is pulled up the incline by a counterweight…

A: The relation between the displacements of block of weight 'W' and the crate will be determined, and…

Q: A cable with supports at the same elevation has a span of 550 ft. The cable weighs 4 lb / ft and the…

A: Given data: Weight of the cable, W = 4 lb/ft. Sag at the midspan of the cable, h = 100 ft. Distance…

Q: THE 500LB BOX IS RAISED USING ROPES AB AND AC. EACH ROPE CAN WITHSTAND A MAXIMUM TENSION OF 2500LB…

A:

Q: a) Calculate the forces in cables AC and AB needed to hold the 20-kg ball D in equilibrium as shown…

A:

Q: A 200# stone is being lifted off the ground by a levering bar. Determine the push P required to keep…

A:

Q: final Consider ACB as two segments (AC & CB) and 5ft each have a weight of 14 lb. If part DE is…

A: Giventwo segments AC and CBeach have a weight of w=14lb

Q: The cylinder having a diameter 2.5 ft weighs 57 lb and is 6 ft long. Determine the reaction (lb.) at…

A:

Q: The forklift supports the engine. Determine the force that this load generates on element FB. Write…

A: A moment is a movement of the body when a body is rotating on an axis. The moment is also known as…

Q: 2m 1m 1m -2m- 2m 2m The crate weighs 450 kg andis supported by three cables as shown in the figure 3…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: Calculate the tension T in the cable which supports the 1000-lb load with the pulley arrangement…

A:

Q: Plot the tension in each cable as a function of d , if d varies from 0 to 8 m. The weight of the…

A:

Q: The uniform crate shown in the figure weighs 200 lb. It pulled up the incline by a counterweight W…

A: The problem has been solved and has been attached. The answers does not match with the given one as…

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.