If the viscosity of water at 68 deg F is 0.1008 poise, compute its absolute viscosity (μ) in pound-seconds per square foot. If the specific gravity is 1.02, compute its kinematic viscosity (v) in square feet per second

If the viscosity of water at 68 deg F is 0.1008 poise, compute its absolute viscosity (μ) in pound-seconds per square foot. If the specific gravity is 1.02, compute its kinematic viscosity (v) in square feet per second

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter8: Time And Time-related Variables In Engineering

Section: Chapter Questions

Problem 12P

See similar textbooks

Related questions

Q: Calculate the density of carbon dioxide at a gauge pressure of 30 kN/m2 and 100°C. Given: R= 189…

A: P1V1T1=P2V2T2131300*V1373=101300*22.7273V1=23.92 lt

Q: Estimate the average blood pressure in a person's foot if the foot is 1.49 m below the aorta, where…

Q: PROBLEM 6: A gasoline line is connected to a pressure gage through a double-U manometer, as shown.…

Q: A manometer is used to measure the pressure in a tank filled with air. The fluid has a specific…

A: given atmospheric pressure = 96 kPa S.G= 0.95 ρw=1000 kg /m3 h=65 cm=0.65 m Gauge…

Q: 8. Water flows through a pipe with a diameter of 1.5 inches at the rate of 12 L/s. Determine the…

A: Flow rate and diameter of pipe have been given and it has been asked to determine kinematic energy…

Q: Air is kept at a pressure of 200 kPa absolute and a temperature of 30 degree celsuis in a 500 liter…

Q: If the atmospheric pressure is 101.3 kPa and the absolute pressure at the bottom of the tank as…

A: Given: The atmospheric pressure is 101.3 kPa. The absolute pressure at the bottom is 251.3 kPa. The…

Q: A volume of 25 in3 of air is measured at a pressure of 30 in HG absolute and a temperature of 70°F.…

A: Given P1 = 30 in HG P2 = 10 psig = 20.36 in HG T1 = 700 F T2 = 20 C = 35.60 F V1…

Q: 1.20 Calculate the work done in blowing a soap bubble of diameter 12 cm. Assume the surface tension…

Q: Calculate the specific volume of oxygen in kg/m^3 at 20deg C and 40 kPa abs. a.23.6 b.1.90 c.5.15…

A: Given Pressure P = 40 kpa

Q: A rectangular duct with dimensions of 1 m × 110 cm delivers conditioned air with a density of 1.2…

A: For solving this question we have the following formulas m~=ρ×Q~Where,m~ = mass fow rateρ = density…

Q: Given an air with a known temperature and pressure of 4 degree Celsius and 105 KPa, respectively,…

Q: The density of a liquid is to be determined by an old 1-cm- diameter cylindrical hydrometer whose…

Q: 11. Assuming normal atmospheric condition, how deep is the ocean at a point where an air bubble,…

Q: A child in a boat throws a 6.40 kg package out horizontally with a speed of 10.0 m/s. Calculate the…

Q: If a vessel that contains 9.2 ft3 of water at 50°F and atmospheric pressure is heated to 160°F, What…

Q: Problem #1. The pressure on a closed tank reads 58.86 kPa. a. What is the equivalent height in…

Q: Determine the viscosity of a liquid having kinematic viscosity 6 stokes and specific gravity 2.0

A: Viscosity is the resistance of a fluid to a change in shape, or movements of portions relative to…

Q: 6. Determine the specific gravity (s.g.) of a 2.5 m. column of liquid if its pressure in its column…

Q: The reading of an automobile fuel gage is proportional to the gage pressure at the bottom of the…

Q: QI) If the system is in equilibrium, calculate the magnitude of F. F-100 KN 105

Q: An open tank is filled with oil liquid of Gs=0.85. Calculate the absolute pressure at 30 feet below…

A: Specific Gravity = 0.85 Barometric pressure = 28.5 inches of mercury h = 30 feet

Q: An aeroplane is flying at an height of 15 km where the temperature is – 50°C. The speed of the plane…

A: Given: Height of plane, h = 15 km Temperature, t = -50°C Mach number, M = 2 k = 1.4 Gas constant, R…

Q: Topics: Fundamental of fluid flow In Lake Geneva (Switzerland), there is a water jet (called the…

A: step 1-

Q: SITUATION. At a certain elevation above sea level, a mercury barometer reads 700 mm. What is the…

A: Reading of mercury barometer at height h = 700 mm Air weight = 12 N/m3 Height above sea level can…

Q: H.W.7//As shown, air space above a long tube is pressurized to 50 kPa vacuum. Water (20°C) from a…

A: given data: unit weight of water (γWATER)=9790 N/m3 consider Point A inside the tube and Point B on…

Q: the surface tension of water in contact with air at 20c is given as 0.0716 n/m. the pressure inside…

A: Given Data:- Surface tension σ=0.0716 nm Excess Pressure inside droplet of water ∆P = 0.0147ncm2…

Q: Problem. Determine the mass in kgm, and weight in Newton of the air contained in a room whose…

A: Density of air = 0.72 lb/ft3 = 11.53 kg/m3 Mass of air contained in room = Density x Volume…

Q: Water at 68 has a dynamic viscosity of 1 centipoise. Compute its dynamic viscosity and kinematic…

A: The viscosity is defined as the measure of the resistance developed in the fluid against the flow.…

Q: If a natural gas has a specific gravity of 0.60 relative to air at 14.70-psi-abs and 68 degrees…

Q: Wet air out Water in Air in Air in Water out An cooling tower (see the figure above) is used to cool…

A: The given values are as follows,The water enterat rate of=117639kg/hThe dry air flows at rate…

Q: the surface tension of water in contact with air at 20c is given as 0.0716 n/m. the pressure inside…

Q: Water flows in a 30 cm diameter cast iron pipe of relative roughness 0.0008. If the water flow rate…

Q: In a food processing (drying) application, air ( ρ = 1.10 kg⁄m3 , V = 3 m⁄min ) enters a chamber…

A: Given: Dimensions of duct = 500 mm x 450 mm Velocity at entrance = 3 m/min Dimensions of ductwork =…

Q: An industrial tank is discharging a fluid through a 5-inches nozzle with a velocity of 5 meters per…

A: Given; Diameter of nozzle=5"=5×0.0254m=0.127m Velocity of water flowing out = 5m/s Rate at which…

Q: A 100-L container is filled with 1 kg of air at a temperature of 27°C. What is the pressure in the…

Q: 4. Calculate the pressure of air at a height of 3500m from sea level where pressure and temperature…

A: Fluid mechanics is the discipline of physics that studies the mechanics of fluids (liquids, gases,…

Q: A cylindrical tank 400 mm in diameter, discharges water through a 30 mm under a constant head of 5…

A: Given:Orifice diameter, d=30 mmd=0.03 mgravitational acceleration, g=9.8 m/s2Orifice head, h=5 m

Q: The design fluid (typically water and antifreeze) flow rate through a solar hot-water heater system…

A: Given:- The design fluid (typically water and antifreeze) flow rate through a solar hot-water heater…

Q: The diameter and depth of cylindrical tank are 9m and 4m respectively. This tank contains brimful of…

A: As the temperature is increased the liquid will expand(decrease in unit weight). However the weight…

Q: *1-20. If a man weighs 155 1b on earth, specify (a) his m ass in slugs, (b) his m ass in kilograms,…

Q: 5. Calculate the pressure increase that must be applied to water to reduce its volume by 2%.

A: given Change in volume = 2 % we have to find change in volume

Q: 3. A conical tank shown in the figure has a diameter of 3 meters and an altitude of 5 meters. Find…

Q: the surface tension of water in contact with air at 20c is given as 0.0716 n/m . the pressure inside…

A: Given: Surface tension at Tatm - 20 degree C = 0.0716n/m The pressure inside a droplet of water is…

Q: 4. Air is exiting a 100-cm-diameter balloon out a 1-cm- diameter nozzle. If the pressure and…

Q: WORK-ENERGY EQUATION A block moving at 22 m/s stops after traveling 100 m on a horizontal surface.…

A: Given Initial velocity,U=22m/s Final velocity,V=0 Distance,S=100m Assume ,g=9.81m/s2

Q: Use the work energy method to develop an expression for the maximum height attained by a projectile…

Q: The density of air at a city (such as San Diego) located at sea level is 1.225 kg⁄m3, while for a…

A: Given:- The density of air in a city (such as San Diego) located at sea level is 1.225 kg⁄m3 The…

Q: 2Q. Calculate the density, specific weight, and specific volume of air at 120°F and 50 psia.

Question

If the viscosity of water at 68 deg F is 0.1008 poise, compute its absolute viscosity (μ)
in pound-seconds per square foot. If the specific gravity is 1.02, compute its kinematic
viscosity (v) in square feet per second

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

If the viscosity of water at 68° F is 0.01008 poise, compute its absolute viscosity in pound-seconds per square foot. If the specific gravity at 68° F is 0.998, compute its kinematic viscosity in square feet per second.
A water manometer attached to a pitot static tube used to measure air velocity shows a reading of 0.1 m. Assuming the ecoefficient of velocity as 0.98 and the density of air as 1.2 kg/m3, calculate the air velocity.
The diameter of a pipe carrying water changes gradually from 6 inches at a lower point to 18 inches at a higher point by 15 ft. What will be the difference in pressure, in psi, between these points if 6.2 cfs is flowing considering no loss in energy.
Assuming specific weight of air to be constant, what is the approximate height of Mount Banahaw in m if a mercury barometer at the base of the mountain reads 654 mm and at the same instant, another barometer at the top of the mountain reads 480 mm? Show Unit Analysis Solution
Water entering through 5 ft long and 1 inch diameter pipe has a flow rate of 100 kg/min at a temperature of 100 °C and pressure of 1.95 bar at exit. The density of water at these conditions is 961.5 kg/m3. Calculate the rate of work done at the exit of pipe.
The water in a tank is pressurized by air, and the pressure is measured by a multifluid manometer as shown. The tank is located on a mountain at an altitude of 1400m where the atmospheric pressure is 89.6 kPa. Determine the pressure of air in the tank if h1 = 0.5m, h2 = 0.5m, and h3 = 0.6m. Take the densities of water, oil and mercury to be 1000kg/.850 kg/and 13,600 kg/
Given a liquid water having a volume of 6m3 and weight of 44kN at 4°C, Calculate a. Specific weight (N/m3) b. Specific mass (kg/m3) c. Specific volume (m3/kg) d. Specific gravity (unitless)
An open cylindrical tank 800mm in diameter and 2000mm high contains water to a depth of 1.6m. It is rotated about its vertical axis at 13 rad/s. How many liters of water are spilled? Use density of water as 1000kg/m3 and specific weight as 9.81kN/m3
Air is introduced through a nozzle into a tank of water to form a stream of bubbles. If the bubbles are intended to have a diameter of 2mm, calculate by how much the pressure of the air at the nozzle must exceed that of the surrounding water. Assume that surface tension of water is 0.073 N/m. What would be the absolute pressure inside the bubble if the surrounding water is at 100 kPa?
the reading of an automobile fuel gage is proportional to the gage pressure at the bottom of the tank. if the tank is 30 cm. deep, and is contaminated with 3.42 cm. of water at the bottom, how many meters of air remains at the top when the gage indicates "FULL"? use weight of: gasoline = 6.62 kN/m^3; air = 14.67 N/m^3. the tank is closed.
Water flows through a pipe 25 mm in diameter at a velocity of 6 m/s. Determine whether the flow will be laminar or turbulent assuming that the dynamic viscosity of water is taken as1.30 × 10−3 kg/ms and its mass density as 1000 kg/m3. If oil of specific gravity 0.9 and dynamic viscosity 9.6 × 10−2 kg/ms is pumped through the same pipe, what type of flow will occur?
A house has a volume of 1200 m3 (a) What is the total massof air inside the house at 15°C? (b) If the temperature dropsto –15°C what mass of air enters or leaves the house?