iGiven 60 uC point charge located at ongin, the total electric Aux through as spnere r-26cm o plane z=2e cm

Q: resistance of each of the given resistor. Use the samples presented in the discussion part as your g...

A: With this table , it is possible to answer only the ideal resistance value so i will answer that onl...

Q: A uniform volume charge density ρv1 = 50 µC/m3 is present throughout the region 6mm < r < 8mm, and l...

A: The solution is given below 

Q: Problem 2 De ter mne io,t02, Uo, Vn for the following cirenits the 0,7V Constant voltage model for t...

A: The diode will conduct only during the forward bias and it can be replaced by its equivalent voltage...

Q: Q1: If the frequency of information signal is 5kHz find 1- The number of pulse in one second and fin...

A: Given:f=5 kHz

Q: If characteristic equation is s' +s (K +6)+s(6K+9)+9K =0 ,what is the minimum value for k to be in o...

A:

Q: w- 2k 3 kl E120 V a. Find the total resistance. b. Calculate the current. Find the voltage across ea...

A: Please find the detailed solution in below images

Q: (5) Using the method that applies the Laplace Transform to the circuit below, find and v.(t) and i(t...

A:

Q: 3. An emf of 50 v is applied in turn to the following resistors: (a) 222 , (b) 8202 , (c) 2.7 MN , (...

A:

Q: Derive the Fourier Series expansion of ) given 4-Vpp, 1MHZ square wave signal shown in Figure 2.1. b...

A:

Q: For the given circuit shown in figure 3(a) below, it is observed that VRE = 0.7 V, VE = 2.1 V, VcE =...

A:

Q: 2.4 ΜΟ5% 67.3 k ΚΩ + 1%

A:

Q: Find the equivalent admittance circuit and the value of I and total impedance in both circuits. I 15...

A:

Q: Problem 1.4: A code is created as 3 distinct letters followed by 4 distinct non-zero digits. (a) How...

A: The code is created using 3 different letters and 3 different non-zero digits.  Number of letters=26...

Q: prime implicants (specific product terms) for each of the given Boolean functions: (Format example: ...

A:

Q: 42 MAL -> Vz Vz Find z-Paramefar find Y- fafametar

A:

Q: 1. Using Kirchhoff's Current Law (KCL) and Kirchhoff's Voltage Law (KVL), equivalent resistance and ...

A: 1) False Using Kirchhoff's law, equivalent resistance can not be obtained 2) True Kirchhoff's Voltag...

Q: (s+a)(s+b) plant is sampled using a zero-order hold (ZZOH) before the signal is fed to a digital con...

A:

Q: Theoretical Computations. a. Identify the DC operating conditions of the BJT. b. What is the region ...

A: Given the circuit, as shown below: Given the table as shown below: a) We need to identify the DC o...

Q: 2. The number of turns on the primary and secondary windings of a single-phase transformer are 350 a...

A: This question belongs to electrical machine . It is based on the concept of single phase transformer...

Q: Two balanced three-phase loads that are connected in parallel are fed by a three-phase line having a...

A:

Q: what u meant by Ny quist rate?

A: We are authorized to answer one question at a time in case of multiple questions, so we are answerin...

Q: Q) 14. For the network of Fig. 5.153 , what value of RC will cut the voltage gain to half the value ...

A:

Q: 10.25: For the following electric circuit, find Z and Y parameters? Also, compute input and reflecte...

A:

Q: A magnetic coil with 2000 turns produces 1 mWb of flux when it carries a current of 2 A. The current...

A: Given,N=2000 turnsϕ=1mWb=0.001 WbI=2 AFlux collapses in t=10 ms= 0.01 sAverage voltage that will app...

Q: R=_2 %3D

A:

Q: How would you rearranged this circuit if a pnp should be used to light up the led instead?

A: Bipolar junction transistor is current controlled Device in which base current control the mode of o...

Q: A 2-port network is defined by the relation: V1 = V2 Then y12 is (a) u (m) o (b) 2 2 (c) 1U (d) -1 U

A: Given a 2-port network with relation, V1=34I1-14I2V2=-12I1+12I2

Q: Cross Arm iz mc 13 Line Conductor Pole 可工

A:

Q: Obtain the Thevenin 's equivalent at terminals A-B of the network shown in Figure 1.30. Label each c...

A: To obtain thevenin's equivalent resistance all the current and voltage sources are replaced by its i...

Q: If the frequency of information signal is 5kHz find 1- The number of pulse in one second and find th...

A: The solution is given below. 

Q: For the given circuit shown in figure 3(a) below, it is observed that VRE = 0.7 V, VE = 2.1 V, VcE =...

A:

Q: 1. Find the Fourier Transform of the rectangular function

A: Note : According to the guidelines of the company if the questions are of different we supposed to a...

Q: Exercise#1 Good voice reproduction via PCM can be achieved with 128 quantization levels. a- How many...

A: Please find the detailed solution in below images

Q: Problem 3 Determine the following when R = 1n: a. The Norton Equivalent Circuit. b. The value of the...

A:

Q: A coil of resistance 152 and an inductance 1H and a capacitance 15µF are connected in series across ...

A:

Q: Q1. Consider a message signal m(t) = 20 cos(2Ħt) and a carrier signal c(t)=50 cos (100 z t), both in...

A: Please find the detailed solution in below images

Q: 'Let E=yax V/m at a certain instant of time, and calculate the work required to move a 3 C charge fr...

A: When an electric field is present ,then it generates a force as well as it creates a potential diffe...

Q: 피(t) 3 2 -2 -3

A:

Q: Find V, in the circuit in the figure. 20 60 12 v(+ 6 V 203 Vo 3.33V 8.25V 9.33V O 2.25V

A:

Q: Q/ Point charges of 500G, each are located at A(1, 0, 0), B(-1, O, 0), C(O, 1, 0). and in free space...

A:

Q: Given the following network determine the total Ri,Av,Ai and Ro if hie=2KQ and B=175. *

A:

Q: Find the current in each branch of the circuit below. 3.00 N E5.00 N 8.00 N: 31.00 2

A:

Q: (13) Suppose r(t) has the spectrum in the figure below, where fu 25kHz and E =10kHz. Sketch Xs(f) fo...

A:

Q: Determine the magnitude and phase angle of the total impedance for the circuit below. Xc 50 Ω 1V 100...

A: Given:  

Q: 5. R-_요 %3D R, = 100 Ω R2 = ,200 Ω R3= 300 Ω R4 400 Ω %3D %3D %3D %3D

A:

Q: 45. Determine the output voltage for the network of Fig. 8.87 if V; 0.8 mV and ra 9 30V 3.3 k2 40 M)...

A:  GIVEN: a circuit diagram with                 Vi=0.8rd=40kΩ FIND: output voltage of the network    ...

Q: 2.16 Determine V, in the circuit in Fig. 2.80. 162 142 10 V Vo 25 V (+1

A: Given circuit,

Q: Design the combinational circuit using decoder and two-input NAND gates. (a) F(A, B, C)= A B'C + AB'...

A:

Q: . For the circuit shown in figure below, determine the current flowing at impedance (4+j3) Q 132 15 ...

A:

Q: what is the z transform of (1/4)^k

A:

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.