(II) At t=0 the current through a 45.0-mH inductor is50.0 mA and is increasing at the rate of 115 mA/s? What isthe initial energy stored in the inductor, and how long doesit take for the energy to increase by a factor of 5.0 from theinitial value?

(II) At t=0 the current through a 45.0-mH inductor is50.0 mA and is increasing at the rate of 115 mA/s? What isthe initial energy stored in the inductor, and how long doesit take for the energy to increase by a factor of 5.0 from theinitial value?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 14.6CYU: Check Your Understanding How much energy is stored in the inductor of Example 14.2 after the current...

See similar textbooks

Related questions

Q: A solenoid of radius 3.5 cm has 480 turns and a length of 15 cm. (a) Find its inductance. mH (b)…

Q: The mutual inductance of two coils (1 and 2) is 48.0 mH.Find the magnitude of the emf induced in…

Q: How would you place two identical flat coils in contact so that they had the greatest mutual…

A: Given: Two coils

Q: Discuss the factors determining the induced emf in a closed loop of wire.

Q: The self-inductance of a solenoid increases under which of the following conditions?

A: When an electric current is passed through a solenoid, a coil of insulated wire wound on a…

Q: A square conducting loop is in a region of uniform, constant magnetic field. Can the loop be rotated…

A: Can the loop be rotated about an axis along one side and no emf be induced in the loop?

Q: 11. (II) What is the direction of the induced current in the circu- lar loop due to the current…

A: We have given four figure in given diagram. Lenz law Lenz law based on the conservation of energy…

Q: If the emf of the battery of Figure 14.12 (b) is reduced by a factor of 2, by how much does the…

A: The inductor’s energy can be given as, Here, L and I represent the inductor’s inductance and…

Q: A 35-turn 12.5-cm-diameter coil is placed between the polepieces of an electromagnet. When the…

A: Number of turn, N = 35 diameter, d = 12.5 cm emf, e =120 V

Q: (I) Neon signs require 12 kV for their operation. To operatefrom a 240-V line, what must be the…

A: The ratio of secondary to primary turns of the transformer can be obtained as…

Q: uhew many furns are there the primary ríde coil ey the 6) If the seeondary side rme Current fs rms…

A: Given data: Primary voltage, Vp=120 V Secondary voltage, Vs=6 V Number of turns in secondary coil,…

Q: How can we calculate the self inductance of a solenoid?

A: Solenoid is a device made by a coil of wire.

Q: A circular coiVhas a radius of 10 cm and 50 turns are rotated about its vertical diameter in a…

A: i) at position 40° Emf = NBAW Cos40° 228.4 = 50×0.6×(π×0.12)×W×Cos40° 228.4 = 0.722W W = 316.34…

Q: half O A tectangular conducting loop has its left in a magnetic field directed into the page. S…

A: when we increase the magnetic field in the page so Loop pused itself on the right side because it…

Q: How does the self-inductance per unit length near the center of a solenoid (away from the ends)…

A: The expression for the self inductance , L=μN2Al

Q: A 24-V battery is connected in series with a resistor and aninductor, with R = 8.0 Ω and L = 4.0 H,…

A: Formula to calculate current at any time in a circuit is,

Q: if the angular speed v of the loop is doubled, then the frequency with which the induced current…

A: Scenario: Loop's angular speed gets doubled & frequency at which current(induced) changes…

Q: In what three ways can the strength of an induced current be increased?

A: Explanation: Induced Current(emf): When the conducting loop or coil of wire is placed in a…

Q: Calculate the self-inductance (in mH) of a 50.0 cm long, 10.0 cm diameter solenoid having 1000…

Q: An RL circuit with a 5-Qresistor and a 0.05-H inductor carries a current of 1 A att= 0, at which…

A: Given: An RL circuit contains resistor, R=5 Ω and inductance L= 0.05 H Current at t=0, I(0)=1 A…

Q: by how much is the maxium electromotive force produced by a generator changfe if its angular…

A: To determine: The correct option.

Q: 1/7he Coessicient of mutuel incluctance betheen twothansformmer Windings is ay Hi 1ş the equefion of…

Q: How fast can the 160 A current through a 0.260 H inductor be shut off if the induced emf cannot…

A: Current , I = 160 A Inductor , L = 0.26 H Induced emf = 73 V To find = Time taken

Q: Is more energy stored in an inductor by doubling the inductance or by doubling thecurrent?

A: To determine: Whether the energy stored is more or not by doubling the inductance or the current.

Q: (I) The north pole of the magnet in Fig. 21–57 is being inserted into the coil. In which direc- tion…

A: Answer: Magnetic field: In physics, the term magnetic field is represented as the region in which…

Q: I • P One long straight wire connect ed to the DC power supol If f lows up to 25 A ) current a etion…

A: Given: I=25 A r=10 cm =0.1 m

Q: Can there be an induced emf in a circuit at an instant when the magnetic flux through the circuit is…

A: Faraday's Law gives us the concept of the induced emf being equal to the rate of change of magnetic…

Q: Amp) 6 ((mili sec) The current through a 4.6 H inductor is shown in the following graph. The induced…

A: Given: inductance L=4.6HSo from the graph we can observe that the rate of decay of…

Q: An inductor is formed by winding N turns of a thin conducting wire into a circular loop of radius a.…

A: Given data: Magnetic field, B=B02y^+3z^sinωt Number of turns, N=10 B0=0.2 T; a=10 cm=0.10 m;…

Q: . How would you arrange two flat circular coils so that theirmutual inductance was (a) greatest, (b)…

A: The mutual inductance between two circular coils can be given as, Here, ϕ21, μ0, N1, N2, A, l, and…

Q: How many turns should a coil of an inductor is needed in a low pass filter with a cut-off frequency…

A: The resistance in the circuit R=8 Ω The cut-off frequency f =500 Hz The equation for cut off…

Q: Inte Circuit nelow, the switch is initially open(sushere is no Current), he close the swriten at t…

A: R1 = 1.8 ohm R2 = 2.3 ohm R3 = 1.4 ohm R4 = 5.2 ohm E = 6 volts

Q: A single loop is made around the center of a solenoid with a length of 20 m and a radius of 5m. How…

A: Given Length of solenoid, h = 20 m Radius of solenoid,R = 5 m Mutual inductance, L = 1 Henry No…

Q: At a certain instant the current flowing through a 5.0-H inductor is 3.0 A. If the energy in the…

A: Given: Inductance, L=5.0 H Current, I=3 A Rate=power, P=3 J/s Emf due to inductor: ..... 1…

Q: In a homopolar motor (like Faraday’s motor), what happens to the motion if the current is reversed?

A: A Homopolar motor is a direct current electric motor with two magnetic poles .The name Homopolar…

Q: The field outside the coils of the solenoid is nearly zero. Why?

A: Solenoids are long straight coil of wires used to generate nearly uniform magnetic fields similar to…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

(II) At t=0 the current through a 45.0-mH inductor is
50.0 mA and is increasing at the rate of 115 mA/s? What is
the initial energy stored in the inductor, and how long does
it take for the energy to increase by a factor of 5.0 from the
initial value?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Trending now

This is a popular solution!

Step by step

Solved in 4 steps with 5 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

If emf of the battery of Figure 14.12(b) is reduced by a factor of 2, by how much does the steady-state energy stored in the magnetic field of the inductor change?
Show that the self-inductance per unit length of an infinite, straight, thin wire is infinite.
A steady current flows through a circuit with a large induct3ve time constant. When a switch in the circuit is opened, a large spark across the terminals of the switch. Explain.
In the simple RL circuit of Figure 14.12(b), can the emf induced across the inductor ever be greater than the emf of the battery used to produce the current?
A 5000-pF capacitor is charged to 100 V and then quickly connected to an 80-mH inductor. Determine (a) the maximum energy stored in the magnetic field of the inductor, (b) the peak value of the current, and (c) the frequency of oscillation of the circuit.
Check Your Understanding (a) Calculate the self-inductance of a solenoid that is tightly wound with wire of diameter 0.10 cm, has a cross-sectional area of 0.90 cm2, and is 40 cm long. (b) If the current through the solenoid decreases uniformly from 10 to 0 A in 0.10 s, what is the emf induced between the ends of the solenoid?
An inductor is connected across the terminals of a battery. Does the current stance of the battery? Does the time required for the current to reach its final value depend on this resistance?
Check Your Understanding For the circuit of in Figure 14.12(b), show that when steady state is reached, the difference in the total energies produced by the battery and dissipated in the resistor is equal to the energy stored in the magnetic field of the coil.
How would changing the radius of loop D shown below affect its emf, assuming C and D are much closer together compared to their radii?
Discuss how you might determine the-inductance per unit length of a long, straight wire.
When the current through a large inductor is interrupted with a switch, an are appears across the open terminals of the switch. Explain.
Suppose that a cylindrical solenoid is wrapped around a core of iron whose magnetic susceptibility is x. Using Equation 14.9, show that the self-inductance of the solenoid is given by L=(l+x)+0n2Al where l is its length, A its cross-sectional area and N its total number of turns. Nm=U