In a steam power plant that uses reheat cycle steam at 15.5 MPa, 545 °C enters the engine and expands to 1.95 MPa. At this point, the steam is withdrawn and passes through a reheater. It reenters the engine at 535 °C. Expansions now Occur to the condenser pressure of 0.0035 MPa. Find the QA, Wnet, and cycle and engine efficiency in %.

In a steam power plant that uses reheat cycle steam at 15.5 MPa, 545 °C enters the engine and expands to 1.95 MPa. At this point, the steam is withdrawn and passes through a reheater. It reenters the engine at 535 °C. Expansions now Occur to the condenser pressure of 0.0035 MPa. Find the QA, Wnet, and cycle and engine efficiency in %.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

If the net power output of the cycle is 100 MW, and that the working fluid enters the turbine as saturated steam at P= 8.00 MPa and exist the condenser as saturated liquid at P=8kpa Determine: a) the terminal efficiency (%) b) The mass flow rate of the steam , kg/s C) The rate of heat transfer to the working fluid as it passes through the boiler, KW D) The heat rejected by the working fluid as it passes through the condenser, kW. e) The mass flow rate of the cooling water, kg/s. N.B ( the cooling water enters the condenser at 15°C and leaves at 35°C)
rankine cycle, the pressure and temperature entering the turbine is 1800 kpa and 380 degrees celsius and the pressure leaving the turbine is 20 kpa, the quality of steam entering the condenser is 90%. what is the turbine work in kj/kg at 1.8 mpa and 380 degrees celsius
A steam power plant operating on regenerative cycle, as illustrated in Fig 8.5, includs just one feedwater heater. Steam enters the turbine at 650 psia and 900oF and exhaust at 1 psia. Steam for the feedwater heater is extracted from the turbine at 50 psia, and in condensing raises the temperature of the feedwater to within 11oF of its condensation temperature at 50 psia. If the turbine and pump efficiencies are both 0,78, what is the thermal efficiency of the cycle and what fraction of the steam entering the turbine is extracted for the feedwater heater?
In a reheat cycle steam at 15 MPa, 540 ̊C enters the engine and expands to 1.95 MPa.At this point the steam is withdrawn and passed through a reheater. It reenters the engineat 540 ̊C. Expansion now occurs to the condenser pressure of 0.0035 MPa (a) For theideal cycle, find e. (b) A 60,000 kw turbine operates between the same state piontsexcept that the steam enters the reheater at 1.95 MPa and 260 ̊C, departs at 1.8 MPa and540 ̊C. the steam flow is 147,000 kg/hr, generator efficiency is 96%. For actual enginefind ek, mk, and nk.
In a refrigerator the power rating impressed on the compressor is 1.2 kW. The circulating wire in evaporator is 5 kW and the cooling water took away 10 kW from condenser coil. The operating temperatures range is 18ºC and 0ºC and their corresponding latent heats are 170 kJ/kg and 230 kJ/kg and the difference between theliquid energy is 35 kJ/kg. Find the actual COP of the system (2) relative COP, assuming the vapor is just dry and saturated at the end of the compression.
A 1000-MW supercritical double-reheat steam power plant operates withthe main (live) steam condition of 250 bars and 560°C and the condenserpressure of 0.04 bar. The steam is reheated first at 30 bars to 560°C andthen at 4 bars to 560°C. The turbine efficiency is 0.92. The feed pumpwork may be ignored. Calculate: (a) the plant net specific work, (b) the plant thermal efficiency, (c) the plant steam mass flow rate, and (d) the plant heat rate.
A dry and saturated steam supplied in a power plant is at 1500 kPa. Determine theefficiencies of Carnot and Rankine cycle if the pressure at the condenser is at 40 kPa,neglecting pump work.
A flashed-steam geothermal power plant is located where underground hot water is available as saturated liquid at 600 kPa. The flashed steam enters a turbine at 529 kPa, 98 % quality and expands to 15 kPa, when it is condensed. The flow rate from the well is 28.9kg/s. Over-all efficiency is 90%. Determine the power produced by the plant in KW.
At 10kPa pressure and dryness degree x=0.90, the steam coming out of the turbine goes to the pump with adiabatic efficiency of 0.85 after condensing in the condenser. The pump sends the condensed water to the steam boiler with a working pressure of 8MPa. a) Find the h.T values of the inlet points of the condenser, pump and boiler b) Since the flow rate of the condensed water is 9000 kg/h, find the load of the condenser c) Find the power of the pump
A flashed-steam geothermal power plant is located where underground hot water is available as saturated liquid at 620 kPa. The flashed steam enters a turbine at 530 kPa, 98 % quality and expands to 15 kPa, when it is condensed. The flow rate from the well is 27.8 kg/s. Over-all efficiency is 90%. Determine the power produced by the plant in KW.
Steam enters the high-pressure turbine at 150bar and 550c and low pressure turbine at 40bar and 550c .the condensor pressure is 0.1bar using mollier diagram find 1.the dryness fraction at the end of low pressure turbine 2.efficieny 3.steam rate 4.heat rate 5.work ratio
Air enters the compressor of a regenerative gas-turbine engine at 100 kPaand 300 K and is compressed to 800 kPa. The regenerator has aneffectiveness of 65 percent, and the air enters the turbine at 1200 K. For acompressor efficiency of 75 percent and a turbine efficiency of 86 percent,determine(a) The heat transfer in the regenerator.(b) The back work ratio.(c) The cycle thermal efficiency