In a steam Rankine power plant, the moisture content of the exhaust steam will by increasing the superheat temperature of the steam at the inlet of the turbine. decrease 4 increase O remains constant none of the above

In a steam Rankine power plant, the moisture content of the exhaust steam will by increasing the superheat temperature of the steam at the inlet of the turbine. decrease 4 increase O remains constant none of the above

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter10: Heat Exchangers

Section: Chapter Questions

Problem 10.17P

See similar textbooks

Related questions

Q: In a gas turbine plant working on Brayton cycle, the carbon dioxide at inlet is 27°C, 100 kPa. The…

Q: ooking again at problem 1 how would you define the efficiency of the system? whicch components would…

A: In a particular system, efficiency is defined as the ratio of energy output to energy intake.…

Q: simple-cycle gas turbine plant has compressor and turbine efficiencies of 0.88 and 0.91,…

Q: The thermodynamic process that happens in pump used in steam power plants is isoenthapy compression…

A: Thermodynamic Process:- This brings the change in the state of the system which includes mainly…

Q: The following data was given for a steam power plant operating on the ideal reheat Rankine cycle.…

A: Given dataP3 = 17.5 mPa , T3 = 600°CP6 = 11.16 kPa , x=1-0.1 ⇒ 0.9V1 = 0.00101 m3/kg

Q: 3.2 In the steam power plant, the turbine receives 700 kg/s of main (live steam at (i) 250 bars and…

Q: 3 13 15 Boiler Turbines 2 Condenser 1 P Pump In a reheat ideal Rankine cycle, steam enters the…

A: Given dataConditions of steam at high pressure turbine : 8.6 MPa and 600°CReheat temperature = 500…

Q: A single flash geothermal steam power plant is operating at maximum turbine power output with a…

A: Given data, Temperature of the geofluid at state 1, T1 = 250 °C Mass flow rate of the geofluid,…

Q: Which one of the following statements is false about Reheat Rankine Cycle? O a. Consumes more heat O…

A: Refer belo T-S diagram to understand the effect of reheating. In the above diagram, Standard…

Q: C. Equal to 5. In compound gas-steam cycle, there is ---- for the steam cycle A. a separate boiler…

A: Combined gas and steam (COGAS) is the name given to marine compound powerplants comprising gas and…

Q: Consider the Diesel engine cycle below: 3 V 1-2 Adiabatic. 2-3 Constant-pressure. 3-4 Adiabatic. 4-1…

Q: In an ideal reheat cycle, the steam throttled condition is 8 MPa and 480 degree C. the steam is then…

A: Given:- To Find:- The enthalpy of steam entering the reheater (h2)

Q: Draw the diagram. In a reheat Rankine cycle, the steam throttled condition is 8 MPa and 480°C. The…

Q: In the simple ideal Rankine cycle, the enthalpy of water at the pump outlet is 230 kJ/kg. If the…

Q: Q4/1. in the steam turbine the common sources of ? the irreversibilities are the good isolation of…

A: 1) Irreversibility in the steam turbine is due to the heat loss to the surrounding at a particular…

Q: The goal of adding a reheat line to a Rankine cycle is to increase the thermal efficiency of the…

A: In the Rankine cycle the process reheating is done to remove the moisture carried by the steam to…

Q: steam power plant saturated steam at 50 bar enters the turbine and leaves at 1 bar. Show by…

Q: You are to design a 500 MW gas turbine power plant running on Ideal Brayton cycle with the following…

A: Wnet=500 MwT1=22°C or 295 KP1=95Kparp=P2P1=P3P4=20T3=1700 K

Q: Steam enters the turbine of a simple vapor power plant with a pressure of 12 MPa and a temperature…

Q: A power plant uses a gas turbine to produce electricity. Assume that the gas-turbine operates on the…

Q: saturated Rankine cycle turbine receives 125 kg/s of steam

Q: A power plant uses a gas-turbine to produce electricity. Assume that the gas-turbine operates on the…

Q: Q2a. plant with two stages of expansion and two stages of compression An ideal Brayton cycle is used…

Q: 1. In a reheat Rankine cycle, the steam throttled condition is 8 MPa and 480 °C. The steam is then…

Q: For a pressure ratio of r, specific heat ratio of y. the thermal efficiency of Brayton cycle is…

A: Given pressure ratio=rp, Specific heat ratio=γ

Q: A 350-MW simple-cycle gas turbine power plant operates with a compressor pressure ratio of 16, TIT…

Q: 2. A 150 MW gas turbine power plant running on Ideal Brayton cycle has the following initial…

A: Note: According to Bartleby's rule, only first three parts of the same questions are to be solved.…

Q: For the Rankine cycle shown below, Determine the power output from the turbine? Steam 140 bar, 350…

A: Given that , At stage 1,PressureP1=40barTemperatureT1=350°CAt stage 2,PressureP2=0.035bar

Q: Tmin in cycle = 27 C Tmax in cycle = 1327 C %3D Heat addition during each reheat stage is 25 of the…

Q: The following data was given for a steam power plant operating on the ideal reheat Rankine cycle.…

A: Thermodynamics : It is a branch of science which deals with work , heat , energy. Also it studies…

Q: In steam Rankine cycle, feed water heaters can O increase the work output of the turbine increase…

A: Its answer may be the third option, increase the efficiency of the cycle.

Q: For a Steam power plant working on Rankine cycle, if the boiler pressure is increased then it…

A: Option ( a) more pump work

Q: A steam power plant operates on the ideal Rankine cycle(dry steam at entry to the turbine) between a…

Q: 2) A steam power plant operates according to the simple ideal Rankine cycle. The pressure limits of…

A: Given, m˙=60 kg/s P2=P3=9 MPa=9000 kPa P1=P4=10 kPa x4≥0.9

Q: P= Ps = Prcheat (2 Pump Condenser The following data was given for a steam power plant operating on…

Q: Q1. Sketch T-s diagram for Rankine cycle with clear label for the following condition: • Condensate…

Q: electrical power plant that uses the Rankine cycle has a pump to increase the water pressure and…

Q: 1. A two-stage regenerative steam power plant produces 37 MW. The steam leaving the boiler is at 6.0…

Q: Can the re-heater in the gas turbine power plant reduce the compression ratio Pfor a given power…

A: Given:- Can the re-heater in the gas turbine power plant reduce the compression ratio ?for a given…

Q: True or False 1) In a Rankine Cycle, real work produced by the turbine is less that the isentropic…

A: Answer 1: Isentropic means the turbine works in reversible isentropic process and according to law…

Q: 5- For the same peak pressure and heat input a) Otto cycle is more efficient b) Diesel cycle is more…

Q: 2. A GAS TURBINE WORKING ON A SIMPLE BRAYTON CYCLE HAS A TEMPERATURE OF 300K AT THE INLET OF THE…

A: To find : The mass flow rate of air in kgsec, when the isentropic efficiency is 100%. Given : The…

Q: A power plant uses a gas turbine to produce electricity. Assume that the gas-turbine operates on the…

Q: 1. In a Rankine cycle, steam enters the turbine at 2.5 MPa and condenser at 50 kPa, what is the…

A: Given Dataat 2.5MPahg=2803.1kJ/kgsg=6.2575kj/kg.Kat…

Q: For the Rankine cycle shown below, Determine the power output from the turbine? Steam 40 bar, 350 °C…

Q: 5.4 A single-pressure combined-cycle power plant consists of a gas turbine, HRSG, supplementary…

A: According to terms and conditions of bartleby we can only provide upto 3rd part. Thank you !

Q: A 350-MW simple-cycle gas turbine power plant operates with a compressor pressure ratio of 16, TIT…

A: Given data as per question p1=1 barT1=100Crp=p2p1=16T3=14500Cηc=0.87ηt=0.92Temperature at exit of…

Question

What’s the correct answer for this please ?

In a steam Rankine power plant, the moisture content of the exhaust steam will
by increasing the superheat temperature of the steam at the inlet of the
turbine.
decrease
4
increase
O remains constant
none of the above

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

It is known that the increase in the pressure of the boiler increases the thermal efficiencyof the Rankine cycle, but which also generates the problem of excessive humidity in thefinal stages of the turbine. Determine:a) How do we solve this problem?
Steam enters the turbine at the rate of 1.5 kg/s with enthalpy of 2300 kJ/kg andexhaust enthalpy of 1200 kJ/kg. Steam is extracted from the turbine at a rate of 0.78kg/s for heating purposes with enthalpy of 2750 kJ/kg. What is the turbine work? A. 1305 kW B. 441 kW C. 2145 kW D. 495 kW
A flashed-steam geothermal power plant is located where underground hot water is available as compressed liquid at 2610 kPa and 250 C. The flashed steam enters a turbine at 557 kPa, 98% quality and expands to 10 kPa. The flow rate from the well is 40 kg/s. Mechanical efficiency is 90% and generator efficiency is 92%. Determine the power produced by the plant in KW.
I need help on the following question: The vapour compression cycle (picture provided), utilises the refrigerant R134a flowing at 0.05 kg s-1. Assuming that the compression is adiabatic and reversible. If the actual input power to the compressor is 2 kW, then: 1. You need to determine the theoretical input power to the compressor and the heat transfer (Φ) to theevaporator. Take the enthalpies h1, h2, and h3 to be 238.41, 263.68 and 81.5 kJ kg-1 (use the 'NH3 Refrigeration Table' where you can find online). 2. You need to determine the coefficient of performance based on your answer to the previous question (1). 3. You need to determine the compressors mechanical efficiency.
how do i calculate for a power plant, iv. The rate of heat rejection at the condenser; andv. Determine the rate of entropy generation in that power plant. Please provide example
A flashed-steam geothermal power plant is located where underground hot water is available as saturated liquid at 620 kPa. The flashed steam enters a turbine at 530 kPa, 98 % quality and expands to 15 kPa, when it is condensed. The flow rate from the well is 27.8 kg/s. Over-all efficiency is 90%. Determine the power produced by the plant in KW.
A flashed-steam geothermal power plant is located where underground hot water is available as saturated liquid at 600 kPa. The flashed steam enters a turbine at 529 kPa, 98 % quality and expands to 15 kPa, when it is condensed. The flow rate from the well is 28.9kg/s. Over-all efficiency is 90%. Determine the power produced by the plant in KW.
The enthalpy entering the turbine of a geothermal power plant is 2750 KJ/kg and ,ass rate of 1 Kg/sec. The turbine brake power is 1000 KW condenser outlet has enthalpy of 210 KJ/kg. If temperature rise of cooling water in condenser is 8, what is the mass of cooling water requirement?
In a marine gas turbine unit, a high-pressure stage turbine drives the compressor and a low-pressure stage turbine drives the propeller through suitable gearing. The overall pressure ratio is 4/1 and the maximum temperature is 650 o the isentropic efficiencies of the compressor, H. P. turbine, L. P. turbine are 0.8, 0.83 and 0.85 respectively and the mechanical efficiency of both shafts is 98 %. Sketch the process on the T-s diagram i. Calculate the pressure between turbine stages when the air intake conditions are 1.01 bar and 25 oC. ii. Calculate also the thermal efficiency and the shaft power when the mass flow is 60 kg/s. NB: Neglect kinetic energy changes and the pressure loss in combustion.
A turbine engine air intake is at pressure and temperature of air drawn 99 kPa and 29 0C respectively. The maximum pressure and temperature during the cycle is 990 kPa and 888 0C respectively. The adaibatic index as 1.4. After claculations, the pressure ratio of the cycle is , compressor exit temperature is K, turbine exit temperature is K, net specific work output from the gas turbine engine is in k, thermal efficiency is % and work ratio of the cycle is to I decimal place
Pls. answer thank you! In a 13 MW geothermal power plant, the mass flow of steam entering the turbine is 30 kg/s. The quality after throttling is 23% and enthalpy of ground water is 730 KJ/kg. Determine the overall efficiency of the plant.
Steam enters the high-pressure turbine at 150bar and 550c and low pressure turbine at 40bar and 550c .the condensor pressure is 0.1bar using mollier diagram find 1.the dryness fraction at the end of low pressure turbine 2.efficieny 3.steam rate 4.heat rate 5.work ratio