In a steam turbine operating according to the simple ideal rankine cycle, the boiler pressure is 2 MPa and the turbine inlet temperature is 450 °C. Determine the net power produced if the pump pressure is 15 kPa and the heat released from the system is 1200 kJ/kg at a flow of 1.3 kg /s.

In a steam turbine operating according to the simple ideal rankine cycle, the boiler pressure is 2 MPa and the turbine inlet temperature is 450 °C. Determine the net power produced if the pump pressure is 15 kPa and the heat released from the system is 1200 kJ/kg at a flow of 1.3 kg /s.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: 3. For an ideal diesel cycle, the pressure at the beginning and at the end of compression are 98 kPa…

Q: An ideal diesel engine has a compression ratio of 20 and uses air as the working fluid. The state of…

A: Consider P as the pressure, V as the volume, T as the temperature, s as the entropy. In the P-V…

Q: A gas turbine cycle with a stage of reheat and regeneration operates under the conditions given…

A: Increasing the enthalpy of the fluid entering the gas turbine and extending its expansion to the…

Q: In a steam power plant that operates based on a Rankine cycle, the operating pressures of the steam…

A: Answer: (a) The specific heat transfers in the steam generator is 2523.6 kJ/kg and in the condenser…

Q: 4. A steam power plant operating in an ideal Rankine cycle has high pressure 500 kPa and low…

Q: gas turbine power plant operates on a standard air cycle between extreme pressures of 1 and 6.4 bar.…

A: Given Inlet temperature, T1 = 22°C Turbine inlet temperature, T3 = 807°C…

Q: Why are the back work ratios relatively high in gas-turbine engines?

A: The expression for the back-work ratio is given by, Here, WB is the back-work ratio, wC is the…

Q: A Rankine Cycle operates at a throttle pressure and temperature of 5 MPa and 450°C, respectively.…

A: Given DataWT=20MWηTs=85%ηm=97%T1=450°CP2=P3=10kPax3=0T3=45.8°Ch3=hf=191.8kJ/kgv3=vf=0.00101m3/kg

Q: An ideal diesel engine has a compression ratio of 20and uses air as the working fluid. The state of…

Q: If the thermal efficiency of a steam power plant operating on the simple ideal rankine cycle is 26%…

A: Solution: Given" The enthalpy of steam leaving the turbine = 3166 kJ/kg The condenser pressure = 75…

Q: A steam power plant operates on a simple ideal Rankine cycle between the pressure limits of 5 MPa…

Q: Determine the thermal efficiency of a simple rankine cycle

A: Answer: The thermal efficiency of the simple rankine cycle is 37.1626%.

Q: 3. Show that the thermal efficiency of the Carnot cycle in terms of the isentropic compression ratio…

A: Draw the T-s diagram of Carnot cycle.

Q: Air enters the compressor of a regenerative gasturbine engine at 310 K and 100 kPa, where it is…

A: Given data

Q: Q(4) A steam power plant operates on a simple ideal Rankine cycle between the pressure limits of 3.5…

A: Given Data Turbine Inlet: 3.5 MPa, 400°C Turbine outlet: 75 kPa Mass flow rate: 45 kg/s

Q: How do the inefficiencies of the turbine and the compressor affect the thermal efficiency of a…

A: The back work ratio is given by The inefficiencies of turbine and compressor increases the…

Q: Consider a two stage compression and two stage expansion in an ideal gas-turbine cycle. The air…

Q: A steam power plant operates on the cycle shown in Fig. 10-5. If the isen- tropic efficiency of the…

Q: What components can be added to a simple open cycle gas turbine power plant in order to increase its…

A: There are basically 3 components, which can be added to gas power cycle to increase the efficiency.

Q: A steam power plant operates on a simple ideal Rankine cycle between the pressure limits of 6 MPa…

Q: 15. Determine the maximum temperature of a Carnot cycle if it operates at a minimum temperature of…

Q: In an air standard gas turbine cycle, air at 14.5 psia and 70 F is first compressed to 80 psia in a…

Q: A.) Quality after turbine expansion B.) Turbine work C.) Heat added in the boiler D.) Heat…

A: Given: An ideal reheat cycle the steam throttled condition is 7 Mpa and 460 C reheated to 1.5 MpA…

Q: A steam power plant operates on a simple ideal Rankine cycle between the pressure limits of 3 MPa…

A: Pressure P1 = 50 kpa Pressure P2 = 3 Mpa Temperature T = 300 C Mass flow rate = 35 kg/s

Q: An ideal diesel engine has a compression ratio of 20 and uses air as the working fluid. The state of…

A: Given data r=20P1=95 KPaT1=20°cT3=2200 K

Q: 1. Describe the carnot cycle and explain why it limits the thermodynamic efficiency of a heat…

A: 1.A carnot cycle is an ideal reversible thermodynamic closed cycle. It has been shown by a…

Q: 2.) A power plant operating on a Rankine cycle has steam entering the turbine at 500 °C and 2 MPa.…

Q: Q15/ (9-121) Consider an ideal gas-turbine cycle with two stages of compression and two stages of…

A: Given Data : Pressure ratio = 3 Temperature of air enters in compressor T1 = 300 K Temperature of…

Q: Air enters the compressor of a regenerative gas-turbine engine at 100 kPa and 300 K and is…

Q: 15. Consider a Carnot cycle executed in a closed system with air as the working fluid. The maximum…

A: Note: As per our guidelines we are supposed to answer only the first 3 sub-parts. Kindly repost…

Q: 3) A steam power plant operates on a simple ideal Rankine cycle between the pressure limits of 4 MPa…

A: From the properties of steam The enthalpy and the entropy of the steam at the pressure of 4 MPa and…

Q: An ideal diesel engine has a compression ratio of 20 and uses air as the working fluid. The state of…

Q: A gas-turbine power plant operates on the simple Brayton cycle with air as the working fluid and…

Q: A stationary gas-turbine power plant operates on a simple ideal Brayton cycle with air as the…

A: Given Inlet compressor pressure = 95 kPa Inlet compressor temperature = 290 K Turbine pressure = 760…

Q: An ideal Ericsson engine using helium as the working fluid operates between temperature limits of…

A: Given: The temperature at heat rejection, T1 = 550 R The temperature at heat addition, T2 = 3000 R…

Q: A steam power plant operates on a simple ideal Rankine cycle between the pressure limits of 3 MPa…

A: Given Data Initial pressure is: P1=3 MPa The final pressure is: P2=50 kPa The temperature of the…

Q: Consider a gas turbine cycle with two stages of compression and two stages of expansion. The…

Q: in a rankine cycle, what is the entrance pressure of the turbine if the condenser pressure is 105…

Q: Consider a steam power plant that operates on a simple ideal Rankine cycle and has a net power…

Q: A gas-turbine power plant operates on the simple Brayton cycle between the pressure limits of 100…

A: Given, Pressure, P1=P4=100 kPaP2=P3=1600 kPa The inlet temperature of the air in the compressor,…

Q: How does the ideal Ericsson cycle differ from the Carnot cycle?

A: Ideal Ericsson cycle Ericsson cycle consists of four processes which are as follows- Isothermal…

Q: A steam power plant operates on a simple ideal Rankine cycle between the pressure limits of 1250 and…

A: Given: The initial pressure is P1=2 psia. The final pressure is P2=1250 psia. The mass flow rate of…

Q: None

A: Turbine: A turbine is a mechanical device that converts the kinetic energy of steam into mechanical…

Q: An ideal Otto cycle has a compression ratio of 9. Using constant specific heats at room temperature,…

Q: What are the four processes of the Carnot cycle?

A: given: What are the four processes of the Carnot cycle?

Q: An ideal Stirling engine using helium as the working fluid operates between temperature limits of…

A: Given Data⇒Ideal Stirling engine Temperature limitsT1=300 KT2=2000 KPressure limitsP1=3 MPa=3000…

Question

In a steam turbine operating according to the simple ideal rankine cycle, the boiler pressure is 2 MPa
and the turbine inlet temperature is 450 °C. Determine the net power produced if the pump pressure is 15
kPa and the heat released from the system is 1200 kJ/kg at a flow of 1.3 kg /s.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A steam power plant operates on a simple ideal Rankine cycle between the pressure limits of3 MPa and 50 kPa. The temperature of the steam at the turbine inlet is 300°C, and the massflow rate of steam through the cycle is 35 kg/s. Show the cycle on a T-s diagram with respectto saturation lines, and determine (a) the thermal efficiency of the cycle and (b) the net poweroutput of the power plant.
A gas turbine cycle with a stage of reheat and regeneration operates under the conditions given below, as illustrated in the figure. The turbine efficiencies are 86%, and the compressor efficiency is 81%. Furthermore, the work output of the high-pressure turbine is just enough to drive the compressor. Determine the pressure at which the reheater operates. T1 = 1300 K, T6 = 3000 K, P1 = 450 kPa, P6 = 100 kPa
What components can be added to a simple open cycle gas turbine power plant in order to increase its efficiency? Given the gas turbine is powered with auto-diesel fuel.
15. Consider a Carnot cycle executed in a closed system with air as the working fluid. The maximum pressure in the cycle is 1300 kPa while the maximum temperature is 950 K. If the entropy increase during the isothermal heat addition process is 0.25 kJ/kg·K and the net work output is 110 kJ/kg, determine (a) the minimum pressure in the cycle, (b) the heat rejection from the cycle, and (c) the thermal efficiency of the cycle. (d) If an actual heat engine cycle operates between the same temperature limits and produces 5200 kW of power for an airflow rate of 95 kg/s, determine the second-law efficiency of this cycle
A gas turbine works on the basis of the Brayton cycle where the temperature and pressure entering the compressor are 27°C and the pressure is 100 kPa and the mass flow rate of air entering the compressor is 6 kg/s. The compressor pressure ratio is 10 and the temperature of the working fluid entering the turbine is 1100 °C. If the value of k = 1.4 calculate : a) the thermal efficiency of the system b) the back work ratio c) the amount of power produced.
Prove that the efficiency of the carnot cycle in terms of compression ratio is derived through e = 1 - [1/(rkk-1)]
Consider an ideal gas-turbine cycle with two stages of compression and two stages of expansion. The pressure ratio across each stage of the compressor and turbine is 3. The air enters each stage of the compressor at 300 K and each stage of the turbine at 1200 K. Determine the back work ratio and the thermal efficiency of the cycle, assuming no regenerator is used.
The pressure ratio of a gas-turbine power plant operating on an ideal Brayton cycle is 8. The gas temperature is 300 degrees Fahrenheit at the compressor inlet and 1300 degrees Fahrenheit at the turbine inlet. Assuming an 80 percent compressor efficiency and an 80 percent turbine efficiency. A regenerator with an 80 percent efficiency is installed at the power plant. Determine the variation of particular heats with temperature using specific heats. a. The back work ratio b.The thermal efficiency
An ideal diesel engine has a compression ratio of 20 and uses air as the working fluid. The state of air at the beginning of the compression process is 95 kPa and 20°C. If the maximum temperature in the cycle is not to exceed 2200 K, determine the net work of the system as a function of compression ratio, r.
In an ideal Brayton cycle, air is compressed from 100 kPa and 25°C to 1 MPa, and then heated to 1000°C before entering the turbine. The air temperature at the turbine exit is
A Rankine Cycle operates at a throttle pressure and temperature of 5 MPa and 450°C, respectively. The generator produces 20 MW at an efficiency of 95% while the mechanical efficiency is 97%. The actual expansion efficiency of the turbine is 85% and the pressure of the condenser is 10 kPa. Determine the theoretical engine thermal efficiency in %.
An aircraft engine operates on a simple ideal Brayton cycle with a pressure ratio of 10. Heat is added to the cycle at a rate of 500 kW; air passes through the engine at a rate of 1 kg/s; and the air at the beginning of the compression is at 70 kPa and 0°C. Determine the power produced by this engine and its thermal efficiency. Use constant specific heats at room temperature.