In a three-phase induction motor the maximum torque occurs at 20% slip and the equivalent resistance of the secondary is 0.04Ω per phase. Find the equivalent load resistance and the load voltage and the load current. Output power is 20 kW.

In a three-phase induction motor the maximum torque occurs at 20% slip and the equivalent resistance of the secondary is 0.04Ω per phase. Find the equivalent load resistance and the load voltage and the load current. Output power is 20 kW.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter32: Three-phase Motors

Section: Chapter Questions

Problem 13RQ: A squirrel-cage induction motor is operating at 1175 RPM and producing a torque of 22 Ib-ft. What is...

See similar textbooks

Related questions

Q: 4. Determine / in the given circuit. SV 3.2 M 752 +8V

A: Given data, Circuit diagram is given as,

Q: Draw the output waveforms (S, X, and Y) for the below sequential circuit by assuming the propagation…

Q: Determine the Norton equivalent of the circuit in Fig. 10.30 as seen from terminals a-b. Use the…

A: Given: Circuit diagram

Q: Explain the effect of temperature on a diode. Explain the relationship between current and voltage…

Q: Q5: An output pulse of 3 ms duration is to be generated by a 741S122 one-shot. Using a capacitor of…

A: Given data:- Time period, T= 3 ms Capacitor, C= 50,000pF The 74LS122 is a retriggerable monostable…

Q: Write three important factors which justify the need of modulating a message signal. Show…

A: The method used to convert information into electrical signals that are best suited for transmission…

Q: A 110-V shunt generator has a full-load current of 100 A, shunt field resistance of 55 Ω and…

Q: The cathode of zener diode in a voltage regulator is normally 1- less positive than the anode 2-…

Q: 1. Find the mesh currents for the circuit shown and the voltage across the resistances.

Q: The power delivered by the 3A source is 3A O 20W O 15W O 40W O-20W 5.02 10V

A: Given circuit:

Q: The correct Boolean expression for the shown logic circuit is Ao- Bo- Co y

A: Given Boolean circuit:

Q: The system that has the transfer function G(s) = Underdamped system Undamped System O Critically…

A: Given data, Transfer function of system is given, Gs=144s2+6s+144.

Q: Apply superposition theorem to the circuit of fig. for finding the voltage drop v across the 50…

Q: Q2/ A discrete time system characterized by the following unit sample response h(n) = 8(n) + 8(n −…

Q: EIRP Calculations 8) Consider a wireless transmitter that has an antenna gain of 5 dBi. Calculate…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: In free space, E = co -cos(10*t – kz)a,V/m 50 Find k, Ja and H.

A: Given data: The electric field E=50ρcos108t-kzaρ V/m

Q: Find the representation of the state space using the following state variables see the variables…

Q: 1.23. Let the signal input to a galvanometer be x (1) = 0 t≤0 1>0 (1) = Kt in which K is a constant.…

Q: b. Choose the suitable choice foL ping of the following sentences 18 Maces 1. In order to tune a…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Q5: A tank contain 200 L of Hydrogen gas with 5 C temperature and under a pressure of 156 kpa. If…

Q: calculate the effective resistance of the following combination of resistance and the voltage drop…

Q: Wavelength division multiplexing, to put it briefly.

A: Wavelength division multiplexing:- A fiber-optic transmission method called wavelength division…

Q: A coil of inductance 318.3 mH and neg[1]ligible resistance is connected in series with a 200…

A: Given that The coil has inductance L=318.3 mH and negligible resistance RC=0 ohm. Series resistor…

Q: + % t=0 R₁ www R₂ C₂ The value of v(t) for t> 0 is + v(t) The circuit in the given figure is the…

A: For t>0,C1=0.5μFC2=5μFR1=5MΩR2=2.6MΩV0=60ut v.

Q: Describe two types of noise that may contaminate kinematic data and describe how each of them can be…

A: Noise: It can be defined as the unuseful form of energy that gets introduced into a system and leads…

Q: The dynamic resistance can be important when a diode is 1- reverse-biased 2- unbiased 3-…

Q: The electric field intensity of a spherical wave in free space is given by 10 E = " sin e cos(wt –…

A: Given data The given electric field intensity is E=10rsinθ cos (ωt-βr)aθ Vm

Q: Please explain this question properly A capacitor has a reactance of 40 when operated on a 50 Hz…

Q: 18 ма ф ZMA | чка Gu + Vx тка зна ззка чка

Q: 6. Hysteresis loss depends upon a. the volume and grade of iron c. frequency of magnetic reversals…

A: Since you have posted a question with multiple sub-parts, we will solve the first three…

Q: 2. Determine the current and voltage through R₁ and the power absorbed by R1 using mesh analysis. V1…

Q: 4. Given x₁(t) = cos(t), x₂(t) = sin(ät), and x3(t) = x₁(t) + x₂(t) a. Determine the fundamental…

A: Given the signals are x1t=costx2t=sinπtx3t=x1t+x2t find: Fundamental period of x1(t) and x2(t).…

Q: B)-A transistor is used as an amplifier circuit at 8 GHz for which the S-parameters at reference…

Q: Q3: Astable multivibrator was designed using a 555 timer. The periodic time of the output signal…

A: Given: External capacitor C=10 μF Time period T=35 ms Duty cycle D=60% Find: Design a Astable…

Q: What is the expression for thevenin's current if there is an external resistance R in series with Rh…

A: Given: In a Thevenin's equivalent circuit, The Thevenin's resistance is Rth and external resistance…

Q: Which mode of wave propagation is suitable for television broadcast and satellite communication, and…

A: Categorization of Modes of wave propagation on the basis of signal type: Transverse Electric and…

Q: Solve the base voltage of an emitter stabilized bias circuit with Vcc=18V, RB-720k ohms, RC=2.7k…

Q: Calculate the current taken by a 23µF capacitor when connected to a 240V, 50 Hz supply

Q: . (A)-Create an 8086 Assembly language program that subtracts two 8-bit ASCII numbers, the first and…

A: Given: 8086 Assembly language program to subtract two 8 bit ASCII numbers. Two 8-bit ASCII numbers…

Q: If a voltage of 200 v, 50 Hz is applied to a resistance of 4092, write the voltage and current…

Q: A 12 V battery is connected across a series combination of 68 , 47 , 220, and 33 . The amount of…

A: Given : V=12V All resistance connected in series so, RTotal=68+47+220+33RTotal=368Ω

Q: Determine the total resistance, R W RT 6&R 41.5 8ksz

Q: A 100μF capacitor will have 100 reactance at f= Select one: O a. O Hz b. 100 Hz c. 1000 Hz d. 15.9…

A: Given, Capacitance of capacitor, C=100 μF. Capacitive reactance, XC=100 Ω.

Q: X -3-0d X jo |j7=jou s-plane -j7 =-jod

Q: The load in a factory is 300 kW at 0.8 lagging power factor. It is required to improve the overall…

Q: For the below frequency distribution table calculate all the below reequipments. Frequency 46 -10…

Q: oose the right option for the following. L... villy 1. If a DC voltage is applied to a DC motor,…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: Q2: Draw the output waveforms (S, X, and Y) for the below sequential circuit by assuming the…

Q: Consider an n-channel metal-oxide-semiconductor field-effect transistor (MOSFET) with a…

A: Given- MOSFET- Ratio of width of the gate and channel length- WL=4, Mobility of the carrier × Oxide…

Q: For a particular depletion mode NMOS device, Vt = -2V, kn W/L = 200 µA/V2 and λ = 0.02V-1. For VDS =…

Concept explainers

Three Phase Induction Motor

The induction motor is an electric motor that runs on AC (alternating current) and it is of two type single phase motor that work on single-phase power supply and three-phase motor that work on three-phase power supply.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Induction motors and welding transformers require magnetizing current, which causes a. lagging power factor. b. leading power factor. c. unity power factor. d. zero power factor.
A squirrel-cage induction motor is operating at 1175 RPM and producing a torque of 22 Ib-ft. What is the horsepower output of the motor?
Name three factors that determine the torque produced by an induction motor.
A 3-phase induction motor has a starting torque 100% and a maximum torque of 200% of the full load toque. Find the slip at maximum torque. Answer: 26.8%
In a 3-phase induction motor, express the mechanical power developed, in terms of air gap power Pg.
The power supplied to a three-phase induction motor is 20kW and the stator losses are 1000W. If theslip is 4 %, find the rotor copper loss
440 V, 50 Hz, 3-phase, wye-connected Induction Motor with the following particulars, R1= 0.075 ohm, X1=0.204 ohm, XM= 8.74 ohms, R2=0.063 ohm, X2=0.204 ohm NR @ full load=1560 rpm Find a. Stator current b. Pf of the stator c. Torque induced
The speed of an induction motor fed from a 3-phase and 50 Hz source is 1440 rpm, so which of the following is the number of poles of the motor?a)2b)4C)6d)8f) 12
3 phase motors are widely used in the industry. they require little maintenance, having no brush gear or centrifugal switch, are robust and relatively inexpensive.
The name plate of single phase induction motor has following data output 373W,230V, frequency 50Hz. Input current 2.9A and power factor is 0.71. Speed 1420 rpm What is efficiency of motor.
E-a). The lower the speed setting, the_________ the impedance of run winding in a single-phase multi-speed motor. a) lower b) higher c) either "a" or "b" d) neither "a" nor "b" E-b)The rotor of a single-phase repulsion motor gets its voltage a) by induction b) direct wired from an external AC source c) direct wired from an external DC source d) all of the above
A three phase induction motor with supply frequency of 60 Hz , 6 poles. If the slip is 5 % at a certain load, determine (a) the synchronous speed, (b) the speed of the rotor (c) the frequency of the induced e.m.f in the rotor and (d) speed of the induction motor if the slip changes to 6.75 %