in a vertical pipe conveying oil of specific gravity 0.8, two pressure gauges have Problem been installed at A and B where the diametres are 16 cm and 8 cm respectively. A is 2 metres above B. The pressure gauge readings have shown that the pressure at B is greater than at A by 0.981 N/ cm'. Neglecting ali losses, calculate the flow rate. If the gauges at A and B are replaced by tubes filled with the same liquid and connected to a U-tube containing mercury, calculate the difference of level of mercury in the two limbs of the U-tube.

in a vertical pipe conveying oil of specific gravity 0.8, two pressure gauges have Problem been installed at A and B where the diametres are 16 cm and 8 cm respectively. A is 2 metres above B. The pressure gauge readings have shown that the pressure at B is greater than at A by 0.981 N/ cm'. Neglecting ali losses, calculate the flow rate. If the gauges at A and B are replaced by tubes filled with the same liquid and connected to a U-tube containing mercury, calculate the difference of level of mercury in the two limbs of the U-tube.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

23 - Where atmospheric conditions are 100 kPa and 20 ºC, there is air at a pressure of 103 kPa in a tank. The 6 cm diameter plug in the tank is opened. Determine the maximum airflow through the hole? (R=0.287 J/kgK) a) 0.122 m³/h B) 0.145 m³/h NS) 0.133 m³/h D) 0.197 m³/s TO) 0.098 m³/s
Determine the NPSH available to avoid the formation of cavitation in the system, water T° 13°C, pipe F°G°, Q=2.45 L/s, Re= 5.4 x 104. The efficiency of the motor will be 0.7, NPSHr = 3mca, the system has an average altitude of 3341 msnm, it is also known that the suction height is 0.80m. Suction pipe diameter 1 ¼”.
21 - Since the pressure loss is 70 kPa when the water flowing through a 6 cm diameter pipe passes into a venturimeter that narrows to 4 cm, what is the flow rate here? (ρ=1000 kg/m³) a) 0.028 m³/s B) 0.025 m³/s NS) 0.021 m³/s D) 0.017 m³/s TO) 0.030 m³/h
14. Through a refinery, fuel ethanol is flowing in a pipe at a velocity of 1 m/s and a pressure of 101300 Pa. The refinery needs the ethanol to be at a pressure of 2 atm (202600 Pa) on a lower level. How far must the pipe drop in height in order to achieve this pressure? Assume the velocity does not change. (Hint: Use the Bernoulli equation. The density of ethanol is 789 kg/m3 and gravity g is 9.8 m/s2
The water level in a tank is 34 ft above the ground. A hose is connected to the bottom of the tank at the ground level and the nozzle at the end of the hose is pointed straight up. The tank cover is airtight, but the pressure over the water surface is unkown. Determine the minimum tank air pressure (gage) that will cause a water stream from the nozzle to rise 72 ft from the ground. A. 13.5 psi B. 14.4 psi C. 16.5 psi D. 15.5 psi With F.B.D.
29. A mixture of water and steam flowing out of a vent at 200 psia and quality of 0.27. Find the void fraction at critical flow condition according to Moody and Fauske models. [Ans. αMoody = 0.65 and αFauske = 0.81].
Oil with a density of 917kg/m3917kg/m3 is flowing smoothly through a pipe, as shown. In the lower portion, the oil is flowing at v1=2.24m/sv1=2.24m/s, and the pressure gauge indicates P1=227kPaP1=227kPa. In the upper portion of the pipe, oil is flowing at v2=3.26m/sv2=3.26m/s at a height that is 12.98m12.98m above the lower portion. What is the pressure reading, in kilopascals, on the gauge on the upper portion of the pipe?
1) Which of the following statement is NOT correct about piping network? a) In parallel pipes, the flow rate is proportional to its diameter and inversely proportional to its length and friction factor. b) When analyzing the piping network, conservation of mass throughout the system must be satisfied. c) In piping systems with pumps, the Bernoulli equation should be corrected by introducing a kinetic energy correction factor. d) The algebraic sum of head losses for all loops equal to zero. 2) The EGL is always a distance V2/2g above the HGL. True or False
A pitot tube is used to measure the mean velocity in a pipe where water is flowing. A manometer containing mercury ia connected to the pitot tube and indicates a height of 150 mm. The specific weights of the water and mercury are 9810 N/m³ and 133,400 N/m³, respectively. Calculate the velocitu of the water?A. 6.09 m/sB. 12.87 m/sC. 18.42 m/sD. 24.90 m/s
Air is kept in a tank at pressure Po = 689 KPa abs and temperature To = 17°C. If one allows the air to issue out in a one-dimensional isentropic flow, the flow per unit area at the exit of the nozzle where P = 101.325 KPa is Blank 1 kg/m2-s. For air, Use R = 287 J/kg-K and Mol. Wt. = 29.1 *Express your answers in whole significant figure without decimal value and without unit*
16 - The static and stagnation pressures of the fluid passing through a pipe are measured using a piezometer and a Pitot tube. Fluid heights in the piezometer and Pitot tube were read as 2 m and 2.2 m, respectively. If the density of the fluid is 1000 kg/m³, what is its velocity? a) 1.98 m/s B) 1.43 m/s NS) 0.92 m/s D) 1.65 m/s TO) 2.39 m/s
please include fbd A 22 L kerosene tank is filled with 2 cm diameter hose equipped with a 1.5 cm nozzle meter If it takes 20 s to fill the tank, determine the pressure differnce indicated by the nozzle if Cd= 0.96. The specific gravity of kerosene is 0.82. a. 12.8 kPa b. 11.8 kPa c. 10.8 kPa d. 9.8 kPa