In an experiment conducted at Carleton university, following experimental setup has been prepared. In this experiment, block A is released from rest and strikes cart B. Neglecting the effect of friction, find the maximum displacement s that cart B travels beyond point C. The coefficient of restitution for the collision is e = 0.7. 0.6 m 30 Impact Test 3 kg 60° 1.8 m B 1 kg This region is the arc of a circle

In an experiment conducted at Carleton university, following experimental setup has been prepared. In this experiment, block A is released from rest and strikes cart B. Neglecting the effect of friction, find the maximum displacement s that cart B travels beyond point C. The coefficient of restitution for the collision is e = 0.7. 0.6 m 30 Impact Test 3 kg 60° 1.8 m B 1 kg This region is the arc of a circle

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter4: The Laws Of Motion

Section: Chapter Questions

Problem 4P: Two forces, F1=(6i4j)N and F2=(3i+7j)N, act on a particle of mass 2.00 kg that is initially at rest...

See similar textbooks

Similar questions

A hammer of mass m = 0.465 kg is moving horizontally at a velocity of v = 5.5 m/s when it strikes a nail and comes to rest after driving the nail a distance Δx = 1.15 cm into a board. a)What is the duration of the impact, in seconds, assuming the acceleration of the hammer was constant? b)What was the average force, in newtons, exerted on the nail?
A hammer of mass m = 0.455 kg is moving horizontally at a velocity of v = 6.5 m/s when it strikes a nail and comes to rest after driving the nail a distance Δx = 0.95 cm into a board. a.) What is the duration of the impact, in seconds, assuming the acceleration of the hammer was constant? b.) What was the average force, in newtons, exerted on the nail?
A hammer of mass m = 0.465 kg is moving horizontally at a velocity of v = 4.5 m/s when it strikes a nail and comes to rest after driving the nail a distance Δx = 0.95 cm into a board Part A) what is the duration of the impact, in seconds, assuming the acceleration of the hammer is constant? Part B) what is the average force, in newtons, exerted on the nail?
The masses m1and m2shown in the figure are tied to eachother by a rope over a frictionless pulley. While the mass m1rotates in the horizontal plane, the mass m2staysat rest. Neglect the mass of the pulley and the rope. (m1= 4 kg, m2= 5 kg, L = 2 m)a) Find the tension in the rope.b) Find angle c) Find the velocity of the mass m1.
The following graph corresponding to the motion of a 3.0 kg particle in the axisx-axis, starting fromfrom the position x = 0 m for t = 0 s.The particle travels to the left in thestage: _____a) Ab) Bc) Cd) D
A cart of mass 8.0kg was moved by applying two constant forces. Force 1 is 28.0N at 42.0 degrees, and Force 2 is 13.0N at 110 degrees. Initially, the cart has a velocity of (3.50i + 2.20j)m/s. a. Express the two forces in unit-vector notation.b. Find the total force exerted on the cart.c. Find the angle at which the total force is applied.d. What is the acceleration of the cart?e. What is the cart's velocity after 5.0s?f. What is the position of the cart after 5.0s?g. What is the angle of the position after 5.0s?h. What is the total work done by the two applied forces?
A spacecraft flying horizontally over the surface of the moon at an elevation of 1500m with a speed of 350m/s, drops a package with a mass of 1200kg to astronauts on the surface. Use gm= 1.6m/s2 for the acceleration due to gravity on the Moon. a)How long does it take the package to hit the surface after it is dropped? b)How far ahead (distance) of the package’s landing spot should the package be released? c)What is the velocity of the package just before it hits the surface? d)What is the magnitude of the velocity of the package just before it hits the surface of the Moon?
A block of mass m1 = 3.0 kg rests on a frictionless horizontal surface. A second block of mass m2 = 2.0 kg hangs from an ideal cord of negligible mass that runs over an ideal pulley and then is connected to the first block. The blocks are released from rest. a.) Find the magnitude of the acceleration of the two blocks after they are released. b.)What is the speed of the first block 1.2 s after the release of the blocks, assuming the first block does not run out of room on the table and the second block does not land on the floor?
A hammer of mass m = 0.44 kg is moving horizontally at a velocity of v = 4.5 m/s when it strikes a nail and comes to rest after driving the nail a distance Δx = 0.85 cm into a board. Part A : What is the duration of the impact, assuming the acceleration is constant during this time period, in terms of the given variables? Part B: What was the average force exerted on the nail, in terms of the mass, initial velocity, and distance traveled? Part C: What was the average force, in newtons, exerted on the nail?
If the vector components of the position of a particle moving in the xy plane as a function of time are x(t) = bt2 and y(t) = ct3, where b and c are positive constants, b has dimensions of length per time squared, and c has dimensions of length per time cubed, when is the angle between the net force on the particle and the x axis equal to 45°? (Use the following as necessary: b, c. Enter an answer greater than 0.)
A ball is thrown from point (0,0,0) with initial velocity v=vx0i + vy0j. The forces acting on theball are given as gravitational force F = −mg and air friction force Fs = −bv. Where b is thecoefficient of friction constant.a) Find the position and velocity of the ball as a function of time.b) What is the approximate distance from the origin when the ball lands?c) If the friction coefficient b is too small, what approximate the results you find in options a and b?Show it mathematically.
As part of a physics experiment, youstand on a bathroom scale in an elevator. Though your normal weight is 610 N, the scale at the moment reads 730 N. (a) Isthe acceleration of the elevator upward, downward, or zero?Explain. (b) Calculate the magnitude of the elevator’s acceleration. (c) What, if anything, can you say about the velocity ofthe elevator? Explain.