In an industrial installation there are two motors. One of them demands 150 kW at 0.8 in lagging and the second one is 300 kVA at fp of 0.9 in lagging. Which of the following options if connected in parallel would bring the fp at the input of the plant to 0.95 in lagging?

Q: A synchronous motor absorbing 60 kW is connected in parallel with a factory load of 240 kW having a…

A: In synchronous motor the rotor is rotate a constant speed and this type of rotor is wound rotor.…

Q: A resistor of 4 ohmsisconnected in parallel with an impedancecoil whose resistance and inductive…

A: We are authorized to answer one question at a time since you have not mentioned which question you…

Q: power station has this daily load curve data (a) Draw the daily load curve. (b) Draw the load…

A: Answer shown below

Q: ^ what is 200121° Urm 2001-95° Urms 200 1145 Vrms 4 3 IL1 I. k 2a 26 Zc N 2a= 2b = 2c= (25+j5) e…

A: In this question,  We need to determine the complex power, active power and reactive power?.  We…

Q: An industrial plant consisting primarily of induction motor loads absorbs 500 kW at 0.6 power factor…

A: In this question we need to find a KVA rating of shunt capacitor and overall power factor when…

Q: S.2) The serial impedance of the 300 km power transmission line is 23 + j75 ohm / phase and the…

A: According to policy, attempting only three sub-section of question Per km series impedance can be…

Q: You own a factory that uses several conveyor belts and other motor-driven machineries. Upon…

A:

Q: A generating station has a connected load of 43,000 kW and a maximum demand of 20,000 kW, the units…

A:

Q: A power station is to supply four regions of loads whose peak values are 10,000 kW, 5000 kW, 8000 kW…

A: Since nothing is given to answer which of the following question but I can find ink marked in Ques…

Q: 'The contract load of a medium scale Industry (MSI) at 6600 V, 50 Hz is 1.2 MW, but the maximum…

A: Given VL = 6600 V  F = 50 Hz Contract demand = 1.2 MW Average Power factor = 0.85 Power factor…

Q: A group of small appliances on a 60 Hz system requires 20 kva at 0.85 lagging power factor when…

A:

Q: A generating station has a maximum demand of 20 MW, a load factor of 60%, a plant capacity factor of…

A: The solution can be achieved as follows.

Q: Problem 4 An electric saw, a wood shaper, and a motor load of a workshop establish a 18 kVA power…

A:

Q: 1-Alternators can be overloaded by 10 percentage for 10-15 minutes, this a. Steady state voltage…

A: Need to find the correct statement for the given questions

Q: generation station of 1MW supplied

A:

Q: The power consumption of an industry is 500 kVA, at 0.8 p.f lagging. A synchronous motor is added to…

A: Given that power consumption of industry (Load) is 500 kVA at 0.8 power factor lagging and…

Q: A power station is to supply four regions of loads whose peak values are 10,000 kW, 5000 kW, 8000 kW…

A: The solution can be achieved as follows.

Q: 3. A yearly load duration curve of a gas turbine power plant is a straight line from 50,000 to 5,000…

A: a yearly load duration curve of a gas turbine power plant is a straight line from 50000 to 5000KW.…

Q: An industrial load uses 310-kVA at 0.6 pf lagging. A synchronous motor is added to the system to…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: n alternator is supplying a load of 350 kW at a p.f of 0.7 lagging. If the power factor is raised to…

A: The solution is attached below for the given alternator problem.

Q: The

A:

Q: A 3-phase transmission line having a capacity of 10,000KVA serves as a balanced load that draws…

A:

Q: 7. A power station has to meet the following load demand 50 KW 30 kW 20 kW between 10 A.M. and 6PM.…

A: Load A 50KW 10AM to 6PM Load B 30KW  6PM to 10PM Load C 20KW 4PM to 10AM Draw load curve, diversity…

Q: Q10. If the impedance of a circuit = 20 – j10 1. if a voltage source is connected across this…

A: Given: Impedance Z=20-j10Ω Voltage source is connected across impedance.

Q: 5. The maximum load on the Thermal Plant of 60MW capacity is 50MW at an Annual Load Factor of 50%.…

A: Thermal power plant is generate the electricity . it is also known as a combustion power plant . it…

Q: When connected to a 120-V (rms), 60-Hz power line, an inductive load absorbs 4 kW at a lagging power…

A: Given as per the circuit,Power factor = 0.8cosϕ1=0.8ϕ1=cos-1(0.8) = 36.87°where ϕ1 is the phase…

Q: A 40 kW induction motor, with a lagging power factor of 0.76, is supplied by a 120 V rms 60 Hz…

A: The solution is given below

Q: The maximum diversified demand of a range of loads supplied by a power plant over one year is 24000…

A: The load diversity factor  is given by the expression as shown below:  Load diversity…

Q: An industrial plant is connected to a 600 Vrms, 90 Hz power line and draws 90 kW at a lagging power…

A: The complex power in an AC system is defined as the product of rms value of applied voltage and…

Q: An AC generator having an internal resistance of 2 k*(omega) is connected to an LCR circuit in…

A: PART (a): The circuit is: Given, L=40π HC=10π μFR=2 kΩr=2 kΩE=282 sin 100πt Vω=100π

Q: The motor inside a blender can be modeled as aresistance in series with an inductance, as shown…

A: Consider the frequency of the voltage source is 60 Hz. Write the expression for the inductive…

Q: The nameplate of an electric molur owing information: Line voltage: 220V rms Line current: 15 A rms…

A:

Q: Problem #15: A manufacturing plant has a load of 3600 kVA at a lagging pf of 0.707. A 500-hp…

A: The solution is given below

Q: A small industrial plant has a 12-kW heating load and a 25-kVA inductive load due to a bank of…

A:

Q: An investor own two large stores at Dubai. Both malls are connected in parallel and operating at an…

A: Given: An investor owns two large stores in Dubai. Both malls are connected in parallel and operate…

Q: A generating station has two 50 Mw units each running for 8,500 hours in a year and one 30 Mw unit…

A:

Q: From the circuit given below, How can I find the value of load Z for the maximum power transfer and…

A: According to question: The value of 'Z' for maximum power transfer is calculated as…

Q: A generating station distributes the following loads. 2500KW, 7500KW, 15000KW and 3500KW, The…

A:

Q: Determine the value of Rµ for the maximum power transfer, Pmax to occur and calculate the maximum…

A: Thevinins theorem for DC circuit here   Providing The procedure is quite same for AC also It is also…

Q: Problem 4 An electric saw, a wood shaper, and a motor load of a workshop establish a 18 kVA power…

A:

Q: A power station is to supply four (4) regions of loads whose peak values are 10 MW, 7.5 MW, 8 MW,…

A:

Q: A generating station distributes the following loads. 3000 kW ,8000 kW,14000 KW and 4000 kW. The…

A:

Q: At an industrial sub – station with a 6 MW load, a capacitor of 2 MVAR is installed to maintain the…

A:

Q: Determine the PF associated with a load: (a) consisting of a 6.25-µF capacitor in parallel with the…

A: In this question we need to find a power factor.

Q: The 3-phase average power rating of the CPU on a mainframe computer is 22,659 W. The 3- phase line…

A: Determining the value of, We have, Therefore, the value of is 31.544.

Q: Problem 9: Determine the complex power absorbed by each passive component in the circuit shown…

A:

Q: If the power received at the MU is lognormal with standard deviation of 9dB, the outage probability…

A: According to the question we have to find the value of outage probability and value of x.

Q: Businessman Lance Smile own two large malls in Basilan Island. Both malls are connected in parallel…

A: Power factor: It tells how much the active power is utilized by the circuit from the apparent power.…

Q: An alternator is supplying 300 kW at a power factor of 0.6 lagging. If the power factor is raised to…

A: An alternator Active power P =300 kW  a power factor of 0.6 lagging. If the power factor is raised…

Synchronous Motor

The synchronous motor is an AC electric type motor where at a steady-state the shaft rotation is synchronized with the supply current variable-frequency. To an integral number of AC cycles, the rotation period is exactly equal. The stator of the motor in the synchronous motor contains multi-phase AC electromagnets due to which a magnetic field is created that rotates in time with the oscillation of the line current. The rotor contains a permanent magnet and the rotor rotates in synchronization with the stator field at the same rate and provides the second synchronized magnetic field which is rotating in nature as a result. When the synchronous motor is supplied with independently excited multi-phase AC electromagnets on both the rotor and the stator, it is termed as a doubly-fed machine. The most widely used AC-type motors are the synchronous AC motor and the induction AC motors.