In an oedometer test, a specimen of saturated clay 19 mm thick reaches 50% consolidation in 20 minutes. How long it would take a layer of this clay 5m thick to reach the same degree of consolidation under the same stress and drainage conditions? How long would it take for the clay layer to reach 30% consolidation?

In an oedometer test, a specimen of saturated clay 19 mm thick reaches 50% consolidation in 20 minutes. How long it would take a layer of this clay 5m thick to reach the same degree of consolidation under the same stress and drainage conditions? How long would it take for the clay layer to reach 30% consolidation?

Principles of Foundation Engineering (MindTap Course List)

9th Edition

ISBN:9781337705028

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter15: Foundations On Difficult Soil

Section: Chapter Questions

Problem 15.2P

See similar textbooks

Similar questions

A saturated clay specimen is subjected to a pressure of 240 kN/m2. After the lapse of a time, it is determined that the pore pressure in the specimen is 72 kN/m2. What is the degree of consolidation? Show free body diagram. a.75% b.60% c.70% d.65%
1.In an oedometer test a specimen of saturated clay 19 mm thick reaches 50%consolidation in 20 min. How long would it take a layer of this clay 5 m thick toreach the same degree of consolidation under the same stress and drainageconditions? How long would it take the layer to reach 30% consolidation?
The time required for a 50% consolidation of a 25 mm thick layer (drained at both sides) in the laboratory is 2 min and 20 sec. How long in days will it take for a 3 m thick layer of the same clay in the field under the same pressure increment to reach 50% consolidation? In the field there is a rock layer at the bottom of the clay.
In an oedometer test, with half-closed drainage condition, a specimen of saturated clay 19 mm thick reaches 50%consolidation in 20 min. How long would it take a layer of this clay 5 m thick to reach the same degree of consolidation under the same stress and drainage conditions? How long would it take the layer to reach 30% consolidation?
In a consolidation test, a fully saturated clay sample was subjected to a load of 500 kN/m2. After 12 hours, the average pore pressure was found to be 200 kN/m2. The time (in hours, rounded off to two decimal places) required for 50% consolidation to take place is
Refer to the soil profile shown in Figure P2.12. The clay is normally consolidated. A laboratory consolidation test on the clay gave the results: If the average effective stress on the clay layer increase by 50 kN/m2.a. What would be the total consolidation settlement?b. If Cv = 9.36 x 10-4 cm2/sec, how long will it take for half the consolidation settlement to take place?
The rate of consolidation for a stratum of clay soil is affected by several factors. Describe these factors.
A 10 ft thick clay layer of saturated clay (two-way drainage) under a loading underwent 90% primary consolidation in 400 days. The laboratory test’s specimen will have two-way drainage. Find the coefficient of consolidation of clay for the pressure range. For a 1 inch thick undisturbed clay specimen, how long will it take to undergo 80% consolidation in the laboratory for a similar pressure range?
The time for 75% consolidation of a 25 mm clay specimen (drained at top and bottom) in the laboratory is 22 minutes. How long will it take for a 6 m thick clay layer (same clay) in the field to undergo 55% consolidation under the same pressure increment? In the field, there is a rock layer at the bottom of the clay layer.
A 75 mm diameter clay specimen was consolidated in an oedometer under 200 kPa. At the end of consolidation, the void ratio is 0.863 and the specimen thickness is 18.51 mm. When the stress increment of 200 was added to the current vertical stress of 200 kPa, the specimen consolidated to a thickness of 17.56 mm. Assuming that the clay was normally consolidated under the vertical stress of 200 kPa, find the a) coefficient of volume compressibility in (MPa)^-1 and rounded to the 3rd decimal place.b) and the compression index of the clay rounded to the 2nd decimal place.
A 6 foot thick clay layer is determined to have the consolidation properties shown below. If the average in-situ stress is 500 psf and the preconsolidation stress is 1,000 psf, what is the settlement for this overconsolidated soil subjected to a stress increase of 2,000 psf.
An oedometer (consolidation) test is performed on a normally consolidated clay stratum that is 8.5 feet thick, and it found that the clay's initial voids ratio was e_0 = 0.8 and its primary compression index is C_c = 0.28. The in-situ stress at mid-clay layer is p_0 = 2, 650 psf, and the building exerts a pressure through its mat foundation of 970 psf. The secondary compression index C_ alpha = 0.02. The time of completion of the primary settlement is approximately 18 months. What is the total consolidation of the 8.5 foot clay stratum 5 years after the primary consolidation?