Question 43In an RL circuit, if R = 1 k 2, L= 100 mH, the time constant T will be:OA.B.0.01 msOC.OD.1 msOE.None of the other choices are correct0.1 ms10 ms.

Given, In an RL circuit, R=1 kΩL=100 mH

Answered: In an RL circuit, if R = 1 k 2, L= 100…

In an RL circuit, if R = 1 k 2, L= 100 mH, the time constant T will be: OA. B. OC. OD. 0.01 ms 1 ms None of the other choices are correct E. 0.1 ms 10 ms

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter13: Transmission Lines: Transient Operation

Section: Chapter Questions

Problem 13.19P

See similar textbooks

Related questions

Q: Prove that the sinewave shown in Fig. Is a periodic signal. x(1) Periodic signal x(t)= A sin(2xfot)…

A: We need to prove that the given signal is periodic .

Q: 8. Determine the reluctance of a materi- al with a length of 0.28 m and a cross- sectional area of…

A: Given: A material has Length, L=0.28 m Cross sectional area, A=0.08 m2 Absolute permeability,…

Q: For the following sensors using variable resistors, match the type of variable resistor with the…

A: Given: Various sensors and physical quantities are given. Suitable matching is required between…

Q: Solve the following problems: Given the differential equation, c'"'+3c"+5c'+c=r""'+4r"+6r¹+r a.…

A: Given here a differential equation and asked to find the transfer function and characteristic…

Q: (b) (c) ܙ ) - M m ܐ | ܤ | ܐ ܐܠ 3 t .. ܝ

A: 1. When a PN junction is in forward biased mode Then current flowing through transistor is…

Q: 12-19. Determine the characteristic impedance for an air-filled concentric transmission line with a…

A: Given here an air-filled concentric transmission line with a Dd ratio of 6.and asked to find the…

Q: If the voltage sources in the circuit shown are converted to current sources and then combined, what…

A: Given here a electrical circuit and asked to convert the voltage sources to current and asked to…

Q: 15-21. Determine the effective isotropic radiated power for an antenna with a power gain A, = 26 dB…

Q: 2. Complete the timing diagram of Q and Q' of the following circuit for the given inputs. Neglect…

A: A logic gate is a component used to construct digital circuits. They carry out fundamentally…

Q: 64. A 50 Hz, 11 kV, 3-phase alternator with earthed neutral has a reactance of 5 ohms per phase and…

A: Given, A 50 Hz, 11 kV, 3-phase alternator with earthed neutral has Reactance = 5 ohms per phase The…

Q: 2. The load per phase of a balanced 30 wye connected load is 8 + j6 Ohms per phase. This is…

A: In the given system, the load and source are balanced,so we can do the calculations of on per phase…

Q: Find the voltage across the capacitor terminal at time 1 ms for the circuit below. ww R 10 Ω C 100…

A: Given, To determine voltage across capacitor at t=1 ms

Q: A meter whose constant is 600 revolution/ kwh makes 5 revolutions in 20 seconds . Calculate the load…

Q: A sinusoidal voltage source of v(t) = 100cos (2π60t) V is applied to a load, resulting in a…

Q: Your team are been assigned to develop a portable electrical car jack as shown in Figure 3. The…

A: In this, The portable electric car jar has four subsystems Electric wrench Electric jack electric…

Q: 12-14. Using TDR, a transmission-line impairment is located 2500 m from the source. For a veloc ity…

A: The electromagnetic wave that is moving via the transmission lines is simply a combination of an…

Q: What is the radius of a copper cable having resistance of 10 ohm and length of 10 km. Assume the…

A: Given, Resistance of cable, R=10 Ω Length, L=10 km=10,000 m Resistivity of copper, ρ=1.7×10-8 Ωm

Q: 5-17. For a rectangular waveguide with a wall separation of 2.5 cm and a desired frequency of op-…

A: Given parameters : Wall separation in the waveguide, a - 2.5 cm Desired frequency, f = 7 GHz Here we…

Q: 19. Consider the circuit present on the right. Assume all emfs are ideal batteries. B a) What is the…

A: The given circuit diagram is shown below:

Q: A pressure measuring device indicates 12 psi which actually has the true value as 11.5 psi. The…

A: Given data, Measured value = 12 psi True value = 11.5 psi

Q: The input-output relation of a system at initial rest is given by, dx (t) + 2 x (t) ¹+ 3y(t) =…

Q: In the system shown in Fig. 6.12, two functions of time x₁(f) and (t) are multiplied together and…

Q: the following services: CB radio at 27 MHz; cordless phone at MHz; FRS at 460 MHz; cellular radio at…

Q: 2. In a certain magnetic field the cross- sectional area is 0.5 m² and the flux is 1, 500 Wb. What…

A: Given, In a certain magnetic field, The cross sectional area, A=0.5 m2 Flux, ϕ=1500 μWb

Q: PS1 (1) Determine the voltage and current meter indications in each circuit. .3kOhm RS 2.7k0ha D7…

A: The above circuit is connected in Easy EDA and Circuits cloud using si diodes

Q: A line having a total resistance of 0.20 ohm delivers 10 kW at 250 V to a small factory. What is the…

Q: The continuous time signal *(t) = cos(4000) is sample with a sampling period T to obtain a discrete…

Q: 8. Derive the Characteristic Table and complete the timing diagram of the following gated SR latch…

A: SR Latch : R S Q Remark 0 0 NC No Change 0 1 1 1 0 0 1 1 - Racing When both input…

Q: 2) Determine the value of R for the circuit below that will result in a diode current of 10mA if…

A: Given, The circuit is, Diode current, ID=10 mA Supply, E=7 V

Q: 6. A series RC circuit consists of R=2 mega ohms and an uncharged capacitor C=2 microFarad. The…

A: given circuit.

Q: Given the expression for the potential V= P. €= - [A]- -a +[C] -a +[E]. a a[B] ?х a[D] dy d[F] дz E…

Q: what is capacitor star in induction motor ?

A: Given: What is a capacitor start induction motor?

Q: The symbol shown is for i Ţ O a. DPST O b. DPDT O C. SPDT d. SPST

A: Given, The symbol shown is

Q: A 200kVA transformer with impedance of 5% and the power factor of the load is 85%. The primary…

A: Given data, Rating of transformer S = 2000 KVA Percent impedance %Z=5 % Power factor cosϕ=85 % =…

Q: 13. Find Vx in the circuit of following figure: ΤΩ M 15 V 2 Vx + 502 (4.167V)

A: Given circuit,

Q: Draw block diagram of 8 to 1 multiplexer also draw truth table and state Boolean expression for same…

Q: 4. What is the voltage gain of an inverting op-amp in which the feedback resistor has a value of…

A: Given data, An inverting op-amp in which Rf=7000 ΩRin=1500 Ω

Q: 1. The following are the given for the circuit below: VRY = 220 cis 0°, VYB= 220 cis -120° and VBR =…

Q: The electric field in the region is given as E= meters. x²x2 + measured in volts per meter. Find the…

Q: A T-junction power divider is the simplest network that can be used for power division or power…

Q: 6. In a parallel circuit the voltage drop across each branch is always equal to the source voltage.…

A: The answers to question number 6 and 7 are wrongly marked. 6. Answer: True Explanation: In a…

Q: z=3 A vector field is given by F = y'e"i-x*yj- xtan-lyk use the divergence (Gauss') theorem, to…

A: The given figure is shown below: A vector field is given as: F→=y3ezi^-x2yj^-xtan-1yk^ The circular…

Q: Finally, by inspection, essentially < [A] [B] [C] [E] [G] [H] ✓ [0] 5 is obtained by taking the…

Q: 9. Which of the following equation represents mass semiconductors in electronic circuits? action law…

A: The solution is provided in the following section.

Q: An EM wave progating in a certain medium is described by E = 33.3 sin(1002.4 x 10°t - 4.4x)az V/m…

A: Given data, An EM wave propagating in a certain medium, E=33.3sin1002.4×106t-4.4xaz V/m

Q: What is the purpose of an Amperian Path in Ampere's circuital law? 1 Computation of magnetic field…

A: Ampere's law relates the integrated magnetic field intensity around a closed loop to the current…

Q: electrical engineering what is the function of inverter ?

A: Inverter : A converter known as an inverter transforms DC energy (from a battery or storage battery)…

Q: Calculate the magnetic field strength at a distance 3 cm from a long, thin wire which is carrying a…

A: Given data, Current is given I = 1.75 A Distance a=3 cm = 0.03 m μ0=4π×10-7 N A-2

Q: Exponential to exponential function convolution For an LTI system with unit impulse response h(t) =…

Q: 2. Show that a rfo/Q for a parallel RLC resonance cir 4 R ww CA

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The givens are I1 = 0.219A, R1 = 66 ohms, R2 = 38 ohms, C = 0.1 farads. What is Vc across the capacitor at time t = 4.58 seconds?
The following is given for a series R-L-C circuit: resistor (R) = 8 Ohms, an inductor (L) = 32 mH and a capacitor (C) = 800uF. The circuit is supplied by a voltage source of e = 120 sin (125t) Volts. What is the real power of the circuit?
A 160 μF capacitor is connected in series with a 10 Ω resistor. Write the equation of the current when the voltage is 220 Vp? a. 11.4 sin (377t + 59) b. 8.9 sin (377t – 46) c. 9.8 sin (377t + 52) d. 7.2 sin (377t + 46)
Solve no.05 and show solutions. (Situation no.02 image below)
S:41) A circuit consists of a current source, Is = 43 sin(5386t - 40.29 °) mA in parallel with a 72 kΩ resistor and a 2895 pF capacitor. Determine the magnitude of the effective value of current that flows through the resistor.
If the rise time of a second order damped system is 0.16 s and its natural frequency is 10.4 rad / s, calculate the damping ratio? A) 0.54B) 0.51C) 0.53D) 0.52E) 0.55
Given the following points: A(3,-2,0) B (4,5,2) C (-3,2,1) Determine the RAB x RAC
21. The time constant of an RL circuit is the time when the current reaches to what percent of its steady state value? A. 90% C. 57.7% B. 63.2% D. 50%
The following is given for a series R-L-C circuit: resistor (R) = 8 Ohms, an inductor (L) = 32 mH and a capacitor (C) = 800uF. The circuit is supplied by a voltage source of e = 120 sin (125t) Volts. What is the period of ac source?
topic : capacitors, inductors, source free and step respons RL & RC circuits could use some assistance answering no.3, kindly show me the complete process as it helps me understand the problem completely. thank you
Since they are defined as X=1 and Y=10 Ω, respectively, in the circuit given below; What is the angle of the voltage phasor Vo? NOTE: Please enter your answer as 2 digits after the comma.
Please provide Handwritten answer. b) Sketch the root locus if C(s)=k. The root locus crosses the imaginary axis at s=1.6j rad/s.