What is the purpose of an Amperian Path in Ampere's circuital law? 1 Computation of magnetic field intensity Determination of differential element of path length Estimation of electric flux density Detection of a loop in a constant plane S. C.

What is the purpose of an Amperian Path in Ampere's circuital law? 1 Computation of magnetic field intensity Determination of differential element of path length Estimation of electric flux density Detection of a loop in a constant plane S. C.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.2MCQ: Overhead transmission-line conductors are bare with no insulating cover. (a) True (b) False

See similar textbooks

Related questions

Q: PRACTICE EXERCISE 7.11 Two #10 copper wires (2.588 mm in diameter) are placed parallel in air with a…

A: It is given that: d'=1.294 mmLA=LB=1.2 μHm

Q: 1. Which of these is incorrect for an operational amplifier? a) It has a high voltage gain b) It is…

A: In this question we will write about operational amplifier.....

Q: A separately excited DC generator is rated at 172 kW, 430 V, 400 A and 1800 rpm. Its magnetization…

A: The Given Separately Excited DC generator is rated at 172kW,430V,400A and 1800r/min The…

Q: Q4 The control system of an engine has an open-loop transfer function as follows; G(s) (a) (b) (c)…

A: "According to the Company's policy we will solve the first three parts". The control system of an…

Q: Q.7 a) Ring and number the junctions of component in the below circuit. R1 R2 R4 Input Output Q4 R3…

A: The given circuit diagram is shown below:

Q: Use words (not an equation) to describe one of the reciprocal identities.

A: Calculus aids in comprehending how values related by a function change over time. It is utilized in…

Q: A parallel RLC resonant circuit has a quality factor Q-80, and a resonant frequency of 200 krad/s.…

A: Given: A parallel RLC circuit has Q=80ω0=200 krad/sR=40 Ω

Q: The z-parameters Z11, 212, 221, and 222 are measured in a. A/A b. V/V c. A/V d. V/A

A: Given, The z-parameters z11, z12, z21, and z22 are measured in

Q: Calculate the inductance for a coil with 120 turns, a current of 0.47 mA, and a flux of 1.2x10Wb. a…

A: Given: No. of turns, N=120 turns Flux, ϕ=1.2×10-6Wb

Q: R(s) K (s+ 2) (s+5) s² (s+ 6) (s+14) (s +55) C(s) use Routh-Hurwitz criterion method to determine…

A: Given data : The given block diagram is,

Q: What are the basic logic gates in the MOS logic family? 1. NOR & NAND 2. AND & OR

A: Given: MOS logic family

Q: Draw the logic diagram of a 2-to-4-line decoder using (a) NOR gates only and (b) NAND gates only.…

A: The two to four decoder can be designed by using the universal gate and this can be achieved by…

Q: Design a wide band pass filter with f = 500 Hz and f = 2 kHz, and a pass band gain = 5 for both…

Q: In the circuit shown above, the initial voltage across capacitor is 2 V and I is a unit step current…

A: The required parameters can be obtained by considering the state of the circuit at t=0 and after…

Q: (a) Figure Q4(a) shows a two-port network circuit. (i) (ii) Calculate the admittance parameters of…

Q: j5 Ω 3 Ω CC 15/90° V 20/0° V j4 Ω

A: Given circuit:

Q: 12-10. Determine the SWR for a 50-02 transmission line that is terminated in a load resistan ZL = 75…

Q: Given: VCC = 20V RB = 390KΩ RC = 2.2KΩ RE = 1.2KΩ Beta = 80 rO = ∞ Calculate: a) re b) Zic) Z0d) AV…

A: The required parameters can be calculated by using the DC and AC analysis of the amplifier circuit.

Q: Derive condition of symmetry for Z- parameters. Consider the condition of symmetry as shown in…

Q: R(s) G₁(s) G₂(s) G4(S) G3(s) G5(s) G6(s) -H₁(s) G7(s) ) Find the equivalent transfer function of…

Q: What are the basic logic gates in the MOS logic family? 1. NOR & NAND 2. AND & OR

A: In this case, the basic logic gates corresponding to the MOS logic family is to be determined.

Q: actice problems: a) Write the transfer function H(s) = Vo(s)/I;(s) for the parallel RLC circuit…

A: given data,

Q: Jw/2 sinc (w/2) Oxx (W) = e Hint: sin 1/2 [ee] Rxx (1) 1 1

A: Solution- ϕxxω = ∫-∞∞Rxxτe-jωτdτ =∫011.e-jωτdτ = e-jωτ-jω01 =…

Q: VRY = 220 cis 0°, VYB = 220 cis -120° and VBR = 220 cis -240°. IR = 10 cis 0°. The load is balanced…

Q: 8. MIMO was initially developed in the year.

A: The correct option along with the explanation is provided in the following section.

Q: A 118 V, 50 Hz, single-phase synchronous motor is taking a current of 40 A at 0.85 lagging power…

Q: 7. A microwave link consists of repeaters at 40-km intervals. What must be the minimum height of…

Q: Find the number of resistance sections and the resistance of each section of a starter for a 3.7 kW,…

Q: An electric utility company runs two 100 m copper wires from the street mains up to a customer's…

A: we have to calculate voltage drop.

Q: For a pulse code modulated system, the uniform quantizer has 256 different levels.…

A: Given information: The number of levels present in the uniform quantizer is N=256

Q: Simplify the following Boolean expressions to a minimum number of literals: xyz + x ′ y + xyz ′

A: The given Boolean expression can be reduced by using the Boolean law and postulates.

Q: A pulse code modulated system has 8 bits per sample. What is the number of levels present in the…

A: Given information: The number of bits transmitted per sample is 8. The number of levels present in…

Q: Question 6 a) Obtain the transfer function for the block diagram shown, by using the signal flow…

Q: IA = 4mA, R1 = 12kΩ, R2 = 6kΩ, R3 = 3kΩ, β = 2 the node voltages in the circuit calculate.

A: Given data : The given circuit is shown below,

Q: Draw & Explain single line diagram of 11KV substation

A: parts of a substation lighting suppressant Transformer, circuit breakers, relays, fuse isolators,…

Q: clamped cubic spline S for a function f is defined by + + 7 (x − - - 5(x) = {a + b(x-2) - c(x - 2)²…

Q: A load consisting of a 1.35 kO resistor in parallel with a 405 mH inductor is connected across the…

A: In this question, We need to determine the average active power, reactive power ,apparent power and…

Q: 12.a. Section ___ requires seals to be installed in a raceway system whenever the raceway changes…

Q: 12-12. Determine the characteristic impedance for a quarter-wavelength transformer that is used to…

Q: 17. Four electricians are discussing the size of boxes that must be installed to allow for the…

A: Here four electricians are discussing about the size of boxes that must be installed to allow for…

Q: The BJT in the circuit in the figure below has Is = 10-¹5 A at room temperature. a) Find Vo at room…

Q: A large electric utility company spews 62 million tons of greenhouse gases (mostly carbon dioxide)…

A: Given: Annual emission of greenhouse gas (mostly carbon dioxide) is 62 million tons each year.…

Q: The Maxwell-Boltzmann distnbutlOn function  

A: Solution- Given, fE=e-E-Ef/KTDcE = AE-Ec1/2 a) Carrier distribution taken as f(E) in conduction…

Q: 2. Calculate the power density (a) 500 m from a 500-W source and (b) 36,000 km from a 3-kW source.…

A: Given & to find: Calculate the power density (a) 500 m from a 500-W source and (b) 36,000 km…

Q: se the best statement that explains why a constant magnetic field cannot do work on a mov O The…

A: The fact that magnetic force do no work is an elementary and direct consequence of the Lorentz force…

Q: In a balanced delta connected 30 circuit, the load in each branch consists of a 10 resistance in…

A: Given Data, Line Voltage VL=400 V Frequency f=50 Hz Resistance R=10 ohm Inductance XL=0.0318 H

Q: Prove that the sinewave shown in Fig. Is a periodic signal. x(1) Periodic signal x(t)= A sin(2xfot)…

A: We need to prove that the given signal is periodic .

Q: analyse any six rules of indian electricity are mostly preferable

Q: (II) (a) If the resistance of the resistor in Fig. 21–60 is slowly increased, what is the direction…

A: The given figure is shown below:

Q: (b) Vi A circuit which operates at = 50 rad/s is shown in Figure Q2(b). (i) (ii) If an input…

Question

What is the purpose of an Amperian Path in Ampere's circuital law? 1
A.
B.
C.
D.
Computation of magnetic field intensity
Determination of differential element of path length
Estimation of electric flux density
Detection of a loop in a constant plane

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Concept

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Determine the GMR of each of the unconventional stranded conductors shown in Figure 4.30. All strands have the same radius r.
General Background for Inductance of Transmission line 1- Introduction: 2- Derive one of the formulas used to find the flux linkages: 3- Calculation of Inductance of Transmission line (give an example):
Find the flux
A three phase, 11 KV, underground cable system, consider a single core of conductor radius 0.5 cm diameter and lead sheath of 1.25 cm. The core and lead sheath have been separated by two intersheaths with radius 0.75 cm and 1 cm. Draw the cable core, dielectric and intersheath layers showing the thickness of each layer, then determine the voltages on the both intersheaths. Suppose the maximum stress on the layers are the same.
1. In addition to resistive components, state or name one other electromagnetic component found in the equivalent circuit of a transmission line. 2. State or name one equivalent or simplified model of transmission lines 3. In general, the fluxes whether electric or magnetic are maximum when the area vector and the active field are ______ degrees with each other. 4. Complete the Parallelism: "Charges are to Electric, while __________ are to Magnetic"
A three phase, 33 KV, underground cable system, consider a single core of conductor radius 0.8 cm diameter and lead sheath of 2.3 cm. The core and lead sheath have been separated by two intersheaths with radius 1.3 cm and 1.8 cm. Draw the cable core, dielectric and intersheath layers showing the thickness of each layer, then determine the voltages on the both intersheaths. Suppose the maximum stress on the layers are the same. Please i need it know please
Q-1) Compared to a three-wire bundle, a single wire using the same amount of metal per km wouldhave higher losses. Elaborate. Q-2) What is the main objective of transposition in transmission line conductors? Course is power transmission
Which of the following is?are an application of electrimagnets. A) relays, B) generations, C) magnetic cluches, D) all of the above. When using the left hand rule for conductor, the fingers point in the direction of_______. A) the electron flow, B) the field around the conductor, C) both a and b, D) none Upon what does the strength of an air-cored coil depend?A) amount of current flow, B) number of turns, C) permeability of the core, D) all above
Rigid metal conduit (RMC) is a threadable raceway of ____ designed for the physical protection and routing of conductors and cables. Select one: A. AN INCOMPRESSIBLE MATERIAL B. GALVANIZED STEEL C. VARIOUS BENDING RADII D. CIRCULAR CROSS SECTION
An overhead line has span of 260m. The tension in the line is 1200kg while the conductor weighs 650 kg per 100 meters. Calculate the maximum SAG in the conductor. If the height of the tower is 13 meters, estimate the clearance of conductor to the ground. Draw a figure and mark values of sag, clearance, span, height of conductor etc.
An overhead line is supported between two towers which are at the same vertical height from the ground. The horizontal distance between the towers is 300m. If the conductor weight is 30N/m and the tension at the towers is 30kN, calculate i. the maximum conductor sag. ii. Find also the total length of the conductor.
Electricity has composite demand. True False